Golf/GTI VI :: First And Second Gear At Low RPMs Are Jerky?
I have been noticing that my GTI seems jerky (head bobbling) at low CONSTANT speeds on the highway during my morning commute. For example if I leave it in first and get the speed constant at 10-15km at 1,000 - 1,500 rpms I feel the car to be jerky. Even at low speed/rpm gear changes (1'st - 2nd). Anything past 2,000k RPM is fine though.
Is this normal? Or should I bring this up with my dealer and have them take a look at it. It's just annoying because I don't notice this in the city, just only in bumper to bumper highway driving at a constant low speed in 1st/2nd.
Golf IV R32 :: When Shift Into Second Gear RPMs Go Down Fast
So after my 500 mile break in I decide to see what my new set up is made of. Had the kinetics stage 3 and the south bend stage 3 clutch installed. Did my first launch...everything went great. Got just a little bit of spin and the car took off like a scud missile. Right as Im going to shift into second my Rpms go down fast. No weird noises no metallic sounds nothing. No fluid under the car. Only a slight clutch smell nothing crazy. Car wouldn't go into gear. Shut the car off and it goes into gear.
View 20 RepliesGolf/GTI VI :: 6th Gear RPMs For Manual Transmission
What RPMs do you see in 6th gear, say at 60mph or 80mph? Consumer Reports claims the RPM at 60mph is 3020!
So I went to vw.com to look at the gear ratios for a reality check. The site lists two final gear ratios for the manual. "Final I" is 3.94 and "Final II" is 3.09. When do you get one versus the other? With a final gear ration of 3.09, I get roughly 2400RPM at 60mph. But with a ratio of 3.94, I indeed get about 3000RPM at 60mph or 4100RPM at 80mph!!! That's absolutely insane.
Golf IV R32 :: Ticking Noise While In 1st And 2nd Gear At Low RPMs
Weird noise - searched .. couldnt find anything mainly because its kinda hard to describe it .. While in 1st and 2nd gear at low rpms while barely giving it any gas there is this "ticking" noise coming from under the hood .. it almost sounds like .. lets put it this way .. it sounds like a wire coat hanger .. tapping an aluminum can .. how about that .. I was told it is my flywheel bolts backing out and was a problem around 65-75k .. and I am at 70k at the moment... Should I just bite the bullet and get a new flywheel and if so ..[IMG] [URL] ....
View 6 RepliesGolf VI R :: Fuel Cut In 3rd Gear At 6500 RPMs
I got a fuel cut tonight in 3rd gear at 6500rpms. First time, 30 degrees outside. Carbonio the only other mod. Looks like I need a HPFP next.
View 24 RepliesGolf IV / Jetta IV :: 2003 - Hit 7k RPMs In First Gear - Rev Limiter?
I was driving earlier and some dickhead wouldn't stop tailgating me. I brake checked him and he wouldn't back off so I got pissed and floored it. Didn't watch my rpms and I felt it give like I hit a rev limiter maybe? I'm hoping that's what it was, it was like an instant loss of power for a brief second. Just was curious that I didn't brake anything. Driving a 2003 Jetta 1.8t. Manual.
View 13 RepliesGolf IV / Jetta IV :: No Engagement In Any Gear And Very Loud Clicking That Changes With RPMs
I have a 24v GLI with the O2M 6-speed trans. This morning while leaving for work I accidently let the clutch out while in gear and my e-brake still on. Heard a really loud bang and the engine didn't stall out (which it should have). Now I have no engagement in any gear and there is a very loud clicking that changes with RPMs. Did I blow the CV joint, or is this something much worse (blown diff, destroyed clutch, etc.)??? I'm border-line freaking out!
View 9 RepliesGolf IV / Jetta IV :: Hard Shifting From 1st To 2nd Gear Depending On RPMs
Car in question is my 2003 Jetta 1.8t with the 09A 5 Speed Automatic. For the past 2 or 3 months these have been the symptoms: 1st to 2nd gear, very hard shift depending on RPM's (Higher the RPM's the harder the shift) 2nd to 3rd gear, not really hard but it kinda 'flares' the gearbut still shifts. All other gears are fine, although if you accelerate hard out of 4th it will have a little bit of a hard shift. I'm thinking either solenoids, or the speed sensor?
