Ford Super Duty (1999-2016) :: Add Antenna Via Roof - Now 3rd Brake Light Not Working?
Today I started to install my satellite radio in the 250. I ran the antenna through the roof where the 3rd brake light is. The lights were not working so I thought I'd just replace them while it was off the truck. To my surprise the bulbs the guy had installed must have been too big because the wires, sockets and the housing were melted and not really usable. With that said. I can't seem to find a web site that would have an aftermarket setup that would fit the roof of a F250.
View 8 RepliesFord Super Duty (1999-2016) :: 2007 - Replaced 3rd Brake Light With LED Now Not Working?
On my 07 F250 Outlaw recently I replaced my stock 3rd brake light with a Bully LED brake light.. Noticed last night that it is NOT working.. the red LED's arent working but the white cab lights are.
I plugged the stock one back in and still nothing. After looking in the owner manual at the fuse block I did NOT see a fuse for it... Got to experimenting and my peddle raise lower switch is not working either. I looked at that fuse and it looked good but just to be safe I replaced it with a new one and still nothing...
could these be tied together some how for power?
Ford Super Duty (1999-2016) :: 2005 F250 - Brake Lights Not Working?
I have a 2005 F250 that the brake lights are not working when brakes are applied. The rear blinkers and flashers are working. what could be my problem.
View 2 RepliesFord Super Duty (1999-2016) :: Brake Lights / Cruise Control Stopped Working?
I have a 1999 Super Duty 5.4l Manual transmission 4x4 105,000 miles the cruise control stopped working a month ago, I didn't think much of it because I frankly don't use cruise as this vehicle is usually used to tow and I don't run cruise towing.
Long story short I went to tow my camp trailer and noticed my brake controller was not actuating the trailer brakes when I braked, the controller is showing connected and when I manually actuate the controller its working, so I knew I had a brake light issue, I checked the brakes and sure enough I have no functioning brake lights.
I bought a Motorcraft OEM brake pedal switch and replaced it to no avail,I have also checked the applicable fuses they are fine. I have a master cylinder cruise control switch to change but have my doubts this is the issue since the brake lights and cruise are non functional.
Ford Super Duty (1999-2016) :: 2004 - Dash / Running / Brake Lights Not Working?
I recently got my truck back from the dealership 04 super d 4x diesel (wife put gas in).. Anyway my dash lights, running lights and brake lights are not working. I checked fuses already and I did not see any obvious problems. I also replace the switch but that didn't work. Perhaps a ground somewhere or a relay? Turn signals and headlights work.
View 1 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Third Brake And Cargo Lights Not Working
I have a 2008 F350 Super Duty Regular cab long bed 4X4 I have no cargo light and no third Brake light, checked and even replaced bulbs. Still have no lights up top, what to check or how to fix this? Can I tie the cargo light into the dome light inside without screwing something up? I can't understand why they stopped hooking the cargo light to the dome light but this one seems to be wired separate. Would love to get these lights working again. When I bough t the truck the cargo light didn't work and I thought maybe the bulbs were burnt out, I never checked the brake light I tried to get the cargo light working and that's when I found out the brake light didn't work either.
View 3 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Brake Lights / Flasher Not Working?
2004 f250, brake lights except 3rd brake light do not work. flashers also do not work. turn signals work on both sides. when you turn on the flashers only the right indicator on the dash lights. checked all fuses for brake lights and am at a loss. On a float trip this weekend with my toy hauler and need brake lights to get home.
View 2 RepliesFord Super Duty (1999-2016) :: Parking Brake Not Working - Burning Axle Seal?
Will leaving the parking brake on burn up the axle seals? My parking brake isn't working well at the moment. I need new ones from all the fluid my bad seals leaked on them. So, at the moment they just scrub a bit while its engaged. However, today I found out that my parking brake light for one reason or another is not working and I got in a hurry and didn't release the brake. by the time I got to where I was headed (about 15 miles), I could smell gear fluid burning and my driver side rear was smoking. I'm hoping its the fluid that was already soaked into the shoes. I did find a drop of fluid on the bottom of my brake caliper.
View 5 RepliesFord Super Duty (1999-2016) :: 2004 F350 - Trailer Brake Lights Not Working At The Tow Plug?
2004 ford f 350 super duty, 6.0 Liters international diesel, 4door, 4x4, long bed, dual rear wheels. Over 200,000 mileage. I have no power to the trucks brake lights and no power to the tow plugs trailer brake lights, which is the center left and the center right tow plug blade style contacts, while using a 12 volt test light! All fuses are showing good and I replaced the brake switch at the brake pedal, and I also replaced the towing plug with the short wire and connector at rear of truck which is under the rear bumper and the frame mounted tow hitch bar
- Are there any relays that control the truck brake lights and the trailer brake lights ?
