Toyota - Avalon :: Radiator Fluid Not Being Going Back Into Engine When It Cools
99 Toyota Avalon, 3.6 L engine, 160k milesThe engine sends radiator fluid to the overflow reservoir but doesn't suck it back into the engine when it cools.My mechanic replaced the radiator, cap, and hoses...no change. So. he put a chemical in the radiator fluid that is supposed to form a plug to stop a leak. After ~5 months of waiting, still no plug...no change. Tomorrow, I'm bring it back to him. If he says it needs a new head gasket, do you agree? If so, what would be a reasonable cost? Also, this timing belt has 68,000 miles on, do you think I should have him replace it, too (since he is doing work on the engine)?Do you think I am foolish to put the cost of repairs into this vehicle? The rest of the vehicle is good. We've had it since 2000 and have kept up with maintenance and services.
View 19 RepliesFord F-150 - 1997-2003 :: 1998 4.6 Triton - Slow Coolant Leak - Head Gasket?
New truck to me. Truck was advertised with a slow coolant leak. Figured I would trace the leak down and get it repaired no issues. Anyway, working on it this evening I take a close look around the oil filler area and notice the dreaded milkshake color.
I drained the oil out of the truck and the oil actually came out nice and black. Is the headgasket the only area that would cause the oil/coolant mixture? Supposedly the truck has never been overheated.
At any rate, on to find articles on how to pull apart a 4.6L Triton head. I'll see if I'm up to this challenge.
Eclipse - Mitsubishi :: 1998 - Motor Oil Going Into Radiator?
I recently noticed my car is leaking its motor oil into the radiator. There is no water in the motor oil and the transmission oil is at it's appropriate level and such.
View 2 RepliesAccent LC (2000-05) :: Coolant Tank Filling But Not Draining Back Into Radiator
Having an issue with my 03' Accent. I'm having an issue of my coolant tank filling up but it is not being drawn back into the radiator when the engine cools down. I have replaced the radiator with a new unit because the filler neck of the original radiator was damaged sometime in the past and the cap would not seal good enough to hold pressure . Looks like heat damage to me but I don't know for sure. The system now holds pressure but now I'm having the current issue. My first thought was a head gasket issue creating pressure in the system and forcing coolant into the tank.
The car has 155k miles and runs good overall and is not overheating. I performed a "block check" test using the chemical method that detects combustion gasses in the cooling system and that test was negative. I also pressure tested the system by pressurizing to 16 psi and was unable to detect any leaks anywhere on the engine / radiator and the pressure did not drop until I released it. I guess the next thing to try will be a compression test to see if I have any low cylinders. So, for whatever reason my cooling system is not creating enough of a vacuum to draw the coolant back into the radiator when it cools down. Does this sound like a head gasket issue? The pic is of the original radiator filler neck damage.
Lexus GS 2006-11 :: GS430 - Coolant From Radiator Blowing Back And Causing Reservoir To Be Overfilled
I have a 2006 Lexus GS430 w/ 100k miles. I've been trying to solve my coolant issue for the longest and I've been doing research like crazy!!! The issue that I'm having is that coolant from the radiator is blowing back into the reservoir causing the reservoir to be overfilled and splattering all over the engine bay. Also, when this happens the fluid in the radiator drops significantly ( I have to keep dumping the lost coolant from the reservoir back into the radiator). Under normal driving the fluid wont blow over to the reservoir that much (just a little) but, when I drive long distances or if I floor it that is when the coolant from the radiator really pushes over into the reservoir. When the car cools, I find out that the coolant from the reservoir does not draw back into the radiator. (I'm guessing due to the air in the cooling system?)
Checklist on what has been done to the car:
- NEW Water Pump (Installed by Lexus)
- NEW Timing Belt (Installed by Lexus)
- NEW Thermostat (Installed by Lexus) (I also tested the thermostat in boiling water and it opened and closed)
- NEW Radiator (Installed by Lexus also was pressure tested and passed)
- NEW Radiator Cap (Genuine Toyota 1.1 bar)
- Coolant Flush (flushed radiator and engine block with water hose)
-Bled System with my Lisle Spill Free Funnel and Heater on MAX HOT Full blast! Heater is working good!
(Did this 3 times for 30 min+ to get rid off all the air bubbles)
- Performed a Block Test to see if any combustion gasses were in the cooling system, to determine if it was a blown/failing head gasket (passed)
I dont know what else to do at this point other then do a compression test and a leak down test. There is no coolant in the oil and no coolant leaks. Car drives solid and strong! Is there a bleeder valve on the GS430 somewhere or does it have a bleeder valve? Is it something I'm doing wrong?
