Ford - Explorer :: 1998 - Steering Gear To Rack And Pinion
I just finished replacing the rack and pinion on a 98 Explorer 5.0 V8 AWD 4dr Eddie Bauer edition. My question is...Should the steering gear lower shaft set flush when it is connected to the Rack and pinion knuckle? I have some wiggle room but I think I have it as far down as I can get it. It is about 1/2" from setting flush on top of the knuckle. Once I tighten the bolt, it should hold, right?
It looks just like the picture on the right.....
Jeep - Liberty :: 2002 - Rack And Pinion Failure / Steering Sensitive
My rack and pinion began to fail and my Liberty developed sensitive steering (lane to lane and while towing trailers). I had it replaced locally and aligned but when I got it back it was more sensitive than before and borders on "unsafe to drive". I can imagine what it would do if I put a trailer behind it. In my mind something is binding which is fighting the steering input.
When you turn the steering wheel stays where-ever you steer to (does not return to center). My next repair is a known bad ball joint, but I don't think that is causing this. My question is at 106K could my power steering pump be producing less than full power? Is there a dampener in this system that could have frozen up? I'm ruling out the alignment for now. This is the V-6, 4WD Limited.
I truly intend to repair it forever, but if I can't get past this it goes to the junkyard.
Honda - Odyssey :: 2004 - Power Steering Is Stiff And Making Whining Noise / Rack And Pinion Is Leaking
Last week I took my 2004 Honda Odyssey in to Firestone for a rear brake job and they ended up selling me an oil change, two new tires, alignment, an alternator drive belt, and two front engine mounts as well. When I picked up the vehicle late Friday afternoon, I noticed the power steering was making a whining noise and the steering seemed a little stiff. I took it back to Firestone Saturday morning, and they looked under the hood and said my power steering fluid was low, so they topped it off. That fixed the whining, but the steering still had a bit of a kink in it. They said it might be an air bubble in the line that would work itself out. Monday morning on my way to work, the whining was back and the steering very stiff and getting noticibly worse by the minute, so I took it directly back to Firestone.
It turns out the rack and pinion is leaking, and Firestone denies that it could have happened while they had the vehicle. The manager I spoke to said "all we did was replace a couple of belts -- didn't even get near the rack and pinion." Well, that's not all they did, but if anything they did could have caused the current issue. I know there were no suspension or power steering issues before I took it in, and after I picked it up suddenly it's leaking fluid like crazy. What can I do or say to press my case?
Golf IV / Jetta IV :: 2001 VR6 - Power Steering Rack Replacement
I need to replace the power steering rack on my car. Mech wants 300+parts. I supply the parts. Is there a different rack for the vr6 VS the I4 jetta?
View 1 RepliesGolf IV / Jetta IV :: Traction Control Light On After Replacing Power Steering Rack?
as the title indicates i had the pleasure () of changing out my leaking power steering rack - all seamed to go well but right after that i am now getting a constent traction control warning light on my dash - what should i check ?
View 3 RepliesCamry :: 2010 - Rack / Pinion Are Leaking
I took my 2010 Camry LE for its 70K service to the mechanic to find out there is a leak in the rack and pinion. The tech said that this might happen due the wear and tear as the seal might get eroded or so. He showed me the leaking part and interestingly I never found any oil leak on the garage floor until the day. Anyways I just got the basic powertrain warranty on my camera so will have to take the repair costs on my own. They suggested replacing the rack and pinion with a quote of $1.4K (out the door which includes tax, labor and wheel alignment etc). Not sure if its a rip off being a novice in the auto field. Now my question is, is there a way to get this leak sealed or should i go for the replacement of rack and pinion? Also is it dangerous to drive around in the car which has this leak?
View 4 RepliesDodge - Caravan :: 2005 - How To Replace Rack And Pinion
How do I replace the rack and pinion in my 2005 Dodge Caravan? Looking for a step by step. Id much rather do it myself.
View 1 RepliesEclipse - Mitsubishi :: 2003 - Creaking Noise Out Of Rack And Pinion
I've been getting a lot of noise out of my rack and pinion in my 03 Eclipse. What would cause this noise? It happens when I'm sitting still, driving straight, or turning. It has gotten worse as the weather has gotten warmer. All fluid levels are good.
View 6 RepliesToyota - Sienna :: 2006 - Rack And Pinion Slow Leak?
We had our Timing belt& water pump replaced 5 months ago, due to maintenance book suggestion for our 2006 Toyota Sienna LE, 119,000 miles on her. Now there is a leak in the R & P.
View 2 RepliesToyota - Corolla :: Rack / Pinion And Valve Cover Leaking
I just had my oil changed and was told that my rack and pinion was leaking also my valve cover leaked I had the gasket change about a year ago an the leak is so slight it wont even show up in my dip stick, is it possible the valve cover leak is getting on the rack boot. Also can I change just the boot car has 15000mi in great shape an well maintained.....
