Ford Super Duty (1999-2016) :: Wiring Fault On Trailer Error Message With A Beep
Every time I touch the brakes I now get a very annoying beep and an error message that says "wiring fault on trailer." I don't have a trailer hooked up so not for sure what's going on. The error message on the console I can live with but that loud beeping is driving me crazy.
If you hit the brake and keep the pedal depressed, then you only get the initial beep and then it goes away. The problem for me is I live north of Dallas so if I'm in traffic then I'm constantly hitting the brakes. I called my dealer today so I'll wait to hear what they have to say.
Ford Super Duty (1999-2016) :: 2005 - Died At Stop - Crank But Won't Stop?
I have a 2005 ford f250 6.0 I was driving back home from a interview and my truck died at a stop light it would crank but no start I tried replacing the stc fitting didn't work so the I replaced the ipr still didn't work bought a new hpop still didn't work I'm lost at this point I have low pressure oil pump is working new icp, what is going on?
View 8 RepliesFord Super Duty (1999-2016) :: 2011 F250 - Truck Starts Beeping And Disable Alarm Start Vehicle Message Comes On Dash
Just picked up my F250 a few days ago and it's been great up until yesterday when I hopped in to start her up and nothing. It's a brand new battery and all lights worked, but the dash was dead. I attempted in vain for an hour or so to diagnose as to why this was happening and just happened to open the door with the key in the ignition and hit the door lock button....all of a sudden the truck starts beeping and the message on the dash said "to disable alarm start vehicle". I turned the key, the dash lighted up and away I went. What I may have done to cause this or has it happened to you? I'm thinking it's something with the key fob but not sure.
View 6 RepliesFord Super Duty (1999-2016) :: 2003 Truck Started Losing Power When Going Down The Road And Then Died
I have an 03 with a 6.0 diesel, going down the road and started losing power and then died. Won't start, and I don't have a scan gauge. Several sources said ipr valve, and from videos on youtube I thought may be a good place to start. I bought a socket and pulled the valve, to check the screen. There is no screen whatsoever on the ipr. The oils clean, as I had changed it about 200 miles ago, and I ran a magnet in the hole looking for a screen, couldn't find anything so I used my fluid pump in the hole. No trash, screen or anything. Do some ipr valves not have screens? What would be my next step??
View 2 RepliesFord Super Duty (1999-2016) :: 2013 F250 - TPMS Light Came On With A Low Tire Warning Message
I have a 2013 F250 and to day the TPMS light came on with a low tire warning message. A little back history, I put new tires on the truck when I bought it and they currently have 9200 miles on them. I didn't like having the tires at the 80psi the tire shop set them at so I lowered them to 62psi right away and haven't had any issues with the low pressure warning going off. Today I was backing into a parking spot and the warning light came on with a low tire message. I checked all the tires and they were right where they should be, but when I got home I added another 5psi to see what would happen and the light never went off after taking it on a 10 mile drive.
My question is, do I have a wheel sensor issue or is something messed up in the computer? I know the door sticker says 75psi front/80rear, but I've been running the tires at 62psi for 9200 miles without trouble so I can't think that the pressure is the culprit. Also, does the spare tire have a sensor in it? In the manual in one paragraph it seemed like it does, but in the next it said that the spare doesn't have one so the light will stay on to remind you to change the spare out.
Ford Super Duty (1999-2016) :: 2008 F350 - Heater Died - Passenger Side Started Blowing Cool Air
I was driving from home to work the other day and it was 6 degrees out. My heat was working good and everything was fine and then all of a sudden the passenger side started blowing cool air. Not cold not warm. Driver side was still hot. It is a lariat and has dual temp zones. Everything I read everyone says blender doors but what would make it stop working out of no where when everything was fine. Occasionally when I start my truck and turn the heat on it makes a popping noise under the dash when the blower kicks on. But it has done this since I owned it an never had an issue. It's 25 below today and I would really love to have completely functional heat. It's an 2008 f350.
View 14 RepliesFord Super Duty (1999-2016) :: Oil Change Soon Warning And Oil Change Required Message
Circumstances required me to make an emergency trip to Phoenix this week. On the way down, I first got the "Oil change soon" warning, followed by the "Oil change required" message a few hundred miles later.
I religiously keep my truck serviced on time, and have never had either of these warnings come up before. My truck had 2700 miles on it since last service was done when this first warning came up. My truck gets very little idle time, so it's not sitting idling for hours a day.
My question is, is this oil change message a result of an actual oil monitoring sensor that measures oil quality on-the-fly, or is it strictly based on a miles or odometer timer that gets reset when dealer changes the oil?
At this point I'm wondering if the kid that serviced my truck either forgot to reset a timer, or worse, just "pencil whipped" my oil change. I have to call my home dealer back, since the service manager wasn't in yet when I called.
