Golf IV R32 :: Makes Clicking Binding Noise While At Idle - Bad Throw Out Bearing?
I have a clicking binding noise while at idle, with the clutch out it goes away, when depressed its there. So, is this a bad throw out bearing? Clutches and flywheels?
View 12 RepliesChevrolet - Silverado :: 2000 - Light Clicking From Rear Axle When Coasting At A Slow Speed
I am getting a light clicking from my rear Axel when coasting at a slow speed. It could be clicking at any speed but my car is to loud to hear it going down the road. I don't have more details than this. What to look for ?
View 15 RepliesGolf V R32 :: Front Suspension Clicking Noise At Low Speed
So I've recently dropped the car with ST coils and during the install, I had the mechanic installed NEW strut mounts and strut bearings because I've heard people having noises if they only do the coils.
However, even with the new strut bearings/mounts, I would hear clicking noises at low speed going in a out the parking spot or parallel parking (not every time but getting close). Therefore, my questions are:
1. If strut bearings/mounts are new and put in at the same time as the coils, what other reasons could there be that's causing this clicking noise?
2. If the noise doesn't bother me and I can live with it, would there be any negative effects for not having this issue taking care of?
Passat (B5) :: Clunk And Vibration Under Load - Axle Binding?
MK4/3 having axle binding problems. I installed coilovers on my wagon and when i went for a test drive i heard clunk and the car vibrates under load. Now I know the engine mount and trans mount are shot so there's a big possibility that it's causing the axle to bind.
There's no load and the car was of the ground so it doesn't vibrate that much, but if you take a close look at the boots you can see that it's not rotating evenly.
Golf/GTI VI :: Clicking Noise On Both Driver And Passenger Sides Increases With Speed
I have the Golf 2.5 just under 5K miles with the 15" steel wheels and just recently I've noticed a clicking noise on both the drive and passenger sides. The frequency of the noise increases as I increase speed so I assume it is a tire/wheel issue. Sounds like its coming from the back but hard to tell.
View 5 RepliesGolf IV / Jetta IV :: Spring-clicking Like Noise When Make A Sharp Right Turn At Low Speed
So the Jetta developed a new noise lately that sounds just like what can be head on this video.
The spring-clicking kinda noise only happens when i make a sharp right turn at low speed and seems to be coming from the driver's side. So i though bad outer cv joint.
Well, I put on a brand new OEM unit last night and noise is still there.
Golf/GTI VI :: Clutch Clicking At Initial Travel / Wind Noise From Doors At Highway Speed
So far from reading up here is my list:
1) Water pump.
Its not leaking or making noise at this time.
2) Clutch clicking at initial travel.
Noticed this on the first couple miles.
3) Smelly A/C.
This is ongoing
4) Wind noise from doors at highway speed.
Noticed this also
5) Wastegate rattle
Don't hear any rattle, or I am not narrowing down the sound when it happens.
Anything else I should add?
Golf IV / Jetta IV :: Rumbling And Clicking At 30+ MPH - New CV Axle Broken?
I have a 2001 gti that I just changed the cv axle on and it feels like it's failing already but there's no play in the axle or place it mounts to the tranny.. Doesn't feel like the last one I removed but rumbles and clicks at 30+mph.
View 1 RepliesPassat (B5) :: Clicking Noise When Make A Sharp Turn - Bad CV Axle?
The other day i noticed that when i make a sharp turn left or right i hear a clicking noise. If the clutch is engaged it clicks and if its not then it does not click. It is also louder when i turn right... I am thinking CV axle!
View 4 RepliesGolf V R32 :: Clicking When Reverse Down On Drive Way And At Low Speeds - Axle Replacement?
I'm almost 99% positive I need to replace my Drivers Front Axle Assembly. I can feel it "click" when I reverse down my drive way and at low speeds regardless whether I turn the wheel. However, at street speeds, you can no longer feel it. I wanted to know if all Axles aftermarket are created equal.
Can I go with the one from ECS : [URL] ..... Or is this a part where staying OEM is important?
Golf IV R32 :: Binding Noise When Cold - Power Steering Pump Going Out?
Over the past week its been pretty cold here in IL (hovering around 30 degrees). Car makes a binding noise when its cold, but only when its cold. Noise is VERY similar to this:
Is this my PS pump going out, the rack itself, or something suspension related? Fluid level is up to the Max and there are no leaks....
C/K :: 98 Suburban - Clicking Noise When Go In Reverse Coming From Rear Axle Area
I have a '98 Suburban 4WD, last week I started hearing a clicking noise when I go in reverse. Sounds like it is coming from the rear axle area. I don't hear the sound when going forward.
