Ford Super Duty (1999-2016) :: 2009 F250 - Pulls Right When Brakes Applied?
I have a pedal pulsation, steering wheel shimmy, and pull to the right when the brakes are applied in my truck. It is a 2009 F250 4x4 gas V8. I just replaced the pads, rotors, and calipers on the front and that's when the problem started. It definitely gets worse with speed too. I replaced the calipers because the right one had seized up and the left one looked to be on the way. There are no odd noises and the wheel bearing doesn't feel like there is any play in it. What this could be?
View 1 RepliesRam / SRT10 :: 1997 - Truck Pulls To Left For Second When Brakes Applied
I have a 1997 Ram 1500 when I apply the brakes the truck pulls to the left for a spit second then goes straight.
Example: doing about 40 MPH take hands off the wheel and slam on the brakes, truck pulls immediately to left, like I did a quick lane change then goes straight.
About a month ago I replaced a section of brake line going to left rear wheel.
Ford Escape / Hybrid :: 2005 - Driver Side Brake Light Does Not Come On When Brakes Applied
The driver side brake light does not come on when you apply the breaks but the light comes on when you turn them on.
View 2 RepliesFord Super Duty (1999-2016) :: Pulls To Left While Brake Applied - Piston?
Well just called it quits from working on the truck tonight. Had some issues with my brakes going to the floor and pulling to the right some, so I went to auto zone and bought all new pads. Didn't think it was time yet because I just replaced the rotors, pads, calipers, maybe 20,000 miles ago. When I got home and everything pulled apart I looked at the pads on the truck and they still had 60% life. I looked closely and noticed that the guider pins on the caliper bracket (front drivers side) were seized. I figured this is what was causing my truck to pull. Looked on the passenger side and it looked similar. Went back to auto zone and returned the pads and bought new brackets for both sides. I got the drivers side replaced and working and all seemed well. I got to the passenger and had a hell of a time getting the pistons on the caliper to compress so I could get it off. Once I finally got it, I noticed the pins on that side were not seized. I bought 2 sets of guider pins so I took the old ones out and greased up the new ones and installed them. Put everything back together and took the truck for a drive. Everything seemed normal at first, but once I got on the highway and hit the brakes, my truck pulled to the left. HARD.. Im assuming this is because of the pistons on the passenger side caliper I was having a problem with, not having the piston compress all the way causing my truck to pull. While I was looking at the caliper, I also noticed what '"looked" like a grease fitting, and also a bleeder valve a few inches away from it. Am I crazy, or is that fitting for bleeding the brake lines also...?
View 5 RepliesCorolla / Matrix 2009-13 :: Right Side Make Lot Of Noise When Brakes Applied
I have problem with left front brakes corolla. When I changed the router it was fine, but after few month, during down hill when I apply brake, right side make lot of noise. I cleaned pads and pin are good. It happens only on right side, down hill is problem.
View 2 RepliesFord Brakes/Suspension :: Consistent Squeaking Coming From Back Drum Brakes When Pedal Is Applied
After putting my Ford Ranger in park and pressing down on the E-break to get the news-paper or mail. I've noticed that there is a consistent squeaking coming from the back drum brakes when the brake pedal is applied. But only for a certain period of time; then the squeaking stops.
View 8 RepliesFord - Explorer :: 1997 - Steering Wheel Pulls Side To Side / Alignment?
I have a 97 ford explorer sport with new tierods ball jonts control arms sway bar end links and bushings n I am having an issue with the steering its been in for alignment too n it pulls side to side....
View 6 RepliesFord - F150 :: Truck Pulls To The Left While Applying The Brakes
02-F150-4.2L-102k. Truck was rolling down the road at approx. 35 to 40 mph. A speed bump/table appeared out of nowhere and was hit before beeing seen. Immediately since this event, the truck pulls to the left while applying the brakes. It pulls very hard and is fine while rolling down the road. Is there some damaged steering component or did one of the calipers go out from the jolt?
View 4 RepliesFord Brakes/Suspension :: 1981 F100 Pulls To The Right After Alignment?
1981 f100 2wd 4.9 L6 c6 9" rear w/ front discs and rear drums. went through and fixed all leaks after I got it running. Then I got to steering and suspension. Replaced all tie rods. only thing i reused were adjusting sleeves. Taped off thread protrusion on oem steering parts so i could measure and get the new rod ends in the ballpark. Did a simple shadetree toe adjustment so i could drive it to get it aligned. I should mention i already replaced front rotors and bearings as well. Mic'd the spindles so they're in spec.
I am however running used tires but they balanced out pretty well. all torque application was strictly adhered to by the maintenance manual. made sure tire pressures were up to snuff and greased everything that could be lubed to include kingpins. the kingpins are the only thing i have not rebuilt....but i did check the radial and axial play....nothing out of spec. So I took the truck in for alignment. picked it up and it pulls to the right just as bad as it did when i drove it to the shop. the tech tried to tell me it was just a bad tire and that i needed a new one....of course i knew that was wrong.
Swapped tires from side to side, and magically the truck still pulled to the right. So I've narrowed it down to either the steering box maybe, or just a shade tree alignment tech that doesn't know his fourth point of contact from his elbow. It does not have a steering stabilizer installed, but i would think that shouldn't matter?
