Nissan - Altima :: 2007 - When Shifting Into Park It Won't Shift Down Past Neutral
My automatic 2007 Nissan Altima has developed an intermittent problem when I go to shift it into park it won't shift down past neutral. I can't physically move the gear shift past neutral and can't take my key out of the car. If I wait awhile or drive off somewhere else it will later allow me to shift normally again and won't happen for awhile. It has happened maybe 8-9 times but I worry it will get worse or break the transmission. I've taken it to a mechanic and they looked at the transmission and didn't see a problem but sense they couldn't recreate the issue they couldn't fix it.
View 1 RepliesSonata NF (2006-10) :: Shifter Won't Move Past Neutral Into Reverse And Go Into Park
I have a 09' 4cyl automatic engine with 54k.
About 30min ago when when I parked the shifter would not move past neutral into reverse and go into park. I can go from D into neutral or the next slot over for manual shifting. Naturally this causes a problem as you can't take the key out of the ignition if its not in park.
I took a screw driver and popped open the cap for the shift release button and used that to move it into park. Turned car off, back on, etc etc seemed fine. So when I tried moving it into reverse and it wouldn't budge. It instead would make a electronic click or snap coming form the steering column but more back toward the engine. Like more into the dash area but back in it. It would make this noise every time I attempted to move it but it wasn't a continuous sound. Just once with each jerk to the side to move it out of park.
So the car works fine except for this. I used it with the screw driver/shift release to unlock it and it drives fine. Goes into reverse and back in park but if I move it into neutral or drive it will not go back into reverse or park.
Golf V R32 :: Acceleration Seems Hesitant When Floor From A Standstill
I got a VW Certified R32 back in August and I'm loving every minute of it! I just have two little issues. When I floor it from a standstill, the acceleration seems hesitant almost as if something is holding back the power until I hit about 3500 RPM there's a slight break (as if it were shifting but its in 1st the whole time) and then there's a lot more power available.
Also, when ever I'm shifting there is a slight delay between when I press the paddle or push the shifter. I push the '+' paddle wait half a second or so, and then it starts the shift sequence. Only seems to happen when I try to shift between 2k and 4.5k RPM (4.5k+, the second I hit the paddle it starts shifting). Is this normal? Is this because of the AWD(never had an AWD car before)? Should I complain to the dealer?
Golf IV / Jetta IV :: Car Smokes At Takeoff From A Standstill
Bought lucas oil additive, but have not used it yet. Waiting to burn some more oil and a lower reading on the dipstick before adding the quart of lucas.
Or should I just oil change with some mobile 1 synthetic 0w-40 work?
Engines around 225k miles on it.
Ones moving I notice no smoke at all. Worn out rings? Valve seals or guides?
Golf IV R32 :: Stalling At Any Standstill Longer Than 1 - 2 Minutes With The A/C On
So my R32 just recently started to stall at any stand still longer than 1-2 mins with the A/C on. Every thing works perfectly fine as avertised as long as the engine has not warmed up yet, I am driving at a cruising speed, or the A/C is not turned on. I'm thinking the issue maybe be heat related causing the crank position sensor to malfunction. Is there anyway to check the cps with Vagcom?
View 18 RepliesS-10 :: High Revving In Neutral Until Vehicle Comes To A Complete Stop
I've been dealing with this for over a year. 97 s-10 (4.3, 4wd, 5spd) always wants to keep revving. When I put it in neutral and coast, the rpms rise. When in gear, it powers itself down the road even when I'm off the gas. The part that really gets me, is that it will keep revving in neutral until the vehicle comes to a COMPLETE STOP. Then, it drops to a nice idle within 2-3 seconds. I don't understand what the momentum of the vehicle has to with the revving of the engine when its in neutral.? I replaced the IAC valve (and set the pintle) and tried to clean up everything I could. It seemed to be better for only a little while. Faulty new part? Is the IAC getting "gummed up" quickly because of something else?
View 3 RepliesPrius (2004-09) :: 2006 Vehicle Won't Start And Goes To Neutral
I've searched & still haven't resolved my problem.
