Nissan - Maxima :: 1993 - Will Not Start Intermittently?
My 1993 Maxima at times will not start. There is no rhyme or reason for it not starting. Either that or I have not found a particular reason or reasons for why it will not start. Sometime it is over night and at times it may happen when it sat for a couple of hours. Took it to a garage which they check the battery, starter, ignition switch, starter relay and all was okay.
View 3 RepliesNissan - Maxima :: 2007 Won't Start Intermittently After Stopped For Fueling
I have a 2007 Nissan Maxima and never had a problem with it until recently. My husband and I took a long drive to NJ from NH and went we stopped for gas and turned off the car, we could not start the car back up. We naturally called AAA, but once they came, about a hour later, the car started right up. Since that time, the car has repeated this several times. I take a trip to the grocery store, get back to the car, no problem, then make another short stop and then try to start the car and it does not start. I have no problem starting the car going to work every day and when I come home from work. It only happens when I make short intermittent trips, sometimes 2-3 stops. It always starts when there has been at least 1/2 hour between starts. I have taken it to 2 mechanics and they can never reproduce the problem I now have a car I have no confidence in. I am afraid even to get gas for this car.
View 8 RepliesNissan - Maxima :: 1998 - Won't Start When Hot Outside - Ignition Switch?
The car is a 1998 Nissan Maxima. As you well know a car's interior in the summer is about 10 to 15 degrees more than the outside. When the outside temperature is 80 degrees or more I can't readily start the car. I turn the key and nothing happens. Sometimes I put the switch into the "on" position wait about 20 to 30 seconds, turn the key again and the engine starts. I think I need an ignition switch. My question is why does this happen? What does the temperature of the car's interior have to do with the poor operation of the switch? The interior of the car must be about 75 degrees or less for the car to start.
View 4 RepliesNissan - Maxima :: 2006 - Engine Knocking / Head Gasket Going To Fail?
I have 2006 Nissan Maxima SE with the 3.5 engine. I have used regular gas for the entire 88K miles. Lately the engine knocks (diesel like). I asked my guy what to do. He said a nitrogen fuel injector cleaning.... Did that. No change. When I use premium it stops. However, I suspect something more is wrong. In fact, I suspect a head gasket issue. How can I diagnose without going to the garage? If it is the head gasket, am I doomed (cost a fortune to fix).
View 12 RepliesCamry :: Valve Cover Gasket Replacement On 2006 V6
So I'll be taking on a project to replace the valve cover gasket on my 2002 Camry V6. There's a bit of leakage through the gasket. And while I'm at it, I'll replace the spark plugs as well. I'm looking for a write up on this project. did a lot of searching but couldn't find anything.
View 14 RepliesSanta FE SM (2001-06) :: Valve Cover Gasket Replacement
How difficult is it to replace the valve cover gasket on a 2001 Santa Fe with a 2.7? Can I just do the 'front' valve cover? Are there any tutorials with plenty of pictures while doing this?
View 4 RepliesAvalon 2005-12 :: Valve Cover Gasket Replacement
A few days ago I noticed some oil leaking from the left (front) valve cover area and I suspect it's the gasket. Fortunately, I didn't see any leaks from the back cover. It seemed like an easy job to replace the gasket, but as I started to disconnect the wiring, e.g., cam sensor, spark plugs, etc., I can't seem to find a way to remove the black plastic wiring harness 'housing' out of the way.
View 1 RepliesNissan - Maxima :: 1998 - Runs Rough Once It Warms Up - Doesn't Idle Well
My 98 Maxima won't idle without dying, it sputters when you accelerate, and it tries to die while coasting. I've changed two O2 sensors (AutoZone gave me the code for bank 1 sensor 1 & 2) changed spark plugs, tried fuel injector cleaner, oil change, and cleaned MAF sensor & checked the wiring. It;s still spitting out the black exhaust. Although after changing the O2 sensors it quit for about a day or two but started again (I'm guessing the other sensors need to be changed to) But the main problem is once it warms up, it really runs like crap, and is a major gas hog. I'm getting about 12 Mpg.
View 19 RepliesNissan - Maxima :: 1998 - Service Engine Soon Light On / Random Misfire?
I have a 1998 Maxima with 57K miles on it. I just bought it about a month ago. Anyway, a week ago I noticed It felt very "choppy" when I shifted into Drive or Reverse. It felt like it was going to stall but it never did. The Service Engine Soon light has been on for about 3 weeks but now, when I go up hills especially, that light blinks. I can still drive it but I shift into Neutral at stoplights to avoid hearing the rough idle while in Drive. Went to Pep Boys yesterday - they had the car for about an hour and then informed me that they would need to keep the car for a full day because of the "complex issues involved" - especially concerning the codes. The codes they read were:
p0300 random misfire
p0325 knock sensor
p0440 evap emission
My car passed smog test abut 3 months ago. I can drive it OK it just is very choppy and so there's not a lot of power, especially going up hills.
Nissan - Maxima :: 1998 - Stalling While Driving / At Stop Lights And Turns
My car has been stalling out while at stop lights and while driving as well as spuddering and hesitating . i brought it in to the shop twice and both times they said it ran fine . they ran the code and gave me a new oxygen sensor and it still stalled. i brought it to autozone today and they ran the code and camshaft position sensor came up. so i put a new one in and it still is stalling and hesitating to drive. also smells really bad when it kick in. What could be wrong . short circuit or wiring trouble maybe? fuel pump ? crankshaft? electrical problem? spark plugs? cant get a straight answer.
View 8 RepliesLexus SC430 :: 2002 - Valve Cover Gasket Replacement?
How to replace valve cover gaskets on 2002 430sc???
