Mitsubishi - Mirage :: 1991 Won't Start After Being Warmed Up
This car has the 1.5 liter 12 valve motor and a five speed transmission. Ran pretty good until a few days ago when it died. the next day it started up and ran ok for about a half a block and then I had to pump the gas to keep it running. I had bought gas at a dinky budget station that I had never been to before so I suspected bad gas and I put in a new fuel filter which did not work. I then put some Seafoam additive in. After I got it started I revved it up a bit to try and clear things out and then let it idle for an hour or so.
The engine smoothed right out and didn't idle rough but did not start after I turned it off. I pulled a plug wire, put in a bolt and tested for spark against the valve cover. Not even a weak spark, nothing. I looked for the coil but there is no coil and I am told that the coil is in the distributor. I also saw a reference online about the crankshaft sensor possibly being the culprit. What a crankshaft sensor looks like and the engine compartment is so crowded with hoses, wires and all kinds of things it is real hard to see anything from above.
I am wondering if the coil is bad do you have to get a whole distributor ( I was quoted a price of $269 for a new one) or can you take it out of the distributor and replace just the coil.I have a brand new 154 piece Craftsman tool kit, but I am 62 years old and back when I learned how to work on cars it was a lot simpler. Now when I open a hood about half the stuff there is unfamiliar to me. My other vehicle (Chevy C20 van) is not running that great and gets awful gas mileage. The battery is new and I have never ran out of gas with this car, so they are not suspect.
Mitsubishi - Mirage :: 1991 Will Not Start Again After Warming Up
91 Mirage starts and runs ok but usually will not start again after warming up. What are the possible causes and how do I check to eliminate dead end cures.
View 3 RepliesMitsubishi - Mirage :: Hesitation Accompanied By CEL Coming On And Then Going Out
Got a 1997 Mitsubishi Mirage with this code 0420. Only had car a while. It has always had a hesitation accompanied by the CEL coming on and then going out. Might happen twice a trip and then not occur for weeks. Previous owner said they failed an emissions because he cleared a set code(not told to me). The car dives fine and gas mileage seems to be fine. Car does use about a quart of oil over a 3000 mile oil change. It also has/had a rattle similar to an exhaust baffle...the rattle is not an every trip occurrence either.
Had Autozone check for code and was told catalytic converter needed to be replaced. There are no emissions in my state but I would like to know any opinions on my problem and any issues with driving car without repair. I think I want to clear code by disconnecting battery cable and see if it returns but not that would be a good idea. Also considered buying a scan tool with live data to see if there is another issue that might not involve replacing the catalytic converter. Previous owner also mentioned a hissing when removing gas cap and he bought another cap but the I still notice the hissing.
Mitsubishi - Mirage :: No Longer Stays In 2nd Gear
My 2000 Mirage (with 145,000 miles) no longer stays in 2nd gear. Due to the age of the car I do not want to replace the transmission but I would like to get a few more months out of the car. For now I am just shifting from 1st to 3rd. My questions are;
(1) Is there anything I can do short or replacing the transmission to get 2nd gear back,
(2) if I don't do anything to fix the transmission is there any reason I should not continue skipping 2nd gear until something else breaks and
(3) is there anything I should do like flush the transmission to try to extend its life?
Mitsubishi - Mirage :: 1990 - Rough Idle Only In Gear
I can not resolve a rough idle in gear when engine is warm problem. I've replaced plugs, wires, mounts, isc, o2 sensor, ecu, have no codes.
View 17 RepliesMitsubishi - Mirage :: Front Wheels Have Popping Sound?
I'm sure this popping sound coming from both sides of the front wheels is a serious problem because it happened to my dad's car before. The only thing is that i want to fix it before it gets serious and pops off one day while I'm driving.When ever i turn, about 95% if not 100% of the time, i would hear the popping sound from one side of the front wheel. I want to know how much it usually takes to fix and if its possible for me to fix it myself with almost no knowledge of fixing cars.
