Ford - Windstar :: 2003 - Grinding Front Brakes On Occasion When Coming To A Stop
My 2003 windstar SEL needed new brakes and to have the rotors turned... instead I opted to buy new discs and pads online ... To my surprise the new discs were about a 16th of an inch thinner than the old.... I changed discs and pads and was happy for a few days, but now on occasion when coming to a stop the front brakes grind terribly....the next time i stop everything is fine...visa versa...dscs feel true (no pulsing) I DID APPLY BRAKE QUIET TO THE BACKS OF PADS....
View 2 RepliesHonda - Cr-v :: Rough Vibration / Shuddering / Chattering When RPMs Between 1000 - 2000
I leased a 2015 Honda CR-V AWD LX on March 11, 2015. The following day I noticed a rough vibration/shuddering/chattering that appeared to be coming from the transmission when the rpms ranged between 1,000 and 2,000. The roughness was evident at any speed (mpgs) when the tachometer reading was between the previously stated range. The service technician reported feeling the same roughness, but noted that the problem was characteristic of the CRV with a CVT transmission. On Tuesday March 17, I went back to the dealer and discussed the problem with the service manager. He also stated that he was aware of that particular problem and that it was peculiar to the 2015 CRV with the CVT transmission. He took my car for a test drive and admitted feeling the chattering. It was also evident to me as I sat in the passenger’s seat. He then took out another new CRV and it too exhibited the same characteristics.
View 18 RepliesAccent LC (2000-05) :: 2002 - Brake Chattering Will Rise Or Fall With The Speed
When I depress my brakes the right rear chatters, almost as if metal is on metal. Depending upon my speed when I brake the chattering will rise or fall with the speed I'm braking. Sound familiar?
View 9 RepliesFord - Windstar :: 2000 - Gauges Gone Wild?
My '00 Windstar has recently begun to exhibit some curious instrument panel behavior in the form of dancing gauges. All gauges are affected simultaneously - temp, tach, speedo and fuel - quickly swinging from stop to stop in no apparent pattern. This will go on for a few seconds to a couple of minutes, then they resume normal operation. It may occur again on the same trip or not for a week or so. There are no other symptoms, no CEL, no obvious trigger or apparent after-affects, the van runs fine. The battery is fairly new and quite strong. Is this likely just a ground issue? Where would I start to look?
View 14 RepliesWindstar :: 2000 Ford - How To Put It Into Park By Hand To Start The Van
I a 2002 ford windstar 3.8 engine. I need to put a new shift cable on it. And reconnect it to the transaxel range sensor or the netural safety switch. Not sure what i have on my van. But what i need to know is how to put it into park by hand to start the van, then how to put it into drive to drive the van. I need to get the van running the right way. Next month, I'll get them. but need to get around now. so how to shift the gears by hand.
View 2 RepliesFord - Windstar :: 2000 - Rough Idle Intermittently?
I have 2000 ford windstar with 3.8 engine. I have been reading up on the idle problems with these vans. However, most responses are in regard to the engine stalling and/or it trips a code. My does not do this. Sometimes the idle is rough and other times everything is smooth. I am thinking it may be an egr valve or dpfe valve.
View 5 RepliesFord - Windstar :: 2000 - Temp Sensors Or Sending Unit?
My question is about a 2000 ford windstar with 3.8 engine. Does this vehicle have a coolant temp sensor and sending unit or just a sensor?
View 7 RepliesFord - Windstar :: 2000 - Sounds Like A Machine Gun When Press On Gas Pedal
About two days ago we were driving home and our van started to make a noise when we press on the gas pedal. it sounds like a machine gun under the hood. what can it be?
View 14 RepliesFord - Windstar :: 2000 - Sounds Like A Diesel Engine And Overheating?
2000 Windstar 3.8L sounds like a diesel engine (exactly like and old diesel) when it warms up. My girlfriend noticed the problem and checked oil and it was low, she added, and then when she started it the next day, sound was gone. While she was driving it came back and would stall out. When she got it home I checked and the coolant overflow was empty, I added water and it poured out on the front (passenger) side of the engine. I immediately assumed head gasket.
Once it cooled I started pulling the stuff out. Down to the head on the Right hand bank (front of car). There is oil in the coolant, but no coolant in oil, (or very very little). Found the coolant is leaking from water pump itself it looks like. where the lower rad hose goes into pipe for water pump. or on the flange seal for water pump. It is so tough to actually see where. It also looks like the intake gaskets were bad because of the dirty oily wet condition under the intake manifold.
The car only makes the noise when warm, when it is cold it runs just fine. Would just the water pump being bad and leaking coolant cause this problem, is it a bad head gasket, something else? If it is the head gasket, I cannot get the head bolts to break free. I didn't have a 15mm 1/2 drive, so used a 3/8 drive and the 1/2-3/8 adapter spun right off.
Ford - Windstar :: 2000 Stopped Putting Out Heat To Any Front Vents
Ford - no front heat - 2000 Windstar - actuator
My Dad's 2000 Ford Windstar van stopped putting out heat to any front vents. I was able to hear a rhythmic thumping sound when the heat control slider was placed in the hot position. I looked for info on line, and found many posts that said the actuator was probably the issue. I also went back and asked my Dad if before the thumping sound he had heard anything else, and he confirmed he had heard some gear grinding noises, which others have reported as the actuator is starting to grind and slip its internal gears. If the actuator is not working correctly, it won't hold the heater duct door in the open position, which means you can't get any hot air.