View 3 RepliesFord Super Duty (1999-2016) :: Clicking Noise From Front Axle
I have a slight problem and don't know how serious it is. I own a 2003 F350 with a lift kit. After my drive shaft shattered last September. due to a U-Joint a clicking noise started up in the front axle area after we locked the hubs so we could crawl it down the road out of traffic.
What would be the likely causes and how much would a typical repair/replace cost?
Ford Excursion :: Clicking Noise Coming From Front Right Side Tire - Excessive Play In Axle
I have had a Clicking noise on my 2000 x 4x4 since 6 months coming from the front right side tire noticeable over rough roads or over bumps and I went on a journey starting with ford dealer to almost all well recognized service centers and every body says your front suspension is ok and no one seems to know where it is coming from. I thought it was my hub bearing since it fails almost every year but when I was changing the bearing, I noticed a big Excessive play in axle.
See video : My AXLE Shaft - YouTube
Also I noticed oil mixed with grease the grease is prawny with a reddish sort of color or that is some thing else.
See photos ....
Any way after replacing the hub Bearing with a used one and butting every thing together I went on a test drive. Noticed that the vehicle drive line is not right the car seems to wonder and the noise still there so i didn't get far i came right back and park my x then a funny burned oil smell was present.
Is it some thing i did wrong or is it bad situation gone worst ?
Items Checked Or Replaced In The Last 4 Months ( trying to fix)
Tie Rods. Ok
ball joints. Ok
suspension front and rear. Ok
Front stabilizer bar. Ok
control arm bushings. Ok
stabilizer bar bushings Ok
steering linkage. Ok
brake pads. A new front set installed
Rotors . Both front changed with oem parts
body mounts + sub-frame mounts. Some replaced
shock absorbers . New 4 set installed
- Rear Monroe 911176 Reflex Light Truck Shock Absorber
- Front Monroe 911175 Reflex Light Truck Shock Absorber
tires. Replaced with a new set off four
Hub Bearing. Second hand (that's when I saw it)
Spare Parts waiting list (Ordered):-
O ring ord part # 4C3Z-1K106-AA
(knuckle seal) (F81Z-3254-CB).
and some other dust seals which i can't recall.
I am looking for how to fix axle play and get red of the noise. (this is a video from you tube for clearance)....
F250 wheel bearing, is this bad or not? - YouTube
Touareg :: 2004 V8 - Low Speed Binding When Turning Left
I know from what I've read that this tsb should have been addressed on my vehical (04 V8 early vin). The car has had two previous owners and the 2nd purchased as vw certified. I bought the Treg when it had been certified again 18 months later, so why does this "binding" due to the stepper motor software still exist after all tsb's have been performed
Its happened twice in three weeks now........when you shut down and start again everything is ok.
Ford - Explorer :: 1998 - Steering Is Binding / Shaking During Stopped Or Low Speed Turns
Just replaced a badly worn Hub on my 98 AWD Explorer. The grinding noise is gone but now the steering is binding/shaking during stopped or low speed turns. What is going on or what I might have done wrong?
View 3 RepliesGolf/GTI VII :: Spring Binding Popping Noise After Neuspeed Race Spring Install
This noise I have is driving me crazy, installed neuspeed race springs and now I have this weird spring noise, sounds like the springs are binding and then releasing when you turn the wheel, like a clicking dinging noise, it's on both sides and happens when moving slow and turning the wheel and when stationary and turning wheel, it sounds like tug and release not really spring bind I checked install and everything is correct even disassembled bearing assembly and everything is fine, lubed spring seats with silicone paste nothing is working.
When looking at the spring and turning wheel it's almost like the spring is getting stuck on the middle part of the seat then releasing, I know this was a common problem on the mk6 but I haven't heard anything about the mk7 the spring is seated in the lower perch perfectly the upper is were the noise is coming from you can see as you turn the upper bearing by hand it actually somewhat twists the spring and then releases and that's what makes the noise, and it dose not move in a nice circular motion kind of like an egg shaped rotation and it makes the spring flex and pop I think there's a problem with the springs,
Lexus GS 2013+ :: Clicking Noise At Parking Lot Speed
When I am in the car and the windows down rolling slowly next to a building or something that echos I can hear a clicking that I think is coming from the rear. My salesman is calling me in to test drive a RCF so when I do that I'll have them look at it.
View 8 RepliesSonata I45 (YF - 2011+) :: Loud Clicking Noise When Go Above Certain Speed
When I hit bumps, yank to the left, or go above a certain speed my steering wheel will start shaking and a loud clicking noise happens.
View 2 Replies