Ford F-150 - 1997-2003 :: Water Pump Pulley Shims
Is it common to have to shim the water pump pulley? I don't know why but mine seems to have moved back a fraction of an inch. I loosen the belt tension and slide the belt back and as soon as I start the motor, the belt slides forward again. And as I rev the motor, the belt moves even further out onto the edge of the water pump pulley and starts to squeal. All other pulleys are aligned and the belt spins fine on them. I thought about buying a shim kit, but I ordered a new Motorcraft water pump since I have 154k miles on my truck.
View 7 RepliesCamry :: V6 Water Pump Leaking Through Its Pulley Shaft
I was hearing some sounds from my engine and opened up the timing covers to determine where the sound was coming from. It sounds exactly like the Sienna with the same 3MZ engine in this video: YouTube ....
While I didn't find the source of the noise, I did find that my water-pump is leaking. My question is, is this water-pump leaking bad enough to be replaced? I do not notice any coolant loss and never had the need to top up.
It appears from this last photo that the pump is leaking through its pulley shaft and not at the interface with the engine:
The timing belt and water-pump were changed 3 years ago with the Gates timing belt kit from RockAuto. The pump at the time didn't look that great quality in its casting compared to an Aisin pump.
I could not feel any play or hear any abnormal sounds from the pump while it was running with the timing covers off.
This is on my 2005 Lexus ES330 with the 3MZ-FE 3.3L V6 engine, same motor as the Gen 5 Camry SE V6.
Camry :: Toyota 2008 - Misaligned Water Pump Pulley?
I have a 2008 Toyota Camry, 4-Cylinder w/ 55,000 miles on it.
Yesterday, when I started the engine I heard a rattling noise. Opening it up and looking inside, it seemed to be coming from the area of the serpentine belt. Looking closer, I saw that the pulley appeared to be wobbling slightly, although it didn't feel loose to the touch.
As I'm out of town on a roadtrip and needed to try to get home, I decided to try to drive it anyway. Aside from the noise itself, the car ran fine - the engine temperature stayed normal, which I kept an eye on closely.
After a bit over 50 miles of this, however, the serpentine belt got thrown off. With my engine temperature rising, alternator not functioning and power steering cut out, I pulled over immediately and shut off the car.
Looking more closely at the water pump pulley, I could see that it was clearly tilted in its alignment in comparison to the other pulleys along the belt's route. This explains the wobbling I saw. Clearly that needs to be repaired, lest it throw off the serpentine belt again.
So, this brings me to my questions here.
Given that the water pump itself seemed to be functioning fine during the drive until the belt got thrown, is it possible that just the pulley itself is broken? Or that it's misaligned?
If so, is it possible to replace / realign the pulley without having a mechanic tear the car apart to get the water pump out?
If these aren't the issue, is it possible that the water pump itself is just misaligned as opposed to broken? If so, can it be realigned without buying a new one?
I'm basically trying to assess
* what exactly is the problem
* whether it is something I can fix myself without a mechanit
* whether I'll need parts and what those parts would be
* how many hours of service I should expect to have to fund if I can't do it myself
Here's a picture of how it looks right now .....
Prius (2004-09) :: Rattling Noise Near Water Pump / Pulley
My wife calls me yesterday and said she could hear a rattling noise from the engine area, but no other issues presented themselves. Later, I checked the engine compartment for the noise with the engine on and found that the noise was coming from the area of the engine water pump/idler pulley but i couldn't really narrow it much closer. The noise honestly sounds like bearings about to go out. I did see that behind the water pump pulley there was a small buildup of corrosion on the water pump, but no apparent leaks or wetness. The car has the original water pump and idler pulley with 140k. I plan on replacing the water pump, idler pulley and thermostat in the morning. Or is this overkill? I don't want to lose the engine nor do I want my wife to get stranded anywhere.
View 9 RepliesLexus SC430 :: Squeal From Engine Usually Only When Cold Outside - Water Pump Pulley
I get a small "squeal" from the engine usually only when it's cold out, and have narrowed it down to the water pump pulley (2nd pulley down from the top). I put a drop or two of WD-40 on the "rod" that runs through the pulley and it stops. I know not to put anything on the belt to avoid contamination but it seems to me that it's the metal bolt that keeps the pulley in place. I stopped by an O'Reilly and had the tech have a look because I was going to try a more viscous grease. He thinks that it's either the pump is starting to fail or that the pulley could have moved out of place. He said I should remove the belt and tug on the pulley.
If it moves then it's loose and needs to be lubed and tightened. If it doesn't then it's a water pump replacement. What do you all think? I don't want to drop a ton of money as it truly only squeals when it's cold, and unfortunately I'm thinking Chicago's gonna have a cold one this year even though after the engine heats up it's goes away. If you have a guess to the problem, what do you think replacement will run me. I'm only at 30,000 miles, and has been garaged until recently so I don't think it's a belt change or pump failure yet.
