Ford Transmission :: 1986 F150 V6 Not Shifting In Drive

1986 F150 3spd Auto 300 v6. My truck will not shift out of 1st in Drive, to shift into second I have to column shift to 2nd. 20mph top speed and idk what to do to fix it. I would like to put a 5 spd manual in it cause I would like to drive over 50mph.

View 4 Replies

Ford Transmission :: 1986 - Replaced Torque Converter Now AOD Transmission Won't Shift Out Of 1st Gear?

Replaced Troque Converter, Truck runs engine runs fine transmission won't shift out of 1st gear.

View 2 Replies

Elantra MD (2010-15) :: 2011 - Transmission Started To Grind When Shifting

I purchased my car almost two years ago. I drive a lot for work, and my car now has 74000 kilometers on it.

So far its gone thru 3 CV Axle Joints on the drivers side, a radio unit, clutch bearing, fork, and fulcrum, and now there's something wore out in the rear suspension (squeaking and snapping).

The transmission in mine has also started to grind when shifting like the syncros are wearing out. Motor knocks when it's cold, sounds like the top end goes dry of oil when sitting overnight and takes awhile to get any.

View 27 Replies

Ford Transmission :: 1986 - Gear Ratio On Transmission?

I have a 3 spee Od out of a 1985 F-150 2wd . I was wanting to put it behind a Onan 6AT diesel . The engine came out of a P-350 bread truck . I runs great . I was wanting to know what the gear ratios are on the transmission . The engine has about 135 ftlbs of torque . The tranny was behind a 300 6 cyl . Iam trying to find out if this tranny will work or will I have to go to a N<!-- -->WC or TKO 5 speed .

View 6 Replies

Ford Transmission :: 2003 F150 - Difficult To Put In First Gear / Little Grind Or Thump?

I just got my 03 F-150 with 112k on the clock. It has the manual 5 speed tranny behind the 4.6L.

However, since I've gotten the truck, it's kind of difficult to put in first gear. If you are sitting at a light and in neutral and the light changes and you push the clutch to the floor and put it in 1st (fairly quickly - a normal reaction time), it will actually do a little grind and/or thump. However, if push the clutch to the floor and wait a couple of seconds and then shift into first, it's a bit of a "push" but it will go in without grinding.

Once in a while shifting to 3rd it feels the same way, but won't really grind.

I'm just wondering if that means the clutch is toast or is it the trans that is toast? Reason I ask is my 96 Cobra with the T-45 5 speed would grind going into 5th gear if I just normally put it in. I used to have to put it in neutral and then push the clutch in again and slowly shift to 5th for it not to grind. And it wouldn't go into 3rd if I tried to shift fast or under power. I replaced the clutch and found out the trans was actually going bad, but it had 173k on the clock.

So, I'm really paranoid that it's my darn trans in the truck instead of just the clutch. Whenever my old Camaro clutches used to be dying, they would slip more than they would ever grind going into a gear.

View 14 Replies

Ford Ranger / B-Series :: Loud Screech / Grind - Transmission Locked In 5th Gear

Last night, on my way home, I suffered a catastrophic transmission failure in my 1991 2.3L 5 speed. Stepped on the clutch on an exit ramp from the freeway and was rewarded by a LOUD screech/grind, a stopped vehicle, and a transmission "locked" in 5th gear. The local HERO service pushed me out of traffic and I got towed home. Looks like a transmission transplant is in my immediate future. So - the question is, what year manual transmissions match up to a 1991 2.3L 4 cylinder, standard cab, 2WD? I need to start searching salvage yards.

View 3 Replies

Ford Transmission :: 1986 - Possible Gear Swap 4.10?

My 1986 F150 in my signature has new 33" tires, up from the old 31" tires, and the even older 28" or whatever the stock size was. Needless to say, it feels pretty sluggish lately. First, I want to change the gears to get the engine back into a favorable RPM area while cruising. I used a calc and figured 4.10 gears would get me back to where it was with the 3.55 gears and stock tires.

There are several different spline counts and carriers and all that stuff. I need selecting replacement gears that will work, and first off, knowing if my carrier will even accept them. It has the stock Dana 44 front and 8.8 open rear...

View 4 Replies

Celica :: 1986 V6 Transmission - Hard Shifting / Not Smooth

I have an 86 celica with a 3sgte swap. 92 Camry v6 transmission . It feels rough when going into gears. Not smooth. I just replaced the transmission and it feels EXACTLY like the old the.

View 1 Replies

Ford Ranger / B-Series :: 1986 - Transmission Overhaul - Hard To Get Clutch Into Gear From Neutral

Rebuild on the Mazda 5 speed transmission. My 1986 Ranger 2.3 Four cylinder has 280,000 miles and the clutch has never been replaced. It's not slipping but I'm having trouble getting it into gear from neutral. Was told that the release springs on the clutch plate have weakened causing the clutch to not release completely so figured it's time to replace it. It's done well the last 280,000 miles. The question I have : overhauling on one of these Mazda trans and how difficult was it. Any special tools required, etc...I see Autozone has a rebuild kit which appears to have bearings, seals and gaskets. Figured while it was out I would go ahead and rebuild it myself if I can. Rebuilt a few engines but never touched a trans.

