GTI 337/20th Anniversary :: Engine Failure While Driving - Cylinder 1 Misfire
I am having this failure in my engine that is making me crazy while I am driving. Yesterday i took my car to a shop to see what was it. my MAF was gone ( I replaced it ) and the failure still going on. The mechanic connected his computer in my car and we went for a ride. HE told me cylinder 1 misfire.
This is what i did.
-change spark-plugs position (failure still)
-change coilpack (failure still)
What can i do ?
-clean injectors
-check for any carbon in valves
GTI 337/20th Anniversary :: Cylinder Misfire Codes For OBDII?
I changed my sparkplugs and coil packs last month. Was getting CEL light but it would go away after a while. I figured out that I had gapped my spark plugs way to small (almost touching) so I took them out two nights ago and regapped/ reseated them.
My car was running fine yesterday, but today when I started my car up, the engine was shaking a lot for about 10 seconds and the CEL was blinking. After 10 seconds the shaking and CEL went away...
It drove fine. I'm just wondering what could be throwing these CEL's and causing the shaking? Plugs are gapped to 0.32
Also, I had my timing belt and water pump replaced almost two weeks ago now. Any chance that could be lending to the problem?
My guess is that one or more cylinders are screwy. I'd rather not bring it into the vw mechanic since I'm tight on cash.
Audi - A6 :: 2004 - Check Engine Light Intermittently Flashing / Misfire On Cylinder 2 And 5
I have a 2004 Audi A6 wagon that has an intermittently flashing check engine light. I took it to the dealership to have the codes read and they told me that they got codes for Cylinder 2 and Cylinder 5 misfires. Additionally they got a code saying the Engine Coolant Temperature Sender was electronically faulty. What is this part and what does it do? Is it essential to fix it immediately?
The dealership recommended changing the spark plugs and the air filters for the cylinder misfire issue. We are also talking about replacing the timing belt since the car has 105k miles on it. I know there are several other parts that are replaced during the timing belt replacement (like the water pump, thermostat, oil seals, etc). Is it essential to replace these items if there is no immediate need to do so?
Toyota - Corolla :: 1999 - Check Engine Light Came On Flashing / Cylinder 3 Misfire
I have a 1999 Toyota Corolla. 4 cylinders.
I was on the road about 2 hours from home when my check engine light came on flashing. It stopped flashing so I kept driving. Three more hours of driving at highway speeds and it only came back on once. I then took it into autozone and the code reader told me I had a Cylinder 3 Misfire. The guy told me to change my spark plugs and I would be fine. It was time for a spark plug change anyhow so I drove home and did it. After I changed the spark plugs the car did not start at all. It would cough and sputter and try to start but not actually start. Changed the spark plug wires and then the car stopped even coughing and sputtering. It just didn't start.
I then noticed that my fuel line that feeds directly into the engine was rotten right next to the engine and if I pushed it in I could get the car to try to start. (Try and fail, but at least try.) The fuel line is a molded piece of rubber that flares at each end. It was one of the flares that was rotten and didn't seem to be sealing anymore. The hose is 7 mm inner diameter in the middle and about half an inch on the ends. I took some 3/8 in fuel line and used it to cover over one of the flares. The car tries to start now but wont. 3 of the four cylinders crank. I don't understand how I could break my car on such a simple repair job.
GTI 337/20th Anniversary :: Car Starts Lagging And Check Engine Light Flashing On And Off
I have a 20th anni GTI. I was driving down the road about a week ago going about 50 in 5th gear. all of a sudden when i go to give it gas my car starts lagging and the check engine light starts flashing on and off. I used a check engine light tester to figure out the possible problems and found that cylinder 2 misfired.
Spark plugs could have been the problem so i replace them. Nothing changed. so then i thought it could be one of the coils so i switch 1 and 2 aroud to see if there was a misfire on 1 now. still cylinder 2 misfired. I am starting to thnk it may be my catalytic converter. There's a funny spell coming from my exhaust. Like fire crackers or rotten eggs maybe.