View 7 RepliesFord F-150 (2004-2008) :: 2007 - Clunky Sound On The Rack And Pinion
My son has a 2007 Ford Truck F150 1/2 ton P/U 4WD 5.4L , when he turns the steering wheel left and right you can hear a clunky sound on the rack and pinion right where the steering shaft connects.
View 2 RepliesLexus RX 2010-15 :: Riding Rough And Vibrating At Highway Speeds After Rack And Pinion Repair
I have a Lexus RX 350 and about a month and a half ago I got the rack and pinion replaced. Pretty shortly after, as I was driving highways speeds somewhere in the 60-70 range, it started to feel a little rough, as if I was driving over rough pavement, but it was brand new blacktop. I put the brakes on and the vehicle started to vibrate, not the steering wheel though. After I braked, the rough sound and vibration didn't come back until a week or two ago, it's been happening intermittently and very seldom, maybe has happened a total of 5 or 6 times, but I'm concerned because it never did this before the rack and pinion. I got it all done on a Saturday, alignment was involved too, so I wonder if maybe someone hurried themselves and didn't do something to protocol.
View 2 RepliesJetta - Volkswagen :: 2000 - Steering Rack Keeps On Failing - Coolant Leak?
Here are my questions.
1. What can cause repeated steering rack failures, which I am trying to dianose?
2. I found yellow spots in the snow that would come from the center of the vehicle (as opposed to near the wheels), could this be from the coolant system?
If you got that far, here is the relevant history. My wife drives my 2000 Jetta, its a nice car with repeated problems. One such problem is with the steering rack. 1. The steering rack failed in 2006, it was an expensive fix. It was leaking for a while, but I just topped off the fluid every couple of weeks. 2. Within a year the steering rack failed again, it was still under warranty. 3. 2 years later, the rack failed for a third time. I wrangled with the shop and they agreed to reduce my price for the fix even though the part was no longer under warranty. They had the car for a week trying to diagnose the problem, they said they found nothing out of the ordinary. I took the car to another mechanic a week later for some other issue, and he saw leaking from the fill plug--back to the dealer again. They said they cleaned the washers around the plug to fix the problem. No problems since then. Now its almost two years later and I have found a couple yellow spots in the snow, although near the center of the car and not near the wheels. This makes me think it may actually be a coolant leak, but I don't know right now.
Ford Transmission :: Vibration Occurring During Deceleration - Pinion Shaft Play
I had some vibration occurring during deceleration and though it was either the slip joint or the rear u-joint because I could sense some movement back there.
After I replaced the u-joints and properly serviced the slip joint I still had the issue (although it was a little better). I now see that there is a little bit of play in the pinion shaft. I can't really shake it back and forth, but if I hit it hard upward it clearly has play.
What should I do next? I have read a bunch, but would like to get an expert to chime in.
Golf IV R32 :: Replacing Power Steering Rack
My main concern with this replacement job( I am not doing it), is that the R rack is different that the standard golf rack. is that so?
I have a very good friend and excellent mechanic who said "...it's the part number it gives me." which makes me nervous. I don't want a "less sporty" steering feel.
so are the racks the same? what part number it should be I am having a hard time finding it.
Ford 6.0L Power Stroke Diesel :: 2003 F350 - Drive Shaft Noise / Rear Pinion Seal Is Leaking
I was getting ready to replace the carrier bearing and noticed the rear pinion seal is leaking. Before attempting the replacement myself, I would like some opinions on the noise in the video below. Is this normal? I am confidant I can replace the carrier bearing and pinion seal, but not sure I have the tools for anything else.
YouTube ...
Golf IV / Jetta IV :: One Of High-pressure Lines On The Back Of Rack Has Rotted Out?
One of the high-pressure lines on the back of the rack, close to the exhaust, has rotted out. It was smoking as it leaked right under the exhaust pipe and burned off. The rest of the freshly filled fluid was all over the ground. I crawled under and got a good look at the high pressure line, but where to source these, and if they are even replaceable? I have not tried to remove it yet, but perhaps a shop could bend a new one as a cheap alternative to a new rack. I was also thinking of checking out the pick n pull for a line.
View 2 RepliesGolf IV / Jetta IV :: N75 Valve Connection - Boosts Inconsistently
I bought a Jetta 1.8t few month ago and a hose is missing on the n75. The car run great but it boosts inconstantly (someday it boost at 16 psi peak and another day it doesn't pass 10 psi). Today I bought a hose that I connected to the turbo inlet pipe and now it never pass 10-11 psi. Did I do something wrong? Or my car isn't chip and the previous owner did that to increase the boost?
[URL]
[URL]
I connected the hose there ....
Golf IV / Jetta IV :: How To Remove Heater Core Hose Connection
I have a new hose I need to install because the one on now is cracked... I have pulled the metal clip down, but how do I remove this so I can install the new one? I don't want to break anything else yanking on it too hard.
View 5 Replies