- If yes where are the brake relays exactly?
- Have I missed or not done something else to correct the problem?
Ford Super Duty (1999-2016) :: 2000 - E-Brake Won't Working - Replace Front / Intermediate / Rear Cables?
2000 F 350 super cab 4wd 7,3 auto srw long bed. Problems with emergency/parking. My cable probably needs replacing. My pedal will go to floor when setting the e brake. I use very infrequently, but when loading hay on the big bale trailer. I could ignore it but when hit the slightest bump the brake pedal goes down just enough to activate the brake light on the dash and activates the bell/chime until I raise the brake pedal up.
When searching this site one post stated that should not happen. I am trying to figure out if I need to replace the front cable, intermediate cable, and rear cables. And do I need to replace the foot pedal assembly as well. What are the part numbers for these. I generally order from who ever took over Edpartguys for original ford parts. I have new cryo rotors and Hawke brake pads.
Ford Super Duty (1999-2016) :: 3rd Brake Light And Pedal Adjustment Switch Does Not Work - ABS Light On
Was checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 RepliesFord Super Duty (1999-2016) :: Dome Light Not Working When Open The Door And Ajar Light Is On
My Dome lights don't work when you open the door. I can manually turn them on though. Also door ajar light is on. Are these issues caused by the door latch switch? Also have no fog lights I replaced the switch and bulbs. I have a 2003 F250.....
View 2 RepliesFord Super Duty (1999-2016) :: F250 - Brake Light Stays On
The brake light stays on all the time. It started 5+ years ago going out intermittently, then began going out more frequently for longer as the years went by, until now, where it stays on continuously (except for one small miracle where it cam back on during a short drive around town). I don't normally care if it stays on, but for the first time in 7 years I'm going on a long road trip and can not engage cruise control with the light on.
View 9 RepliesFord Super Duty (1999-2016) :: Brake Indicator Light Comes On When Turn On The Key
My '99 250 SD - Turn on the key and the brake indicator light comes on.
Start it and the indicator turns off, the E-brake is still on but no light.
It does have an aftermarket radio installed, by PO.
Ford Super Duty (1999-2016) :: No Reverse Lights Or 3rd Cab Brake Light Either
I just noticed a week ago that I don't have reverse lights. I check the fuses all good. I have checked the harness and there is continuity. So that tells me that the relays are good. I also read to check the neutral safety switch but where it is located. After trouble shooting last night I also noticed that I don't have my 3rd cab brake light either.
View 3 RepliesFord Super Duty (1999-2016) :: 2011 F250 6.7L - Third Brake Light Went Out
The third brake light (on cab) went out and I can't seem to find which bulb to get to replace it. Are they the same as the 2 Taillight bulbs on the bed?
View 3 RepliesFord Super Duty (1999-2016) :: 4wd Stopped Working - No Light Indicating 2wd / 4wd / Low?
Ok I've done some searching and reading and really haven't found a answer. My 99 f250 sd 4x4 v10 with a automatic transmission stock hubs with ESOF. I checked the fuses under steering wheel. All good. Showing no error codes. Replaced vacuum lines. I've been driving it for some time only using the lock outs on the hub. Whats different is there is no light on dash stating 2wd, 4wd or low. And when manually locked they don't move in snow. new hubs? I don't really care about switching with ESOF I just need 4WD for plowing!
View 11 RepliesFord Super Duty (1999-2016) :: ABS Light Comes On And Off Occasionally At Random - Brake Failure
I have a 99 f450 4X4 I'm having brake problems. Without warning when I go to stop my peddle will go right to the floor and I can't stop, at other times I go to stop and the peddle is stiff and I have to put all I have in to it to stop. The abs light comes on and off occasionally at random but as the brake failure has become more and more frequent so has the abs light. Also my steering does seem a bit off, a little tough N jerky and the power steering pump is whining.
View 6 RepliesFord Super Duty (1999-2016) :: F250 - Parking Brake Light Stays On
I have a f250 super duty. I blew a brake line the main going to the rear. So the genius that I am I replaced the line an simple enough I decide hell why not replace the master cylinder too, so I did an I bleed the brakes an everything works jst fine but now the the brake light won't turn off I have tried everything not sure what could possibly cause the light to stay on. I will eliminate some suggestions, I bleed the brakes, the brake fluid is full, the level sensor is completely attached, the parking brake is not on, I pulled the parking brake completely out, even completely disconnected the sensor thinking it would turn off bu it didn't.
View 1 Replies