Lexus SC430 :: Speed Needle Doesn't Work In Speedometer
In my current speedometer the speed needle doesn't work i did everything and changed all sensors and checked all related issues and all is fine turned out the issue was with the speed gauge it self. So i bought my self a used speedometer.
Now my question is, how to dismantle the speedometer cause I want to take out the speed gauge from my old one a replace it with the new one i know its much easy to change the whole thing but I don't want to play with the mileage I have on my car.
Tiguan :: 2009 - Little Yellow Symbol Just To The Left Of Tachometer Needle
There is a little yellow symbol just to the left of the tachometer needle that looks like a guy sleeping in a bed. I don't have the owners manual handy to check it. What this is?
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Tachometer Needle Will Not Always Move The Way It Supposed To
Just had a question about my 00 F250 7.3. I recently have noticed that my tachometer needle will not always move the way its supposed to. Sometimes it will sit at zero until I drive it for a min then all of a sudden pops up to where its supposed to be. I also noticed today that while i was driving it just dropped to zero for a second or two then back up to where it was supposed to be again.
When it does this there is no drivability issues with it or idle issues what so ever. Which is strange to me and I cannot seem to put my finger on what could be causing the issue. As I have searched online for a while to no avail as most of the other issues include drivability and idle issues. Also not that it matters but I have recently replace the cps sensor with a new one OEM of course but i don't think that has anything to do with this problem.
Lexus SC430 :: AC Started Blowing Hot Air
A few months my AC starting blowing hot air. When I was at the dealer, they claimed the compressor was bad and wanted over a 1000 to replace. I looked online when I was there and said the new denso compressor was about 300 online. They wanted double. I just left and didn't worry about it since it was about winter then. Now I need to get it fixed.
A guy noticed the other day when I cut the AC button on, the clutch engaged and cut back off. He didn't have time to fully check it that day and wants me to bring back if I can another day.
I did some searching on this board, but haven't seen compressor issues with the SC430. I have a 94 ES300 and a 2004 RX330 and neither have had compressor issues. So I am shocked at this anyway.
I bought a relay, but that did not work. I just read on the LS forum that a lot of people have had problems with the AC pressure switch.
I understand that switch could prevent the compressor from coming on when the switch goes bad. Do we have that switch on the 06 SC430? If so, where is it? I can't find a part number listed in All data. I would love to check it before spending a ton of money on compressor replacement.
By the way, I have plenty of refrigerant. They checked that at the dealer and added some then. And I did AC diagnostics and show no codes.
Lexus SC430 :: Car Started To Stink Especially When Its Humid Outside
Since summer is coming up I decided to change my cabin air filter because the car started to stink especially when its humid outside. I was not so surprise on the condition of the filter!!!
View 14 RepliesLexus SC430 :: Heater Fan Started To Switch On And Off By Itself
My 2002 SC430 didn't start this evening.
The engine turns over as normal, I can smell the unburnt fuel out the exhaust. I can hear the fuel pump working etc. It gives a slight cough upon first turn of the key but will not come near firing up properly. The engine turns over at speed from the starter but without any further signs of ignition.
The car's key is unlocking the car with the remote on the key as normal so I don't think it's an immobiliser issue. The battery is fully charged and turned the engine over for about 5 minutes in total during the hour I tried to start her in so there is no battery voltage problem.
A strong side issue is that the heater fan started to switch on and off by itself yesterday, and this morning stopped altogether on the drive home. Another thing is that the heater fan briefly turns for one tenth of a second of so when switching the car off, even when selected to off on the climate control screen.
I disconnected the battery, pulled out the ECU to check for visible problems on the connectors like corrosion, damp etc but found none. The earth straps in the engine area all seem good, all fuses seem good too. I've pulled and re-installed all the visible engine bay fuses, but nothing improved. No big fuses are blown that I can see. The cars remains a non-starter and the heater fan still won't operate as normal.
Lastly, the boot / trunk area seems to be quite damp so I let it open for a while to dry out tonight.
Acura - Integra - Hesitation :: 1992 - Tachometer Started Bouncing Up And Down
My '92 Integra has ~280K miles. A couple of years ago the tachometer started "bouncing" up and down while the engine seemed to run fine. Some time after, it started to hesitate under acceleration. A few months ago the car died while driving along the highway. The tachometer went up and down as the engine cut off and came back on before finally dying. A tow to the repair shop lead to a tune up, changing of spark plugs, wires, distributor cap and the ignition coil. That got the car running again, with its usual erratic tach and hesitation on acceleration. Then, the car died again in a similar way while driving. I was found to have a dead battery. Replacing it got the car running again...but the tach is still erratic and the car still hesitates. I am concerned that there is still some underlying issue that has not been fixed. I sometimes think it is a loose connection because there are times when the car seems just fine, but that is happening less frequently.
View 3 RepliesNissan - Quest :: Tachometer Started Jumping A Little And Engine Rough Then Died
On my way home late at night, my tachometer started jumping a little, and the engine was rough. Then after another minute the lights dimmed and the engine died. It wouldn't start again. The next morning, it started right up, and it seemed fine. Drove it to the mechanic, he took it for a drive on the freeway, then after he got off the freeway it died again and had to be towed. The error code on the computer is P0326- Knock Sensor. I had the same sensor activated a couple of years ago, and my awesome mechanic (we have since moved far away, so I don't have access to the same guy) gave the engine a tune-up and replace the spark plugs and everything was fine (well, for two years). The car has been idling rough, and the intake manifold may be warped. Could the intake manifold cause this? Distributor?