Windstar :: Rubber Squeaking Noise When Step On Brakes / Changes As Wheels Turn
98 Windstar 251K
I recently replaced wheel bearing on Front driver side, the noise was present before replacement. When I step on the brakes I hear a squeaking sound like a rubber bushing squeaking, also it changes as the wheels turn. I have also cleaned the brake rotor but have not had it turned for being warped, could this be the piston seal in the caliper or pins.
Ford - Windstar :: 2000 - Coolant Leak From Back Side Of Motor When Step Hard On The Gas
On my 2000 Ford Windstar when I step hard on the gas I have a coolant leak from the back side of the motor and had antifreeze coming up onto the windshield when I turned on the heat. I took the van into the shop and they did a pressure test on it and could not find any leaks and after this I didn't notice any leaks or smell of antifreeze. Drove the van 400 miles with no problem but last Friday I had to step on the gas to exit a parking lot and then again I smelled coolant and my van was steaming. I added coolant and drove it and it is fine now. There is no oil in the coolant tank.
View 4 RepliesFord - Windstar :: 2000 - Power Windows / Windshield Wipers / Radio And Heater Blower Motor Won't Work?
I have a 2000 Ford Windstar Van with 155,000 miles on it. A problem has developed with the electrical system/components. The van will start and run fine. With the engine running, there is no instrumentation, power windows do not work, wind shield wipers do not work, radio does not work, heater blower motor does not work. After the engine has been shut off, the radio will work, windows will work, door locks until such time as you open the door, then all quits. With the key in accessory, the windows work, door locks work, radio works, etc. The neutral module was replaced (the old one, none of the contacts appeared to be burnt). Ford dealer spent an hour trouble shooting - checked body modules (2) - found nothing.
View 4 RepliesFord Super Duty (1999-2016) :: 2000 - Rear Brakes With More Power Than Front Brakes
I use a bottle hanging like an I.V. drip to flush the Brake Fluid in all my cars. I can pump all the old fluid out, as well as the air. My Superduty 7.3 has a good solid brake pedal after the flush. It seems to me the rear brakes handle 60% of the stopping load. Its been like this for so long I'm not sure if it's ever been different. i then go to a gravel or wet road and test the rear abs, and it seems o work, but definitely has a squirrely feel. I did some strong pavement stops with speed, and it stops, no skidding. Is that the way it should be?
View 14 RepliesWindstar :: 2000 - ABS Warning Light On And Off Intermittently
I decided to tackle my ABS warning light issue because it's been on and off intermittently since I bought it.
I first suspected bad wheel sensor(s) per many previous threads. I borrowed a scantool with the ABS diagnosis and found that all 4 wheel sensors are reading same speed value, but they indicate wheel speed of about half of the speedometer reading. Another thing I noticed was that the ABS main power relay output is "1bit" when the ABS warning light is OFF and is "0bit" when it is ON.
So it seems like the ABS power relay is bad. My alldata manual for this model says that the part number for the relay is FOAZ14N089A but it also says that "the ABS is not equipped with an external ABS Relay. According to wiring diagrams provided by Ford, the function of the ABS relay is incorporated into the ABS module". Does this mean that I have to replace the whole ABS module or HCU just because the relay is bad?
Why wheel speed is different than speedometer?
Windstar :: 2000 Horn Came On Solid After Parked
The horn came on solid about 10 minutes after parked. This is not alarm, as horn is blowing solid. Tried all things to reset the alarm, started engine, locks, etc. Only way to get to stop blowing was to disconnect battery. Re-connected, still blew, disconnected 5 minutes, reconnected, and was ok.
Since that time, it has started going off randomly, even when driving on road.
Windstar :: 2000 - Cooling Fan Runs All The Time When Driving
My 2000 Windstar cooling fan on the passenger side is running all the time when I am driving, even in freezing temperature. My gas mileage goes from 18 to 13 now.
View 7 RepliesWindstar :: 2000 - Car Cranked But Not Started In Cold Weather
First, it's not a sticky IAC. I already experience that in cold weather and compensate simply with the gas pedal until engine warms up. However this coughing, sputtering, backfiring, misfiring problem is very severe. When it is in this state, the engine will lose rpm and stall. No way to coax it with the gas pedal to keep it running.
It happens most often when you restart the engine after having stopped somewhere for 10-30 minutes. It happens less often during a cold start in the morning. When it does this, I remove the key, and try again. Usually in 3-10 tries, the engine runs properly. Once running properly, there is never an occurrence of this.
However, today only, first cold start, it cranked and would not fire at all. Repeatedly. Jiggled the key and maybe they made it start. Ignition switch? If Neutral Switch, it should not have cranked. Perhaps my intermittent problem is worsening.
Wet weather seems to aggravate it.
Windstar :: 2000 - ABS Not Functioning / Rapid Repeated Turning Steering Wheel Has No Effect
Windstar 2000, 260K, ABS not functioning, previously ABS light on all the time now of even with Key on Engine Stopped. While a long drive after 1600 KM failed to apply the Cruis. Horn not blowing. Retried cruise engaged but resume, horn, deceleration did not not function. Stopped, disconnected battery for half hour cruise and horn started functioning. Again after 400 KM stopped functioning. Now it is intermittent. Tail lights normally working. Cruise deactivating switch (switch unser the master brake cylinder) was changed by ford 5 years back, it is dry no signs of brake oil on it. Fuse no 10 is OK. Rapid repeated turning steering wheel has no effect. CEL On since 4 years code is for bank 2 CTM.
View 7 Replies