View 4 Replies

Ford Transmission :: 2000 F150 - Transmission Holding 2nd Gear Too Long Before Shifting Into 3rd

I have a 2000 F150 5.4L with 157k miles on it. I think it has the 4r70w trans. The transmission has started holding 2nd gear too long before shifting into third. Throttle position doesn't matter, it does it even under light throttle. I do not have a check engine light. I have owned the truck since new and the trans fluid has been changed 3 or 4 times. The fluid looks pretty good now, not burnt or anything. The truck has been sitting in the garage a lot over the past 2 years, I drive it at least once a month and have put maybe 2000 miles on it this year. It shifts fine through the other gears, just 2-3 has an issue. Truck has the towing package.

View 6 Replies

Elantra XD (2001-06) :: Transmission Is Shifting Into Higher Gear Without Releasing The Lower Gear

My 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.

My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.

The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.

View 1 Replies

Ford Transmission :: Hard Shifting From 1st To 2nd Gear

Have a 2000 expedition with 84,000 miles. Tranny seems to shift hard from first to second gear. Its been 24,000 miles since my last dealer tranny service. Thinking of getting a new service now before the recommended 30,000 manual recommendation. Whats happening?

View 6 Replies

Ford Transmission :: 1994 F150 Not Shifting Into 3rd Gear Or Above

My 94 F150 has been actingup lately with the 4r70 transmission not shifting into 3rd gear or above. I replaced the MLPS sensor and re pinned the plug as per the instructions with the switch.The old sensor had the plug on the side, same type of plug, but wires indifferent spots. Truck wouldn't start like that, so repinned to match the instructions. I couldn't get the neutral mark to 100% line up as there is not enough adjustment, but it is very close.

The old plug had

32-298-140-33
57-199-359-463

I switched it to

57-359-199-463
33-140-298-32

Then tried

463-359-199-57
33-140-298-32

Truck still won't shift to 3rd, overdrive off button doesn't light up and itwon't start in neutral. I tested the ground at the connector and it lights up atest light connected to the pos bat cable with no issues.

Back up lights won't work, but flicker as going from R to N, so I suspect that is due to the fact I couldn't get the marks to line up 100%, but i'm not worried about that now.

View 1 Replies

Ford Ranger / B-Series :: 1993 - 4x4 Not Engaging / Grind Just For A Quick Sec When Shifting

So went today and bought a 1993 ranger 4x4 ext cab 4.0! Runs good some bad handy work that i need to fix but truck has plenty of power and good handling...

issue 1- 4x4 not engaging. the light by the push buttons does not come on and you dont hear the "clicking" of the relay trying to engage. so whats the problem and how do i fix it?

issue 2- when clutch is fully depressed and you go to shift (this is only sometimes) you can feel and hear it grind just for a quick sec. and forget about down shifting you cant do that without slowing down. so maybe new clutch?

issue 3- at 65 the vehicle does shake a little otherwise but pretty smooth. any tips on how to smooth it out? maybe new ball joints? tighten some stuff up maybe?

View 14 Replies

Ford Transmission :: E4od Not Shifting Out Of First Gear Half The Time

Trying to fix my 97' F-250 5.8, e4od. The e4od won't shift out of first gear half the time. It is fine when I manually select 1 or 2 when the problem happens, no check engine though. The fluid looks great and doesn't have an odor. Here is a video of it failing to shift...

YouTube....

View 7 Replies

Ford Transmission :: E4OD Streaming Fluid Now Not Shifting Into Any Gear

My son was driving my F250 (big mistake) when as he says he noticed it was leaking transmission fluid. As he was driving it he noticed fluid coming out then it just stopped working.(motor was running but transmission would not pull in any gear) We towed the truck home and let it sit for about a week. Now it will start but when I try to shift it into gear it will run through the gears but there is no action. It will not engage into any gears.

View 6 Replies

Ford Ranger / B-Series :: 1997 - Transmission Not Shifting Down Into First Gear Not Even Manually

I just had a 97 Ford Ranger with a 3 speed overdrive transmission in my garage that we replaced the transmission because it was not shifting down into first gear, not even manually!. The new transmission is doing the exact same thing as the original.

View 5 Replies

Ford Transmission :: E40D - Rough Shifting From 1 To 2 Gear / Whole Truck Shudder

My 1992 F-250 7.3 4X4 has a very intermittent issue with the E40D. Rarely, usually after a lot of around town driving (I don't know if that has any direct correlation), I will get a rough shift from 1-2. It will kind of bang into gear and make the whole truck shudder.

On one of it's episodes, it also did it in 2-3, however that only happened once and I haven't been able to make it do that again. I'm worried that it's something that I should address, if I can do so without just rebuilding the whole transmission. It doesn't slip and shifts fine most of the time, other than the occasional 1-2 issue.

To cut this short, does this sound like a 1-2 accumulator issue? Maybe just old truck syndrome? I feel like this is a dumb as hell question, but isn't it a bad idea to install a shift kit in an E40D with 126K miles on it?

View 3 Replies

Ford F-150 - 1997-2003 :: Transmission Seems To Be Sliding Or Shifting Backwards When Takeoff In 1st Gear

I have a M5OD that I replaced the clutch in in my '99 150 4wd in December . Manual Tranny. Now when taking off in 1st gear the transmission seems to be sliding or shifting backwards, but only in first gear. Got under my truck and looked, can't find any identifying marks to where it might be moving or what is causing this. All frame mounts are tight and the bell housing is flush with the motor. Yes, i did do the clutch change myself in shop class.

View 1 Replies