View 1 RepliesGolf V R32 :: Resonant Metallic Buzzing From 4800 - 5000 RPMs In 3rd And 4th Gear
My CW R has 12k of combined mileage primarily in D/S with some aggressive Topanga Canyon driving in M. While sprinting onto the 405 the other night a resonant metallic buzz/vibration was audible between 4800-5000rpms in 3rd & 4th gear! The sound is coming from below the shifter console area. I can't reproduce it in any other gears or rpm range.
View 3 RepliesGolf IV / Jetta IV :: 3rd Gear Will Grind When Driving For More Than Half An Hour / Over 2800 RPMs
I noticed through careful investigation that my 03 GTI 1.8T (180,000 KM's or 111,850 miles) will grind 3rd when in these conditions:
1. When the car has been driving for more then half an hour and everything is hot
2. When the car is over 2800 RPM's while hot (ie. getting on a highway)
Now I know lot's of people blame syncro's and yes I could see that my car has had 8 previous owners so I can't say they all shifted perfect. But what I do know is that when I downshift from either 4th or Neutral it will never grind even when I don't Rev Match or "Blip" the throttle. So it can't be syncro's in my opinion.
So what I've done to the car to rule out some problems were:
- Change the gear oil from what ever it was before to Royal Purple 75W-90 (NO luck.)
- Then I added a short shifter and adjusted my cables properly (still No luck)
- Finally I noticed my shifter was sloppy and one of my bushings were torn so I bought 42 DD's metal bushings and the shifter did stiffen up a lot, however!!! (No luck)
I know it's not my driving technique because I watch my foot depress the clutch fully and then I gently push it into third. I also know I'm shifting correctly because I can double clutch and normally shift through every other gear properly without any grinds or clunks. Just the devilish 3rd gear.
I would like to hear the solution. I'm going to change the oil one more time to Redline MT-90 and see how that goes, but if that doesn't work I might just tear apart or get a new tranny.
Golf IV / Jetta IV :: Losing Boost / Power At High RPMs In High Gear
2003 jetta gls 1.8t 5spd - gts stage 1 tune(gonzo stage 2)
tt 2-1/2" downpipe with high flow cat
turbo smart splitter valve(set to divert only)
turbo inlet pipe
homemade intake with k&n filter
stock n75 valve (f)
So in first through 3rd gear my car gets 20psi of boost then at 3,500 ish rpm smoothly starts to lower down to 15psi. but in forth and 5th gear the boost drops faster, enough so the diverter valve actually opens. then the boost will bounce up and down, around 15psi. the car still accelerates but with obvious power loss.
Is my diverter valve not "firm" enough? it is adjustable, so I've tightened it as much as it can. it doesn't seem to change anything. it came with spring spacers to make it tighter, but I haven't tried that yet.
Is it something with the tune? not enough fuel, need bigger injectors? The problem is only at about 100mph, so its not a big deal. I would like to get it straightened out if possible.
4Runner/GX470 :: Low RPMs In 5th Gear / Won't Rev Over 2500
The son inlaw just bought a 86 4runner. It's been beat pretty good but I know Toys are good for it. My question is, it rev's just fine in every gear but 5th. Going down a flat highway and in 5th it won't rev over 2500 no matter how much gas ya give it. It has a 22re and 31-9.50's under it. My daughter had a 86 p/u with a 22r (I believe) and 33-10.50's and it had no problem hitting 90. Is there a limiter on these things? Thought i'd ask before chasing vac lines.
View 2 RepliesCivic - Honda :: 1989 RPMs Will Never Get Above 2000 In 1st And 2nd Gear
RPM's will not get above 2000, in 1st and 2nd gear. No power....
