Camry :: 2004 V6 XLE Power Steering Pump Making Whir Noise
I finally have a first 'major' problem with my Camry 2004 V6 XLE right at 75K ish.
The last two days I've been hearing my power steering pumping making that familiar 'whirrrrr' noise. I thought it was just the pump going out because it has always made some noise when it was cold. Lo and behold, I checked my fluid today and found it was completely dry. I knew it wasn't a good thing because when fluids are dry, they must go someplace. Either way, I got a gal of Dextron ATF in the trunk now.
I filled it up and all was good, so I started to look around for obvious leaks. I did find a hose going to a metal line that DID seem to be dripping, but I wanted to see if maybe others had the same problem and found it was to be a different thing leaking/running down or if this is a common issue.
Not sure if the hose is a dealer only thing. It does look like it's leaking from the end. I could get one of those screw tightening clamps to see if the clamps isn't putting enough 'squeeze' on it. I couldn't see a tear on the hole, but I'm assuming it's a high pressure hole, so it won't leak unless I'm doing a lock to lock turn.
Lexus ES 2013+ :: ES350 Steering Wheel Making Noise At Full Lock - Change Fluid?
Where the power steering reservoir is located on an ES 350 (2013)? I am looking to change the fluid out since my steering wheel is making some noise at full lock. I have been looking under the hood for 2 days now and cannot seem to locate it. I have located the brake fluid reservoir which was flushed out today...night and day difference in braking btw. Now this power steering is bugging me but i cant locate the reservoir.
View 8 RepliesAccent LC (2000-05) :: Power Steering Pump Making Lots Of Noise
My car is a 2002 Accent. So last weekend I replaced my timing belt and my 3 other belts. Before I did this the belts were not squeaking and I was not having any issues with my power steering. I started my car up and the power steering pump was making lots of noise, the power steering reservoir was still full. I was told it's probably the power steering pump and that I would need a new one. So I got a new one, put it on and still the same thing. I looked online and saw that it may be an air bubble in the line so I removed the cap on the reservoir and, with the car turned off and the front wheels off the ground, cranked the wheels lock to lock about 20 times. I started the car and it still makes noise. This morning the power steering felt like it was lagging as I was backing out of my driveway and the squeaking happens when I am idling and gets louder and worse up to about 2000 rpm then stops, which it has been doing since I replaced the belts. I am not sure what else to do, did I mess up the new pump by driving and not bleeding the air out?
View 2 RepliesFord 6.7L Power Stroke Diesel :: Fuel Filter / Pump Started Squealing And Making Vibrating Noise
Well, I last summer my fuel filter/ pump started squealing, and making vibrating noise, replaced the fuel filter changed the noise slightly, some times it would go away, sometimes the line going to the filter under the hood would vibrate, couple weeks ago truck warning light came on- "low fuel pressure warning" came on, hum... went out, came on a couple days later, then finally put me into limp mode, luckly only 1/2 mile from home... checked filter on frame/ tightness, it was tight, the pump on the filter housing was very noisey still, well, I figured 200 dollars cheaper than taking to ford....
I waited and pump arrived 3 days later, replaced it and low pressure warning still on, but pump was very quiet, and when I restarted low pressure warning and reduced power came on in driveway, hum.... I thought code was still in computer, I disconnected battery and turned headlights on to try and kill the code, started it and now the engine light came on, nothing else, and truck ran fine....hum.... went to autozone, and they pulled the code, low fuel rail pressure, p0087, guy said to drive and code should go off, truck runs fine. Drove truck a couple days and engine light went off, Truck runs great.......All is good.
Lexus SC430 :: Rubber O-ring On Power Steering Pump Solenoid Valve Leaking Fluid
My car is in the shop and has a leak at the Power Steering Pump. The rubber O-ring on the Power Steering Pump Solenoid Valve (p/n 4417030120) is leaking fluid. The Solenoid Valve is ok, just the Rubber O-ring is bad, but it looks like you have to buy a complete new Solenoid Valve to get the O-ring (a lotta bucks).
I did find a Lexus Power Steering Pump rebuild kit online at, but I can't see if it includes the solenoid valve o-ring or not. Have to replace their solenoid valve o-ring?