Mustang :: Replaced Water Pump / Thermostat / Underdrive Pulley But Still Overheats?
My son has a Mustang GT 5.0 that is overheating. I replaced the radiator with a heavy duty 3 core radiator. It had underdrive pulleys so I replaced them with stock pulleys. I put dual electric fans on it. I flushed the block and put a new thermostat and replaced all the hoses (made sure the bottom radiator hose had wire in it so it wouldn't collapse). I put a new water pump and drive belt but it still overheats when sitting in traffic and overheats when driving with the A/C on.
View 14 RepliesGolf IV R32 :: Noise Coming From Front Of Engine - Water Pump Or Idler Pulley?
I have a noise coming from the front of the engine. The noise stops once the the thermostat opens and the water pump starts circulating coolant.
View 1 RepliesPrius (2004-09) :: Pink Coolant Residue On Inside Of ICE Water Pump Pulley
On the 06 Prius I have been working on, I noticed a light build up of pink coolant residue on the inside of the ICE water pump pulley. I assumed that this was due to a coolant leak from the weep hole, which points to an impending water pump failure.
View 16 RepliesFord 6.0L Power Stroke Diesel :: Bolt Size For Water Pump Pulley
Need to know the thread pitch and diameter for the water pump pulley bolts? The previous owner of the engine I bought clearly didn't know how to get the fan off as the pulley and plastic fan are both loose so I cannot loosen large nut.
View 1 RepliesCamry :: 2010 V6 SE - How To Remove Engine To Replace Water Pump
When the water pump goes bad do you have to remove the engine to replace it?
View 2 RepliesFord 6.0L Power Stroke Diesel :: How To Remove Water Pump
I'm replacing my water pump and was wondering how to remove this.
View 3 RepliesPassat (B5) :: 2001 1.8t Overheating After New Water Pump
i just did a new timing belt water pump kit on a 2001 1.8t (aug engine code) the new pump has a metal impeller. i ran it in the drive way for mots of an hour off and on. figured it was good. took it for a drive and at 5 miles it overheated. Temp Went straight to 260 and stop light came on. coolant could be heard boiling in the system. when i let it idle and ran the heater i got the temp to go back down to 190. but after idling for couple minutes it started going back up. I don't think the stat is bad considering that the heater works which shows that the system is flowing.
View 5 RepliesCamry :: How To Remove Crankshaft Pulley - No Holes For Bolts
How to remove a crankshaft pulley like this one? It doesn't have any holes for bolts, to hold some soft of breaker bar in place.
Pulley.JPG ....
Elantra HD (2006-10) :: 2007 - How To Remove The Crank Pulley
Preparing for a timing belt replacement on a 2007 elantra. well aware of how to remove the crank pulley and do the job. My question is this : once you have the nut off, does the crank pulley come off by hand or is a puller required? came off nicely wiggling it by hand on any accent i've done, but never done this particular job with the elantra.
View 4 RepliesGeo - Prizm :: Cannot Remove AC Belt / Pulley Is Stuck In The Bracket
I'm trying to remove the AC belt off a '96 Geo Prizm. I've loosened the idler pulley adjusting bolt, per my Chilton's manual, but it doesn't loosen the belt. It's as if the pulley is stuck in the bracket. Even if I completely removed the adjusting bolt the pulley wouldn't budge. How can I unstick this thing without damaging the pulley?
View 6 RepliesCelica :: 2001 - How To Remove Power Steering Pulley
I need to remove the power steering pulley on a 2001 Toyota Celica GTS to replace the pulley shaft's seal. I've got several pullers, so I figure one of them will work. But, I'm concerned that when I pull it out it could damage whatever it messes with inside. Also, I'm going to try doing this with pump on the vehicle.
View 1 RepliesPassat (B6) :: 2006 2.0t - Timing Belt And Water Pump Replacement?
How to change the timing belt and water pump on a 2006 2.0t passat?
View 3 RepliesPassat (B5) :: Oil Leak After Replacing Timing Belt And Water Pump
I replaced a timing belt and related parts on a v 6 atq motor and three weeks later there's a pretty good oil leak, where its from or if oil leak can be related to timing belt replacement... leak seems to be in same area as crank pulley but not sure...
View 2 RepliesOldsmobile - Alero :: 2003 - Water Pump Is Going Out
There is a car i am interested in buying but the person selling it says the water pump is going out. The car is an Oldsmobile 2003 Alero with 141000 miles on it. How much would it cost to fix this water pump and how can i check to see how its working?
View 6 Replies