View 19 RepliesPrius (2001-03) :: How To Put Vehicle Into Neutral With Dead Battery
I'm sure it's been mentioned before, but if you need to put an 01-03 Prius into Neutral with dead battery (i.e. to push the car so you can reach it with jumper cables) you need to remove the rectangular panel on the bottom drivers side of the steering column. It's tiny, smaller than a postage stamp. Use a strong pen-knife or very small screwdriver to pop the panel out.
You may want to remove the panel when things are good, so if you ever have to use the gearshift release you don't have to hunt around for a knife since it's on pretty tight from the factory. (just leave it off once removed).
Santa Fe (CM - 2007-12) :: 2008 - Grinding Noise Coming From Front Of Vehicle When In Neutral
When I start my vehicle, it makes a grinding noise, sounds like it's coming from the front of the vehicle, when I put into gear it stops. It started gradual and is getting worse. It's a 6 cylinder automatic, with 108 k miles.
View 3 RepliesGolf IV / Jetta IV :: Speedometer Won't Go Past 70 - 75?
My vw jetta 2.0 mk4 runs perfectly fine till i hit 70mph then it just bounces slightly between 70-75mph and stays there. Everything else on the dash seems to work fine. my rpm is working fine, odometer is working fine, it's just the speedometer that gets stuck once i go past 70mph. I can tell that i'm going faster than 70mph yet it wouldn't go past 70-75.
View 3 RepliesGolf IV / Jetta IV :: Won't Boost Past 4 Lbs?
my car into VAG COM and since then it hasn't boosted past 4 lbs. it has Revo stg 2, K04, aftermarket side mount, full exhaust and a couple other bolt ons. Before the car was spiking at around 23/24 lbs. after pressure testing the system I found that the turbo inlet pipe was lose, so I tightened it. Still no change. I tried holding the battery terminals together for 10 minutes to reset the ecu and I also tried clearing the codes through a handheld code reader. No codes even come up anyways for this. The car is a 1.8T.
View 4 RepliesGolf IV / Jetta IV :: 2001 - Won't Go Past 10mph
I have a 2001 1.8t. Was stock except for exhaust and Cai. This weekend I installed a Audi K04 turbo, Audi exhaust manifold, 3" down pipe to 3" exhaust, 3" maf, front mount intercooler, 3 bar fuel pressure regulator, high pressure fuel pump, 386cc injectors, r8 coil packs, ngk plugs. The car start but sounds like it's going to turn off and can't get it out of first gear. As soon as I put some gas it seems like it chokes and can't go past 10 MPh. I don't have it chipped could that be the reason or should I look at something else that could be causing the problem. I'm wanting to go Unitronic stage 2+ but don't wanna do that and still have the same problem.
View 1 RepliesGolf IV / Jetta IV :: 2001 2.0 Wagon Won't Rev Past 3200 RPMs
The wife's Jetta wagon has been giving us some issue. It is a 2001 2.0 AZG engine auto trans wagon. 195,000 highway miles and well serviced and taken care of.
Here is the symptom : Engine will NOT rev over 3200. It will hit 3200 and stop dead. This is the case either in gear and driving or just sitting in Neutral. The engine seems to take a bit longer to start but does every time. The car seems to run great other then the 3200 rpm ceiling.
Wife has been driving it around like this for a while and I have let the codes accumulate. Here is the codes it gave me.
16727-cam position sensor- I just replaced the CPS with no improvement, issue is still there and code still pops up. I was told this code comes on when the car does not fire on the first rotation anyhow so it could be something else.
16804-cat o2 bank 1
16990-ICM issue
Cleared the codes and restarted the car. 16727 comes on immediately but other codes take a while to come on again.
I am leaning towards maybe an electrical issue? Bad ground, alternator output or something. Any tips on places of ground, connectors etc to clean and check? Also one or two guys keep mentioning coolant temp sensor and crank position sensor...but wouldn't those toss a code too?
I also pondered a plugged cat but I dunno, have had that before and you can usually tell right away...the car runs great until it hits 3200 and it is like a governor kicks in and she stops dead at 3200.
Golf/GTI VI :: Slight Vibrations In The Seat And Steering Wheel Past 60 Mph?
