Golf IV / Jetta IV :: 2003 - Throwing P0113 Code?
I have a 03 GLI 24v VR6 thats throwing a P0113 code, which is for the intake air temperature sensor. The sensor is part of the MAF sensor, ive tried 2 brand new BOSCH MAF sensors yet the same check engine continues to reoccur. Is there anything else that oculd be triggering it to come on? Is there anyway to bypass/disable it through vagcom?
View 8 RepliesGolf IV / Jetta IV :: Error Code P0113 - Intake Air Temp Sensor
My 2003 Mk 4 Golf have had a lot of error codes and I have cleared most (O2 sensors, thermostat, and Mass Air Sensor) I now have an error P0113 which is the Intake Air temp Sensor.
So I need to clean the sensor first then maybe replace it, but I can't find the sensor on the intake manifold.
I have looked all through the U-Tube info, but nothing matches my 2003 Golf 2.0L ...
Golf IV / Jetta IV :: 2003 - Error Code P0113 / Intake Air Temp Sensor
My 2003 Mk 4 Golf have had a lot of error codes and I have cleared most (O2 sensors, thermostat, and Mass Air Sensor) I now have an error P0113 which is the Intake Air temp Sensor.
So I need to clean the sensor first then maybe replace it, but I can't find the sensor on the intake manifold.
I have looked all through the U-Tube info, but nothing matches my 2003 Golf 2.0L ....
Golf IV / Jetta IV :: Rattle Coming From Back Of Engine Near Intake Manifold When Rev A Little
I have a 01 vr6 mk4 gti. When I bought the car I noticed a rattle but never paid mind to it. But now I just want it fixed. I hear the rattle come from the back of the engine near the intake manifold when I rev it a little. The most rpms the louder the rattle . I been doing some research and came to a conclusion that it could be the shift rod and bad intake bushing. But, I'll like a link on how to replace the shift rod.
View 5 RepliesGolf IV / Jetta IV :: P0171 Code Come On - Tapping Noise Coming From Engine
P0171 system to lean.
I already replaced the MAF so what else could it be I cleared it once and the cel came right back on. I have a stasight pipe from the catback on my car and the cabin started smelling like burning plastic and eggs every time I accelerate. I'm going on a road trip tom and was wondering if I'll be fine. The car has a bit more noise coming from the engine the usual more like a swiping tapping noise
Golf IV / Jetta IV :: Door Light Comes On - Dings Constantly
so it started like a month ago my door light would occasionally come on for no reason now it's to the point where my door light is always on and it constantly dings, i know its the door lock module but is there any way to tell which door? it might be the trunk and also is there a way to temporarily fix it soi don't drive my car into a tree from being so annoyed.
View 4 RepliesGolf IV / Jetta IV :: 2001 - Cooling Fan Constantly Running?
I've decided the first issue w/ my new-to-me jetta I want to focus on is the cooling fan constantly running. I suspect this is potentially related to the temp gauge not reading anything, which I suspect might be because of the coolant temp sensor.
So basically, when I turn the key to on (I'm pretty sure it's on, not start), one of the cooling can comes on. It's the fan on the right side as if you are sitting in the driver seat. I've been looking at the wiring diagram for this issue as well, and the only other thing I can think of that isn't a computer involving issue would be the thermo switch. But it seems like both fans should be coming on in that case, and it's definitely only the one fan that is coming on.
Santa FE SM (2001-06) :: 2003 2.7L Engine P0113 Error Code
So the check engine sign came up on my car and using the OBD it tells me the error is P0113. After googling the information, it looks like I have an issue with IAT sensor.
I opened the air filter and what I believe what could be the sensor and there was nothing clogging up, so I'm assuming the sensor needs to be replaced
Question is where is the IAT sensor located and how do I dis-assemble it so I can replace it. Is it the piece that is located just before the air filter?
