GTI 337/20th Anniversary :: CEL On - Code Is Running Lean With A Base One
I was parking today and when i looked up my CEL was on. So I got the code pulled and it turns out I'm running lean with a base one. I think it was? the mechanic told me it was my o2 sensor but I'm not sure which one it may be whether it be before or after the cat?
View 5 RepliesGTI 337/20th Anniversary :: Lost 1st And 2nd Gear - Swapping Transmission?
Alright so basically i lost 1 and 2nd gear and i want to replace the transmission since this one already has 150k on it. The hard part is finding a used one because of the six speed! What models can i swap transmissions from? Like i heard i could use a 2003 Audi TT six speed transmission! What I can use to swap out my transmission or do i have to just look for a used one specifically for a 20th?
View 20 RepliesGTI 337/20th Anniversary :: 2004 To 2005 Transmission Swapping?
I was wondering if I could take the automatic transmission from a 2004 Jetta 1.8 turbo gas and put it in my 2005 automatic 1.8 turbo gas GLI. Everything about the cars seems the same to me except some of the cosmetics on my GLI.
View 7 RepliesGTI 337/20th Anniversary :: Inner CV Joint Boot Cover Won't Come Off
Trying to do new boot kit on inner cv joint. I have the ball and cage type inner joint. The joint cap comes off really easy (and a new one comes in the boot kit). The boot cover doesn't come off so easy (and there is no replacement in the boot kit). Bentley's and pretty much every other source of info says to carefully drive off the boot cover to remove cage. But they all pretty much gloss over how to do this carefully. I've hit it a couple of times with a screwdriver blade and hammer, but it's not budging. Trying not to hit it too hard.
View 6 RepliesGTI 337/20th Anniversary :: CV Boot Blow Out After Few Hundred Miles
So the long story short, i bought a JB 20th with 36k miles on it, lowered on Neuspeed Race Springs and HD Koni Struts. When bought, both inner CV boots were torn on the car. I ordered OEM CV boot repair kits for all four joints (made by Rein OEM manufacturer) and rebuild the axles completely.
I got the car up in the air today and the drivers side inner CV boot is already torn, after only a few hundred miles (if that many).
From what i understand, it is a common problem on the O2M 1.8T setups after lowering? Is there a solution?
I searched around, but it is still not clear what is the source of it, even though i found plenty of threads that state that its a common problem.
Upon inspection, the geometry of the axle or the angle at which it operates when the car is on the ground does not look that bad, it simply does not make sense.
GTI 337/20th Anniversary :: CV Boot Shredded On Driver Side
I know this has been covered before and I did search but got no where. It's covered in the FAQ sticky but the link is no good. Where can I get an axle assembly that's not going to cost me 550 bones like on ECS?
View 14 RepliesGTI 337/20th Anniversary :: Tore Second Driver Side Outer Boot
Just tore through my second driver side outer boot it's frustrating. I'm thinking about buying an axle but are the boots not going to rip on them. Thing is I don't really get why the are ripping since I'm not super low or anything I know people that are lower and haven't had any issues
I put this new OEM axle in just a couple months ago. Could my Coilover be sitting to low in the strut housing and rubbing on the boot or what. I don't know if that is the mechanical terms but I did my best but how would I go about fixing this.
When I was looking around for the axle last time and I tried to go through smaller shops but none of the axles they had matched up, so I had to go to the dealership and my wallet took a beating. This time thinking about the cv boot kit for urotuning.
GTI 337/20th Anniversary :: 2002 - Gear Selector Broken Down Under The Boot
I have a 2002 337. My gear selector has broke down under the boot.
Can I replace this part? Where can I get one? How do I get the old one out?
Prius (Gen 3) :: Swapping Base Headlights For Advanced?
I have a 2012 PiP Base. Wondering if there is a post for this. Is it worth it? Will it work? Better light output? Less battery usage? etc?
View 19 RepliesGTI 337/20th Anniversary :: Shifter Console Box Broken?
