Ford Wiring/Electrical :: 2004 F250 - Turn Signals And Hazards Stopped Working
So I have an 04 F250 Super Duty 6.0L and suddenly the turn signals and hazards stopped working. First I replaced the switch on the steering column...no luck. Today I replaced the flasher relay under the dash panel (the blue one)...still no luck. I remember checking fuses in the fuse box but don't remember which ones I checked but I didn't see anything obvious. I also took a quick look under the dash at all the wires for any anomalies...nothing. I'm lost... What to do next!?
View 1 RepliesFord Wiring/Electrical :: Brake Lights / Cruise Control / Rear Hazards Not Working
1991 F250 Supercab Diesel 4X4. I made a mistake while wiring up my trailer lights and ended up grounding out my brake controller, frying it. Along with that, I popped a couple fuses as well (1, 5 and 9 I believe). Replaced all fuses and got my signals (F/R) back at least.
Here's what's NOT working/messed up:
*Brake Lights
*Cruise Control
*Rear ABS light comes on a few minutes after driving.
*Front hazards work, not rear. When I apply the brake, the hazards pause in the on position.
I've tested the brake switch on the brake pedal (Green/Red and Green) and it works properly. So, current is obviously not reaching the rear brake lights.
Another note. The truck is wired with a 7 pin plug in the bed for a goose neck trailer. It also was wired to a 6 pin on the bumper. I replaced the 6 pin with a 7. The signal/brake pins on the plugs (both) and also not receiving power. What's the next thing to check?
Ford Wiring/Electrical :: 2003 - Instrument Panel / Interior Lights / Windows / Radio All Not Working
For about 3 months, my wife's 2003 explorer has had a bad door sensor (I'm guessing). The car claims a door is ajar and the alarm would go off randomly if it's locked. Yesterday the battery died because apparently the alarm had been going off for so long while she was at work. After having a stranger jump it, she has had major problems:
-She claimed the headlights didn't work in any setting except in the on position with high beams on, but now they seem to work.
-The instrument panel is totally out including all gauges and all lights
-the power windows don't work
-the radio won't turn on or show any display
-the interior lights won't turn on
All of the fuses are fine and my mechanic checked them as well. He did say that a few key fuses aren't getting any power to them on either side. But the battery is charging and drawing just fine. The car doesn't seem to have any other issues and all of the flashers work just fine.
What the problem could be? I have wondered if one of the relays is busted.
Ford Wiring/Electrical :: Different Color Wires In Cab - Brake Light Not Working - Wiring Diagram?
Need a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 RepliesFord Wiring/Electrical :: 1973 F250 - No Turn Signals / Brake Lights Or Rear Hazards
Dad borrowed truck and wired 7 pin trailer harness. Lights worked on truck/trailer for use but upon return the turn signals didnt work. Hazards and running and brake lights did work. Replaced TS flasher and Haz flasher. Still no signals. Pulled steering wheel and replaced turn signal cam only, not whole switch. Now no brake lights, no rear hazards or turn signals. Losing my marbles trying to follow schematic and using test light and mulit meter. All bulbs and fuses are good. Running lights and head lights working as well.
View 6 RepliesFord Wiring/Electrical :: 2012 F150 - Reverse Light Wire Color
I've searched all over and can't seem to find the answer. When I pull the tail light out of my 12 F150 there is a blue/wht wire and a black wire going to the back up light. I assume the blue wire is the positive and black is the ground. Is that correct?
View 8 RepliesFord Wiring/Electrical :: 2011 F250 - Reverse Light Wire Under The Hood?
I would like to hook up some auxiliary reverse lights, I want to use a relay. And activate the relay when I put my truck in reverse. I would like the relay to be in my custom relay/fuse box under my hood near my battery. I'm looking for a wire I can tap into, to use to active the relay as close to the battery as possible. Or at least a wire on the outside of the cab near the engine compartment. Maybe there's one coming from the tranny? I have a 2011 f250 super duty. XL, I think, its a very base model truck no power windows or locks, only fm/am radio, no NAV system, no remote unlock, no nothing, 2 wheel drive.
View 9 RepliesDodge - Electrical-wiring - Ram50 :: 1995 - Intermittent Dash Panel Electrical Malfunction?
My beloved 1995 Dodge Ram Van has intermittent dash panel electrical issues. The gas gauge an speedometer are intermittent, coupled with lights and radio on off too. It It all started when I had the transition services years ago. It has less than 100k mileage.
View 1 RepliesFord Wiring/Electrical :: 2003 F250 - Rear Cargo Light Wired To Reverse Lights?
I am wanting to wire my 03 f250 cargo (3rd brake light area) lights to come on when i put my truck in reverse.
View 1 RepliesElectrical-wiring - Chevrolet - Citation :: 1998 - Panel Light Fuse Blown - Short In Dimmer Switch / Dashboard?
I have a fuse blowing in my 98 Citation that is in the panel light/exterior running lights (front and back). Could the short be in the dimmer switch in the dashboard or is that unlikely?
