Ford Super Duty (1999-2016) :: 2004 F350 - 4x4 Hubs Always Needs To Be Locked In
Well long story short, I had the the factory hubs in my 04 f-350 and I was driving down the road and it started making this horrible popping noise. So I pulled over and couldn't find anything and just curiosity locked in the hubs and all was fine. Made me think my hubs were bad, so I went and bought the warren premium hubs, installed them. Went for a drive and still the same noise is there when they are in free spin. But once they are locked in its fine. What this could be? Wheel bearings?
View 4 RepliesFord Super Duty (1999-2016) :: 2002 F350 4x4 - Hubs Locked / Truck Not Shifting From 2nd To 3rd
Ok so some one locked my hubs and put the truck in 4x4 4low i assume my aunt was driving it, truck wouldn't shift from 2 to 3rd is this normal since its in 4low. The shifter also seems pretty stiff and 4wheel isn't used much if there a way to know if 3rd gear toon a crap? Trans fluid seems fine not dirty or burnt...
View 1 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Auto Hubs Won't Stay Locked
2008 F350 hubs wont stay locked in when in auto position. everything stays locked while in manual and 4x4 works fine, but in auto the hubs wont stay locked while spinning. I was trying to find the problem when i noticed that one hub stays locked all the time and the other locks and unlocks as it should but it wont stay locked while spinning. My question is do I have two bad hubs or is their a leak that wont let the hub stay locked? Also on the hub that wont unlock is this a leak problem as well or a internal problem?
View 5 RepliesFord Excursion :: Keeping Front Hubs Locked And Switch In 2wd Position For Everyday Driving?
Is it ok to keep my front hubs locked in and the switch in the 2wd position for everyday driving? Only reason I do it is because in auto it doesn't always go into 4wd.
View 11 RepliesFord Transmission :: 2006 F350 5.4L 5R110W - Replaced Solenoid - Locked Up - Code P0743?
2006 F350 5.4L 5R110W
I've had the TCC solenoid replaced. Not long after, it locked up again. I had the whole solenoid body (including harness & sensors) replaced .....continues to run hot and eventually lock up. IIRC, it gives code P0743
Transmission shop seems to think it's an electrical issue outside the transmission and thus not something they can deal with.
I took it to a dealership and they said that if it was an electrical issue outside the transmission, it would be throwing codes every time I start it up....which it isn't. They would start be replacing the solenoid (and possibly the whole body) with 'brand new' parts.
Ford Super Duty (1999-2016) :: F350 - Steering Wheel Locked While Driving
Yesterday while traveling about 30mph and starting into a slight left turn the steering wheel locked, when the brake pedal was applied it was rock hard and would not engage braking resulting in a single vehicle crash, no injuries. 8300 miles...
How would I make Ford aware of this incident and get them involved? Is it likely that such events may have been logged somehow in the computer? The truck is at our collision repair shop waiting for an insurance adjuster to inspect.
Ford Excursion :: Stuck In 4x4 With Hubs Locked
A relative's '04 EX Limited is having an odd problem. He put it in "4x4 Low" to back a trailer into a barn and after the task was complete the transfer case wouldn't shift out of low range. He tried multiple times and after about 5 minutes of fiddling around with it, it shifted into 4-Hi but wouldn't go back to 2-Hi. The hubs are in the "auto" position and will not manually unlock (the selector turns). 4x4 indicator on dash is not lit. Could the dash switch be bad? Why would the transfer case and hubs act up at the same time?
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Grinding When Hubs Are Locked
Warn Premiums, installed them and now the 4x4 is engaging, but still have a grinding issue. When the hubs are locked and the switch is in 2 wheel drive, the frond end is grinding, if I switch it to 4 hi, the grinding goes away.
View 3 RepliesFord Super Duty (1999-2016) :: 22K With Hubs In Locked Position
Its a 2016 F-250, 6.2L gas truck with the electronic shift on the fly transfer case.
I have put right at 22,000 miles on it like this, frequently at 70-80 mph.
What are the odds I have damaged it and is there anything I should do now that I discovered it - other than put them both in "AUTO".
Truck has been to the dealer twice and not once was this noticed. They blamed the squealing on the brakes which I knew it wasn't.
Ford F-150 (2004-2008) :: Front 4x4 Hubs Always Locked - Vacuum Is Too Low Under Hard Acceleration
I have an 04 F150 (4.6, auto, 4x4, SCrew) with 300,000 miles. Any success modifying existing 4X4 IWE actuators so they are always locked in?
My last set of actuators didn't last long My vacuum is too low under hard acceleration... Actuators partially engage leading to early failure.
I'd like to take an actuator apart, modify it so it's always locked in. Some loss of mileage? Other ramifications?