Golf IV / Jetta IV :: ABS / Traction Control And EBrake Flashing Constantly
I just recently replaced all timing chains on a 2000 VR6 jetta, all is working great but now I have an ABS, traction control on and ebrake on (flashing) constantly. Did I miss a ground somewhere? the only one I know of was from battery
View 3 RepliesGolf IV / Jetta IV :: Brake Light In Cluster Constantly On With Beeping
I started the car one morning after it snowed. the red "BRAKE" light is constantly on and while the car is moving it beeps which is extremely annoying.. I have tried:
-Topping off brake fluid
- another ebrake sensor (under the center console)
- brake pads have plenty of meat on them
- brake light are working
Golf IV / Jetta IV :: AEG Engine Constantly Stalls While Driving - No Diagnosis
2000 Jetta, 2.0 AEG engine with 220k miles, recently started intermittently stalling (about 15-20 minutes into my trip) while driving mostly on city streets but has also stalled on the freeway at 65mph. Fuel level is always > half full, verified against my tripometer. When it stalls, engine completely cuts off, all dashboard lights are all lit, and no power steering.
I have VCDS but know only enough to be dangerous My mechanic has no answers and I don't want to randomly throw new parts at this the car, hoping to resolve the problem. It's becoming seriously dangerous to drive, knowing it will die at least once on every trip. What's the chance the oxygen sensors need to be replaced ?
Symptoms
(1) Most of the time the engine just turns off, as if I turned off the ignition. Other times, I can catch the engine RPMs drop to ~300 and just hit the gas, which sometimes saves car from stalling.
(2) Immediately after it stalls, there is is rotten egg smell.
(3) Once stalled, the engine won't start back up again for at least 5 minutes. (turns over, but doesn't start)
(4) Confirmed error codes from VDCS: misfires on all cylinders and random
(5) Took it to my mechanic for diagnosis. They were unable to duplicate on a road test. Smoke test showed no vacuum leaks, road test monitoring data did not capture any additional faults, and found no faults running it heat soaked and parked. They captured sensor signal data and found no abnormal patterns. They feel replacing the O2 sensors is an expensive guess.
(6) Replaced the crankshaft position sensor after the car would not start at all, one morning. (discovered that the CPS tested at a faulty ~50k ohms). Bought a new one, installed it and it turned over immediately but the stall issue continues)
Fault Codes
Code:
18057 - Powertrain Data Bus
P1649 - 35-10 - Missing Message from ABS Controller - Intermittent
16684 - Random/Multiple Cylinder Misfire Detected
P0300 - 35-10 - - Intermittent
16685 - Cylinder 1
P0301 - 35-10 - Misfire Detected - Intermittent
16524 - Oxygen (Lambda) Sensor B1 S2
P0140 - 35-10 - No Activity - Intermittent
seen separately
Code:
16517 - Oxygen (Lambda) Sensor B1 S1
P0133 - 35-10 - Response too Slow - Intermittent
Note that I have been ignoring the ABS-related errors for 4+ years. (not a concern or priority). On the short list are ignition coil or crankshaft sensor. Both of which require my mechanic to replace, I think.
Lexus GX 2004-09 :: Code P0113 / P0113P Appeared - Cannot Find Reason
I've been getting these 2 codes (P0113 / P0113P <--?) for a few months now. I know what P0113 means but I've never heard of P0113 P?
Ive cleaned the MAF w/ CRC MAF cleaner. Ive swapped out MAFs and I still get the code every week or so. I ordered a new gas cap & gasket but it seems to tighten fine so I dont know.
Is there anything else I can check?
The GX idles fine, even with the CEL light on. No weird noises or anything else wrong that I can see / hear / feel other than the still 11-12 MPG I'm getting.
Elantra XD (2001-06) :: 2003 - CEL Code P0113 / IAT Sensor High Input
So my mom recently bought a 2003 Elantra (75K miles, auto trans) and within a few days the CEL came on. She took it in to PepBoys and had them hook it to their scanner to get the codes out of it. The only code that came up was P0113 Intake Air Temp (IAT) Sensor high input. I've done a little research on the net but there is a lot of random info for this code out there. Is the IAT a separate sensor or is it combined in with the Mass Air Flow (MAF) sensor(if this car even has a MAF) or combined in with the MAP sensor? I've read on the net that it could be any of these 3, I think it's combined into the MAP.
