GTI 337/20th Anniversary :: Hardly Gaining Any Speed When Driving On Highway In 6th Gear

So I was driving on the HWY in 6th gear cruising at about 60, and I go to speed up and when my RPMS hit about 3k or over it feels like I am pressing in the clutch, like my RPMS are going up but I am hardly gaining any speed.

View 24 Replies

GTI 337/20th Anniversary :: P0172 - Hesitation When Start To Get Into Throttle

So my car is throwing a P0172 and when I start to get into the throttle, I get hesitation. I have replaced the plugs and the coil packs, and I tried unplugging the MAF which just made the car run worse. What could it be? Boost leak? Something else?

View 9 Replies

GTI 337/20th Anniversary :: 1.8T Cold Start Hesitation - Choking And Sputtering

Recently purchased a 2005 Jetta GLI with 31,xxx miles on it. It is my second 1.8T. My first was very reliable, with never any issues even after the 100k mile mark and is the reason I didn't hesitate to buy another one. That, and the Recaro Edition GLI has always been one of my favorite cars.

So I've had it for about a month now and I've noticed on occasion a problem with cold starting. One weekend it sat for almost two days because we used our other car, and then again this morning it was particularly chilly here in Pittsburgh, about 35degrees F and it took me two starts to get it going.

I always turn the key to 'on' for a few seconds and let the fuel pressurize and all the indicators light up. It doesn't appear to be the battery as it turns over strong, though I have not yet confirmed this is a Voltage reading. Once it kicks over, it seems to be choking or sputtering, unable to get up to idle. The second time, it does it again but gets past it and all is well...

I'm checking records now to see if the 30k mile service was completed. perhaps a tune up and new plugs would work?

View 8 Replies

GTI 337/20th Anniversary :: Car Died On Highway - Crank But No Start Or Spark

So driving on the highway my car died. It would crank but not start. Got it towed. This is what I have done to troubleshoot.

1. Swap ECUs. The car should start for a second and shut off because the car doesnt match with the ECU. Still just crank and no start.

2. Fuel pump still primes when I open the door. I also hear a weird air leaking noise when I reconnect the battery, but I think it comes from the fuel pressure regulator (which I think is normal).

3. Checked for current at the ecu wires, wasn't sure what to look for but it was getting numbers.

4. Battery had 12.1 volts running through it (Haynes said 12.5 but is that really much of a difference?

5. Checked spark plugs for spark. Pretty sure we did it right, but there was still no spark. We tried multiple times.

6. Scan car, get code P01314 twice (ECM error).

7. Try to clear codes, says Comm error.

Why am I not getting spark? and why is the ECU error occurring, because we tested with a new ecu, and there was still no start, not even for a second like there should be.

View 2 Replies

GTI 337/20th Anniversary :: Clunking When Just Start Out In 1st Gear Or Reverse

I just had my transmission fluid changed today and I have some clunking when I just start out in 1st or reverse. They told me my mounts are weak but not bad.

View 2 Replies

GTI 337/20th Anniversary :: Hesitation After Intercooler Install

Last week I had the Godspeen intercooler installed on my 05 Jetta GLI. I would say that since the install I have put about 300+ miles on the car so I would think that the computer has learned the additional air flow. I notice that if I'm cruising in 4th gear just below 3000 RPM's and punch it there is hesitation. It is quite noticeable because I have a full 3" inch exhaust so you can hear it hesitate for about a second and then kick in again and continue up the powerband. Do I need to get a good tune or has the computer just not learned it yet?

View 15 Replies

GTI 337/20th Anniversary :: Hesitation On Takeoff - PCV System Malfunction?

I have a 377 gti 2002 and just the other day i had some hesitation on take off. it sounded like the engine was cutting the fuel, at the time i had an o2 sensor code so i replaced the o2 and got new spark plugs while i was at it. it was still hesitating and cutting out so i figured it might be the maf because ive already replaced it once, i cleaned it and still doing the same things. i called my local vw/audi shop (audub) and he said it might be the pcv valve. i checked to see if there was air sucking in through the oil dip stick and the oil cap. its running just fine at idle and it seems that in first and second gear that its hesitating at 1000-2000 rpm and the higher gears are fine. could a leak cause this or is the pcv system bad?