Elantra MD (2010-15) :: 2012 - Power Steering Pump Making Whining Noise That Changed With Engine Speed
So I have a 2012 Elantra Limited. From what I understand the power steering is no hydraulics and is only electric assist. So I have a strange problem. I can remember in previous cars when a power steering pump was going bad it made a whining type noise that changed with engine speed. My Elantra is making the same type of noise. I'm trying to track this down. My car doesn't have any other symptoms aside from the noise. It's hard to really tell but it does appear to be coming from the belt side of the motor (passenger side).
View 14 RepliesFord F-150 (2004-2008) :: Power Steering Pump Started To Whine Really Loud
i have an 04 f-150 with a 5.4 motor. about 2000 miles ago the power steering pump started to whine really loud. I sucked out the power steering fluid and started it up and the fluid that back into the tank looked like it was gritty and rusty. I replaced it out a few times and no change. I then did the job of replacing the power steering pump which was about a 5 hour job.
It was quiet for about 5 miles and the new one started whining. Every week I have been sucking out the old fluid and replacing it and it still seems to be gritty. What could I do to quiet it down? the steering works perfect btw. I am looking at selling this truck and buying an 09 or newer ford and want to quiet it down before selling it. The truck has 88,000 miles on it and i am the original owner.
Lexus GX 2004-09 :: Mirror Started Making A Clicking Noise
So I was driving my wife to dinner the other night, it was about 30* F out and the mirror started making a clicking noise (of course, I had no clue it was the mirror until I stopped and looked around). Sure enough, the mirror was clicking and the display was going back and forth between the "188" (the start-up display) and "NW" or "W" or whatever direction we were traveling in.
Obviously the clicking noise is a relay.
Lexus GX 2004-09 :: 2005 - Started Making Clunking Noise?
'05 Gx470 w/ 93k mi. Time for new parts for all orig. frt. suspension? Started having "Clunking" up frt. Assume time for new shocks all around. Also, grease from upper ball joints half-way down steering knuckle arm, so probably dry? Thinking of replacing everything up frt. incl. hub bearings while have all apart and be done w/ it. Notice in FSM that this means replacing both upper and lower control arms that come w/ bushings and ball joints installed. Parts very pricey even w/ discounts ( 27% at myLparts), somewhere around $3,500 +/-, incl. rr. shocks. Rather cry once and hopefully get get another 90K +/- mi. w/o problems. I've always gone w/ OEM parts in past and probably paid the price, but since I'm doing all the work, hopefully evens out in long run.
View 1 RepliesCamry :: 2002 Steering Making Noise After PS Fluid Flush?
I have a 2002 camry and I flushed my power steering fluid today using the following procedure:
- emptied the reservoir
- connected return hose to a bucket
- added new fluid (ATF dexron III - from toyota dealer)
- jacked front wheels
- turned steering wheel side to side till new fluid came out of return line (my reservoir did get empty couple times in the process so air may have went in)
- lowered the vehicle
- reconnected the return line to reservoir
- ran the engine and turned side to side couple times (did not see bubbling and fluid level did not drop)
I took the car for test drive and noticed that my steering wheel was still making noise when turning. Also, when i was turning the wheel side to side with hood open, I noticed a change in the sound. There was a sticking sensation and steam pressure release noise when I locked the wheel on either side.What could be the problem?
Lexus RX 2004-09 :: Power Steering Fluid Leak Under Carriage Of Car And Garage Floor
Yesterday the power steering exploded on our 2008 Lexus RX 350 spewing power steering fluid all over the under carriage of the car and the garage floor. Left a trail every where we went. The loss of fluid caused the power steering to quit working. I had no prior signs of any leaks of any kind and no noise or symptoms from the steering prior to this. Had this happened on the highway at speed, I don't know what could have happened.
Loss of steering and the catalytic converters covered in oil could have resulted in a fire and or wreck. I see on line that power steering leaks seem to be a problem with many Lexus models. I have heard that a screen/filter in the power steering solenoid can clog causing the pressure in the system to go sky high blowing the rack seals. Some have said that by cleaning the filter and flushing the system that the problem can be solved without having to replace the rack and pinion.
Lexus RX 2004-09 :: Remove Engine Cover For Access To Power Steering Fluid Reservoir?
I am trying to remove the engine cover on the passenger side of the engine bay so that I can access the power steering fluid reservoir. What is the procedure for removing the plastic clips, rivets or whatever they are and also how do you reinstall them? This is a hair brained design if I ever saw one!
