Ford Wiring/Electrical :: 2000 F150 - Hooking Power Door Lock To Command Start?
I am trying to hook up my power door locks to my command start. I am having trouble getting it to work. Ive tried a number of relay diagrams from the12volt.com. I've tried actuators/reverse polarity and it blows both my factory door lock fuse and the fuse I have supplied to the relays. Ive also tried 5 wire alternating 12 volt positive door locks, and 3 wire positive door lock combinations. Both of these combinations the relays click back and forth fine with the actuators unhooked, when I connect the actuators the doors unlock with the factory switch but when I unlock with my remote it blows the fuse. How to properly connect the actuators?
View 3 RepliesFord Wiring/Electrical :: 2000 - Beeps But Won't Lock By Key Fob - Driver Door Lock Switch Won't Unlock?
So, I got my explorer about 3 months ago and it has never locked, the door ajar light was always on and I fixed that by using some WD-40.
Now that the door light is off, the explorer beeps once when i lock it using the key fob but it doesn't actually lock. When I use the lock switch in the rear (by the spare wheel tools) it will lock and unlock. The driver's door lock switch won't lock or unlock, the passenger will unlock but won't lock.
Stock alarm system.
Ford Wiring/Electrical :: 2005 - All 5 Doors Stopped Working When Trying To Lock Or Unlock With Remote Or Door Switch
I have a 2005 excursion with about 112,000 miles and last week all 5 doors decided to stop working on me when trying to lock or unlock with the remote or the door switch. I do hear a sound like something is happening just right of the fuse box. I did a little research and found that this is a wide spread problem. I did order 4 of the 5 actuators and I replaced the drivers door but nothing yet. Do they all have to be replaced in order to work? Or is it most likely something else causing this? Just trying to figure it out before I install the other actuators or take it in to a shop.
View 1 RepliesFord Wiring/Electrical :: Power Windows And Door Locks Suddenly Quit Working
1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
Electrical-wiring - Chevrolet - Cobalt :: Radio Won't Working - Power Locks Occasionally Lock / Unlock Themselves
My landlord's daughter is having some electrical problems with her car, and we're trying to troubleshoot it ourselves. It's a 2006 chevy cobalt with 66,000 miles on it. Here are the issues: 1) The radio's display does not work (you can't see the time or the station). The radio's volume, on/off switch, AM/FM control, and tuner don't work. So, basically, it's stuck on one AM station and she can't do anything about it. 2) Her power locks occasionally lock / unlock themselves when the vehicle is running. 3) This is the most important safety issue right now - there's no power to the pump for her windshield washing fluid. What could it be? Fuses? Wiring? Something else?
View 4 RepliesFord Excursion :: Repairing Electrical Malfunctions - Power Door Lock Button Stopped Working
My power door lock switch in the drivers door stopped working (not the actuator problem, but the actual switch would unlock, but not lock the doors)
I started to research if it could just be simple corrosion and decided to spray the contacts with CRC electronics cleaner. It completely fixed it.
Next, my parking brake light sensor stopped working so I did the same and it fixed it.
I began to research cleaning contacts and found a number of people in the automotive forums who basically spray contact cleaner on every electrical connection they ever touch.
I will do this in the future. The only part I wonder about is if there is something better to spray on them to prevent further corrosion in the future. I used dielectric grease but it would be nice to just spray the thing down. However, CRC does say their electronic cleaner prevent future corrosion.
Ford Wiring/Electrical :: F350 - Switch On Door Does Not Work For The Lock
Repaired my locks on my F350. Had the motor reversed. Before I figured that out I thought I needed to change the wires in the plug. Changed them and it didn't work, put them back and now the switch on that door does not work for the lock; however, all other switches work. What do I need to fix?
View 2 RepliesFord Wiring/Electrical :: 2009 F250 - Driver Door Won't Lock?
My door will not lock..when you hit the remote, the door button or try to push it down..it goes down a little and there is resistance and then it comes right back up. If I use the key it will lock easily, but once you turn the key to get it out it comes right back up. I can hear the motor working, but it feels like there is something stopping it from going all the way down.
View 1 RepliesFord Wiring/Electrical :: 1996 F350 - Driver Rear Door Lock Stuck In Locked Position
My 96 F-350 Crew Cab driver rear door lock is stuck in the locked position. I don't have a cause but do now notice that the pass door lock will not operate with the lock/unlock switch. The rear solenoids seem dead. Front door locks are working.
I tried to put a 10-32 coupling nut on the lock riser and pull. The down position is now 1/8-1/4" higher than normal. This thing is really stuck and is really bad.
So before I start pulling the rear seat and trying to remove the door panel from a closed door; how I might unlock this door? It would be a lot easier to get the panel off if it is open.