View 8 RepliesIgnition - Mitsubishi - Mirage - Sparkplugs :: Cranks Over But Will Not Start
Details. I was driving my car yesterday. It stop as i gave it fuel to go around a corner.Its a 95 mitsubishi mirage s manufacture october 94 in japan. Its a manual turned the key. Nothing but cranking and flooding. My friend came to take a look at it. no spark.I smelled fuel and have still almost half a tank which mean its pumping but no spark came from the ignition wire.I have replaced the rotor and am waiting on new ignition wires and distro cap. When i took off the distro cap I didn't see any visible cracks.
View 9 RepliesMitsubishi - Mirage :: 2015 - Got Code P0068 Suddenly - Stalling - Now All Seems Well?
My 2015 Mitsubishi Mirage had a strange little incident the other day. I have posted this on the forum for these cars and as far as the people on that site know, I am the first to experience this exact issue. I also called the Mitsubishi dealer and they said this would be under warranty if it happened again. They said they had never experienced an issue like this in the Mirage either. Whatever this is isn't a common problem which is good and bad.
I was pulling out into traffic and then there was a sudden momentary loss of power and then power returned. The check engine and traction control light were on. I pulled into another parking lot and when I came out, the check engine light was on but the traction light was off. I put the car in reverse to backup and it stalled. There was an Autozone across the street so I took it over there and had the code read. The P0068 appears to be a mismatch in input from the MAF, MAP, or TPS sensors.
I was low on gas but not that low so I went across the street to a gas station. While the car was filling up opened the hood and unplugged/replugged any wiring connectors going to sensors around the intake and manifold, wondering if it was a bad connection. The car took about 7.5 gallon of gas. These hold like 9.2 gallons or something.
I got in and started the car and there was no more check engine light. I hadn't cleared the code so that wasn't why. Anyway, I have been driving the car like normal the past 3 days with no repeats of the behavior.
I figure that a connector might have been loose from the factory or after the repairs from when I hit a deer a few months back. The car sustained front end and side damage so maybe something wasn't plugged in snug enough after the work.
I guess I could have had a bad tank of gas and was starting to suck moisture or something. I would have thought that would have triggered a misfire or something so my guess leans to a loose connection. The CEL went away immediately when I started the car. The new tank of gas would have at least taken several seconds to have any impact.
Mitsubishi - Mirage :: 1997 - Grinding Sound When Transmission Shifts Under Load
I'm writing to ask a question about my 1997 Mitsubishi Mirage. It has 98,000 miles on it. I had my transmission fluid changed at my regular shop about six months (2,000 miles) ago.
For the past six to eight weeks, I have noticed that a light grinding sound comes from the bottom of the engine compartment. This sound happens briefly, for about 0.5 to 1.0 seconds, when the transmission shifts from first to second. I can try to find previous maintenance records if it's relevant.
My question is, is it worth it to change the transmission fluid again? Is it possible that will take care of this? Are there any homeopathic cures?
I will note that the owner's manual calls for "Mitsubishi Diamond ATF SP-II." The shop didn't have it, so I recommended a Valvoline ATF designed for imports, based on some searching?
So a second question is, would it be worth it to take this to the Mitsubishi dealer to get the official fluid?
Mitsubishi - Mirage :: 1997 - Automatic Transmission / Cranky Transition In Low Gears
I just bought a used automatic MM with 137k miles. Engine and interior super clean. I did test drive and it seemed to pull back a bit and rev harder when I was starting out from a stop or in intermittent traffic where I was slowing down and speeding up with flow of traffic. It also does it worse on hills. The guy from the car lot said it was the way I was driving the car...hmmmm...I'm not a lead foot. I let the car ease into higher speeds, I don't punch it. Ever.
Yesterday I took a longer drive and had other people in the car with me who also noticed the rough transitions between low gears and asked if that was "normal." NOT being a car mechanic I get alarmed when others are pointing something I too thought could be at issue. I bought the car "as is" after doing some online research and finding out that these car's even at this age get 4.5 to 5 star ratings from people who have them.
I took it to Auto Zone and they put the little code reader on the car but no codes came up. His suggestion was to have all the fluids changed in case someone put the wrong weight of transmission fluid in the car. I did check the fluid at the car lot and it was bright pink and at correct levels. Not sure that's what it is. He also suggested the possibility of it being a "shift cellinoid"?