I've also read that this code could be caused by a bad IAT, bad O2 sensor, an exhaust leak, bad wiring/ground(I checked the wiring/grounds visually and everything seems ok) or many other things. If it's as simple as replacing one of the sensors I can do that myself, I just don't want to go randomly buying things and either it be the wrong part or have it be the right part but not fix the problem. The car runs great, even with the CEL on. Yesterday when she stopped by my house I disconnected the battery for a couple minutes and reconnected it, started the car & no CEL. She drove the car for about 125-150 miles before the light came back on.
Golf IV / Jetta IV :: EBrake Light Staying On Constantly / Loss Of Power
Where to begin, I've checked things i thought could be the issue but aren't. I am having a constant e-brake light on which as you know emits the loud and annoying beep sound. What I've checked and done:
I checked the brake fluid, its fully topped off. I also removed the ebrake switch (the thing under it that when depressed pushes the button and turns the light off) and just crossed the wires to complete the circuit (this does the same as the button essentially) before buying a new one to see if that was the issue, which is doesn't seem to be. I had my buddy run vagcom which turned up no codes that SHOULD make this issue occur. I even popped in a new brake light switch which didn't work.
At the same time of this happening my car is making ZERO boost at all. Is it a coincidence? I don't know... it's just weird they would both happen at the same exact time. Again, no codes are showing up. Checked lines and didn't see any potential boost leaks. What to do.
Santa FE SM (2001-06) :: 2005 - P0113 Code After Spark Plugs And Coils Replacement
Just replaced the spark plugs and coils yesterday, today it gives P0113 code, Intake air temperature (IAT) sensor - high input Wiring open circuit/short to positive, ground wire defective, IAT sensor, ECM...
View 3 RepliesGolf IV / Jetta IV :: 2002 GTI 1.8T - Unknown Fuse Blowing Constantly When Engine Starts
I have a 2002 GTI 1.8T with the AWP engine and tiptronic. There is a fuse in the picture below that blows as soon as the car is started. It is located next to the brake booster on the firewall. It does not blow when the ignition is turned on, just when the engine actually starts. I'm not throwing a check engine light, pulling a scanner code or noticing any of my electronics not working. I took a 20 AMP fuse out and replaced with another 20.....and have since blown 5 of them trying to diagnose the problem.
View 10 RepliesElantra XD (2001-06) :: 2003 - Intermittent Check Engine Light And Error Code P0113
I have a 2003 Elantra GLS. I am intermittently Check Engine light and error code is P0113 - Air Intake sensor issue. I can't locate where the sensor is. I don't see any wire coming of the tubing that connects the air filter to the engine.
View 18 RepliesFord - Windstar :: Code P0113 - Intake Air Temperature Sensor 1 Circuit High Input
Check engine light is on, this is the code that came up when checked at OReillys, "P0113 Intake Air temperature sensor 1 Circuit high input". Earlier took it to repair shop, he did not give the code, some sensor needs to be changed (don't know if he came up with same code). He had erased the code but it came back on within minutes. Wanted to check if there is any cheaper way to fix this. This is a windstar van.
View 15 RepliesFord Super Duty (1999-2016) :: F250 - Rough Idle And Code P0113
I have a 99 f250 5.4l 2v with 165000. just two weeks ago i went to start up the truck on a job site to take lunch and it was running really rough. I talked with a mechanic at my shop and he said that it sounded like the aic or that i needed plugs. I went and bought aic and plugs and installed them all in one day. I unhooked the battery before i did any work and have changed the coil packs about 3-4 months ago when it was jerking at highway speeds. I am at a loss.
Read so much on the site about could be this or that and cant afford to through money at it like the govt does. I replaced the ait(air intake temp sensor) and the ect(engine coolant sensor) after i got a code from oreillys that said p0113 which is high input on it. I have read it can be so many things and it seems to be running rich because i am getting about half of mileage i was getting before problem started. i need a fix soon as i must drive the truck to work everyday which is a 52 mile trip total.