View 7 Replies

GTI 337/20th Anniversary :: Bucking / Limp / Hesitation After Clutch Install

I took my car in for a clutch install, everything was fine except the clutch slipping. I go to pick up my car and once the car warmed up it started bucking / limp mode while accelerating. Take it back to the mechanic and he thinks he didn't reset the throttle body. So he says that should be it and I pull away. Same thing. Leave it with him again and he replaces with "diag" coils and new plugs. Leave again, same thing. He tells me to get totally new coils and try that. I am thinking its a missed ground cable or messed up ECU or something. During all this not one code it thrown.

20th GTI 1.8T 6 speed, stock clutch, all stock

View 14 Replies

GTI 337/20th Anniversary :: 2004 1.8T - Half Throttle Boost / Little Hesitation At 5 PSI

I have a 04' Jetta 1.8T (AWP) my mods are APR Chip (91octane program) Forge 007 DV, APR TIP, NGK spark plugs, catback exhaust. This issue I am having pretty much started when i got it chipped and I've got it reflashed and I've even talked to people at APR and they are saying that it couldn't be a software issue. Anyhow the problem I am having is at partial throttle my car kind of hesitates a little at 5psi and when i let of the gas the car kind of hiccups a little.. but if i really punch it in every gear i hit 21-22psi no problem, the problem happens when I am driving normal and its really annoying.

I have switched several different N75 valves, I am running the stock one now, I've switched different DV's, i have switched my spark plugs and even put at APR turbo inlet pipe and i have checked for boost/vacuum leaks, I have no CEL...all this hasn't resolved my problem.. I don't know what else to do..

I was thinking about switching my MAF to see if it works, but then again if it was my MAF im sure I would have a CEL. I also was thinking about putting my N75 valve backwards even the DV backwards to see if it works?

View 10 Replies

GTI 337/20th Anniversary :: 2002 VW Automatic Shift - Slight Hesitation When Slowing Down

I have a 2002 1.8 Turbo VW GTI. Lately I've noticed that the car would hesitate slightly when slowing down. It would go up to at least 5000 RPM's or higher before it shifted over. The hesitation when slowing down and accelerating tend to happen when I drive. What to do, I went to the vw company they said if i want to change the transmission would cost me ~6k$ and f*ck me twice if if am paying 6k on a 2002 car.

View 3 Replies

GTI 337/20th Anniversary :: Stutter During Acceleration On Highway

I was driving the other day and accelerated in 5th and the car stuttered before finally going- I got the flashing CEL. I figured that the car was misfiring and that a coilpack change was the culprit. All my coilpacks are fine and the sparkplugs look good as well. CEL hasn't come back, but the car just feels like it doesn't want to go right away when if i give it some gas when I'm going about 55-65 MPH.

Other guesses would be there is a fuel cut somewhere and that may be causing it?

View 6 Replies

GTI 337/20th Anniversary :: Temporary Power Loss On Highway

So over the past couple months when driving on the highway I would notice that sometimes my car would lose all power and slowly coast to a stop, but then the power comes back on and I'm off after a few seconds. It happened again today and I notice when I do hit the gas when it decides not to accelerate my boost gauge shows that there is vacuum building up in the engine. It just doesn't make sense to me. Would my car be getting thrown into a limp mode? Or is it something to do with fueling?

View 4 Replies

GTI 337/20th Anniversary :: 2003 Shaking When Driving On The Highway

I have a 2003 20th anniversary edition GTI. Yesterday I noticed my car started shaking when I was driving on the highway. The only thing I can think of that I did was run into a snow bank during the snowstorm. What is causing my car to shake?

View 2 Replies

GTI 337/20th Anniversary :: Clutch Stuck To The Floor On The Highway

50k Miles on my clutch. Was driving a couple weeks ago on the highway and clutch stuck to the floor. At first I thought it was my Slave cylinder. Got the trans out this weekend to find the mess (below) inside my bell housing. Obviously need a new clutch now and will still replace the slave while I am in there.

Cars setup is around 375ish whp. I know I could spend 1300 bucks and call it a day for a clutch master or south bend but was seeing if there is a cheaper alternative.