View 3 RepliesMazda - Mazda6 :: Clutch Started Sticking Right Where It Would Engage Into Gear
I have a 2006 Mazda 6 with 104k on it. The clutch started sticking a couple weeks ago right where it would engage into gear, and I'd have to use my foot to pop it back up. It only happened here and there until finally, it stuck to the floor and became very difficult, if not impossible, to get out of gear. So everywhere I looked, it seemed that the slave cylinder was the culprit. I got a new one at AutoZone, replaced it yesterday, and the car ran great last night and this morning.
Then, this afternoon, in one 10 mile trip, it went back to the original problem. Stuck with every gear change, then stuck to the floor after I pushed it in and darn near wouldn't come out of gear. What in the world could be the problem?
Ford Excursion :: Needle Started To Stumble / Flicker When Boost Gauge Reached At 15 PSI?
So driving over the pass last weekend, I noticed as I reached about 15 psi on my boost gauge the needle started to stumble/flicker and I could audibly hear a "pffsssfftst" at that same time, back down away from 15lbs boost and the noise goes away? I am leaning towards a boost leak, it sounded like it was coming from the driver side anyways. I hate to just assume it is something, and mindlessly throw parts at it, on the other hand I know that is one way to start replacing old worn out parts.... So I am thinking start at ordering some new CAC boots from riffraff, anything else I could consider? Could be a worn out spring on the wastgate?
View 14 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Brake Started Sticking?
I have a 2002 Ford F250 Superduty with a 7.3 diesel. Brakes started sticking on it. I replaced all the calipers cause the boots were starting to crack but not leaking. All four brakes are still sticking. I can drive a little ways and then the brake peddle feels funny and they start dragging all four. I can loosen the bleeder and brake fluid will spray out and release the brakes for awhile.
View 4 RepliesFord Super Duty (1999-2016) :: Takes Longer To Start And Needle Doesn't Move Until After Motor Started
It used to be, if I remember correctly, that while turning the key on a cold start the oil pressure gauge needle would show pressure prior to the engine starting, now it takes longer to start and the needle doesn't move until after the motor has started. I had the O-ring kit replaced due to oil leakage, and I wonder if there is an issue with the system. N to watch as they deedo their cold start today...
View 4 RepliesFord 6.7L Power Stroke Diesel :: F350 - Rear Parking Brake Sticking / Wheel Started Smoking Severely?
A few weeks back my rear drivers side wheel started smoking severely...when I stopped you could smell the brake material, feel the heat coming from the wheel, and lots of smoke. I speculated it was the parking brake that got hung up. I jiggled that cable around and then went around the block - no issue. Note: I did not leave the parking brake on.
It happened again a week later, but not as bad. I took it into the dealer today. They said heat was evident as it burned off a sticker on the disk or caliper hsg area. They have not determined yet if it is parking brake or caliper?
Lexus IS 2014+ :: Can't Find Digital Tachometer To Customize
I have a 2014 Lexus IS 350 .
I was wondering where the digital tachometer is, could I customize it to just stay in one spot and to stop going back everyone I turn the car off? I would like for it to stay on source with the artist and song information. Is it possible to do this or am I just stuck?
Lexus IS 2014+ :: Tachometer Automatically Slides Back When Turn Off The Engine
I would like to tachometer to slide to the right by default so I can see the extra menus and pop up displays. Every time I start my engine, I need to press the menu button on the steering to slide the tachometer to the right and when I turn off the engine, it automatically slides back to the middle. How can I keep it set to slide to the right by default?
View 1 RepliesLexus GS 2006-11 :: Speedometer Needle Won't Pass 40 Mph
My 2007 gs350 is acting up lately, I was on freeway doing around 70mph but speed needle only pointed at 40mph on the gauge. Could it be speed sensor?
View 9 RepliesLexus GX 2004-09 :: Gas Needle Dropped To 1 / 2 Of Tank After 60 Miles
I have GX470 2007 (100k miles) and last weekend I noticed that I drove 60 miles (on streets) and gas needle was down to 1/2 of tank. When I went to gas station to fill up, I was able to get only 5 gallons and tank was full. I drove another 45 miles (on the highway), and needle already was down to 3/4 of tank. I did not have this in the past. I was getting 12-14 miles / gallon on the street and 20 - 21 miles / gallon on the high way.
View 6 RepliesLexus GX 2004-09 :: Right Front Caliper Is Sticking
I heard a grinding noise coming from the right front tire last night. Came home, removed the wheel / tire and noticed the caliper was stuck pushing the pads against the rotor. I pushed the caliper pistons back in so they're not frozen, just sticking.
View 14 RepliesLexus GX 2010+ :: Brakes Sticking To Rotors After Wash
Having issues with the brakes locking to the rotors after washing the vehicle? I washed it on Saturday afternoon, pulled it back into the garage and it sat there until Monday morning.
I back the vehicle into the garage, always. I started it up, put it in D and usually it will want to lurch forward if I don't hold the brakes firmly. Not today. I could not get the thing to budge. I sat there for a few seconds to make sure the parking brake was not on. It was not, as I never use that. My garage floor is the slippery concrete, plus with the tire shine that I applied, the wheels were just spinning.
After I managed to get the vehicle halfway out, I put it in reverse...that worked no problem. I put it back in drive and had no issues after that. Do I need to have the vehicle looked at? It only has 5,400 miles, and it was just in last week for the 5K mile service.