View 2 RepliesGmc - Sierra :: 2013 - No Dash Instruments Working And Shown In Reverse Gear
All the sudden today all the dash indicators died & the seatbelt indicator light is flashing. It drove OK, but something is definitely wrong. Fuse maybe?
2013 GMC Sierra 2500HD Duramax Diesel.
Ford Wiring/Electrical :: Dome Light Not Working - Tested Almost All Components?
I can't find out why my dome light doesn't work. I threw a bulb at it first, and then a tester but found no voltage with the door open or the dome lights dimmer roller clicked over to "interior lights on". I do get a door chime with the door open, so seemingly the door switch is working. Fuses 4 and 14 are good. They seem to be the related fuses.
Here's what I've checked.
1.. Fuses are all good.
2.. Removed and tested the relay. It tested properly, closing the large contacts when voltage is applied across the two coil terminals.
3.. 12V is present at the large left contact in the relay plug.
4.. I applied voltage to the relay output pin (the large contact next to ^^) in the fuse panel and get the dome/cargo lights to illuminate, so I know the wiring from the relay to the lights is good.
5.. The two smaller relay pins upper and lower look to be the relay coil/turn on contacts. (The middle contact is not used) There is 12v on one of them and it seems the other should be grounded with a door open or when the dash roller is rolled past the detent. I'm not getting this grounding signal.
6.. I do get a warning chime if I open the door while headlights are on etc, so it looks like the door switches are working.
Just got back in from some more testing... Here's a breakdown of how the relay works:
- Relay socket we're looking at is the upper socket.
- High amp 12V power is on the left large vertical contact. The relay's function is to port this voltage to the middle large vertical contact. (the load contact)
- The middle vertical contact (load contact) goes to the dome light and cargo lights.
- The upper horizontal contact is one end of the relay throw coil. This one has 12V present when probed.
- The middle horizontal contact is not used. (actually it's an empty socket with no female terminal behind it.)
- The lower horizontal contact needs ground applied to it to get the throw coil to close the high amp contacts.
With the relay plugged in, I was able to sneak a thin probe to the lower horizontal contact and ground it. The relay activated and the lights came on. So, for some reason I'm not getting the grounding signal to the relay with the dome light rocker or the doors open even though I get the door chime.
Apparently there is something between the door switches and the dome light/roller switch and the relay? Is this the GEM module? If so, I don't see the reason for anything between the switches and the relay? It should be a pretty basic relay circuit?
Is this something (GEM?) programmable, or testable? I don't want to throw parts at it. Looking for a wiring diagram, a diagnostic flow chart or a pin out?
Ford Wiring/Electrical :: 2003 - Instrument Panel Does Not Work?
03 F250 Instrument panel does not work. Have checked all fuses with a meter. Have already fixed broken wires from the OD button on shifter handle. and also the alternator is not charging. I need wiring diagram that shows the wires coming out the back of the fuse box so I can see if the fuse holder is burned out......
View 8 RepliesFord Wiring/Electrical :: 2005 - Rear Turn Signal And Brake Light Won't Working?
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights dont work.
the front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
my second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
Ford Wiring/Electrical :: 7 Pin Trailer Wiring - Running Lights Not Working
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 RepliesFord Wiring/Electrical :: 2001 - Dome Light And Door Chime Bell Stopped Working?
I'm having a problem with my interior dome light and my door chime bell not working in my '01 F-250. I found that the bulb was blown,so I replaced it thinking it might fix the door chime bell also, thinking they were wired together from the factory.
The new bulb didn't fix the problem. I recall that when I noticed the door bell didn't ding-ding anymore was about the time(when it got dark), that I noticed the dome light was out also.
What I may check? The fuses all work, the interior dome relay switch works and I see nothing else in the owners manual to look for as far as dome lighting and door bell chime.
Ford Wiring/Electrical :: 1995 - Speedometer Not Working / Transmission Shifting Hard And OD Light Blinking
I recently purchased a 1995 F150 4x4 with the 351 Windsor. Upon driving it I realized the speedo didn't work, transmission shifted hard,and OD light blinking. After googling my issue I found out it was the VSS. I climbed under the truck to find out the VSS isn't even plugged in. I searched for the wire but could not find it, only a spliced cable.....
View 4 RepliesFord Wiring/Electrical :: 1997 - Tail Light Not Working After Installation Of Trailer Towing Kit Round 7 Pin?
I have a 1997 F150. I installed a trailer towing kit round 7 pin. I followed the instruction and replaced three different fuses after installation. The passenger side turn signal will not work. I replaced the bulb. The brake light works and the bulb is on when the lights are on it just will not blink. When the turnsignal is on it clicks very quickly.
View 4 RepliesFord Wiring/Electrical :: 2007 F250 - Power Out On Cabin Temp Control Panel
Well I've had her just 1 week, used, and today I turned it on and the power is out on the A/C n Heater /Fan Control ASSY. It worked the last 900 miles from FL to OH. And today worked this morning, but 2nd time I got in the truck today there was No Lights in the Air Control Assy. I didn't get an Owners Manual, so what fuse to check.
View 3 Replies