Ford Wiring/Electrical :: 1999 F250 - Door Courtesy Light Wiring Diagram
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 RepliesFord Wiring/Electrical :: 2009 F250 - Driver Door Won't Lock?
My door will not lock..when you hit the remote, the door button or try to push it down..it goes down a little and there is resistance and then it comes right back up. If I use the key it will lock easily, but once you turn the key to get it out it comes right back up. I can hear the motor working, but it feels like there is something stopping it from going all the way down.
View 1 RepliesFord Wiring/Electrical :: 2002 F250 PSD - Driver Side Door Unlocks Immediately When Locked / Battery Drain
My 02 F250 is killing batteries. Also, when I try and lock the doors with the door lock switch, the doors lock then the driver side door almost immediately unlocks.
View 6 RepliesFord Wiring/Electrical :: 1997 F250 - Rear Tail Lights Wiring
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 RepliesFord Wiring/Electrical :: 1990 F250 Hard To Start - Glow Plug Controller Relay Wiring
I just bought a hard to start 1990 F250. Per the board, just replaced all 8 glow plugs with Motorcraft. Still wouldn't start (it turns over but will only start if you use either). I attempted to install a new BWD brand (Borg Warner I believe) glow plug connector relay today...I removed the old no problem, but am unsure what wires to plug where....the only connection that I'm sure about is the blue wire that works the WTS feature...it plugs in easily but I don't know if there are other connections that need to be made or not? All the wires run from the posts and into the bottom of the unit.
View 2 RepliesFord Wiring/Electrical :: 2001 F150 - Moon Roof Stuck Open
Moon roof is stuck open can hear motor trying to run on open side od switch but nothing on close...
View 1 RepliesFord Wiring/Electrical :: 2014 - Program Headlights And Running Lights Not To Come On When Open The Doors?
Wondering if there is a way to program the headlights and running lights so they DO NOT come on when I open the doors?? And to turn OFF when the switch is off??
2014 super duty lariat
Ford Wiring/Electrical :: 1998 Expedition - Lights On Running Boards Do Not Work
1998 Expedition EB, the lights on my running boards do not work. Checked online and can not locate the fuse for them, checked the lamps and found one that is burnt out. Here's the dumb question, if one bulb is out will that make the other three not work, something like the Christmas light strings?
View 4 RepliesFord Wiring/Electrical :: 1998 F150 - Truck Won't Start With A Fully Charged Battery
I have a 1998 Ford F-150. It has an issue with starting sometimes. The truck won't start with a fully charged battery but when I hook it up to a charger, the truck starts normally. It was going to get the wheels aligned today and when the mechanic went to drive it off the ramp, it wouldn't start. I told him to put a charger on the battery and it started right up. Without the charger it just cranked over and wouldn't start. It doesn't do this every time I go to start it only occasionally. The mechanic had no idea what the problem was and has never heard of this kind of situation. I'm assuming it is an electrical problem but I'm not an expert with engines. The battery was fully charged at the shop and the battery is a year old.
View 4 RepliesFord Wiring/Electrical :: 1983 F250 - No Spark At All
I have a friend of mine that has a 1983 and he had me change the water pump in it because it started leaking and it has been sitting for 7 Months now. I changed that but I can't get this bugger to start. I used to be a mechanic in a past life so I know what I'm doing most of the time so let me explain what has transpired here.
I attached my remote starter, turned on the key and cranked over the engine after shooting a little bit of starting fluid in the carb and she cranks over but won't start. I then pulled the #1 spark plug out and then did the same thing to check for spark and nada. I put my light tester on the coil and there was power. I have run into this kind of problem years ago with other vehicles so I thought I would just go ahead and replace the Coil and also the Control Module. After replacing these parts, still no spark. Since the distributor is there only to distribute the spark (meaning no electrical connections to it) I'm assuming that the Pick Up part that is down by the Crank shaft might be bad.
How to test either the Control Module or the pick up. I'm trying to diagnose this problem without needing to remove the module and taking them to the parts house for testing. (long drive). These wires should have 12 volts when the key is off and these wires should have 12 volts when the key is on.... and so on.
Ford Wiring/Electrical :: No Dome Light And Door Ajar Always On
My dome light does not work and door ajar light is always on. I cant even turn the light with the switch on the side. Just don't know where to start. Do you think it is a switch on one of the doors? I have tried spraying cleaner and WD40 in there but it has not worked. Its been this way since I bought the truck but it is starting to drive me crazy....