GTI 337/20th Anniversary :: 2004 GLI 1.8T - CEL Came On / Code P0303 Cylinder 3 Misfire
So I have a 2004 Jetta gli 1.8turbo and my CEL came on last night from normal driving, after it came on it still drives the same. I had it scanned for codes and got the p0303 cylinder #3 misfire. wondering what could be the solution for this? I dont think its the coil pack because I had them changed at the dealer from the recall about 2 months ago (anyway to check?) Also I have 97,000 miles on my car and my last oil change I used 0w-40 oil. I know this is probably not the best oil to use at this mileage but I had an extra 5 quarts of them laying around so I decided to use it.
View 24 RepliesFord - F150 :: Check Engine Light Started Flashing / Cylinder 4 Misfire Code
1997 Ford F150 - 133K Miles - 6cyl - 4.2L. This is a truck that gets less than 2K/year put on it. Has had "issues" with worn bearings and holding oil pressure for a few years now. Yesterday, the check engine light started flashing (as opposed to solidly lit) and the code came back as a cylinder #4 misfire (only the one code). The truck was clearly not firing on all cylinders and at idle, ran terribly (couldn't be driven). I just did a compression test on all the cylinders and all measured around 140-145psi except the #4 which read almost 170psi. I rechecked this a few times as well as a couple of the others and am now sure of the results. What could cause this one cylinder to have a higher compression ? Is whatever is causing this increase in the compression, also be the cause of them misfire ?? I'm stumped here and quite frankly, expected the compression on the #4 cylinder to be really low as opposed to the others.
View 13 RepliesGTI 337/20th Anniversary :: Red Light Flashing On Dashboard
I just had this red flashing light next to the brake sensor light in the dashboard turn on when i turned on my car tonight.
View 4 RepliesGTI 337/20th Anniversary :: Airbag Light Flashing
The other night on my 337 the airbag light turned on which is located in the rpm spedometer. It wont turn off and i dont know what i need to do in order to fix it.
View 3 RepliesGTI 337/20th Anniversary :: Beep Noise And Oil Light Flashing
My car is 2000 GTI 1.8T. When you put the key in ignition and turn it( not to start car, but get all the instrument lights to come on), after 15 seconds there is a "beep" noise and the oil light flashes.
Vag-Com doesn't pick up any faults, and when you start the car and start driving the light doesn't come on, and I am talking 600 miles 5 times in the last month!!!
Only when the key is in Ignition on position does it beep. Also recently the brake light has started coming on as you drive. It flashes and beeps only when you driving! Vag does not pick up this fault either...
GTI 337/20th Anniversary :: Temp Light Is Flashing But Car Does Not Overheat
I have a 20th GTI and the Temp light is flashing. The car does not overheat, and runs normally. The temp gauge acts normally.
View 6 RepliesGTI 337/20th Anniversary :: Brake Light Appear Flashing For Several Seconds Then It Goes Off
When I am driving around, my brake light will appear flashing for several seconds then it goes off. What is that about?
View 8 RepliesGTI 337/20th Anniversary :: Misfire With Engine Code
So i have a 2004.5 gli 6spd that had two of the coils go bad and had a serious misfire with engine code and all car didnt want to even move. So i got this fixed made it about a mile down the road and it had a cylinder 3 misfire took it back had third coil replaced and all new plugs put it. Got the car back it ran fine until i hit about 4000 rpm under heavy boost it misfires but no flashing cel like before and the car still runs but cold start warmed up it misfires under boost
View 20 Replies1996 Blazer - Flashing Cel Light P300 Multiple Cylinder Misfire?
So my 96 blazers cel started flashing and the truck started running extremely rough. I changed the catalytic converter and the o2 sensor that is in the pipe. Made no difference. So I knew my intake manifold gasket has a leak so I changed the gaskets and put knew bolts in. I wasn't thinking and took my distributor out and forgot to mark the timing. So played like heck getting it in timing again. Took a bit cause I didn't realize there was two timing marks. So got it started again was running really rough so thought 180 off turned it nothing. So put it back started it up still running very rough and flashing cel so put a new crank sensor and cam sensor in and a ignition coil in. No dif still. Could it be the egr or ECM?