Ford - Fusion :: Thermostat Gets Up To 80% Hot Until Crest The Mountain Then Cools Back Down To Normal
2013 Ford Fusion ... My cars thermostat runs normal all the time unless I go up hill. I drive into the mountains to work every day. It runs about 80% hot until I crest the mountain and then immediately cools back down to normal. Since its winter no air conditioning running but heat is on at times. Only 37000 miles on car. Automatic transmission.....
View 8 RepliesEclipse - Mitsubishi :: 1999 - Engine Heating Up / Radiator Was Low
Our 1999 Mitsubishi Eclipse engine heated up. The Anti Freeze reservoir is full but the radiator was low which caused the car to heat up. Why isthe anti freeze not getting to the radiator? The hose seems clear. We filled the radiator with anti freeze and the seems to be working fine. Why is it not sucking from the reservoir.
View 3 RepliesEclipse - Mitsubishi :: Air Bubbling Into Overflow Tank From Radiator
1998 Mitsubishi Eclipse. 2.0L 5-speed. 195,000. When I complete my 33 mile trip home and shut off engine, I can hear air bubbling into the overflow tank from radiator. Temp gauge shows normal. Just had new water pump, thermostat, radiator flush and refill and new 16 lb radiator cap installed. Overflow tank fills up to near top (not running over) and when engine cools, the tank is back down to half way. I've checked water level in radiator when cool and it is full. Question: Is this normal? Don't think I've ever noticed or heard the bubbling sound before. The engine runs great and smoothly.
View 5 RepliesMitsubishi - Eclipse :: Overheating - Steam / Smoke Coming From Radiator Cap
My car was starting to over heat and I wasn't getting any heat thru the vents. Thermostat was replaced and so was the radiator cap. The coolant reservoir is still topped off, and doesn't seem to be getting sucked thru to the radiator. If I pour coolant directly into the radiator, car temp stays even, and heat eventually does come thru vents, better while driving. But, I still get steam/smoke coming from radiator cap. I cannot be buying and pouring coolant into the radiator everyday. I have a 99 Mitsubishi Eclipse with approx 140xxx miles...
View 19 RepliesMitsubishi - Outlander :: 2003 - Radiator Fan Super Loud And Won't Shut Off
I have a 2003 Mitsubishi Outlander. About two months ago, I replaced (myself) the radiator fan because it had stopped working. I bought the new fan on the internet and it was fairly easy to install. It was a little louder than the original fan, but it worked great. Last week it suddenly became louder and stays on for a minute after I turn the car off. Is the fan defective? Should I return it? Should I ask my mechanic to test it? Or just ignore it?
View 6 RepliesMitsubishi - Carisma :: 1998 - Engine Hesitation When Cold
My 98 Mitsubishi Carisma (similar to a Lancer) has a problem when engine cold, the engine seems to hesitate and sputter, and if I try to put it in gear it will only go very slowly. Once the engine is warmed up enough the problem goes away, whats causing this? Its an old car and I don't want to spend a lot to repair it.
View 2 RepliesEclipse - Mitsubishi :: 1998 - Head Gasket Blew Out?
I have a 98 Eclipse (non-turbo) with 221,000 miles. Head gasket blew out on me this morning. Lost water, but stopped before temp went too high. Bought water to put in to make it to work.
Question: What are your opinions on the "Quick Fix" head gasket repair liquids I see advertized? Two that come to mind are Blue Devil and Steel Seal. I am cash strapped and several hundred dollars are not in my future.
Prius (2010-12) :: 2011 - Rear Seat Vent Should Blow Air Out Or Suck Air Into It?
I sat in the back of my recently purchased 2011 Prius Three, not III, for the first time yesterday. I learned from this forum that the vent in the rear seat is to keep the hybrid battery cooled. However, while sitting the back during a ride, I noticed it was blowing air out instead of sucking air. I would think the vent should be sucking air from the cabin to keep it cool, but that does not seem to be the case here. After a 30 minute drive, I even felt the air coming out of it was warm and the A/C began to feel that it was not enough for my area in the back of the car.
View 16 RepliesCoolant - Mitsubishi - Galant :: 2003 - Smelling Something Sweet When Cold Air Is Put On
When I put on the cold air in my 2003 Mitsubishi Galant, after it's on for a while, I start smelling something sweet like syrup. I haven't noticed it when the air's not on and I don't know how long it's been happening because my sister's been using my car since 2008. It seems to be coming from the front, but I'm not really sure. what this is (is it coolant?), is it dangerous, and how much it should be to fix?