View 14 RepliesLexus GX 2004-09 :: Power Steering Fluid Level Low - Slight Whine When Turn The Wheel
I started to notice a slight whine when I turn the wheel. My fluid is at low but it's pretty dark and I'm not sure if it was ever changed or when. I have 100k miles. What fluid should I use?
View 10 RepliesFord 6.0L Power Stroke Diesel :: Power Steering Pump Making A Loud Whining Sound
My power steering pump was making a loud whining sound. No problem, changed the pump. Now after the truck is started I will have no power steering or brake assist, give the truck a little gas and you can hear the power steering pump "start". I have tried every way to get the air out, or is that not the problem. I even lifted the front of the truck off the ground with a forklift and with the truck off turned the wheel about six times stop to stop. Fluid level looks good and has since adding after the change.
View 4 RepliesSanta FE SM (2001-06) :: 2004 - Whining Noise From Power Steering Pump
I have a 04 santa fe , which slowly started whining which was diagnosed a power steering pump, when replaced the problem got worse and it became very hard to steer. Steering rack was the next diagnosis, replaced and another new pump. Now its so hard to steer and the whining has returned. Looking in the reservoir the fluid seems to be moving good with no bubbles??
View 3 RepliesSanta FE SM (2001-06) :: Power Steering - Pump Making Whine At Idle
I have a 01 santa fe 2.7 motor. I have read several threads in here regarding the famous pump whine. my pump is making a whine at idle, I have cleaned the bottle and made sure the screen has not restrictions, drained all the fluid, and have inspected the lines for leaks.
With a stethoscope have pin the noised to the pump, the noise travels in the reservoir when I race the engine the noise is more evident on the bottle. I am tempted to replace the pump, but the steering has no issues and operates fine, also no change in the whine noise when moving left to right.
Golf IV / Jetta IV :: Power Steering Fluid Leak / Pump Is Shot
A few days ago I had a big PS fluid leak. Turned out the return line had been sliced a bit. I had to drive it for a couple days before I could get around to fixing it. The steering is still stiff and the pump whines. Is this an indicator that I need to replace the pump?
View 4 RepliesFord Aerostar :: Power Steering Fluid Leaking - Pump Replacement?
Proud owner here of a '96 3.0L RWD Aerostar Utility Van with about 138k miles, and leaking power steering fluid. At this point I'm replacing fluid from zero every time I have to drive it which is about once a week. I've located the leak and it seems to be coming from the pump/reservoir around the pressure hose. The hose is loose as in i can move it around a bit, but from what I've read, this is normal and the hose is supposed to be like that. I figure that at this mileage, with so much air going through the pump, all the crazy squealing and whining it does even when full, at this point it probably makes sense to replace the whole pump while I'm in there, as opposed to just doing the reservoir. Anyway, I'm planning to do this in a couple of weeks, and have some questions...
1) The pump - I've read on this forum that the best way to go on brand of the pump is Motorcraft.
2) Hoses - I'd like to replace the hoses coming out of the pump while I have this thing all taken apart, but I'm not exactly sure what parts to get. I know one is the pressure and one is the return, but there are variations of each based on the research I've done. The parts on the Napa site have different descriptions like "with switch port", "without switch port" "56in hose" "26in hose", and so on. Which ones I need, specifically the ones connecting directly to the pump? I havent been able to find anything in my research online, in Haynes, or Chiltons manuals.
3) Washers - Whether or not I replace the hoses, should I replace the washers at the connection point? Chilton's seems to recommend replacing them. Will they come with the new pump?
My local auto parts shop has the pulley remover/installer for me to rent so I've already got that squared away. I'm pretty sure I've covered all of my bases otherwise.
Ford Brakes/Suspension :: Power Steering Pump Boils Fluid
I am trying to use a ford pump to power a Hydro-boost off a diesel pickup, took everything off same truck. Started it up, ran ok for 5 mins & PS pump fluid boils. No PS box in the system, just the Hydro. Seems like the fluid is not getting out of the pump & circulating either. I figure a blocked pump discharge or blockage in the Hydro. I can shoot air backwards thru the hydro, too hot to touch the pressure side. I had the outlet nut off the pump, could I have blocked the discharge when I put it back?
View 6 Replies