Lexus GX 2010+ :: Front Differential Leaking From Drive Shaft Output
My front diff appears to be leaking from the drive shaft output. it's not enough to leave drips but the skid plates are oily. Having the dealer look next week. 60k on a 2011 460.
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2003 F350 - Drive Shaft Noise / Rear Pinion Seal Is Leaking
I was getting ready to replace the carrier bearing and noticed the rear pinion seal is leaking. Before attempting the replacement myself, I would like some opinions on the noise in the video below. Is this normal? I am confidant I can replace the carrier bearing and pinion seal, but not sure I have the tools for anything else.
YouTube ...
Lexus RX 2004-09 :: 2005 RX330 AWD - Back Drive Shaft Removal
I have Rx 330 2005 AWD, recently we dont have winters, so I don't need 4x4 . Is it possible to drive without the back drive shaft? It very easy to remove it, but is it save for e.g. differential or other mechanisms? By the way I could reduce fuel consumption, I think, 18miles/gallon is really too much for polish realities.
View 2 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 RepliesPhaeton :: Water Pump Leaking Out Of Shaft?
A little less than a year ago I decided to change the timing belt & water pump on my then 61k miles '05 V8. I bought the BlauParts timing belt kit and rented the tools from them also. The install went without a hitch, the old water pump gasket came off nice and clean and I installed the new water pump gasket without any RTV as per the instructions.
A couple of weeks ago the Phaeton hit 65k miles so I did an oil change and while I had the belly pan off I noticed a small whitish pink spot on the belly pan, right below the crankshaft pulley. Looking closer I found coolant traces that came from the water pump area. I cleaned it all up and decided to drive it for a few weeks to see if it's an actual ongoing leak or if that was maybe just an old leak that might have happened just after the install. Unfortunately it's an actual leak ..
First I thought maybe it's leaking out at the gasket but closer investigation shows that the leak is actually right below the pulley at the bottom of what looks like a freeze plug at the front of the water pump. Is this a common area for a leak with this type of water pump? It's only been installed for 11 months and 4,500 miles. Btw, the pump in the kit is a Saleri model GD42107.
I'm really bummed about this because it's a lot of work to swap a water pump out and I'd hate going thru all that work again (and having to rent the tools again). Question is, can I swap the water pump out without putting the front bumper into the service position? From what I recall the only clearance issue might be finding a puller that is short enough to pop off the camshaft sprockets with the radiator that close.
Here are a few photos from when I found the leak:
This was after a 200 mile trip, fresh coolant:
This is were the leak is coming from:
Passat (B5) :: Cam Shaft Adjuster Seal Leaking
Passat, 2003, 5 speed, turbo, 1.8T engine, 4 door, 66K miles.
No oil on garage floor and tiny amount of oil at rear of engine, Is this urgent?
(I have had many cars with no seal or gasket issues- especially at 66K).
Ford Excursion :: A/C Shaft Seal Leaking?
Well, the ac in my truck has been less than exciting since I've owned it and its time to address it before another trip.
I crawled under last night to explore the Ac clutch air gap and found that the shaft seal is leaking and clutch is grooved pretty bad and covered in oil.
I'm thinking it's time for a compressor, clutch, orifice tube, expansion valve and reciever/dryer. Does that about sum it up? I haven't messed with AC systems much outside of my simple jeep system that was as easy as two seals and recharge in my garage to fix it.
Do I need to flush the lines out? Should I do that at all? Motor craft worth the cost over something like four seasons? Its almost twice the cost but in the end if something goes I'm further downstream after freon etc to charge it and the possible shop charge if I pay to have to done.
Dodge - Ram :: 1997 - Drive Shaft Fell Off?
I've got a 1997 Dodge Ram with 150k miles. I was driving down the Parkway today and the drive shaft fell out of the rear differential. Is this a major problem? Can this be easily bolted back on or is this the end of my truck? Or something in between? I have no clue where I stand.
View 19 RepliesChevrolet - Trailblazer :: 2002 - Bad Drive Shaft?
What are symptons of a "bad" drive shaft? Just curious because during a recent trip to the dealership for an oil change a mechanic told me I had one(I had mentioned I heard a noise that seemed to speed up and slow down as I drove-kind of a whirring noise). He arrived at that diagnosis by pushing down on the hood with enough force to make the vehicle(2002 Chevy Trail Blazer w/4wd) bounce up and down - there was a clunking noise. I haven't taken it in to have it looked at more closely, mainly because I am afraid of the cost. What's involved in replacing a drive shaft? What's the cost? If it is really "bad" will it break suddenly and cause an accident?
View 2 RepliesCamry :: V6 Water Pump Leaking Through Its Pulley Shaft
I was hearing some sounds from my engine and opened up the timing covers to determine where the sound was coming from. It sounds exactly like the Sienna with the same 3MZ engine in this video: YouTube ....
While I didn't find the source of the noise, I did find that my water-pump is leaking. My question is, is this water-pump leaking bad enough to be replaced? I do not notice any coolant loss and never had the need to top up.
