GTI 337/20th Anniversary :: Overheating Indication On Temp Gauge / CEL On But Car Running Fine
My sister has a 2004 gli 1.8t with 65k. The temperature gauge says its overheating, the cel is on, but the car appears to run fine, the fluid levels are appear to be fine, and you cant see any leaks. Her fiance thinks its water pump issues...
View 4 RepliesLS / MKZ :: 2000 - AC Works Fine But No Heat
Have no heat, the a/c works fine, ran the diag. and got codes 1262,1265,1947, and 5041, I don't even know where to begin.
View 10 RepliesVolvo S40 :: 2000 Starts Up / Run Fine But Won't Idle
I have a 2000 volvo S40 19T, it starts up, and will run just fine if you give it any amount of gas, but it just wont idle. I unplugged the MAF sensor and it ran the same. I then took the IAC valve off and put a towel over the port (To let some gas in but not completely shut it off) It runs GREAT like that! I kept the IAC plugged in and the towel over the port, started her up and put a lot of pressure on the towel to cut of all air, the car idle went really really low and then it shut off. Now since the car knows it is stalling, and it needs more air I should be able to see the IAC opening and closing (Remember it is plugged in, but in my hand), it didn't move at all!
I have run the car with my towel over the IAC ports and chased all around the intake manifold and other intake duct work with carb cleaner to try and fine vacuum leaks to no avail. I even did the towel trick with a multimeter hooked up to the wires that plug into the IAC valve, it is getting a small amount of voltage, say 2 to 3 volts, but the new valve still won't open, and I have yet to confirm that the current changes with idle fluctuations when I press on the towel.
Infiniti - G20 :: 2000 - Dies When Put In Drive / Fine In Reverse?
Very strange problem for me especially since it's not my car, belongs to my sister. Only code that was set last month indicated the MAF so I cleaned it and the car ran fine. Started to hesitate up hills (steep uphill driveway) so I replaced the fuel filter yesterday and my sister said it drove just fine uphill. Now it stalls whenever put into drive, no codes set and none pending. It will idle in reverse but not in drive.
View 1 RepliesDurango :: 2000 - Vehicle Will Not Start / Engine Turn Over Fine
Will not start. Engine turns over fine. Have electric to lights, radio, everything but the fuel pump, coil and fuel gauge. Ignition switch and fuel pump check out okay. Checked fuses, okay. Vehicle has an add on after market remote start/security system, has been working fine for years.
View 1 RepliesGolf IV / Jetta IV :: 2000 GLS Run Fine For 10 Minutes Then Will Stall - ECU Replacement
I took my 2000 Jetta GLS 2.0 5 speed it a certified mechanic shop that I have used before. This scan show a speed sensor (which I already replaced) and the ECU. He said that the ECU is discontinued and that he could not do the repair.
The car will run fine for 10 minutes then will stall, wait 5 minutes and it will run again for 5-10 minutes stall and repeat the process. Question, what is involved with swapping the ECU with an identical numbered one from a junk yard? Also could swapping out my headlight assembly have any effect, this started to happen shortly after the new headlights were installed.
Golf IV / Jetta IV :: 2000 - Misfires Only When Cold But Fine Once Warmed Up?
My brothers car is a 2000 VW Golf 2.0 that recently started starting rough in the morning, when the motor is cold it will struggle to even turn on and will act like its only running on like 2 or 3 cylinders for a second and most cases stall, he is having to pump the throttle to get it to even stay cranked until it all sudden just starts idling fine and it idles perfect but still acts boggy if you try to rev it right away as its warming up, after about 10 seconds of it idling the motor can be revved perfectly fine and you can turn the car off and it will start back up immediately..
View 1 RepliesVenture :: 2000 Silhouette Backup Light Don't Lit - Fuse / Bulbs Fine
This is for a 2000 Silhouette, yet I see there's lots more traffic for the Venture, so thought I'd start here first.
Backup lights don't light, when minivan put into reverse. b/up fuse ok (engine bay, #27), bulbs ok (swapped with new lights, and switched with turn lights, to confirm).
The circuit board is a potential, yet hard to believe that out of 8 bulbs, only 2 would go, and that would be 1 on each side, and only the reverse lights (not the marker, stop, or turn). Will go at it with a multi-meter, to see if there's current, for the next step.
Searches show that it could be the gear position sensor, stuck with what part this would be, and where this part would be. Would this be a pin-to-ground physical sensor, a gear position sensor by the transmission, something linked to the gear selector arm, etc? And once found, is this something that is replaced, or adjusted (imagine the reverse lights going on, when in neutral!)? Still looking for info, on that one.
Durango :: 2000 / 5.7L Runs Fine But Doesn't Want To Start Again - Cranks But Does Not Fire Up
I have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 RepliesToyota - Mr2 :: 2000 Cranks Fine But Barely Starts When Engine Warmed Up
My 2000 Toyota MR2 started to act up a bit lately.
I noticed that the car cranks fine, but turns over very weak. almost seems like it barely starts. This happens ONLY when the car is already warmed up. This does not happen when car is starting from cold start. Like, starting first time in the morning is fine, but after 10 minutes of driving, then turned off, the subsequent starts are weak as a fart from a butterfly. But it does start, and when it does... it seems to drive okay.
Now, I've been hearing it can be leaky fuel injectors, or... Mass Air Flow sensor, .. or .... bad fuel pressure..(which may be part of leaky injectors?)
Accent LC (2000-05) :: 2004 - Starts And Idle Fine For A Few Seconds Then Dies - No CEL
A few days ago, I went to start the car, and it will start, and idle fine for a few seconds, and then begin to run crappy, idle down, and die. I tried starting it, and giving it some accelerator pedal, and it dies. I changed the timing belt, idler pulley, and tensioner this summer, so I'm ruling out a bad timing belt. There is no check engine light, and I replaced the plug wires because when I removed the cover, I noticed one of them was worn in a spot, and the wire shielding inside the rubber insulation was visible.
