GTI 337/20th Anniversary :: High Pitched Whirring Sound And Rattling Coming From Engine Bay
My 337 didn't pass inspection (control arms, inner tie rod, no cat because the guy I bought it from sucked etc) but it sat for probably 3 weeks and I just sold my other car (I was planning on using that $2000 to get the 337 to pass inspection) but I just drove the VW down the street for the first time and it's making some scary sounds.
Basically when I give it throttle there's a high pitched whirring sound and something keeps rattling that sounds like its coming from the engine bay. I'm really freaked out, I'm leaving in two months because I'm transferring to a new college and I need this thing to run perfectly.
It's also shifting a little strangely and if you don't shift absolutely perfectly then it starts to rattle (not like you're about to stall but something completely different) I can't take it to a VW dealer or anything because I'm way over the 15 days past a failed inspection and I can't afford a tow.
GTI 337/20th Anniversary :: Odd Sound Coming From Right Side Of Engine?
So my 1.8T GLI is making an odd sound that sounds like it's coming from the right side of the engine. Sounds like a busted bearing of some sort. Not too keen on this engine yet...
View 4 RepliesGTI 337/20th Anniversary :: Clutch Pedal Went Soft?
We were headed home the clutch pedal went soft... Ok, I thought it's either the clutch master or slave. I get it home and replace the master and after bleeding I had good pedal feel.
Great I thought, I got lucky and it was only the master. Drive it around for a bit and get on the highway and just as I was about to downshift the pedal went flat to the floor again.
Well after pumping the pedal until it had good feel again I got it home and bleed it a couple more times just to make sure I got all the air out. Drove it again. Same thing, after a little while the pedal gets soft again.
Now before I go and replace the slave is it possible I have a faulty master? Having issues after replacing the master?
GTI 337/20th Anniversary :: Clutch Pedal Is Soft At First And Then Gets Harder
I keep finding air every time i bleed my clutch. I am not losing fluid but i can not figure out whats causing my problems. The pedal is soft at first and then gets harder and it sometimes needs pumped before i change gears or to even get into gear. I am afraid its the slave but i also just may have air in the system.
View 8 RepliesGTI 337/20th Anniversary :: Sudden Low Boost - Soft Limp Mode?
Preliminary info:
APR 93 tune
Carbonio Intake
Silicone TIP
I picked up my 20th today and drove it 4 hours home. It has 74k on it, original timing belt. The timing belt kit is in the mail on its way here. Its the first thing I'm doing.
As I was driving it home on the autobahn doing about 150k/hr and I gave it half throttle to pass, I felt the turbo spool and I accelerated past the car. However, when I went to make the next pass, it felt like I had no power. I feathered the throttle a bit and it felt like my car was only getting maybe 3 PSI of boost. Very little actually. I do not have a boost gauge so I can't really say it accurately. As I was driving, i shut the ignition off and turned it back on. After that, I was able to get full pressure back.
GTI 337/20th Anniversary :: Clutch Soft In The Cold, Stiffens Up When Warmed Up
20th with 120,000 miles. Ok here's my problem, get in my car in the morning after a coldish night, (around freezing) clutch pedal goes almost to the floor with no resistance, i pump it a say 5 or 6 times and it gets stiffer but not 100% i drive it for 10 or 15 min and it warms up and the clutch gets back to normal stiffness. I'm thinking its the master or slave cylinder going bad or maybe it just needs to be bled and before i go and buy both of them and replace them, just wanted some opinions. Also its not leaking fluid at all and the reservoir is full.
View 2 RepliesGTI 337/20th Anniversary :: Clutch Pedal Goes From Being Soft To Very Hard When Close To Disengaging
I have an Imola 20th and recently i have been having some problems with my clutch. The pedal goes from being soft to very hard when its close to disengaging. It also engages very heavily when I go to let it out. This only started happening recently when temperatures started to drop if this has any effect on a clutch. Also, I replaced a shift fork two months ago and was curious if there was possibly anything going on with seals around the slave cylinder.
View 2 RepliesGTI 337/20th Anniversary :: Clunking Sound Coming From Under / Around The Feet
For a couple of weeks, when i put my car in reverse and also sometimes in first, I hear a weird clunking sound coming from under/around my feet when i release the clutch and start taking off....is the clutch gone or going soon???
View 5 RepliesGTI 337/20th Anniversary :: Rattling Sound Coming Below The Handbrake
I've been trying to locate the source of the noise that is coming under the car. Specifically below the handbrake. Like something is lose, took the car to a shop to have it inspected, checked the exhaust, and there was nothing there, all clamps there and screws.
It only happens most of the time when the car is cold and it feels all the way from the hand brake to the stick shift. Sounds like a rattle like something is about to go off from the car but I cant imagine what could be. Couldn't replicate the noise at the shop, only when you are driving and the car is in inclined it rattles really bad until the car gets back to the normal position. Specifically in 1st gear .
GTI 337/20th Anniversary :: 2004.5 GLI - Constant Air Hissing Sound Coming Into The Cabin
I installed a Eurojet "Street" FMIC on my 2004.5 GLI a few weeks ago and ever since there has been a constant air hissing noise coming into the cabin. The noise has proven to be tricky to diagnose. It is loudest inside of the cabin and isn't audible under the hood. I boost leak tested the system and didn't find any obvious leaks. The sound doesn't appear to be boost related.
I don't seem to be loosing performance. (I've read a 2-3 psi drop is normal after FMIC install) The sound is constant and is faintly detectable even at idle inside the cabin. The sound's volume is dependent on the RPM's the engine is turning. The sound is constant whether the engine is on boost or vacuum. I can't explain this. My car isn't throwing any CEL's at all.