I was driving today and when attempting to go to fifth gear and sixth gear the shifter went completely loose, but if I returned it to neutral and go back to 1st through 4th I regain feeling of the shifter. Could something within my shifter box be box be broken? I can go into fifth and sixth manually from the shifter tower on the transmission,
View 3 RepliesGTI 337/20th Anniversary :: Efficient Way To Remove Stock Shifter?
So I have been looking but cant really seem to find an efficiant way to remove my stock shifter.
View 1 RepliesGTI 337/20th Anniversary :: OEM Shifter Makes Clicking Noise Going Into Gear When Driving
When driving my car, my oem shifter makes a clicking noise going into gear. is there a way to get it to stop, other than getting a short throw?
Looking for 2004 gli all weather floor mats? or ones that would fit?
[IMG][URL] ....
GTI 337/20th Anniversary :: Barely Able To Move The Shifter / Clutch Pedal Fell To Floor
The transmission is a Six-speed MQ350 transmission in an MKIV 337 GTI.
I was driving last week and ran over a large snow chunk, heard it hit the underside of my car. A mile down the road my foot is resting on the clutch pedal at a stop light, and the clutch slowly went to the floor. It was still drivable, barely. The clutch came about an inch off the floorboard, but still caught. So i pull into the parking lot ahead of me, and was barely able to move the shifter left to right nor would the shifter go into gear. There were no fluids coming from under the car, nor could i see anything that looked wrong. I turned off, back on again. nothing. I then pulled the clutch pedal up from the floor and it went back to normal. Everything seems normal now, but the shifter seemed a little sticky yesterday from left to right.
GTI 337/20th Anniversary :: Can't Shift To Reverse
I have a 20th ae Gti. When i bought the car it has installed a EIP Short Shifter and it was working fine, But... Yesterday i cant shift to reverse. So i decide to take a look since that was the first time that i have a problem with that, i thought that was something wrong with the Short Shifter so i decide to see how to install the Short Shifter so i can Re do it all by my self and now i cant Find any gear, No reverse, no 1st no 2d not even neutral.
View 2 RepliesGTI 337/20th Anniversary :: Not Able To Shift Into Reverse 1st Or 2nd?
So i went to start up my car after about an hour of not driving , (previously working fine) and I am not able to shift into reverse 1st or 2nd , ive been looking around and i guess the options are linkage, gear selectors, gear box or tranny.... Its a 337 so its a 6 speed . don't know if that makes a difference
View 2 RepliesGTI 337/20th Anniversary :: Cannot Shift Out From 2nd To 3rd Gear When Going At 25mph
Yesterday I went to shift from 2nd to 3rd real easy going like 25mph and i couldn't shift out of second. I could wiggle the shifter up and down but barely side to side. Even when moving it up and down it didn't feel like it was engaged in any gear although it was apparent I was stuck in second. Clutch feels normal and still grabs well.
So after driving only in second all the way to my uncles shop I sit at school waiting to see where i can pour more money into the GTI. Its a 20th ae totally stock tranny, I don't know a whole lot about transmissions but possibly the linkage got messed up? I didnt hit any big bumps or anything before it happened.
GTI 337/20th Anniversary :: Removing Shift Knob?
How to remove the OEM "golf ball" shifter on a 20th AE? I tried everything but it still won't budge. Is there a trick to removing it? Is it a tight press fit or does it screw on?
I have the latest edition of the Bentley repair manual and it does not cover this shifter knob.
GTI 337/20th Anniversary :: Shift Knob Removal?
I was looking through the DIY and I couldn't find one that just removes the knob it self. I know its all the same steps to remove everything but everyone just swapped the boot and everything. I want to keep my boot and just change the knob to a solid glass ball.
View 1 RepliesGTI 337/20th Anniversary :: Tranny Won't Shift Into 2nd / 4th And 6th Easily
I am having trouble shifting my 6 speed into 2nd, 4th, and 6th. I got my clutch replaced about a year ago, not sure if that makes a difference. Any fixes short of bringing it to a shop?
View 1 Replies