Golf VI R :: Headlights Not Adjusting After Coilover Install
Installed coilovers and took it for a drive today/tonight..I turned the headlights on and they adjusted side to side like normal..when they went to adjust up they moved like an inch..making it almost impossible to drive at night..I reset the battery and still the same scenario..is this a setting I have to change or can change thru vag com? Everything worked fine prior to install, and no I did not break anything.
View 7 RepliesGolf VI R :: Creaking Under Extreme Turns After Coilover Install
I just installed a new pair of PSS10 coilovers on the R today and everything is running great, except a creaking noise I am hearing under extreme turns. If I am going slow, I can whip the wheel all the way to one direction and hear the creaking noise, or if I am going around a longer corner at higher speeds, I hear it as well. I've taken the wheels off and checked, everything is tightened.
Based on the searching, most are complaints of similar sounds but in straight lines. This is only when turning. There are only 20k miles on the car, but that includes 7 weekends of HPD events. So worn/dry bushings or joints was my first thought.
Golf IV / Jetta IV :: Rear Suspension Rattle After Coilover Install
This previous weekend, my buddies and I finally got my FK coilovers installed on my GTI. I have heard that people say there is a little bit of rattling upon them getting properly seated. Well it has been 4 days of driving and now sounds like the rattling has gotten worse! I took it into a local suspension shop and they couldn't put a thumb on it. We in-turn found out that my rear hub bearing was going out and has since been replace. Having issues with coilovers? I have contacted the company that I purchased them through already and am awaiting feedback from them.
Pic of the car in question. (Before coilovers)...
Golf IV R32 :: CV Boot Popped Out During Coilover Install - Slide It Back On?
I was installing my fk streetlines yesterday and when I was taking the strut out I must of let the knuckle sag to close to the ground. This caused the outer cv boot to stretch and pop out. Do I need an entire new cv boot? Or can I just slide it back on?
View 4 RepliesCamry 2012+ :: Pop / Clunk Noise Coming From Front Wheel After Coilover Install
So I was searching around online and it seems this thing happens to some ppl after lowering their cars. I'm getting a loud pop/clunk noise from the front left side only. Seems that's the most common place ppl are having this type of issue with. What it could be? My mechanic wont be able to look at it till Friday. So not sure on what to do. The sound only happens when I'm hitting bumps on the road.
View 6 RepliesGolf V R32 :: How To Get Rid Of Bulb Out Warning After LED Install
I recently installed the LED euro tail lights with out swapping pins, or any ghetto harnesses. i simply installed my tail lights with the oem harness. Anyways, after i installed the lights, the bulb out warning came on, i got rid of it, but when i press the brakes it triggers the warning light to appear after i vagcomed it to go away. so what is the coding to get rid of it?
View 2 RepliesGolf/GTI VI :: Airbag Light Came On After Euro Cup Holder Install?
Ok, so I installed my euro cupholder today, and I love it. Simple, yet so pleasing! So just for those interested in possibly installing one, but worried about the work, I'm not MKVI inclined whatsoever, so I figured if it would take someone who knows their car well an hour and half, it'd take me 2 and a quarter. I went slowly and as I took the console apart, I meticulously cleaned all the crevices and it only took about 1.5 hours, and that was with some re-fittting and tweaking to make sure everything was perfect. So with my first dive into takng apart the car, it was fairly painless and I love the outcome....except:
For some reason I get an Airbag Error and a warning light. The passenger light works well and goes off with a passenger in thier seat, like its supposed to. I only unplugged, then replugged in 5 things: Passenger Airbag on/ off light, ESP on / off button, 12 V power, Light for shifter (auto), and I Pod (well just an aux line in).
Golf VI R :: Tire Pressure Light Illuminates After H And R Sport Install?
This happened to me, my tires are aired up to 40 all around. Does the light comes on if wheels are out of alignment?.
View 4 RepliesGolf IV R32 :: Passenger Strut Won't Come Out When Installing Coilover
The strut is lose, I can spin it hardly but I can't get the rotor to go down far enough, already disassembled the control arm but it didn't do much considering I couldn't move it forward or backward so the rotor still sits on a corner or the arm. I did the drivers side already.
View 3 RepliesGolf/GTI VI :: Setting ST Coilover On Highest Settings?
Installing STs on my mk6 tomorrow. Doing it in a steep driveway. want to be on the highest setting when I leave. regular v1 st coil over.
View 1 RepliesGolf IV / Jetta IV :: Ultimo Coilover - Squeaking Noise In Rear
Installed a set of ultimos about 2 weeks ago. Replaced everything. Control arms, ball joints, mounts, bushings, pinch bolts. And I'm hearing a squeaking noise in the rear. Just started noticing it Saturday after we had a very hard rain.. Could it be from them being wet?
View 4 RepliesGolf IV / Jetta IV :: Coilover Caps Are Sticking Out And Hitting Hood
I bought some coilover for my mk4 Jetta, and the two front coilover just don't seem write, they are sticking way to much from where they need to be at, and they are hitting my hood..