Ford :: Chatter When Brakes Applied
I lost a brake line on my pickup truck, had it replaced a couple days ago. Occasionally, when i apply the brakes i get a brake chatter. It has occurred 3-4 times in the last 4-5 days. No pattern to it happening.
View 4 RepliesFord Brakes/Suspension :: Truck Badly Pulls Left When Braking Hard
Just replaced break pads and rotors. Inner pad on left side was gone leading me to believe slides were not working properly. Pulled apart, cleaned and greased everything, and replaced pads and rotors. Calipers seem to be working fine. Now when I break hard, the truck pulls badly to the left. When I break softly, it seeks normal. My front end is a bit out of whack and veers just a bit to the left. Do you think this is my issue with the breaking ? I'm getting new tires and an alignment soon but was just curious.
View 3 RepliesFord Super Duty (1999-2016) :: Pulls To The Left When Push The Brakes
My 2012 f350 6 lift when I push the brakes it pulls to the left kinda bad and the steering wheel is off to the right..
View 4 RepliesFord F-150 (2009-2014) :: Bad Vibration When Brakes Were Applied
I have a 2012 FX4, 5.0. The dealer tuned the front rotors and replaced the pads at 19k because of a bad vibration when brakes were applied. Now at 45k, the same thing is starting to happen again. I am pretty sure it is not my driving because my 2001 F150 4x4 had 162,000 miles on it and never had a rotor off of it or turned and was on the 3rd set of pads when I traded it on the 2012.
View 14 RepliesFord Excursion :: No Trailer Brake When Brakes Applied?
So on our trip up here I experienced a strange problem. Normally when I apply my brakes my trailer brakes kick in via the controller. This time when I apply the brakes I'm only getting my truck brakes. I can still use the brake controller manually to slow down but it's worrying. What is going on.
View 7 RepliesFord - F250 :: 2001 - Shake And Vibration When Brakes Applied
My F-250 7.3 liter diesel is eating up front tires. I have tried new upper and lower ball joints, new shocks, alignment, and new tires (again). Tire wear is on the outside right and inside left. At times when the brakes are applied it causes a shake and vibration. One mechanic though I should get the leaf springs redone.
View 4 RepliesFord Excursion :: 2001 - Acceleration Pulls Left / Deceleration Pulls Right
2001 Ex 7.3 4x4 with 4" lift (6" with 37" Pro Comp tires)
All new front end steering components.
All new Shocks (bilstein)
All tires properly inflated to same PSI
All new brake rotors, calipers, caliper mounts, and pads.
When under hard acceleration the vehicle pulls to the left and I have to compensate by steering to the right. Under deceleration the vehicle pulls to the right and I have to compensate by steering to the left.
I am about to change all four brake lines to Braided Stainless Steel lines, replace all leaf spring bushings with polyurethane, and install a rear anti-sway bar. I'm going through this methodically enough or am I just building a brand new truck one part at a time?
Ford 6.0L Power Stroke Diesel :: Vibration Noise When Brakes Applied
I have a 2007 Ford F-250 6.0L that's making a vibration noise when I come to a stoplight with my foot on the brake, just idling. I just recently replaced the front brake pads this past weekend. I looked under the hood and visually checked for any obvious things that could be making the noise and did not find any, I did notice my power steering pump is damp with fluid. Now this noise only occurs when my foot is on the brake, anytime my foot is off the brake, it goes away.
I checked brake fluid level and power steering pump fluid level, both are fine except power steering fluid looks like chocolate milk. I don't know if the power steering pump would be the cause of this, but I'm going to replace it because it's leaking and I'm guessing the fluid for the power steering is way overdue. I've only owned this truck since March of this year and it has 128,000 miles on it. Hopefully this video link to youtube works, the sound in the video is the same noise that I'm hearing from the truck. Where this noise is coming from.
Vibration noise powerstroke - YouTube....
Ford Excursion :: Turn Signals Stop Working With Brakes Applied
Just noticed this tonight. While making a left turn, I had the blinker on and had the brakes applied and noticed the indicator on the instrument cluster was blinking. Once off the brakes, it took it a few seconds for it to resume blinking.
When I got home, I checked to see if the right signal did the same and it did. I also checked the rear lights and when the signal is on and the brakes are applied the light does not blink nor does it brighten up like they're supposed to when the brakes are applied, it stays dim as if both the blinker and brakes are off.
I did a quick search. I have not checked any of the bulbs or wiring, but I'm thinking it might be the turn signal switch/ lever. What the problem might be?
Ford Super Duty (1999-2016) :: 2003 F250 - Truck Pulls To Right When Driving And Pulls To Left On Braking
My 2003 F250 6.0 pulls to the right when driving at any speed. In order to keep it going straight the steering wheel must be slightly tilted to the left, not much but a little. When the brakes are applied hard it will go to the left slightly if you are not holding the wheel good. Neither of these are terrible, just a nuisance. I'm worried about uneven tire wear too. One front wheel bearing was replaced a few weeks ago. It had this problem before that and still does after. Does this sound like an alignment or maybe something more?
View 13 Replies