View 12 RepliesGTI 337/20th Anniversary :: Battery Light Flashing A Few Times Then Stopped
Sometimes my battery light will come on. It started happening about a few weeks ago. At the time i was on the parkway so i couldn't pull over and it was flashing a few times then stopped. It started doing it more often, now it did it around town so i would slow down and i could hear the belt squealing. It just happened again and this time my car sorta lost power but only for a second. Now my question is, how would i check if its
a) alternator,
b) the belt or
c) the tensioner?
Or, I won't know til i start messing with it?
GTI 337/20th Anniversary :: Traction Control Light Started Flashing - Hesitates?
So I was exiting the freeway the other day. It was a long gradual sweeping left hand turn. And I was doing about 80 mph and the traction control light started flashing and the car started to hesitate a bit. What this could be. Btw I have a 2005 gli intake,exhaust,chipped. Not lowered stock bbs rc's...
View 1 RepliesGTI 337/20th Anniversary :: Flashing High Beams Causes Buzzing Noise And Dashboard To Light Up
Just the other day, I'm driving along and flashed my lights at another car so they can make a left turn into a parking lot. No big deal. However, when doing that, I noticed a buzzing noise when I pulled back the lever to engage the lights.
After I got home, I tested things out and found:
With my Euroswitch, I don't have any lights on during the day (no DRLs, etc). This is when this buzzing noise occurs. As it was getting dark out, I also noticed that when I pull the lever back to engage the high beams (i.e., to flash them) the dashboard would light up (like if I turned on the lights normally).
Now, if I have the park lights or headlights on already (which includes the dashboard), and flash the high beams, the buzzing noise does NOT happen.
It also doesn't happen when I push the lever forward to enable the high beams fully. The buzzing sound seems to come from the lower left, around my left knee area or near the steering column.
Why this is happening, and what the cause might be? What is the possible part that needs to be replaced?
I have a 2004 Jetta GLI 1.8T 6-speed. Seems like the old signature is gone.
Passat (B7) :: Flashing CEL - Cylinder Misfire At 50K Miles
Today I started up my 2013 Passat SEL up and it started shaking and idling very strange. A few seconds later I had a flashing CEL so I decided to turn her off. I waited about 5 minutes (after cursing for about 4.5 if those minutes) and tried again. This time the car started and everything was fine, no CEL, no other issues. I drove for about 10 miles, shut off the engine and re-started about 5 more times with no issues.
I just had the car in for the 50K mile service at VW and everything checked out ok. I copied the VAGCON report below and I also sent it to my service manager to get his opinion. What I should do?
Saturday,02,January,2016,17:24:51:53498
VCDS -- Windows Based VAG/VAS Emulator Running on Windows Vista x86
VCDS Version: 15.7.3.0
Data version: 20151216
[Code] ....
Passat (B5) :: V6 Check Engine Light - Misfire In Cylinder 4
I'll try to break this down as best I can. I went to my mechanic this am with a check engine light. My suspicion is 02 sensors. This was confirmed as a problem area, but separate they said I had a spuratic misfire in cylinder 4. With that info, i pulled the plug to inspect (I had just installed new ngks in it and they have 18,000K on em.
I put beldon wires on about 8k ago.) plug looked to be normal, but there was definitely a puddle of oil from the valve cover leaking. Oil went into the cylinder head but I didn't really think that was an issue. Nothing abnormal jumped out at me so I reinstalled plug and checked all wire connections at both ends and called it a day.
Then I drove it. Check engine light flashing. Major performance stutters, etc. I drove it for about 20 miles and hoped it was just the oil raising hell in there and it would burn off eventually. It hasn't gone away yet. Maybe coil pack. Can the single portions of that pack be replaced, all i see them sell is the full three as a unit.