It appears from this last photo that the pump is leaking through its pulley shaft and not at the interface with the engine:
The timing belt and water-pump were changed 3 years ago with the Gates timing belt kit from RockAuto. The pump at the time didn't look that great quality in its casting compared to an Aisin pump.
I could not feel any play or hear any abnormal sounds from the pump while it was running with the timing covers off.
This is on my 2005 Lexus ES330 with the 3MZ-FE 3.3L V6 engine, same motor as the Gen 5 Camry SE V6.
Golf IV / Jetta IV :: ARB Rubbing Drive Shaft After Lowered
Had the common problem of ARB rubbing the drive shaft after I lowered an extra 15mm - It didn't rub before I went this extra 15mm. I got adjustable drop links on and they also didn't work. I basically told the garage to sort it out and they put standard drop links back on (not genuine) and also new wishbones because I needed them. Got my car back and the rubbing was even worse. So I raised it back up the 15mm, to where it was before the rubbing started, yet it's still rubbing like crazy. I'm wondering if the new wishbones may be causing this because of new bushings or something and it all being tighter. And also what am I supposed to do? I shouldn't have to buy a whiteline ARB because it wasn't rubbing at this ride height before the wishbones and drop links were changed.
To summarize:
>Lowered car extra 15mm, rubbing started
>Drop links and wishbones changed, rubbing is worse
>Raised back to the point where rubbing started and still rubbing just as badly.
Mazda :: Drive Shaft Stuck On 1998 Protege
I've managed to remove 95% of my driver's side drive shaft but can't for the life of me remove the spline from the transmission. I cut the boot so all there is is the cup with the spline plugged into the gear box. I've pried and pried with a screwdriver and drove a chisel with a hammer in between the cup (not sure the proper term for it) and it wouldn't budge. I'm going to try and track down a puller that will work on this car but that might take days or weeks. I have to work tomorrow night so my question: Will it do any harm to the transmission or be unsafe to drive with only one drive shaft?
View 19 RepliesTouareg :: Vibration When Accelerating Over 10mph - Drive Shaft?
So I drive a 2003 VW Touareg....and the other day while driving, felt this strange vibration when accelerating over 10mph. The dealership said it was an $1800 repair and diagnosed it as the drive shaft.
View 2 RepliesTouareg :: Heavy Rust On Drive Shaft Flanges
While rotating the tires I've noticed heavy rusting on the flanges that the wheels are bolted to, in fact the rear ones were stuck to the flanges. It looks like the VW logo on the wheels is not hermetically sealing the area and water/salt get in and create a rust heaven.
View 16 RepliesPassat (B5) :: Right Side Drive Shaft Removal / Replacement
From what I've read, the procedure for removing and replacing the drive shaft involves pulling the upper ball joints and tie rod end from the steering knuckle--is it possible to put a floor jack below the lower arm (the load runs to the spring through the lower arm) and undo the lower ball joint to get the clearance required to remove the shaft?
View 9 RepliesSanta FE SM (2001-06) :: AC Compressor Replacement - Shaft Seal Is Leaking
After 9 solid years of service, my a/c compressor finally failed. According to the shop, its leaking at the center seam of the compressor. If the system is charged, then the compressor will operate until the low pressure switch shuts it down. My question is this: Can this compressor be rebuilt? If so, where can I get the parts (I'm assuming the shaft seal is leaking).
Also, a quick search on eBay provides several compressors that fit my car; however, some of them are listed as HS-17 compressors and others are HS-18. My car (according to the A/C sticker on the hood) says I have an HS-18 compressor. Are these two interchangeable? I'm asking because if the current compressor can't be rebuilt, then I will have to buy either a reman. or new unit.
Car: 2002 Hyundai Santa Fe, GLS, 2.7L V6
Jetta - Volkswagen :: 2009 - Crank Shaft Cradle Leaking Oil
Last year I had carbon deposits cleaned on all 4 cylinders and fuel injectors replaced at a local shop. The same shop that did this work is now telling me that my crankshaft cradle needs to be resealed because it is leaking oil. There wasn't an oil leak issue prior to the carbon cleaning and replacement of injectors and they were the last people under my hood. I am wondering if this leak could have been caused by faulty reassembly or other damage after cleaning the cylinders and replacing the fuel injectors? I have a 2009 Volkswagen Jetta 2.0 with about 75,000 miles.
View 8 RepliesFord Transmission :: 1974 F100 - Selector Shaft Is Leaking
I have a 1974 ford f100
302
fmx transmission 14 bolt pan
tag off of transmission (not sure if this tells you anything)
The problem: the selector shaft is leaking
What I need: a replacement seal - part number or where to buy
Also, when I remove the valve body to replace the seal will there be any hidden BB's, springs or any other things come flying out that i need to keep an eye on. Valve body torque specs would be fantastic.
Jimmy :: 2001 - Strong Vibration When In 4WD / Front Drive Shaft?
2001 Jimmy 4wd, 115,000 miles; Recently I noticed a strong vibration when in 4WD, no vibration in 2wd. I found that the rear joint (at the transfer case) of the front drive shaft has play in it. I am assuming that this is the problem. It has the appearance of a CV joint. Is that joint rebuildable or do I need to replace the shaft?
View 1 Replies