Also If I were to buy an OEM clutch or an upgraded one that was not rated for up to 400~whp would it drive and pull the same as a fully upgraded one just not last as long?

6 Speed ...

View 3 Replies

GTI 337/20th Anniversary :: Bog Down A Lot / Rough Running - Complete Power Loss On Highway

About three nights ago I had a complete power loss on the highway and the car began to bog down alot under throttle (and surge at points as well although with no boost). It also idled very rough/erratically. When I unplugged the MAF it cleared up right away; Idle was smooth and it ran without hiccup but in safe/limp mode so very tame (again, without boost really, gauge shows it stays in Vacuum and never passes "0" or goes into boost).

I scanned it this evening and got 2 misfire codes and a MAF code, along with a code related to traction control which I noticed had activated as a result of this and could not be turned on (by activated, I mean the light came on, disengaging T/C). These things make me think it is MAF related, especially because I have bolt down Hitachi coil packs so I do not think that is what it could be in relation to the misfire codes (which I think may be old and needed to be cleared).

Fast forward to last night: I can pretty confidently say my MAF is not the problem and I think I saved an unnecessary expenditure. I was able to meet a friend with a 337 as well and his MAF did not change my car at all and my MAF ran fine in his car so I think my problems are something else. Although with the MAF plugged in my car runs very poor and unplugged it clears up and just runs "limp" (no boost and slow but stable) from what I tested this evening the MAF unit seems to not be the issue.

I think there must be a vacuum leak of some sort between the MAF and the engine which allows more air in than the MAF signals when plugged in which causes the issue. Also, I know a common thing to think is "coilpacks" but I have bolt down Hitachi coil packs so I would imagine that would eliminate those from being the failure they tend to normally be. Agreed ??

View 14 Replies

GTI 337/20th Anniversary :: 2005 - Bouncy Ride When Accelerate On The Highway At 50 Mph Or Faster

I got my 2005 jetta gli used with about 41000 mi on it. Ever since i've had it, when i accelerate on the highway at 50 mph or faster, the car almost feels bouncy throughout, what that is.

View 8 Replies

GTI 337/20th Anniversary :: Slight Whirring Noise When Gently Feathered Gas To Maintain Highway Speed

Middle of May, I went to Boston. On the way there, I started to notice a slight whirring noise that was only present when I gently feathered the gas to maintain highway speed. If I were to apply any more throttle, the noise would go away, and if I were to pull my foot away and allow engine braking, it would also disappear.

So I did my best to finish the trip to and from Boston adjusting my driving to avoid the noise. Once I came home, I researched and thought the noise might have been my wheel bearings (I had just replaced lower control arms, lower ball joints, inner and outer tie rods prior to leaving for Boston). I also had a shop install my upper strut mount bearings and bushings simultaneously with the wheel bearings.

Since then, the problem still continues. It has grown louder, but still occurs under the same situations. I've focused more on it and here are the conditions under which it occurs:

1. Car must be warmed up. Starting it up cold and allowing SAI to run then driving, car is fine, no sounds. Usually takes 20-25 mins of driving to get it to start making noise.

2. Car still only makes the noise when the gas is being feathered (ie barely pressing it enough to give it any sort of throttle. It does also make the noise between shifts when reengaging the gear and applying gas, as the throttle pedal passes the point of throttle off to throttle on.

3. I'm hearing more noise now during engine braking than I had been previously. Could be related?

View 6 Replies

GTI 337/20th Anniversary :: GLI Will Not Go Into 1st Gear

Driving home from work, I was about 5 minutes from home, got to a light only to not be able to go into 1st. I popped it into 2nd and drove home like that pretty much. Car will let me get into reverse and all other gears.

I can put the shifter towards first but it doesn't fully go in and when I gave it gas it would let me start to creep and then grind a little and pop out.

Heres a pic for your click .....

View 24 Replies

GTI 337/20th Anniversary :: First And Second Gear Won't Work

I have a problem with my 20th anniversary gti. My 1st and 2nd gear won't work. Every other gear works fine, the gears never grind before or any unusually noise. I was pulling off my driveway and they just stop working. Even when the car it's on I can move my shifter to 1st and 2nd without the clutch and nothing happens.

View 3 Replies