Park Avenue :: 1992 - Hard To Shift Into Park From Other Gears
1992 Buick Park Avenue, Base. For awhile now I've had trouble shifting into park from other gears. Sometimes, it'll flow right into park without trouble. Other times, I have to work it, to kind of baby it in. However, it simply will not shift into park from reverse. Period. If I'm in reverse and want to park, I have to go into drive, neutral, etc, and then try to move it into park.
A mechanic I know looked at the neutral safety switch and thought it could be causing the problem. We figured it wasn't in the steering column or the cable to the switch because if we disconnect the cable, you can slide that lever all day long. So I purchased a new neutral safety switch and had him install it, but the same problem is there. Actually, let me clarify: while it was in his garage, with the old switch, it would no longer go into park at all, regardless (kind of decided to just stop altogether). At least with the new switch we can baby it into park, but it is basically back to where it was last week. He mentioned it might be deeper in the transmission, but that's out of his league.
Park Avenue :: 1992 - Consistently Getting Code 41
92 PA, 134,000 miles
I'm constantly getting a 'Code 41' and now my fuel economy is almost 100 miles less than usual on a full tank. I was wondering what could be causing the decrease of fuel economy?
Also, direct me to the location of the cam sensor and the directions for replacing. I've tried the AutoZone site to locate it but it was difficult to decipher.
Park Avenue :: 1992 - Water Pump Replacement
92 PA Base ... Attempting to replace water pump. Is a hydraulic jack required to hold up the engine when removing the engine mount? The engine mount (passenger side front) is covering the right portion of the water pump. Although the engine mount has two holes for the remainder bolts of the water pump, there's no room to fit a ratchet or anything to remove the remaining two bolts. It appears the mount must be removed to replace the water pump. Is this so? How to correctly remove the engine mount.
View 1 RepliesPark Avenue :: 1992 Buick Shakes As Slow Down And Stalls When Stopped - Code 41
I recently acquired a 1992 Buick Park Ave. My problem is that she shakes as i slow down and stalls when I stop. Usually about 10 minutes or so of driving. It doesn't stall every time but less when i baby the brake (i think) Its getting worse quickly and I've changed the spark plug wires and that didn't work also the previous owner recently changed the Cam sensor yet I'm getting a code 41.
View 14 RepliesHonda - Accord :: 1992 - Cannot Release The Shifter From Park Unless Use The Car Key To Unlock
I have a 1992 Honda Accord with an automatic transmission and recently I've started having some problems. About 3 weeks ago I noticed that, when I parked my car and put the shifter in "Park", the shifter became locked in this position. In other words, I cannot release the shifter from "Park" unless I use the car key to unlock the shifter. So, I started parking my car in neutral (there are few hills in my area) so that I didn't have to unlock the shifter each time. Occasionally I park the car in "Reverse" (after turning the car off), although I have to put the car in neutral to start it up.
Today I started my car and noticed that I had very little acceleration. In fact, when I was on a slight incline, waiting to pull out into an intersection, it was difficult to keep my car from rolling backward. Also, when I pulled out into the intersection, it accelerated very slowly and took much longer than usual to get up to normal speed. However, after the car sat for 5 hours afterward, I started it and it began accelerating normally once again. This is the first time I've had this problem with the car.
Ford Super Duty (1999-2016) :: F250 - Brake Caliper Won't Release
My 1999 F250 right rear brake caliper will not release. I replaced the caliper, caliper mounting hardware, pads, rotor, emergency brake pads, and I bled the system. For some reason the right rear remains activated when my foot is not on the brake pedal. The other three wheels appear to be functioning normal.
View 6 RepliesPark Avenue :: 2001 - Front Passenger Door Will Not Open
Front passenger will not open. It sounds like it unlocks but won't open. I was able to get door panel partially off. But i can not see the latch assembly. Not sure if I should try to muscle the panel off more probably destroying it so I can get to latch assembly or try to make a hook of some kind to put down next to window to try to pull rod for door latch. I was able to get my hand inside trying to pull on the arms to open but it never worked. Trying to see if I can get more access to spray it with something to free it up.