Toyota - Electrical-wiring - Camryhybrid :: 2009 - Intermittent Door Lock Failure
I have a 2009 Camry Hybrid. Both driver side door locks work/fail intermittently. This sometimes does/doesn't happen when i use the inside door panel button, outside door button, outside hand sensor when i grab the door latch, remote control buttons, gear shift . . . etc. I see the driver side locks open/close or not move while I see the passenger side doors lock/unlock correctly.
For some reason, it seems to be a bit better when the weather gets warmer around hear in the northeast. I thought it might have something to do with the integration relay. But I'm not exactly sure where it is. I looked under the dashboard, too many wires!. On the drivers side I have located the fuse box, unplugged most of the wires, plugged them back in and it seemed to work only for a day or two, but the temperature also warmed up on those days.
Ford Wiring/Electrical :: 2001 - Dome Light And Door Chime Bell Stopped Working?
I'm having a problem with my interior dome light and my door chime bell not working in my '01 F-250. I found that the bulb was blown,so I replaced it thinking it might fix the door chime bell also, thinking they were wired together from the factory.
The new bulb didn't fix the problem. I recall that when I noticed the door bell didn't ding-ding anymore was about the time(when it got dark), that I noticed the dome light was out also.
What I may check? The fuses all work, the interior dome relay switch works and I see nothing else in the owners manual to look for as far as dome lighting and door bell chime.
Ford Wiring/Electrical :: 2000 - Interior Lights Won't Illuminate From Door Opening Or Headlight Switch?
I have a 2000 E150 (Glavel Conversion) van and the interior lights do not illuminate when the doors are opened, although they used to. They also no longer turn on from the headlight dimmer switch. They will turn on individually if the manual switch at each light is pressed while the engine is running, so the bulbs and wiring appear to be working. I replaced the headlight switch with no noticeable effect. Is there a timing circuit that switches these on for a short period of time to allow illuminated entry that could have failed? If so, where would I find the module and how would I test? Relays and fuses look good.
View 1 RepliesDodge - Electrical-wiring - Grandcaravan :: Automatic Door Locks Not Working
2005 Grand Caravan with 160K miles. Automatic door locks started not working two years ago and needed to be reset by either disconnecting the battery or pulling the fuse. First this would happen every six months, then about every three months, then monthly, and now about every two weeks. Is there anyway to avoid having to reset the system every two weeks?
View 3 RepliesFord Wiring/Electrical :: 2000 F250 - Dash / Parking And Tail Running Lights Not Working
I have a 2000 Ford F250 lariat 7.3 .... This vehicle has an aftermarket double din stereo pillar gauges for Pyro meter and transmission temp and has also had a snowplow attached but since re moved since I purchased it. It also has H ID headlights, which are run by the passenger side headlight connection.
The problem I'm having is that whenever I turn on the parking lights it is blowing the number eight fuse under the hood. Which is giving me no dash lights running lights parking lights or taillights. Initially the fuse would last for a few minutes and then burn out. I should also add that the trailer wiring harness doesn't work either and the driver side headlight will work sporadically.
Prius (2001-03) :: Electrical Lock On Driver Door Not Working
I have a 2001 Prius. Well, it looks like the electrical door lock on my driver door is no longer working. I can lock/unlock it manually with the key, but the clicker doesn't work on it at all. I was having trouble with the front passenger door locking, but discovered that clicking twice would get it to lock. Now, that door is working just fine, but the driver door isn't responding at all (the lights don't even flash). All the other doors lock/unlock fine, so it's not the clicker.
View 9 RepliesFord Wiring/Electrical :: 2008 F250 - Power Mirrors Not Working
I have a new to me 2008 F250 XLT. Neither side on the power mirrors is working. The manual shows fuse number twelve on the passenger side fuse block is the one that controls this circuit. The fuse is good (continuity wise). What I need to know is what color is the wire that feeds power to the switch block on the driver's side door panel. Pulled it out of the door panel and wiring was intact and corrosion free. I need to find out if there is power there or is it an issue between the fuse block and the switch.
View 2 RepliesFord Wiring/Electrical :: 1999 F250 - Door Courtesy Light Wiring Diagram
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 RepliesFord Wiring/Electrical :: 7 Pin Trailer Wiring - Running Lights Not Working
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 RepliesFord Wiring/Electrical :: 2000 F150 - Power Cuts Out When Attempting To Start
2000 XLT F150 4.6 - New starter & solenoid(s), battery cable & fuse links good.
When i turn the key, I hear one single click and the power cuts out entirely. I can't attempt a second start or turn on the lights or have any power going through the truck until I disconnect the battery for about 10 seconds then reconnect. Electrical becomes live again, then when the ignition is turned the electrical cuts out again. I do hear a single cluck at the starter (probably attempting to engage when it cuts out) and a clunk right at the inside fuse box (drivers side).