Ford Super Duty (1999-2016) :: 2000 4X4 V10 - Hubs Are Worn / Locked While Turning
But on my 2000 SD V10 the hubs are worn I just cant find which way to turn them to auto ?
I'm getting popping and such so I think I'm locked while turning.
Also.... IS there a way to check the COPS with a multimeter? I think I got a bad one.
Ford Super Duty (1999-2016) :: Full-lock Clunking With Hubs Locked In?
Had to make a sharp circular turn last night in a parking lot, with the steering turned to full-lock...noticed a very audible clunking or clicking noise during the turn...went away after full-lock turning was released. My hubs are locked in...but I was told there was no issue with leaving them locked in, even during the summer. And there shouldn't be...4x4 disengaged, of course. Must have been the u-joints clicking / clunking? Problem?
View 5 RepliesFord Super Duty (1999-2016) :: 2003 F550 - Hubs Won't Stay Locked
Just got done with a ball joint replacement on my 2003 F550, everything went together great, just as it should. Until I got to the drivers side hub lock.
I have Mile Marker 449s/s manual hubs. Turn from free to lock and theres this loud clicking sound about halfway to LOCK (passenger side doesn't do this). Hub will stay locked for about 2 rotations, then it unlocks and makes a clicking sound. You cannot turn the hub back to FREE, it gets halfway and stops. I tried forcing it and broke the spring fingers inside. Have a new set on order.
Is this a locking hub issue or an assembly error? I was going to take these steps.
- Take passenger side hub lock off and see if it operates normally or same on drivers side.
- If same, remove axle and re-seat/re-assemble everything again
Anything to specifically check? All the parts went back in, washers were in correct order, outer snap ring is in groove.
Tacoma :: 2000 - Bad Vibration When Hubs Are Locked In
I get a very bad vibration when my hubs are locked in. If i unlock the hubs it goes right away. It don't matter if the transfer case is engaged or not.
View 1 RepliesTacoma :: 2007 - Electronic Hubs Always Locked In?
I have a 2007 Tacoma 4x4 and until recently everything was fine. I even got almost 75000 miles out of the stock tires. About a month after the new tires the battery died so I replaced it. Since then the front seems to have a slight vibration and a slight noise. Kinda sounds like when you hear a 4x4 with big mudder tires on pavement. Both the vibration and sound are so slight that others cannot hear or feel it, I just notice having driven it for over 5 years, mostly highway.
When rotating my tires I noticed the front "axles" (don't know the proper name) turn with the tires. With the wheel off I tried holding the "axle" while turning the disk brake but it was as if the hub was locked in. A neighbor who seemed to think he'd heard of it before asked if I'd changed out the batter or had to disconnect it which of course I had. He said that maybe the electronic hubs were not unlocking. The tires still spin freely as the transfer case is not engaged but both of the axles coming from it spin with the tires.
Ford Super Duty (1999-2016) :: 2000 F550 - Squealing Then Grinding Noise Instantly When Hubs Locked In
Having an issue w/ my 00 550. When I lock in the hubs there is instantly a noise, More of a squealing then a grinding. The truck goes in and out of 4x4 no problem and the noise is there locked in 4x4 and not locked in, as long as the hubs are locked in. I can't tell if the noise is coming from the 4x4 driveshaft but there is no noticeable play in the u-joints or the u-joints in the front axle. I did notice when I spin the 4x4 shaft by hand the passenger side joint spins slower then the driver, not sure if that's normal or could be the problem.
View 2 RepliesFord Super Duty (1999-2016) :: F350 - 4x4 Manual Lock Out Hubs
I just purchased an F-350 with manual locking hubs. I am unsure if I can keep these locked in for part time four wheel driving or I need to unlock them each time I go back to two wheel drive?
View 6 RepliesFord Super Duty (1999-2016) :: F350 4WD With Locking Hubs - Shimmy / Vibration
I drove my pickup on mostly dry pavement the other day with it in 4WD and the hubs locked. I got a bit of shimmy/vibration which quit after about a mile. When I got back on ice, the 4WD wasn't working. I assumed the transfer case or locking hubs had failed. Today I got it up on jack stands, put it in 4WD, and locked the hubs. Everything seems fine. What might have happened when I couldn't get 4WD to function.
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F350 4x4 - Vacuum Hubs Won't Disengage
I have a 2005 f350 with the power stroke I went through the hole vacuum system all new hubs, seals, vacuum actuator and fixed it all now I'm having the reverse problems everyone has my hubs are locked all the time as soon as I plug in the vacuum actuator the transfer case is still in 2wd and will switch 4x4 and work and disengage but the hubs are always in unless I unplug the actuator ...
View 6 Replies