View 5 RepliesEclipse - Mitsubishi :: 1998 - After Driving A Bit Get Hard Bucks Then Eventually Stalls
Description: after 20-30 minutes (or miles) of driving I will begin to get hard bucks (misfires beyond one cylinder) and eventually stall. The car will typically turn right back over - but stall after only a minute or so. If I leave the car off for around 15 minutes it will run fine for a while and then stall out again.
It sounds as if the car is running out of fuel which it is not. The pump remains primed and the pressure is normal.
What I've done so far:
Fuel pump has been swapped
Fuel filter has been replaced
Fuel lines have been verified (even cleaned to rail - injector heads and intake manifold... It's been a fun weekend)
Fuel pump relay has been replaced
I have also recently replaced the ignition coil due to an unrelated issue for which I will provide detail so that you too can rule this out. I had random multiple misfires in bank 3 - replaced the coil and the misfires were gone. When the problem came back I was suspect of the new coil and originally believed that this had failed at temp. This coil has been tested hot and cold and passed each way. I also swapped out for the coil with the issue on bank 3 just to verify.
I have read in a few forums which point towards either the ASD relay (which I was also suspect of early in the process of elimination) itself failing when heated or the camshaft position sensor and or the crankshaft position sensor causing the relay to trip when they are heated.
Mitsubishi - Galant :: 1998 - Delay In Transmission Development - Won't Engage In Reverse
I have a 1998 Mitsubishi Galant, 4cyl., 165, 000 miles. Without previous symptoms, one day the transmission developed a delay of 5 to 30-seconds before it would engage in reverse. The fluid was clean and I have been using the Mitsubishi brand that they recommend. So I replaced the original transmission with a used one. But the reverse delay continued, even with a different transmission. So I removed the used transmission and rebuilt the original one. The problem STILL remained. Since then, the valve body has been replaced and the speed sensor has been replaced. I cannot figure out why there is a delay when putting it into reverse. I ran out of solutions. I did notice one day that when I first start the car, and the engine is at 1000 RPM's or more, the reverse wouldn't engage. Then, as the RPM's dropped to about 200 RPM's, the reverse would engage. I thought maybe this would be a clue.
View 10 RepliesMitsubishi - Montero :: 1998 - Frame Rust Damage - Unsafe To Drive?
Have a 1998 Mitsubishi Montero.
Best car I've ever owned. 184K miles, never once failed to start.
I was crushed to discover this spot of frame cancer on the driverside rear portion of the frame behind the rear wheel (attached images) .
Is this terminal?
Is it safe to drive and therefore potentially crash this vehicle?
Before the ground froze I dug a 10x18x10 foot deep hole in the backyard....
Toyota - Coolant - Camry :: 1998 - Installed Small Filter Now Engine Burns Too Much Coolant?
I took my relatively well maintained '98 Camry to Texaco Xpress Lube and they changed my oil and air filter. I then embarked on a 400mile trip to Miami. The next morning when I went to start the car, I fogged the entire neighborhood with a thick low-lying white vapor/smoke. It was ridiculous. So, I opened the hood and noticed my coolant reservoir was nearly empty and my oil dipstick was bone dry. Thinking this was awfully strange, I went to inspect the air filter and noticed that they installed a filter that was short by about 1.5" in one dimension and I could see sand, leaves, and twigs in the bottom of the air box. The shop basically put a square filter in a rectangular air box. After some preliminary research, I've concluded that my engine is now completely ruined because of this. From what I gather, the sand in the airbox enterred the combustion chamber and proceeded to grind the internal components to smithereens. Is this a reasonable conclusion considering my engine has never had these problems before. Also, how would I even start to get some rectification?
View 19 RepliesMitsubishi - Sport :: 1998 - Rear Door Unlocked And Can Press Handle But Will Not Open
The rear door of my 1998 Sport will not open. It is unlocked and I can press the handle but the door will not open. I have been able to partially pull back the inside panel (not easy because the bottom of the panel is attached to the closed door) and it I can see the lock/unlock works okay and pressing the outside level works the rod to the latch connecting the door to the car body. But I cannot see where to pull the latch open and cannot locate any diagrams on the internet. I have sprayed some lubricant inside,, no effect. My thought is that if I can get the door open and remove the inside panel the repair may not be to complicated.
View 10 Replies