Buick - Regal :: 1996 - CEL Code P0306 Cylinder 6 Misfire Plus P0102 Mass Airflow Sensor
Ok, my 1996 Buick Regal is acting up. I got a CEL, which was a P0306 (Cylinder #6 misfire), took the car to my shop, and they diagnosed as a faulty Ignition Control Module. Fast Forward, a day later, the car now has a hard start problem and throwing the same code, plus a P0102 Mass Airflow Sensor.
So my questions are:
1) Could a faulty ICM cause a single cylinder misfire, did they just replaced a random part? I would think a bad ICM would a multiple misfire considering on this car each coil controls 2 cylinders.
2) Are the two codes related? ie fix one, and the other would go away? or are they separate issues?
3) What could be wrong with my car?
This mechanic has been in my family for years, however, I'm not very pleased that a day later, my car seems to have more problems than before. Am I being too harsh?
Golf IV / Jetta IV :: 5 Engine Fault Codes - Cam Position Sensor / Knock Sensor / Secondary Injection Pump And Mass Air Flow
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesPassat (B5) :: Mass Air Flow Sensor Burnt Out
I've had two mass air flow sensors burn out in my 05 TDI Passat. Dealer says it's faulty wiring in my vegetable oil conversion. Sensible?
View 1 RepliesGolf/GTI VI :: CEL On - Code For Mass Air Flow Sensor
Need to diagnose an issue with my 2012 GTI its got 39,000 miles its stage 2 Unitronic tune. So I was driving like an idiot coming home one night and i jumped a set of train tracks. Bent my plastics a little and when I cranked my car the next day my CEL was on. I noticed my intake was much noiser than usual. My buddy checked the code and said i needed a new mass air flow sensor. We replaced it and my CEl came back on within 20 minutes of replacing the sensor.
View 5 RepliesPassat (B5) :: 2003 Bad Gas Mileage - Mass Air Flow Sensor?
I think I'm getting bad gas mileage on my 03 passat... I don't think it's my imagination...? I'm gonna keep track of how many miles I get next time I fill up, how do I know if I should look into a new MAF sensor?
View 3 RepliesAccent MC (2006-11) :: Mass Flow Air Sensor Location
2009 accent, cant find its location. Picture would be nice...
View 4 RepliesSonata I45 (YF - 2011+) :: Mass Air Flow Sensor Location?
Oil leak.... I can not locate the MAF sensor in my 2012 gls 2.4l sonata. I followed from the front tube intake through the air box to the throttle body and i do not see one. I also have the service manual and no mention of said sensor!
View 14 RepliesLexus GX 2010+ :: How To Clean Mass Flow Sensor
Cleaning the MAF on the GX460? I have seen videos on youtube but the MAF positioning on the GX460 is a little hard to get to. I am wanting to clean the MAF because I am still experiencing some sluggishness. The vehicle's response had improved after a fuel induction and a spark plug change but it is still sluggish when compared to other GX's I have test drove. It is sort of inconsistent. Sometimes, it drives super smooth and the gears quickly shift other times the gears take forever to upshift and downshift.
View 1 RepliesSilverado :: Check Engine Light Came On - Mass Air Flow Sensor
Ok so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 RepliesGolf/GTI VI :: 2011 - Mass Air Flow Sensor Wiring Harness?
What is that called? Mass air flow sensor wiring harness? I google 2011 vw gti MAF wiring harness, and i get nothing, or crap thats almost not related to what im looking for. While I was installing my intake, I accidently cut half of the wire to my MAF located behind the battery. Why I was cutting, dont ask, i was impatient. Anyways, what is it called? I want to replace my MAF and the wiring that leads to it.
View 1 RepliesSonata NF (2006-10) :: Removing And Cleaning Mass Air Flow Sensor
2006 Sonata with 3.3L V6. How to remove the MAF sensor on this engine? I see it right between the air cleaner and the throttle body input but can't get the electrical connector off for one thing. I bought some MAF cleaner (don't use carb cleaner) and did this on my other car (a Saab) and I cleaned the throttle body butterfly valve at he same time (with Valvoline carb and Throttle Body cleaner spray). It really needed it. I use a lightly oiled K&N filter on the Sonata and I hear it's even more important to clean the MAF sensor it under these conditions. You just blast it with the spray and reinstall.
View 9 RepliesPrius (2004-09) :: Symptoms Of Failed Mass Air Flow Sensor?
I had to have my 2009 Prius towed 2 days ago. It has just over 73000 miles. I was on the highway and suddenly experienced a lack of power. Eventually, the dashboard lit up: check engine light, big red exclamation point, and my favourite: it said "problem" on the center display. I pulled over and let it sit for a few minutes and tried starting it.
All the same warning lights came on. The battery level was at 1 bar. The gasoline engine would start for maybe 10 seconds and shut off. I could move the car on battery power only, but I had several miles to go before the next exit, uphill, so I figured I needed to be towed.