View 14 RepliesGolf IV / Jetta IV :: Misfiring After Valve Cover Gasket Replacement
I did a valve cover gasket replacement. Changed all spark plugs and coilpacks. The car is still misfiring. I also just did the timing belt and water pump. Why it's still misfiring?? I'm new to this whole forum thing so bear with me lol. I'm wondering if it would be my cat, fuel pump, fuel filter. Or could it be a sensor?
View 2 RepliesAccent LC (2000-05) :: 2002 - Valve Cover Gasket Replacement
Replaced this gasket that seems to be leaking oil. Looks simple enough, is there anything i should do or know before taking on this job? It's a 2002 Accent GS 1.5L ....
View 8 RepliesPassat (B5) :: Oil Loss After Cam Tensioner And Valve Cover Gasket Replacement
I noticed the oil smell that can be associated with a leaking Cam Tensioner Adjustor Seal from my 2003 1.8T Passat a few months ago. The dealer confirmed that it was leaking and that it was covered by my extended warranty since my car was 5 years old and at 70K miles. I had the work done and after I picked up the car I noticed that the oil level was at the top of the hashes not at the top bend like it was when I took it in.
I don't know what caused it to drop to the hashes but I do know that the level has dropped to 3 visible hashes in the little over 1K that has been put on the car since then. I am concerned because in it's first 70K miles the car did not visibly lose a drop of oil.
Any logical cause for this annoying trend, the only thing that changed was that the Cam Tensioner and Valve Cover Gaskets were replaced. Is it possible something else was messed up during the repair?
Nissan - Maxima :: 1998 - Check Engine Light Come On And Car Started Running Very Rough
1998 Nissan Maxima had a check engine light come on and started running very rough. I took it to get a code read and came up with P0320 and P0325. I'm not worried about the 0325 since that's a knock sensor. 0320 is a misfire on cylinder 2.
With the car idling, I pulled the power connector from coil pack 2 to see if it made a difference in the idle - nope. I did the same for the other cylinders, and each responded with a noticeable change in the idle, which was remedied when it was reconnected.
I moved the coil pack from #2 to #4 (swapping them) and the same problem existed - idle was rough and didn't make a difference when I pulled the power on 2, but it did on all other coil packs. So, it seems the coil pack ins't the problem since multiple packs don't seem to make 2 work, but they work on other 4 and 6.
I then pulled the spark plug from cylinder 2, it was very black and looked in bad shape. I replaced it. Still no love.
I then put a spare plug in the coil and was able to see spark as the engine ran, so it seems that the coil pack at 2 is getting juice.
So, I have gas (big odor when the car is running - seems super rich) I have spark. Still running very rough and the 0320 code remains.
Mazda :: 2004 - Idle Bounce While Coasting After Valve Cover Gasket Replacement
I've got a 2004 Mazda 6 with the 3.0L V6 & a 5-speed, with about 128k miles.
The car runs fine, but was leaking oil onto the exhaust manifold and so I recently had the valve cover gaskets replaced. the mechanic could not get replacement gaskets from Mazda, and so changed the valve covers themselves also, and consequently needed to replace a couple of hoses that connect to the valve covers.
Since the repair, the car drives fine - acceleration seems normal, I don't notice any performance issues. The CEL is NOT lit.
1) When the car is in neutral, but rolling, the idle consistently bounces back and forth precisely between 1250 & 1500 rpm. This occurs always, and happens whether the gearshift is in neutral or the clutch is depressed. With the radio off I can hear the engine surging when this is going on. As soon as the car comes to a complete stop, the idle immediately drops to the a rock-steady position just below 1000 rpm, as it always has.
2) I assume related to the above, but since the repair my gas mileage has dropped from its usual 18-19mpg to 15.7-15.9mpg as recorded at two fill-ups, and my current tankful is looking to return equally low mileage.
I brought the car back to the shop and the mechanic took the car out for a drive with me, with his computer hooked up while we drove. He found nothing wrong, nothing out of whack, and saw no evidence of any air leaks.
1) Seems strange to me that the valve cover gasket couldn't be obtained, and new valve covers were needed. I want to believe the garage is being straight with me. Is this really plausible?
2) What could cause the idle to behave this way? I understand what a valve cover does (in my earlier years I changed the cylinder head on my old Saturn) and can't figure out how or why changing the valve covers would have an effect like this.
That leads me to conclude this is more likely caused by the new, slightly different hoses attached to the valve cover, but I don't know exactly what those hoses do or why they connect to the valve covers, so I'm stuck here.
Nissan Maxima :: 1998 - Tapping Noise Developed In Front Driver Side Wheel Area
I have a noise that has developed in the front drivers side(wheel area). When I turn right -- it can only be heard at slow speed, when I start from a stop-- there is a " tapping" type noise that appears to come from the wheel area. Is it possible that I am about to have problems from the CV axle?
View 1 RepliesFord Super Duty (1999-2016) :: 2002 F250 5.4 - Valve Cover Leaking - Gasket Replacement?
I have a 2002 F250 5.4with Air Conditioning. The valve covers are leaking and the gaskets need to be replaced. I am attempting the valve cover gaskets. I was able to get the drivers side cover off with some difficulty. For the passenger side valve cover. There is very little " no" room to get at the bolts. I read somewhere that I may have to drop the engine on that side. I will do that if I have to.
View 5 RepliesNissan - Maxima :: Won't Start But Try To Turn Over Occasionally
my car won't start. It would try to turn over occasionally, The battery checks out. i tried to jump start it bypassing the battery with no results. multimeter reads current though cable going from battery to alternator. what is wrong with my car??
View 2 Replies