View 3 RepliesSanta Fe (DM - 2013+) :: Electronic Park Brake Does Not Immediately Release As It Should On Takeoff
I have had my new Santa Fe Elite for three weeks. On three occasions I have found the Electronic Park Brake does not immediately release as it should on takeoff. Why it stays on some times? My vehicle is Right Hand Drive.
View 4 RepliesFord Brakes/Suspension :: 1989 F150 - Park Brake Won't Disengage When Release Lever Pulled?
my park brake will work when pushed to the floor but when i pull the release lever it will not disengaged.
View 1 RepliesLexus GX 2004-09 :: Front Brake Caliper Bolts Frozen
Started to change front pads and rotors on my GX470, but couldn't get the caliper bolts loose. Is it safe to use a torch to heat up the area around the bolts so I can loosen the bolts? Any other way to break these bolts free?
View 12 RepliesFord F-150 - 1997-2003 :: Front Right Brake Caliper Locking Up
My buddy has been having a strange problem with his 275,000 mile 2003 F150 2wd. The right side caliper will lock up out of the blue and will not release for anything. We put 3 news calipers on it within a 4 week period thinking that we had a defective one but no change. I am thinking either a bad brake line or, more likely, the front abs block...
View 1 RepliesFord - Explorer :: Left Front Brake Caliper Locked Up
My teenage son just bought his first car, a 1991 Ford Explorer XLT 2-wheel drive. I had it checked out by our mechanic before I let him shell out the money, and everything seemed OK. It's the prototypical low-mileage car (127k actual, confirmed by Carfax) owned by a little old man who took good care of it (stack of service records a foot high) and didn't drive it very much.
Earlier this week ... he'd driven it for about two weeks with no issues ... the left front brake caliper locked up on it, to the point where it heated up enormously, the pads and rotors got so hot they were discolored and some transmission fluid got blown out by the strain.
He took it to our regular mechanic, great guy who we've used for years and has worked magic with our cars, he got into it and he diagnosed the problem as ... I hope I'm explaining it right ... a little pin or piston or something in the caliper was upside down. He put it back in the right way, and everything seemed to be OK, although he said my son would probably end up needing a brake job sooner than later because of the way the pad got ground down.
FYI, master cylinder is full of fluid, our mechanic couldn't see any leaks anywhere. Although when we took the car to the mechanic, my son tried to back it up to get a better angle at getting into the service bay, and the pedal went to the floor.
Fast forward two days, and danged if the same thing didn't happen with the right front caliper, seized up although he didn't get it as hot as the other time, parked it a lot quicker. And of course it happens on Friday going into the weekend, when our mechanic isn't working, he won't be able to do anything until Monday, which leaves us scrambling trying to get everyone to work, etc., down one car.
Doing a little online homework ... which we probably should've done before my son made this purchase ... I'm seeing a lot of brake issues with '91 Explorers. I asked my mechanic if he thought there was some ABS-related problem here and he said he didn't think so.
I will say that the car apparently sat undriven for a long time, which I know can unleash a lot of issues. What might be going on here? Do we just need to go ahead and replace the calipers, any hoses, etc., as preventive maintenance?
Ford Ranger / B-Series :: Front Brake Caliper Seems To Be Sticking?
Yesterday, I noticed that my right front brake caliper seemed to be sticking. This morning I jacked up the front end, and could barely turn the right front wheel when it was off the ground. So, I have concluded that that caliper is sticking. So, here is the question(s): what is the best way to repair this (new caliper, rebuilt caliper, or rebuild it myself), do I need to do both sides the same or can I just do the one that is acting up, and should I expect to pay. I have some mechanical ability, but that Haynes manual doesn't make too much sense to me. Getting it professionally repaired is extremely inconvenient, I need to be back at school (300 miles away) Tuesday evening, and probably couldn't get it in to get it done before then.