Experiencing slight vibrations in the seat, and steering wheel past 60 mph on the stock wheel & tire set up? I've got about 10k miles on my Pirellis and am thinking that all the winter driving (potholes) have knocked them out of balance. The VW dealer claims they balance fine, but I can feel the vibrations. Just wondering how everyone else is liking their stock set up.. Maybe a wheel has a slight bend? Nothing I can notice from a quick glance tho.
View 6 RepliesGolf IV / Jetta IV :: 2001 / 1.8t - When Accelerate Boost Won't Go Past Zero And Stutters
Okay I have a 2001 Vw Jetta 1.8t Wolfsberg.
I have done a few mods:
- Oil catch can
- Boost gauge
- New turbo (5000 miles old)
- Brake booster mod
- PCV system fixed and some hose deletes (that make the intake manifold have one line off of it rather than two)
- Timing belt/ pulleys
- Accessory belt / pulley
- A few other things but nothing to cause this
The car will do this randomly. And I mean once every two weeks of that. I will go to accelerate and the boost gauge says the "boost" is at zero and no matter how much I give it gas, it won't go past zero and stutters. But it stops almost as fast as it starts. I don't get it...
My catch can has 3/4" line to about 1/2" or so, that meets the oil catch can. (Ebay with the blue hose.) I have new plugs, all new (dealership recommended) lubes, all kinds of new small odds and ends. But it's never done this before. (3rd time now in a month..)
Golf IV / Jetta IV :: 2001 - No Power And Won't Go Past 3000 RPM At 20% Throttle
I made an earlier thread about minor low speed crash and airbag deployment that has sense been fixed.
The engine 2.0 (AZG) will rev to 3000 (3200 sometimes) RPM and stop. This is only if you give it about 20% / 25% throttle. If you give it full throttle it spits and sputters. When I had the airbags installed. The codes were read it and also came up for cam sensor and o2 changed that and now the codes are gone. No CEL and it is exact same issues still. I can't tell if ECU is doing it but it feels like it's not getting enough gas or air since full pedal makes it stall.
Golf IV R32 :: Blinking Engine Check Light When Go Past 2500 - 3000 RPMs
I've been getting a blinking engine check light.. I pulled all the codes:
P0050: H02S Bank 2 Sen 1 Heater Circuit
P0155: O2 Sensor Heater Circuit Malfunction Bank 2 Sen 1
P0304: cylinder 4 Misfire detected
P0688: ECM/PCM Power relay sensor circuit
I've had the car sitting for awhile because I lost my job and didn't have any money to roll it around much.
I just changed out the spark plugs and two of these had a white coating on them.. I was hoping this would take care of the misfire after I replaced them. I also bought a new battery because mine had lost charge a few times.
The Car will run with an engine check light, but if I go past 2500-3000 rpms then it will start blinking (which means don't drive it )
The oil has been sitting in it for about 2 months, so I'm about to go change that and I'm hoping this will allow me to drive it without issues.
Any of these codes thrown and know what they could be? Which O2 sensor (like a link to a website that sells them). Trying to get this thing running again.
Golf IV / Jetta IV :: Chokes The Power Past 3500 RPMs And Continue Running Rough
I own a 2001 Jetta GLX 12v VR6, lately the car has not been running well. It chokes the power past 3500 rpm's and will continue running poorly and sound sort of like a Subaru boxer engine. Sometimes it corrects itself and runs okay but goes back and forth.
I ran the codes on VAG COM:
6 faults found:
17551 - Load calculation cross check
P1143 - 35 - 10 upper limit exceeded - intermittent
16712 - Knock Sensor 1 (g61)
P0328 - 35 - 10 Signal too high - intermittent
[Code] .....
I ran VAG COM a couple of days before these codes came up and I had a different code dealing with air/fuel mixture, something about fuel running to rich. I'm stumped.
Golf/GTI VI :: Hesitating As Accelerated Past 2500 - 3500 RPMs - Ignition Coil Blown
So over the last couple of days my GTi has been hesitating as I accelerated past 2500-3500 rpms so I took it in to the dealer this morning to have them look at and sure enough, it had blown an Ignition Coil.
I know this was a common issue with the 1.8l Turbo engines but I thought this had been corrected in the new models.
I have a '10 GTi with 14000 km's on it and some mods (see signature). And no, they didn't comment or ask about the APR chip or intake.