Ford Wiring/Electrical :: 2004 F150 - Parking Brake Light Stays On

Why the parking brake light in my dash stays on, 2004 F150. Fluid in master cylinder is full, has no signs of leaks anywhere.

View 2 Replies

Ford Wiring/Electrical :: 1979 - Taillights Only Stays On With Key Inside?

my 79 Bronco tail lights only are stuck on with the key on? the brake lights and blinkers and headlights work fine and (all the running lights) work fine when turned on, but with all the switches off and key on only my tail light running lights stay on?

View 14 Replies

Ford Wiring/Electrical :: F250 - Airbag Light Blinks And Stays On

I pulled my CD player and put it back in and now my air bag light won't go out when it self tests. It blinks for a while then stays on steady. What's up with that -- I thought I was having enough problems with the CD player as it was?

View 14 Replies

Ford Wiring/Electrical :: 2004 F250 - Airbag Light Flashes And Stays On

I have a 2004 250 SD. Supercab. Took out the bench and replaced with captains or buckets, whatever you want to call them. Perfect fit. The new seats have their own seat belts built in to them. The old ones, were mounted to the floor and roof. Now the air bag light blinks for a fairly long time, then stays on! What? OK, So, what do I NOT know about this project? I did have to make the wires longer in order to reconnect the plugs. Not a problem, I am an electrician. Trouble shooting is ok, when you know where to start.

View 10 Replies

Ford Wiring/Electrical :: Airbag Light On Dash Blink 3 - 2 For Several Cycles Then Stays On Solid

What the code "32" means for the airbag? Lately my airbag light on the dash will blink 3-2 for several cycles then stays on solid til I shut down the truck.

View 12 Replies

Ford Wiring/Electrical :: 2007 F350 - Parking Lights Won't Work

I am beginning to think that I need a whole forum dedicated to my trucks wiring issues ... I finally got my reverse lights to work but my newest issue Is that while driving tonight i lost power to my parking lights, my instrument cluster lights, and my heat control lights... everything still works inside (gauges all act properly but they won't light up) and i still have turn signals and brake lights, and headlights. I really don't know where to start with this one. I don't have an owners manual so i can't figure out what fuses to check or what relays to look at. It is a 2007 f350 diesel....

View 9 Replies

Ford Wiring/Electrical :: 1999 Explorer V8 - Parking Lights Won't Turn Off

I just bought a 99 Explorer v8 2wd to replace my aging aerostar and to tow my boat. I already knew it had this problem and a destroyed rear diff when I bought it, I figured this would be the easiest problem with just a new switch. I was wrong.

pulled the fuze
pulled the headlight switch
pulled the relays at: power dist. box, keyless entery/alarm?, the box under the dash
disconnected the harness from the GEM behind the dash and from the keyless entery/alarm

Lights only go out when I pull the park lamp relay. I know what you may be thinking. But no. Its still not gonna be that easy. The relay is not bad or being activated. Its just acting as a jumper from pin 4 to 3. So out comes the test light.

At the park lamp relay (without the relay in)on the relay module I get power at 1, 5, and 4. When I ground 2 with the test light, the headlight relay kickes on. Which seems normal to me by my assumption of how the system works. Which is that these relays are only for the RAP module to flash the lights by grounding the 2 pin. Anyway... I think I've narrowed it down.

According to the wiring diagrams, the 4 pin should only get power from the headlight switch and the GEM from a white/black stripe wire. With the relay in (only to jump the power)I have unplugged both the headlight switch and GEM, and the lights stay on and there is power at 4. I figured the white/black wire may have a short to 12v and I would just bypass it. Then today I can disconnect the battery, then reconnect it and the lights will stay off. Keep in mind all other relays are out and everything is unplugged. If I plug the headlight switch back in, cycle the switch, the lights will go on and off correctly, but will eventually stay on. Even after removing the head light switch.

Does the white/black wire go to anything other than the switch, GEM, or relay. It doesn't say so in the diagram but I can't figure out why its getting power intermittently. Still thinking it could be a short I did a wiggle test on the dash harness to try to get them to come on if off or off if on. Nothing.

View 3 Replies

Ford Wiring/Electrical :: Tail / Parking / Dashboard Lights Stopped Working?

My tail lights parking lights and dash board lights stop working my turning signals work my brake lights work and my headlights work fine I checked all fuses are good I even switched out the headlight switch with a new one and nothing. What can this problem be?

View 14 Replies

Ford Wiring/Electrical :: Both Blinkers / Tail And Parking Lights Came On When Push In The Brake

I just bought my first Ford its an 1996 f250 powerstroke, and I am having issues with it. Every time I push in the brake both blinkers come on and tail lights and upper parking lights on cab, and when I turn on a blinker everything flashes.

View 8 Replies

Ford Wiring/Electrical :: 1985 - After TPS Sensor 0 Volts?