View 11 RepliesAccent LC (2000-05) :: Cold Weather Start / Turns Over Fine Just Not Firing
So my wife drove her car all day yesterday, everything fine. This morning went to start and it wouldn't. It turns over fine just not firing.
Now during the summer I had replace the fuel pump/filter before discovering that was not the issue.
I know you are already thinking CPS!.. I replaced that over the summer.
I have not checked the spark yet, kinda hard to do that one by yourself.
Beyond spark I am not sure what else could be wrong, especially because it was running fine last night. Is it common for accents to have issues in 20 degree weather?
Yaris/Scion & Vitz :: 2000 Toyota Echo Drives Fine Until Warmed Up
I have a 2000 Toyota Echo. Symptoms are, the car drives fine until warmed up. Once warmed up, about 10 min or so, there is surging, an inability to maintain idle, periodic loss of brake assist, all consistent with my p1349 code. This happened about two months after I changed my oil (the old oil was in there for an embarrassingly long time). I ran motor flush and again changed the oil; symptoms persist. I have removed the OCV and OCV screen; both look fairly clean. Here's the question: what checks can be done on the OCV itself before I call a bad OCV and replace it? The service manual was of only marginal quality in explaining any checks.
View 2 RepliesAccent LC (2000-05) :: 2001 GS Won't Start / Engine Cranks Fine But Doesn't Fire
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
Ford 7.3L Power Stroke (1999-2003) :: 2000 - CEL Came On / Idle For About 20 - 30 Seconds Then Fine
2000 f350 CCLB SRW 176,000. I have a touchy accelerator. About two weeks ago the CEL came on and it wouldn't do anything but idle for about 20-30 sec then fine. Then it got a little worse. I disconnected the two harnesses on the accelerator pedal and sprayed them with electrical cleaner. Put it back together and it seemed to be ok. Today the pedal is real sensitive. Sometimes bogging down other times accelerating real high even tho my foot is pretty consistent and gradually accelerating. No CEL tho. Do you think I am in for a new pedal assembly? Could it be something else? UVCH?
View 13 RepliesFord - Explorer :: 2000 - Tranny Shifts Fine - Power Loss When Climbing Hills
I have a 2000 Ford Explorer with 188,000 miles on it. I bought it used with 110K miles and put a new tranny in at that time. Now, I am having problems. I don't know if it's the tranny or the engine. It looses power when climbing hills. It takes off really slow with no power and finally gets up to speed it switches gears the whole time smoothly but the engine just can't take a load.
The check engine light came on and put out 10 codes:
P1451 EVAP Control System Canister Vent
P1747 Electronic Solenoid A-Short Circuit
P0743-Torque Converter Clutch Circuit Electrical
P0750-Shift Solenoid "A"
P0755-Shift Solenoid "B"
P0760-Shift Solenoid "C"
P0765-Shift Solenoid "D"
P0135-O2 Sensor Heater Circuit
P0155-O2 Sensor Heater Circuit
P1409-EGR Vacuum Regulator Circuit Malfunction
Those are the codes and I don't know how one has anything to do with the other. I checked the dip stick on the tranny and it's clean. Juicy red and not shavings.
Accent LC (2000-05) :: Overheating With A/C On While On Freeway
Car heats up (dial at 3/4 temp.) with A/C on at highway speeds. Turn off A/C and temperature drops back to normal (in between the two dots). Everything appears to be in working order.
View 18 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Transmission Shifts Fine With Disabled O/D?
And if I have to sift through one more "My O/D light is blinking."
I have a 2000 F350 7.3 4x4 SRW CC with several issues but right now I'd like to address the one plaguing my transmission. If I crank the truck and take off it will not shift out of first gear, well it might but it'll take a while, be at high rpms, and a hard shift, throwing the 1-2 shift error code. Now if I disable O/D with the button on the shifter and take off it shifts through all gears fine. I can drive it normally and if I hit the highway, when I'm up to speed I can enable O/D, it shifts into O/D and I can keep on trucking. When I stop I disable O/D and take off normally again. After about 10 minutes of driving and several start/stops even with O/D disabled it will eventually throw the 1-2 shift error code and give me a harder shift into 2nd and I guess enters its limp mode but is still drivable. This appears to be the only code dealing with the transmission.
Due to the fact that it shifts fine with O/D disabled, doesn't skip any gears, and I can manually shift it through 1-2-D I'm guessing it's not the mechanical diode I've heard so much about but an electrical issue. Before I bought this truck it had been abused, at one point the front driveshaft came loose and ripped the wiring harness going to the TRS in half. They soldered it back together but it still looks a little rough. I figure this is a good place to start. What readings I should get at the TRS? Sensor side and plug side. I have the AE enhanced ford bundle and a good DVM. If the TRS can't cause an issue like this where do I go from here, shift solenoid?
TLDR Version
2000 F350 7.3 4x4 SRW CC
Won't shift out of first with O/D enabled.
Shifts fine with O/D disabled.
Can manually shift through all gears.
Eventually throws 1-2 shift error code.
TRS/TRS Harness has been damaged in the past.
Appears to be an electrical issue with the transmission.
Can the TRS cause an issue like this?
How do I test the TRS/Harness?
If not the TRS what could it be, shift solenoid?
Explorer :: 2000 - Overheating And Air Conditioner Went Out At Same Time
My Explorer has been overheating for the last couple of days. It red-lines unless I turn on the heater, and then it still runs pretty hot. From all I can tell, there is plenty of coolant in it, and the fan is running.
The air conditioner went out about the same time (it goes in and out), but that may just need to be recharged.