Dodge - Stratus :: 1999 - Fuel Gauge Works From Half To Full
1999 Dodge stratus fuel gauge works form Half to Full. Fuel pump replaced and mechanic thinks the BCM is bad. Need to figuring out the issue. Fuel gauge was checked and it gives the correct voltage.
View 3 RepliesFord Super Duty (1999-2016) :: Fuel Gauge Not Working
Everything was working fine, getting down to about 1/4 tank. I do the usual, fill up, startup, reset the trip, and look at my level and it hasn't changed, neither has the 'km until E'. What would cause this? Failed Sender? No check engine light (yet). I guess I'll be watching the trip meter for a while.
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Gauge Goes To Beyond Full And Stays There
Two years ago I acquired a very very nice 2001 F350 DRW crew cab. The person I purchased it from put a Remanufactured 7.3 in it and set the truck up to pull wedge trailers. He put 25K miles on it and put it on Craig's list where I found it. It just turned over 300,000 miles.
One of the changes he made was to install a 70 gallon fuel tank in the frame rails below the bed. He told me that when the gauge reads EMPTY there is still 20 gallons in the tank. I remember him telling me that this anomaly is due to using the stock Ford pickup in the larger tank.
I have never filled the tank because so far the truck is used locally. I usually put 10 to 20 gallons in and when it gets to E I do the same fueling.
Then one day I turned the key on and the needle went up and beyond the full indication.
I can get under it and maybe the tank has some name or model number on it.
The truck runs fine, but the gauge concerns me. Eventually the truck will be making round trips from Chicago to our retirement home in Santa Fe, NM. It would be nice to have a working fuel gauge!
I have spoken to the person I purchased the truck from. He installed the tank as part of a complete upgrade that included a re-manufactured 7.3. The fuel tank is a 67 gallon Titan mounted between the frame rails. He believes that the original Ford sending unit was installed. That means it has 300,000 miles on it. I had the truck on a lift yesterday and it is a very tight fit. The garage said the best way to do the repair is to remove the bed. Six bolts, disconnect the tail lights and the 7 pin trailer connector and it is off.
So, my questions now are... Should I stay with a new Ford sending unit or are there better ones to install? Are there any other updates to the fuel delivery system that should or could be done at the time?
Ford Super Duty (1999-2016) :: Fuel Gauge Stuck On Full
2000 v10 f350 single tank...fuel gauge is stuck on full. I'm on the road so I don't have my drawings so I tried some quick troubleshooting. If I remember right 160k or so is full and 20k ohms is empty...so I unplugged the sender from the harness which should be open and the gauge should read empty. With key on its reading full. I then followed the harness and unplugged it near the brake booster...key on it reads full. Just wanted to make sure I'm not doing anything wrong before I rip the dash apart.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Gauge Stuck On Full
Well besides the pyro breaking friday BEFORE live tuning,and the exhaust leak I gained on the way to Texas(not inpart of the pyro not working). Now the fuel gauge is stuck on full. It looks good,200+ miles and still on full. Could it be the gauge,or possibly just the sending unit? Maybe a fuse?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Installation Of Fuel Pressure Gauge?
I bought an Autometer 4763 gauge that didn't come with the correct fittings to plumb the sender into one of the extra ports on the back of the bowl. I went to the Ace hardware store right across the street and they didn't have anything (not surprised) and then Napa. They couldn't find a fitting to match either. He found that the plug threads are 7/16 20 tpi and the sender is 1/8" NPT. He suggested getting a 7/16 20tpi bolt, drilling it rifle-style, and then tapping it for a 1/8" NPT. The alternative, and what I ended up doing, was to use brass fittings to tee it off one of the supply lines to the heads. I ended up going that route but wanted to know if I should have looked harder for the right fitting.
Here's a pic of what I have now. I've test fit it, and it seems to work although I will need to insulate the hard lines because they rub due to the offset.
Ford 7.3L Power Stroke (1999-2003) :: Fuel Gauge Reading Inconsistently
I've had an ongoing issue with my fuel gauge reading incorrectly, and now I'm trying to fix it! Basically, it will change all over the place while I'm driving (not erratically, but definitely moves occasionally). I recently fixed my overhead display, but the "miles to empty" display doesn't seem to be very consistent. It will read 450 miles to empty, and then the next time I look at it, it will have dropped 100 miles or something (after minimal driving).
So I'm wondering where I need to begin looking to fix this problem. I've replaced the dash cluster using Circuit Board Medics, so I'm fairly confident that's not the issue. I've read that it can be the fuel pump or the fuel tank sender, but how to check if these are actually the problem or how much time it will take. Luckily, I've never run out of fuel and been stranded, but I need to fix this or it's only a matter of time!
Ford Wiring/Electrical :: 1999 F150 - Fuel Gauge Indicates Empty At All Times
My fuel gauge indicates empty at all times. The first suggestion I received was to replace the sending unit in the gas tank. I did that but the gauge still indicates empty.
I tried the HEC Dealer test mode and I now know that FUEL reads 255. Which should be an 'open' state. The connector near the fuel tank does appear to be making good contact, so my suspicion is a broken wire somewhere between the rear of the truck and the front.
I tried following the wire on it's way towards the front of the truck, but I quickly loose sight of the wire as more branches enter into the wiring harness. Where does this wire end? Does it terminate in the engine compartment, at the instrument cluster, somewhere else?
I just can't figure out how to narrow down where the break in the wire might be. Or am I chasing down the wrong root cause?