Long story short, my dealer said all this is due to a failed mass air flow sensor, and is going to replace it. Does that make sense? I thought a faulty sensor might make the car run roughly or whatever, but not actually prevent the engine from running.
Prius (Gen 1) :: Mass Air Flow Sensor Replacement And Cleaning Throttle Body
Got told by the dealer I need to replace my Mass Air Flow Sensor...to the tune of $657 dollars. And get a throttle body cleaning.
View 14 RepliesLexus RX 2004-09 :: 2008 RX350 VSC OFF Light On - Mass Air Flow Sensor Code
"VSC OFF" light came on the other day. I took my RX350 to the dealer. The dealer said Heater Element sensor is bad. They didnot have this part in stock. I googled this part. Nothing comes up under that search. I took it to Autozone and the code came up as Mass Air flow sensor. Are both of these same thing?
View 7 RepliesFord Aerostar :: Code P1100 - Mass Air Flow (MAF) Sensor Circuit Intermittent
So, I've got a new toy (FORscan ODBII software) and a new code that isn't turning on the CEL (yet) but also didn't show up in OBDWiz either.
P1100 - Mass Air Flow (MAF) Sensor Circuit Intermittent
I cleared it, drove a few miles, checked again and it's set again.
The little troubleshooting advise window in FORscan says to monitor the MAF voltage while wiggling the MAF harness and see if the voltage goes below 0.23v or above 4.60v. I was unable to manually make that occur, no matter how I tapped on the MAF or wiggled the wiring.
However, in oscilloscope mode, look at this (at idle):
It sure looks like it went below 0.23v here. I have no time tonight to do any research. This is a relatively new MAF (one week old, Delphi unit). I think I'll swap it out for one of my two old OEM MAFs sometime this week. But if any opinion about this, pipe up. I do damned little work with scanners these days, and the tech keeps changing.
Oldsmobile - Alero :: Possible To Disable Catalytic Converter Sensor?
My wife's car has the check engine light on and she was told by her mechanic that it was the catalytic converter going out, to ignore it. I am thinking that I ought to be able to build a jumper for the sensor and fool it into thinking that it is working, reset the check engine light and wait till it starts to fall apart before replacing it. I'm tired of driving with the check engine light on, maybe missing something else that needs attention rather than the cat. it has 140k on this car but is in great condition. I am a diesel mechanic, no real experience with gas vehicles in a long time. oh, and we just got married. Or maybe I just ought to stay late at work and get this thing up on the rack and look into it. Put the scope on it myself??
View 19 RepliesPassat (B5) :: No Power / Idles Rough And Slow Takeoff - Mass Air Flow Sensor Failure
B5.5 GLX 4Motion ... My Car has no Power. Idles rough. Take off is slow. I can stomp it to the floor but the RPM needle barely moves.
Mechanic says I have many codes going off but thinks its the MAF. Already spent a bundle (misdiagnosed or ripped off) on other non related stuff that was supposed to fix this problem.
Mechanic says 90% sure but part is non return able. Need to know where to get the MAF cheap and quickly. Also part number or other identifying information so I don't get the wrong one.
Oldsmobile - Alero :: 2003 - P0306 Misfire Code - Engine Knocking?
My mom's 2003 Alero has had a bad catalytic converter for the last few years.. at least that's what she was told when she took it to the shop. The engine light (P0420 threshold below efficiency) has been on over the last few years and I occasionally check it with a code reader to make sure no other codes have been added. Up until today - as far as I know - none have been. Now today when she was driving it the engine light started flashing and running rough and making a knocking sound.She brought it straight home and I hooked my scan tool up and it gave the same cat code as I just mentioned, plus a P0306 misfire code. So I pulled the plug wire on number six cylinder and hooked up a spark tester to it - and it showed a decent spark. And to verify the spark being normal, I tested at another plug wire and the spark looked about the same..so I don't think anything is wrong with number 6 plug wire or coil or anything like that but am not sure. Also, the spark plugs were replaced a couple of weeks ago because the ones in the car were worn down about .010''. I can't imagine this having anything to do with the misfire because I did them myself and made sure they were gaped properly and that all the wires were put back on the correct plug/cylinder and plus it ran fine after the plugs were installed - but thought I would mention it anyways. And I was very careful not to damage the platinum on the plug when gaping them.
Did a little bit of research and found this: A code P0306 may mean that one or more of the following has happened: Faulty spark plug or wire Faulty coil (pack) Faulty oxygen sensor(s) Faulty fuel injector Burned exhaust valve Faulty catalytic converter(s) Running out of fuel Poor compression Defective computer
Passat (B5) :: Check Engine Light On / Code 16486 - Mass Air Flow Sensor Circuit Low Input
I cleaned my k&n air filter on my 02 passat 1.8 turbo let it dry oiled it very lightly, and 50 miles later I get a check engine light on, pulled the code 16486 and it says Mass or Volume Air Flow Circ Low Input. Cleared the code put a frame in until I can get it filter. Why that would throw me that code, k&n oil gumming up my sensor??
View 2 Replies