My mods are Revo Stage 2, 4 Bar FPR, 42dd TBE, Hyperboost DV, FMIC.
GTI 337/20th Anniversary :: Whining Sound That Is Going Along With RPMs Coming From Belt Area
Ok, so there's a whining sound that is going along with my RPMs, that is coming from the area of my belt, obviously i think its the belt. I am also leaking a little anti freeze. What this could be.
View 5 RepliesGTI 337/20th Anniversary :: Clunking Sound Coming From Driver Side Front End
We purchased her GLI a couple of months ago, as is, knowing the issues it had and whatnot. We talked the dealer down so much that he refused a warranty.
This pesky *clunk* sound coming from the driver side front-end. Usually on bumps, it sounds like a suspension deal... We took it into a shop, they "re-torqued" the suspension, and did the alignment. It was good for about a week, then it came back. Also, there's a creaking sound when turning, my guess is CV boots? Axles?
[IMG] [URL].....
GTI 337/20th Anniversary :: Nasty Sound Coming From Front Driver Side When Turning Or Going Straight
I originally own an mk4 r32 but my friend owns a 20th.. He recently lowered his car about an inch or 1.5 of an inch he might have a finger gap.. He is on jam coilovers all the way down in the rear and about 20 threads left up front.. There is a nasty sound coming from the front driver side when he is turning or going straight.. he still didn't do an alignment idk if that matters.. and he also miscounted the threads so his driver side is about two threads higher but he fixed that now.. he also doesn't have camber plates up front does this matter?
View 3 RepliesGTI 337/20th Anniversary :: Huge Clunk Sound Seems Like Coming From Under Driver Side Motor Mount
I was sitting at the stoplight in neutral when the light turned green. I pushed in the clutch and put the car in first then all of a sudden a huge CLUNK like when you take out the starter bolt without supporting the trans or motor. Then while letting out the clutch about halfway all hell broke loose. It sounded like a bunch of marbles rattling like crazy in the trans. I pushed the clutch back in then it stops until you let it back out again. The car still moves forward and reverse but with all that noise. The sound seems like it's coming from under the driver side motor mount. When I put my hand on the tranny I can feel the vibrations very well. Does this sound like the throw out bearing?
View 3 RepliesGTI 337/20th Anniversary :: Smoke Coming From The Engine
Car was started for the first time after the radiator was flushed and new coolant was put on it. The car was just jumped and charged after was brought from a copart auction. Now my brother said that everything looks smooth, no xxxmas tree in the dashboard, idle is steady, engine sounds good.
Now here comes the thing, the temps of oil and water are at a proper level. When he steps on the gas pedal a few seconds later there is some sort of smoke coming out from the back of the engine (exhaust manifold, turbo, intercooler stock pipes from the SMIC) My question is cause he's not a mechanic and he will arrive tomorrow. crack manifold, shot turbo or some leak in the hoses?
aBtw the car has 105k miles.
Sonata NF (2006-10) :: Whirring Sound Coming From Right Side And In The Engine Area
I have a 2007 Hyundai Sonata 2.4l GLS. Staring to get an little noise from the engine about a few days ago. The noise what can only describe as a whirring sound and while in the cabin it sounds like it's coming from the right side and in the engine area, especially after a cold start and during acceleration. It is not very loud(have to turn stereo off to hear it and it only last for a couple of seconds as far as I know. My car now has about 240,000kms on it, and since the noise is coming from that area I am guessing it's a pulley of some sort. Serpentine belt was changed last year. What this noise is? I was thinking it might be the belt tensioner, probably should have changed it during my belt change.
View 1 RepliesGTI 337/20th Anniversary :: Strong Gas-like Smell Coming From Engine Bay?
I recently had a turbo installed, everything went well, car runs very smooth considering having just upgraded the turbo. However, I keep noticing a strong smell coming from the engine bay. Kind of like a gas like smell or some chemical. At first I thought it was the loctite we used to put the gaskets in place burning off or the coating of the turbo but it has been a week and it still smells. I do not have a check engine light, my vacuum is right on the money, I am boosting fine, and my temperature gauge hasnt moved. What could this be? exhaust leak maybe?
View 6 RepliesGTI 337/20th Anniversary :: Chirping Noise Coming From Engine Bay
Have a noise coming from their engine bay that kind of sounds like a bird chirping, but when you depress the clutch, it stops?
View 10 RepliesGTI 337/20th Anniversary :: Slight Whirring Noise When Gently Feathered Gas To Maintain Highway Speed
Middle of May, I went to Boston. On the way there, I started to notice a slight whirring noise that was only present when I gently feathered the gas to maintain highway speed. If I were to apply any more throttle, the noise would go away, and if I were to pull my foot away and allow engine braking, it would also disappear.
So I did my best to finish the trip to and from Boston adjusting my driving to avoid the noise. Once I came home, I researched and thought the noise might have been my wheel bearings (I had just replaced lower control arms, lower ball joints, inner and outer tie rods prior to leaving for Boston). I also had a shop install my upper strut mount bearings and bushings simultaneously with the wheel bearings.
Since then, the problem still continues. It has grown louder, but still occurs under the same situations. I've focused more on it and here are the conditions under which it occurs:
1. Car must be warmed up. Starting it up cold and allowing SAI to run then driving, car is fine, no sounds. Usually takes 20-25 mins of driving to get it to start making noise.
2. Car still only makes the noise when the gas is being feathered (ie barely pressing it enough to give it any sort of throttle. It does also make the noise between shifts when reengaging the gear and applying gas, as the throttle pedal passes the point of throttle off to throttle on.
3. I'm hearing more noise now during engine braking than I had been previously. Could be related?