View 16 RepliesAccent MC (2006-11) :: Rough Shifting From 1st To 2nd Gear In Low RPMs
My 2009 Accent has some very rough shifts from 1st to 2nd when I'm in the low RPMs.
Hyundai performed a transmission fluid flush and the other gears shift completely effortlessly. Is my tranny dying or what?
Elantra XD (2001-06) :: Spongy Gear / Idles At 900 Rpms
I have a 05 Hyundai Elantra 2.0L engine(Manual) thats been acting funny. There's a couple issues im having with it.
1. Not matter how far the gas pedal pushed down RPMs wont go over 2,500
2. Car surges and jumps back and fourth sometimes.
3. Idles around 900rpm
4. Sometimes when I take off I'm able to get around 40 mph, and thats where it tops out at.
5. Shifting into 1st gear feels a little spongy
6. Also it can go all the way into 4th gear without dying and the top speed will only be at 10mph
Things I've done so far.
1. Compression test cylinders all came back fine
2. Replaced TPS
3. Checked to make sure exhaust wasn't obstructed
4. I got a stethoscope and listened for the ticking for the fuel injectors and also got some fuel injector cleaner.
Elantra GD (2013+) :: RPMs Too High - Cannot Shift Into 1st Gear
Purchased my 2013 Elantra GT a few months ago and have been having a problem that had stumped everyone at the dealership. Thought I'd see who else is having it and what the thoughts are. To start, this is a 6SPD Manual Transmission.
Problem: Say you're at a stop and begin accelerating in 1st gear and then shift into neutral because you have to come to a stop again. When operating normally, the RPMs immediately wind down to idle. Well for me, about 15% of the time or more, the RPMs will take up to 10-15 seconds to wind down to idle. During this time, you cannot really shift into 1st gear because the RPM are too high.
The dealership has been working on this issue since last month. They replaced some parts and it is still doing it. They got diagnostic data and told me the throttle was sticking. No one could figure it out. Engineers got involved from regional, and it got pretty heavy as far as time. After several attempts at figuring out the problem and replacing things (which didn't resolve the issue), the engineers drove another new GT and found it was also doing it. So all of a sudden they said "it's normal" and closed the case.
Chances are, if other new ones are doing it, so is yours. I got second opinions from other auto shops who said it is not at all normal and that there may be a defect in the design. I've owned 4 Manual Transmission cars and I have never seen this before. If you're curious and have the 6spd manual version of this car, the easiest and quickest way to see this happen is accelerate in 1st gear to about 4000RPM and shift into neutral. Eventually, it'll get stuck and take a significantly longer time for the RPMs to return to idle. Usually when it finally happens, it'll keep doing it for several subsequent acceleration cycles.
Santa Fe (DM - 2013+) :: Tranny Slipping In 1st Gear At Around 3k RPMs
So dont know whats going on, but after my santa fe sat for a day, I went to go for a drive and when I left the house, the tranny slipped in 1st gear at around 3k rpms. The rpms just shot up, hammered into 2nd, then drove off as normal.
I couldn't get it to repeat it after that.
Facts:
-Car in eco mode
-Car sat for at least 24 hours
-Outside temp 70F
-slippage happened on takeoff at 3k rpm
-No CEL's
-around 11500 miles
What it could be? Should i take it in to hyundai? OR wait and see how it drives the next couple days.
Passat (B5) :: V6 Auto Only Goes 20 MPH And RPMs Hit 8000 - Stuck In 1st Gear?
Car can't go above 20mph and the tach hits 8000RPM. Looks like the tranny is not getting out of 1st gear. No dash lights are on to alert errors.
View 4 RepliesCelica :: 2000 GT - High RPMs On Highway When Going Around 70 To 90 Miles On Fifth Gear
I have a 2000 GT with over 120K miles on it. The car works perfect, just a minor issue with O2 Sensor that I am going to replace soon
My question is, when I'm on the highway going around 70 to 90 miles on fifth gear, her RPMs are about 4K to 5K, is that normal??