View 24 RepliesGolf IV / Jetta IV :: Left Front Tire Hitting Coilover And Making Car To Vibrate
I installed 2 new axles and replaced the upper motor mounts in my car. Now when I turn to the right the left front tire is running against the coilover and making my car vibrate. I put a 5mm spacer to give it some clearance but it didn't make much of a difference. What could be wrong?
View 2 RepliesGolf IV / Jetta IV :: Passenger Side Coilover Loose / Little Movement When Wheel Is Lifted
So I just installed brand new coilovers and I quickly noticed a this problem. On the passenger side, when the wheel is lifted, I can feel a little bit of movement from the coilover and it really seems like it is the top bushing that is moving. I can see the metal top plate moving a little also. Everything is we tighten andI did the same thing as the driver's side but only this one does this. When the car is on the ground I can feel there is a bit of play in the wheel if I bang on it with my hand. Also, I know the gap on the top plates is normal, specially when lowered but again the passenger side looks weird and is much higher then the other side. What I'm I missing here ? Both side top bushing and bearing are also brand new.
View 14 RepliesCamry 2012+ :: Check Charging System Warning After HID Install On Toyota SE 2015
I installed some 5K HID's with 35W ballasts and a relay on my 15 toyota camry SE. When I start the system, it says check charging system and once the engine starts it goes away. I initially had 50W ballasts installed but I changed it to 35W as the 50W caused the HIDs to be too bright for my taste.
View 4 RepliesGolf IV R32 :: How To Avoid Airbag Light And Seatbelt Warning Light
I am installing Sparco Evo Seats, a custom Harness Bar and racing harnesses in my MK4 R32 and have questions about wiring of the airbag and seatbelt sensor. What do I need to do so the airbag light and seatbelt warning light do not come on.
View 2 RepliesPrius (2004-09) :: 2005 - Master Warning Light / Malfunction Indicator / VSC / Brake Warning Light Came On
In my one-owner purchased-new 2005 Prius w/ 74K miles and w/ no maintenance/accident history other than doing all scheduled maintenances at Toyota Dealers along w/ recalls applicable at each time (other than we had Toyota replace the 12V battery last year just because I knew it would die at some point anyway and I don't like pushing my luck; I'm not 100% certain if there's been a recall on any water pump for this car and if so, don't believe the dealer has mentioned it), I have the following indicators which appeared all at once while I was driving along at around 45 MPH in no unusual circumstances (80F, dry afternoon, about 30 minutes into a trip of mixed speeds, no loads in the vehicle, no effect on the car while driving):
From Left to Right on the display:
1) Red Triangle - Master Warning Light
2) Orange (Symbol)CHECK - Malfunction Indicator Lamp
3) Orange (!) - Brake Warning Light (but it didn't highlight the word 'Brake' in red)
4) Orange VSC - Vehicle Stability Control Warning Light
On the Screen:
Orange Car w/ the ! symbol - Hybrid System Warning Light
We immediately aimed for the house (about 5 miles away); the car drove perfectly fine, with the engine stopping and starting at lights as needed, with speeds going from the 55MPH we were traveling at the time of the alarms down to 0 and back up thru 35/45 MPH and such per normal off-interstate driving. The battery currently shows all the blue bars, and the engine and hybrid systems showed charge/discharge as usual as we drove. There was no discernible change in the driving reaction of the car to brake, steering, accelerator, etc.
Golf VI R :: TPMS Warning Light Did Not Go Off
The other night I was driving home and my tps light came on, Wasn't sure if it fluctuated because of the weather. So I waited until the morning, checked the light and it was still on. I checked the pressure of the tires (stock) and they were all around 36, I checked the door panel and it said they should be 41. I filled them up to 41, however the light did not go off. I held the reset button and it went off and hasn't come on. It didn't blink when it came on. It popped on and was solid.
View 5 RepliesGolf/GTI VI :: Cannot Get Led Bulb Out Warning Light To Go Off
I have read all 11 pages of the led light post, and I am more confused then when I started. I bought Ed's opt.4 lights with the LED's. I bought the light kit he recommended: [URL] .... with H7 harness. I have 2012 North American TDI Golf. I purchased and had installed the Bold eruo light switch with light sensor kit. I had someone install everything for me. They have had trouble finding out the proper codes needed. The issues I am having are:
1: with the above set up, they can not get the light bulb out warning light to go out. I was told that it is due to the light kit purchased above, and the fact that it only connects to the drivers side harness, and not the passenger side, so the warning light on my car keeps saying there is a bulb out on the right side.
2: With the euro switch in the Auto position, I get no DRL's at all. The only way I get that is if I turn the switch to the next position, and then I get the low beams, as well as the LED's, and no fogs. This stays the same day or night with the light switch in this position. To get the fogs as well, I turn the knob one more turn, and pull it out, and this gives me the fogs as well as the low beams and LED's.
My questions are:
1: can I get the LED's as DRL's in the Auto position or in the position next to it, and then have the rest of the lights come on automatically at night via the sensor? If so, what are the vagcom codes I would need?
2: Is there anyway to get the bulb out warning light to go away without putting in a different light kit. I was told by the installer that they had to try a few light kits to get one to work with the coding of the vw, and the kit they use connects with two harnesses(one for each head light, and not one harness for both as my set up is).