Ford Ranger / B-Series :: IAC Open Up And Raise The Idle
My 04 ranger is back at it AGAIN. It started about 3 years ago.
- Cruising along on the highway and then come into town. Idles at 2000 RPM
- Shut it off. and restart it. Again, 2000 RPM.
- Shut it off and it idles normal
- Drive it 2-3 day and then it idles high again
- I have clean and functioned the IAC and it works fine
- Cleaned throttle body and I never can get it to stick.
- Replaced throttle cable
It still was idling high
- Replaced ECM and it idled normal for about 1 year
- Replaced em again and it idled normal for about 6 months
It is back at it again. For what ever reason the EM is telling the IAC to open up and raise the idle...
Santa FE SM (2001-06) :: Engine Code 102 - Idle Will Raise For A Minute Then Drop Down To Almost A Stall
I have a 2001 santafe with a 4 cyl The code 102 was up so I replaced the mass air flow censer . I go on a test drive and the light stays off , but when I go to re start it again the light come on and stays on, with the same code. The only strange thing is the idle will raise for a min then drop down to almost a stall.
View 2 RepliesGolf/GTI VI :: Vent Fan Only Works On High Setting?
So tonight I went to turn my fan on for my heat when I started my car and noticed it is will only work when it is on the highest speed (4 I think). What the issue could be?
View 10 RepliesGolf/GTI VI :: Setting ST Coilover On Highest Settings?
Installing STs on my mk6 tomorrow. Doing it in a steep driveway. want to be on the highest setting when I leave. regular v1 st coil over.
View 1 RepliesGolf IV / Jetta IV :: Cooling Fan Won't Work On The Low Setting?
I have a 00 Jetta 2.0 AEG engine code and my cooling fans don't seem to be kicking on the low setting. I have changed out my FCM and have also checked the fans to see if they were burnt out and both fans work on both low and high settings. This is also causing my car to overheat but the high speed will kick on when the temp gets too high.
View 9 RepliesGolf/GTI VI :: 2010 - Fan Malfunction - Stopped Working On 1-3 Setting
I've got a 2010 Jetta TDI Sportwagen and the blower fan stopped working (again).
About 3 months ago it stopped working on the 1-3 setting and 4 worked fine. So I searched these forums and found the resistor pack was blown. Replaced it with the ~$30 official VW part and it worked fine until last week.
Now all settings are not working. I ohm'd out the resistor pack and they appear to be fine. I put a current limited 12v supply on the fan and it spun up without a problem. I checked the voltage coming from the car to the fan connector and it was at 0v.
From reading the forums this tends to point to a faulty switch. If it is a fault switch then why does the AC light turn on when I switch from 0 to 1?
Golf/GTI VI :: TPMS Light Won't Go Off After Setting Tire Pressure
I just got st coils and apr stg1 software put in my car and love it. the question i have is the other day my tpms light came on, so when the guys installed my software (today) the tried to set the pressures and clear the light and it wont go off i want to take it to the dealer but I don't want them to give me a hard time about the mods.
View 3 RepliesGolf/GTI VII :: Running Neuspeed Power Module On Setting 7?
I truly enjoy the benefits of of having the added hp/torque. However, I've only been able to use setting 5. I'm curious as to what would happen if you constantly ran the module on setting 7 without having 100+ octane in the tank? I went to Neuspeed's site and saw that they ran 91 octane for both settings while performing their dyno. So now I'm curious and hoping that one of you have the answer.
View 4 RepliesGolf V R32 :: Low Tire Pressure Light On After Setting Tires To Correct PSI
Because of the cold weather my tires went a little low in pressure and my light came on. Now i set all the tires to correct psi and light is still on. is there a way to reset the light without going to the dealership? went through manual and says nothing about resetting light.
View 24 RepliesGolf/GTI VII :: Green Brake Light On When First Turn On Ignition Prior To Setting In Reverse
I just purchased my first VW about a month ago. (Golf tsi white auto). I love the way the car drives/handles. But I was surprised because at just under a 1000 miles the engine light went on. Took it to VW service to check it out. They had to keep it for a few days to do tests with the main VW center. I got the car back without much explanation other than they put in an O2 sensor.
No engine light now for a couple weeks. They also noticed that my wheels are missing 4 lug nut covers (not a big deal). For some reason I am just starting to notice the green brake light on when I first turn on the ignition prior to setting in reverse which disappears upon reverse or drive. I assume this is normal... Question: should I be concerned about this engine light O2 sensor issue?
Lexus GS 2013+ :: How To Raise Headlights
Any pictures or anything to show how to raise the headlight???
View 13 RepliesCamry :: 2005 - How To Raise The Engine About 5 Inches
How to raise the engine on a 2005 4 cyl Camry. Off hand I am thinking that the 3 motor mounts need to be disconnected. What else would need to be disconnected? I do have an engine hoist that I can use - .
View 4 RepliesPhaeton :: Non-Motorized Trunk Unlocks But Does Not Raise?
I've searched through prior threads but all the trunk issues seem to revolve around either the motorized trunks or wiring loom, my issue is a bit different.
On my recently acquired 2005 Phaeton the trunk unlocks and locks fine, but it does not "pop" up at all. I end up having to pry my fingers under the lid to lift it up(harder to do than you'd think). The trunk shocks hold it up fine and everything else seems normal. Would this be an issue with the latch itself?
Sonata I45 (YF - 2011+) :: Sunroof Will Not Raise Up In The Back
It seems my sunroof will open all the way and close but it will NOT raise up in the back those couple of inches it used. it just doesn't respond to the pressure on the switch....
View 7 RepliesTouareg :: Front End Will Drop And Raise Occasionally
The air suspension is auto adjusting in comfort mode....The front end will drop and raise occasionally, and the "comfort mode" ride seems stiffer than it should be sometimes....
View 6 RepliesLexus ES 2013+ :: How To Raise Front Spoiler
I cannot get my new 2013 ES350 into the garage over the threshold because of the low front spoiler. It doesn't have air suspension. How can I raise it an inch?
View 3 RepliesTouareg :: Rear Seat Belt Is Impossible To Raise
I know the Touareg has a problem with the rear seat belt locking and making it impossible to raise the rear seat after it's folded down. In fact, that happened to me and I'm going to have it fixed next week. Now, however, the front passenger side seat belt is stuck about 2/3 of the way out. Can't pull out more and won't retract.
View 1 RepliesLexus LX 2008+ :: Rear Struts Don't Raise The Hatch All The Way Up
Replace rear hatch struts? Mine don't raise the hatch all the way up and sometimes hit my head so would like to replace struts.
View 11 RepliesSonata NF (2006-10) :: Cannot Raise Window - Popping Noise
So today, when I rolled down my passenger window (2007 Sonata GLS) to talk to someone, I heard a popping sound and the window refused to roll back up. I got the car home and started tearing into the door panel (okay, not literally). By viewing different threads here, I have the door panel off, outside handle is off, all screws loosened (including the 3 for the door latch) and am trying to get the inner sheet metal panel off.
From everything I've read, you need to roll the window up the whole way in order to get the inner panel off; however I cannot get the window up the whole way! By lifting up on it, I have it about 2/3 raised, but it won't budge any more. I have been able to see that the window cable is broken (which explains why the window won't raise), but am at a loss on how to proceed. I'm leery of trying to force the window up any more. I'm tempted to try to pry the inner panel back enough to get the two bolts holding the window loose, but don't want to force *that* either.
So, how to get the window all the way up? And/or the inner door panel off?