View 12 RepliesCaravan/Voyager :: Front Brake Caliper Frozen And Cannot Turn The Tire
My right front brake caliper is frozen and I cannot turn the tire. This happened about a month ago and I went to Autozone and they gave me a new caliper, rotor and brakes, under warranty, and now the caliper is frozen again and I cannot turn the tire when jacked up. It seems to release after a period of time. I am not sure if it has a proportioning valve for the front brakes, but the driver side wheel turns freely and is not stuck.
View 2 RepliesPrius (Gen 2) :: Pistons In Driver Side Front Brake Caliper Is Sticking
One of the pistons in my driver side (UK) front brake caliper is sticking, so I've bought a second hand caliper just to fix the problem until I come to sell my pri in a month or so.
View 15 RepliesCamry :: ABS Brake - Front Driver Side Caliper Sticking And Heating Up
2005 Toyota Solara my front driver side caliper was sticking and heating up a couple months ago... replaced the caliper and the rotor... still had the same problem. I would drive it, it got hot and stuck, after I parked for a little while it slowly released. Talked to a couple of mechanics and they both said undoubtedly I had a bad flex hose and it was collapsing with pressure and then will release... I changed the flex hose and flushed the fluid and it was immediately fixed...no problems.
Drove the car for a month, went to South Carolina and back and then a couple days ago the same thing started happening. Talked to a mechanic, he told me that the new caliper may have gotten fried from over heating before I changed the flex hose... Got a new caliper today (warranty) exchange... changed it out and still have the same problem. When it sticks I can release the pressure by opening the bleeder valve so it seems like the flex hose issue again... my only thought now is maybe the new flex hose is a bad one and someone mentioned the proportioning valve.
Toyota - Highlander :: 2004 - Front Driver Side Brake Caliper Seized?
My 2004 Toyota Highlander with 84K miles has been diagnosed with a seized front driver side brake caliper with worn brake pad (1/32). I had recall work done a few days ago at the dealership and this was discovered afterward during the "complimentary" multi-point check-up. - You know, the long laundry list of recommended work they try to sell you on. Of course the brake work is actually necessary.
Since the vehicle was just inspected 2 months ago at our local shop, my husband suggested I take it back there to verify the diagnosis and see what that mechanic would recommend. That mechanic confirmed and showed me the seized caliper/worn pad, which, by the way, was functioning well in mid January at inspection, and measured 7/32. This mechanic recommends replacing both calipers, pads, turning rotors. There was no indication of a problem with the RF caliper, but he says it's just a good idea to replace it so we would avoid having another problem in the future.
I want to ask everyone's opinion regarding replacement of just the bad caliper vs. both. Are we getting ripped off as far as the estimate and is the flush necessary? Also, is this issue typical in the first place, and what causes a brake caliper to seize? We've had several other vehicles driven many more miles than my Highlander and never experienced a seized caliper.
Park Avenue :: Car Does Not Start Every Time
PA Base 149,000 miles . My car doesn't start every time. Sometimes I have to wait for a few minutes before it does, meaning, when I turn the key, it does nothing. There's no cluttering or blinking of lights or anything else that would indicate a bad starter, bad battery or electrical issue.
I've had the battery, starter and alternator checked and my mechanic says that everything is good. He thinks its the ignition key or the security system is going bad.
I purchased a new key two weeks ago and it started up every time until earlier today.
In the speedometer and odometer section, specifically the 'Park, R, N, D, 2, 1' section, there's an orange pin-like indicator that moves when you change gears. Mine is stuck between the '2 and 1', even when I place the car in park, reverse or drive. Could this be any cause to my vehicle not starting?
Park Avenue :: DIC / AC And Radio Lights Dim Very Low
I just purchased a 2001 Park Ave Base. The DIC, A/C and Radio lights will randomly dim so low that they cant be seen during the day and I have no cluster lights at all. I have checked the fuses and ensured that the dimmer is all the way up (just before clicking on the interior lights which do come on) and have found nothing.
View 4 Replies