Ford Super Duty (1999-2016) :: F250 V10 - Fuel Gauge Not Working
1999 F250 V10 gas. I changed out the fuel pump, and now the gauge doesn't work. Checked all fuses - they're good. Is there any possibility that I could have accidentally pinned the float under the pickup sock, or got it hung somewhere? Is this a common occurrence? Don't really want to drop the tank again - but looks like I will have to in order to check/fix.....
View 3 RepliesFord Super Duty (1999-2016) :: Fuel Gauge Stuck Over Full
I have a 2000 ford F 250 with V-10 engine with fuel gauge stuck. The problem started in the winter a couple years back on a cold night when I fueled the truck with it running. The fuel gauge never went down. I assume this would indicate a stuck float? I dropped the tank and noticed a loose yellow wire. I can't see that the wire was attached anywhere though? A V-10 is not the engine to be guessing with on fuel...
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Pressure Gauge Installation
Looking for pics of where/how they mounted their fuel pressure gauge? I'm getting ready to install one.
View 11 RepliesFord Super Duty (1999-2016) :: Dash Light Out At Fuel / Oil Pressure Gauge
On my 05 Super Duty, the gauge light for the fuel and oil pressure are out. The needles are still illuminated red but the backlight for the gauges are dark. Are these replaceable bulbs or are they a circuit board diode or something that can't be easily replaced?
View 1 RepliesFord Super Duty (1999-2016) :: 2004 - Fuel Gauge Fall To Empty / CEL On?
Ever since January My fuel gauge has been acting up big time. I can have any amount of gas in my tank at any given time and the fuel gauge will fall to empty resulting in the fuel and check engine light coming on. The gauge will then return to its position (it still doesn't read correctly) and the check engine light will stay on. I took it to the ford dealer and they said to replace the entire fuel sending unit assembly. I bought the oem motorcraft fuel sending unit assembly and did it myself. The only problem is, I still have the issue. I'm currently checking fuses and relays, By the way, my truck is a 2004 f250 fx4 5.4
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Crank But No Start With 1/4 Tank - Bad Fuel Gauge
1/4 tank just kept cranking. Added some diesel and started right up thought it was bad fuel gauge. Went about a mile and shut down just off. coasted went got more diesel but this time cranked but no start. anti theft light was flashing too.
Towed home started right up after tow... Starting now... Tomorrow was going to change the fuel filter....
Ford Super Duty (1999-2016) :: Fuel Gauge Slow To Respond After Fill Up
Yesterday went to fill up ($4.05 a gallon geezz!) and noticed that after getting back into the cab, the fuel gauge still showed almost empty. So after yelling a few expletives, I looked again and noticed the gauge starting to make it's way up the dial. It took almost 30 min. before it showed almost full. I'm not sure what the problem is, as the gauge seems to still function. I don't drive the truck much as I use it as a tow vehicle. However, I do try and take it for a spin about 3-4 times a month just to exercise it. I was wondering if the fuel has started to gel and that is the reason for the slow fuel gauge response. Should I add a fuel conditioner/cleaner now that I have a full tank?
View 9 RepliesFord Super Duty (1999-2016) :: Fuel Gauge Will Drop All The Way To Empty Then Go To Almost Full
I have an 03 f350 4x4 cc long bed and I seem to be having a problem with my fuel gauge. It doesn't show the true amount of what's in the tank and because of that I have run out of fuel a few times.
sometimes when I'm driving the light will come on and the gauge will drop all the way to empty then a little later it will go to almost full even with only putting 10 gals in the tank.
Any fix for this or do I need to replace the sending unit?
Ford Super Duty (1999-2016) :: Fuel Gauge On Empty With The Light On 25 Gallons
I have a 2001 f250 with the 5.4. from what I have read i should have the 38 gallon tank. i have been really questioning the accuracy of my fuel gauge on empty with the light on 25 gallons and the fuel pump will click off and after i drive i can park and my fuel gauge will read lower than what it was when i pulled into the driveway with. me and the wife went driving yesterday and we pulled back into the driveway on half a tank this morning I went to go run some errands and when i started the truck the gauge was almost on a quarter of a tank my driveway is flat and after driving for about 35 minutes the gauge was still in the same spot and did not move up nor down.
I have a locking gas cap cover so i know someone is not taking gas out. I have changed the fuel filter and tried numerous different fuel system cleaners to try and see if maybe the contacts on the float in the tank are dirty nothing has changed or gotten any better. I have checked the wire harness from the top of the tank and followed it up under the hood and found no drop in voltage or cracked or damaged wires. I checked with my multi-meter I used my fluke meter not some cheap one. Don't know if the gauge is reading less or more from getting gas i am thinking it is showing less than what is in the tank. What could be my problem?
Ford Super Duty (1999-2016) :: 2003 F250 - Fuel Gauge Won't Go Below Half
I have 03 F-250 with a 5.4 in it. Recently noticed the gas gauge is not moving much and seems like it will not go below half a tank. The gauge will go up however when i put gas in it. I just put techtron in it last night to see if this might work. Wasn't to sure if i did a battery reset on the truck if that may work as well.
View 2 RepliesFord Super Duty (1999-2016) :: 2003 - Replaced Fuel Pump Now No Gas Gauge?
I just replaced my fuel pump to avoid another tow truck ride and now my fuel gauge is off. I filled up the truck today and the fuel gauge is only showing half a tank. I turned the truck on and off several times to try to reset it, but that didn't work.
Truck is a 2003 with the 5.4.