I have an 85 bronco ii 2.8l, carb, with around 109K on it , ran pretty good, some stubles here and there but found out how to read codes and went from there.... Retreived codes 23, 31 and 84. Checked TPS, had voltage to sig return pin but was low, pulled the carb, bought a rebuild kit while i was at it and redid most of the gaskets but did not take the inner parts of the carb out, put on a new TPS, installed the carb, unhooked battery for about half an hour and noticed it idled very high. Once you were moving the rpm's would drop but at idle would climb again. I ran the codes again and got 31, 63 and 84. checked volts from black to vref i have 4.9 and from black to sigrtn i have 0. i have traced all 3 wires through the bundle and did not see any breaks i know that the green wire goes to the ECM? but i do not know what to check from this point.

View 2 Replies

Ford Wiring/Electrical :: O2 Sensor Simulator On Truck?

Having a chance to try an O2 Sensor Simulator on your truck? I am wondering if they actualy work or if I should just stay away from them. Are there any problems or improvements using a SIM?

View 13 Replies

Ford Wiring/Electrical :: 2002 F250 - Parking Lamp Trailer Tow Relay Location?

Exactly where the parking lamp trailer tow relay is located on a 2002 F-250 Super Duty 4X4 CC 7.3L?

View 5 Replies

Ford Wiring/Electrical :: 2005 F350 - No Front Side Marker Or Parking Lights

2005 Super Duty 350. Getting ready to get my truck DOT-ed and I noticed the front amber side marker and parking lamps are not working (both in the headlight assembly). There is a fuse called "exterior lamps" that I believe these are on, the fuse is fine and all the rest of the exterior lamps on the truck work fine (all other markers, clearance lights and I.D. lamps on that same all inclusive circuit). Is there a special relay or something else I'm missing for these four front bulbs?

View 1 Replies

Toyota - Electrical-wiring - Radio - Corolla :: Power Stays On After Turning Car Off

Just this evening I turned off my car (2000 Toyota Corolla), went inside and then came back out an hour or so later to discover that my radio, clock, and cigarette lighter still had power. Without the key in the ignition, I'm still able to listen to the radio, for example. This was never the case before. I had the battery replaced five days ago, but I doubt that makes a difference.... How I can fix this so that my battery doesn't drain.

View 2 Replies

Ford Wiring/Electrical :: 2000 F250 - Dash / Parking And Tail Running Lights Not Working

I have a 2000 Ford F250 lariat 7.3 .... This vehicle has an aftermarket double din stereo pillar gauges for Pyro meter and transmission temp and has also had a snowplow attached but since re moved since I purchased it. It also has H ID headlights, which are run by the passenger side headlight connection.

The problem I'm having is that whenever I turn on the parking lights it is blowing the number eight fuse under the hood. Which is giving me no dash lights running lights parking lights or taillights. Initially the fuse would last for a few minutes and then burn out. I should also add that the trailer wiring harness doesn't work either and the driver side headlight will work sporadically.

View 7 Replies

Ford Wiring/Electrical :: Revs At 1900 RPM And When Unplug Vacuum Hose To Map Sensor It Idles About 700 RPM

I have a idle problem that happens on and off. with my 89 f250 351, it revs at 1900 rpm and when I unplug the vacuum hose to the map sensor it idles about 700 rpm. I've already replaced the map sensor and it does the same thing. i cant find any vacuum leaks anywhere and when i unplug the connector to the IAC nothing happens it continues to rev high.

View 2 Replies

Stalling - Electrical-wiring :: 1992 Buick Century - Replaced Throttle Position Sensor Still Stalls Out

SO, my Buick has given the code for bad TPS, and it was replaced a little over a year ago...and now after the same symptoms, replaced again.. However, this time, right after replacing, it gave the code again, and still stalls out /doesn't want to stay running especially when put in gear. My regular mechanic also recently just put on a new catalytic converter and a new fuel pump and fuel filter. I'm at a loss, and desperately need my car back.

A little back history...about 3 years ago a 'friend' was to work on my car to install the thermostat and power washed the engine...which shortly after started having all kinds of electrical issues. Right after that, my mechanic had to install a coil, spark plugs, new ignition panel and the 1st tps.

View 8 Replies

Ford Wiring/Electrical :: 1967 F100 - Instrument Cluster Gauge Wiring

I am a beginner when it comes to anything involving wiring. I am looking to re-wire all of the wiring coming off of the instrument cluster gauges. Once I have completed all of the wiring on the gauges, I may feel confident to move onto something else. As of rite now, it appears as though my truck is still running on all of the original wiring, and over the past few weeks, I have been having many wiring related issues. I found a schematic that includes the wiring for the gauges that I am going to go off of. I have a couple of questions before I begin.

1.) On the schematic, it shows connectors such as "Connector G" which is moving all of the gauges wires to there locations. Do I need to use a specific Ford connector, or could I purchase a new connector at any hardware store that carries them? As far as I am concerned, connectors do the same thing as all other connectors. (Let you connect and disconnect for easy instrument cluster removal.)

2.) I am not looking to purchase one of those expensive wiring harnesses. I would like to just purchase some wire that I can cut / use myself. What brand / type of wire should I be looking to purchase? I do not care if it is striped / colored as I will use wire tabs to name / label each wire.

Other than that, I feel confident enough to attempt something such as this. Here is the wiring schematic I am going to use.....

View 10 Replies

Ford Wiring/Electrical :: 2002 - Complete Headlight Switch Wiring Diagram?

Any COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.

View 14 Replies