I don't know what that is but he said it shouldn't be expensive to fix. He also suggested getting the transmission serviced to see if that might solve it. Someone else suggested "clean the IAC hole and throttle plate with choke cleaner..." don't know what that is? Someone else said to consider a vacuum leak in the fresh air tube between the air filter box and the throttle body...these are all just guesses.
Santa FE SM (2001-06) :: 2002 - Brake Pedal Has Bad Judder On It When Braking
I have a santa fe 2002 diesel the abs lights stop on all the time the brake pedal has a bad judder on it when braking. I have taken the fuses out and it will still judder. The only thing that is when i disconnect each sensor the red brake light stops on but not with the osf front sensor. All the rings look ok but when i had a problem with 1 of them the abs light would go out then return on...
View 1 RepliesSanta FE SM (2001-06) :: Brake Noise At Lower Speeds And Judder
Occasionally, when braking at lower speeds (i.e. coming to junction) I get feedback through the pedal almost as if the ABS has kicked in....braking is not very effective when it happens. I can also hear a pump type noise going. If I lift my foot and re-apply it clears and normal braking returns. In fact, sometimes I can hear the pump noise going even before I brake....always at low speed (sub 15-20 mph) doesn't happen when driving at higher speeds.
View 17 RepliesMitsubishi - Mirage :: 1998 - CEL Codes For Fuel Trim Bank / Oxygen Sensor Bank 1 Sensor 2 And Cylinder 1 Misfire
I own a 1998 Mitsubishi Mirage with about 190,000 miles on it. The engine light has started coming on and I get three codes:
P0170 Fuel Trim Bank 1P0136 Oxygen Sensor Bank 1 Sensor 2P0301 Cylinder 1 misfire
Read more: [URL] ....
Golf VI R :: Slight Shimmy At Higher Speeds
Just hit a fantastic Minnesota pot hole. Have a slight shimmy now at higher speeds, feels like its from the rear. Don't see any obvious dents in the rim, what else could I have bent back there? I'm wondering if this is psychosomatic and our roads just suck right now or if I really damaged something.
View 6 RepliesPrius (2010-12) :: Shimmy At Highway Speeds?
Having trouble with a shimmy at 65-75mph .....
View 19 RepliesSanta Fe (CM - 2007-12) :: Front Steering Wheel Shimmy On Heavy Braking
2007 SF SE 3.3, approaching 60,000 miles. I'm feeling a front steering wheel shimmy on "heavy" braking, as in a recent trip into the Adirondack mountains with twisty roads.
View 5 RepliesPassat (B5) :: Tires Rotated - Traction Light Goes Off - Shimmy In The Brake Pedal Under Braking
I just got my car back from discount tire. Every time I accelerate above about 45 mph the traction light goes off Also, There is a shimmy in the brake pedal under braking.
NOW: there is ONE tire that is SMALLER than the rest that they put on or something. It is a different tire, same company, but obviously a bit smaller. Now, they told me it would be fine, despite my better judgement that It would preform weird as well as look slightly gimp. the tire went from driver rear to passenger front, and I'm willing to bet that is the cause of both problems. What should I do?
Touareg :: Assorted Rattle And Persistent Shimmy In The Wheel At Certain Speeds
I got my Egg on 8/5/03. I have almost 10,000 miles on it, and other than an assorted rattle and a persistent shimmy in the wheel at certain speeds, despite rebalancing and rotation at 7,000 miles, I love it. It's quick, handles very well, and rides great. It's a topic of conversation everywhere, and while this is a matter of opinion and as I value mine I'll give it to y'all, it is one of the best looking SUVs made.
View 10 RepliesToyota :: Intermittent Shimmy In Steering Wheel At Highway Speeds
2010 FJ Cruiser has an intermittent shimmy that you can feel in the steering wheel at highway speeds. Noticed it not long after new tires. Go around a long curve and it starts, then stays until you go around another curve and then stops. It is as if the wheels have to align a certain way for some harmonic effect. I had the tires rebalanced and rotated. My mechanic said they balanced up very well. Shimmy is better but not gone. Wierdest thing is that when it happens, if I keep my foot on the gas and gently press the brake the shimmy stops and the returns as soon as I let up on the brake. When I asked my mechanic if it could be 2 slightly warped rotors he said the shimmy would be worse braking not better.
View 4 Replies