View 2 RepliesFord Wiring/Electrical :: 1992 F250 - Blinkers Will Not Work
I recently bought a 92 F250 and love it but the blinkers will not work. I have replaced both flashers and the multifunction switch. (the wipers had issues too that were fixed by the switch...) Now what? Im at a loss..
View 7 RepliesFord Wiring/Electrical :: 2003 F250 - Flashers Won't Work
My work truck is an 03 F250 5.3L. My flashers recently stopped working. I turn them on, and they will work anywhere from 5 seconds to a few minutes, then either blink rapidly and shut off, stay solid for a few seconds and shut off, or just shut off. I push the switch off and on again, and the cycle repeats. All my other lights and turn signals work fine with no issues.
This wouldn't be a huge issue, but where I work I need the flashers a lot. The truck has a bar light and siren/pa system wired into it, but not to the lights or anywhere near that. I can't say exactly how it's wired because I didn't install it, but I followed the wires and they don't go under the steering wheel where I would assume the relay and wires for flashers would be.
What sounds like is wrong? I wouldn't think it would be the relay because then I would think that I would be having problems with more than just the flashers. So I'm not sure if there would just be a ground issue or if it's the actual switch that turns on the hazards. Also, there are no lights that are burnt out.
Ford Wiring/Electrical :: 1979 F250 Starter Keeps Running
I have a 1979 f-250 4x4 with a 351m. The problem I am having is my starter keeps running after the truck starts and also after I shut off the key. I didn't get the battery unhooked in time today and it completely melted the lug off on the solenoid, but the other wires were barley warm. What could be causing this problem? The battery is new, the cables are new and the Sol. was new. Maybe the switch or the starter?
View 8 RepliesFord Wiring/Electrical :: 1991 F250 - Dash Lights Have Gone Out Entirely
I have a 1991 idi diesel f250. My dash lights have entirely gone out and i cannot seem to figure out why, i checked the fueses under the driver dash and under the hood for that matter and nothing is blown.
At the same time, the dome lights, door lights, cab lights, stereo, windows, ever the light in the ash trey etc, work perfectly fine. Could a wire have come loose behind the dash cluster and shorted out everything in the driver area?
I still get the high beam signal, check engine, engine, wait to start, and water in fuel light in the cluster. but no back lighting (when turning the key to the on position)...
Ford Wiring/Electrical :: 2002 F250 - All Power Lost
2002 f250 v10 4x4. Truck will loose all power...
View 10 RepliesFord Wiring/Electrical :: 1997 F250 - Battery Light On?
I have a '97 F250 diesel and the battery light keeps coming on and off. The volt meter shows a good charge. How do I fix this?
View 4 RepliesFord Wiring/Electrical :: 1986 F250 - No Spark From The Coil
I have an 86 f250 i just bought back with no spark. this truck is not original. used to be a diesel. has a 400 out of 81 f250. had this truck running just fine 4 years ago. sold it to a guy running and bought it back 4 yrs later not running.
Checked all the connection to make sure they r clean. Had the ignition modular tested and tested good. I have 12+ volts from the white and red wire. I have a little over 6 volts at the bat side of the coil. I have no spark from the coil. I notice every time I connect and disconnected the bat cable I will get a spark from the coil. i ran a test light from the tack test sight on the coil and tried to start and the light stayed real dim and never flickered.
Ford Wiring/Electrical :: 1976 F250 - Alternator Not Charging
I bought a truck recently and I am attempting to get the alternator to charge. A previous owner hacked up the wiring pretty badly. We found that they had connected the voltage regulator to the horn relay for some reason. Anyway, I am trying to get it rewired and have searched existing threads for info and I thought that I had the wiring sorted out, however it is still not charging the battery.
The alternator has been tested and works. The voltage regulator is new. This is how it is currently wired.
Regulator A Terminal --> Battery side of started solenoid --> Alternator Batt Post
Regulator F Terminal --> Alternator Fld Post
Regulator S Terminal --> Alternator Sta Post
Regulator I Terminal --> Empty
Regulator body --> Radiator Support --> Alternator Ground Post --> Neg batt
When running, the battery is showing about 11.8 and slowly dropping as it runs. The truck has an ammeter in the dash, however it looks like it is no longer connected. Does it need to be connected in order for the alternator to charge the battery?