Ford 6.7L Power Stroke Diesel :: 2011 F250 - CEL On Then Stop Safely Now Message
I have a 2011 F-250 with about 5000 miles. Sunday night, I was driving home and first got the CEL. Then less than 5 miles later, I got the red "Stop Safely Now". Pulled over and the thing just died. Checked the message center and nothing out of the ordinary other than the SSN message. Had to wait about 45 minutes for the tow truck and thought it might cool down. I tried to start it while waiting but got nothing. Battery was good and all electronics worked. Waiting to hear a diagnosis from the dealer.
View 14 RepliesFord 6.7L Power Stroke Diesel :: Truck Quit - Stop Safely Now Message And Won't Crank
Luckily I was sitting in the driveway. Pulled the truck out of the garage. It started fine, idled fine, did not make as much noise as I was expecting but was warmer in the garage than outside. Stopped in front of the garage door to grab a couple things in the garage, jumped back in and it quit before I could get it in gear and roll out. Weird. This is the first time I've ever had to get a tow.
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Stop Safely Now Message - CEL Codes P2033 And P200C?
2011 6.7L company truck that I drive. Couple days ago, got the Stop Safely Now message and CEL. There was noticeable loss in power as well. 10-15 seconds after SSN message, power came back and message went away. I'm assuming the loss of power was limp mode. It happened 2 more times today. Got to the dealer and they wouldn't read the code to tell me whether it was safe to drive, they were just too busy to take 3 minutes and read a code! Got codes read at O'Reilly and came up with the P2033 and P200C. I see where the P2033 may be a failing sensor, and that should be easy enough to confirm. My question specifically is regarding the P200C, Diesel Particulate filter Over Temp. Could this be a bad sensor as well, or could it be plugged causing the P2033?
View 3 RepliesFord Super Duty (1999-2016) :: Hard Shifting - Slight Bit Of Clinking Noises Every Time Started From A Stop
Well shoot, not even 120k on the odo and I've had my first major problem with the truck, and the one thing I hoped wouldn't be an issue, especially since I don't work my truck hard and 95% is driving unloaded highway as a daily driver.
Last time I drove it coming home from grocery store there was a big racket from down under (transmission area). It instantly didnt feel right - there was a slight drag even when the clutch was in, but rolled fine when I pulled it out of gear entirely. Was VERY difficult to go into first gear. Other gears shifted ok but some of them felt hard too. Would not go into reverse at all!. Slight bit of clinking noises every time I started from a stop, but made it home ok and things seemed to ease up as I went. Today, seems to be shifting fine, reverse works and everything.
Now for several years I've had a noise that I couldn't figure out. I am guessing it's related because it sounded like was coming from tranny area. Often, when starting out from a stop, there was a bit of clinking noise like a couple tin pie pans rattling together just as the clutch started to go. I kept thinking it was loose heat shield or something clanking just under the initial vibration of getting going. Never did find anything loose. I'm guessing it's internal.
I've called a couple local shops and so far no one wants to mess with it. Dam this sucks i hoped the MT would be more reliable, not the first thing to go. I myself have never messed with any aspect of a transmission, though I not opposed to learn however I was hoping to take this on an out of state trip end of May, and I'm not going to have much any free time between now and then.
Ford Super Duty (1999-2016) :: Engine Died Suddenly When Driving Down The Road
2004 F-250. 6.0 I was driving down the road when the engine dies. It was like I had turned off the key. When I tried to restart it, it was no click, no starter sound, nothing. The glow plug light remained on, even while turning the key over. What could cause this?
View 10 RepliesFord Super Duty (1999-2016) :: 2006 F250 Cutting Out / Engine Died And Now It Will Not Start
I replaced the head gaskets on a 2006 F250 6.0 Diesel, put it all back together and started it up. It ran great for a lil bit, then it started cutting out. It did this for about an hour then I killed it and it took a little bit to restart it, spinning over and over to get it to run, this took place several times. The engine died and now it will not start. I keep getting codes P2284 and P2290. What could be causing this problem??
View 9 RepliesFord Super Duty (1999-2016) :: V10 Running Rough / Engine Ran Fine Until Battery Died
2002 F-250 SD V10 Auto Trans 140K miles.....
Engine ran fine until battery died. Vehicle then sat from Nov to May with no battery in it. On start up now after install of new battery, engine initially surged at idle and seemed to miss (run rough) in gear/under load. No CEL or codes. After a single short drive idle and running under load seemed to have improved a bit, but not yet back to what I would call normal.
QUESTIONS:
Is this simply a matter of the computer having to relearn after battery disconnect?
Will driving restore things back to where they were/should be?
How much driving/How far?
Ford Super Duty (1999-2016) :: 2004 - No Start - Engine Won't Turn Over - Starter Died?
I own a 2004 F-250 Super Duty V10 truck. It's always ran and started great. I don't use it often so I make it a point to start and drive it around town twice a week. The other morning I went to start it and nothing. Engine will not turn over. Tried cranking with head lights on and they stay bright. It's an automatic and I tried going between park and neutral and still nothing. I can hear the little square relays in the fuse box clicking. Could the starter just have died? How are they to replace on these?
View 14 RepliesFord Super Duty (1999-2016) :: 1997 F350 - Engine Stalls Going Down The Road With No Warning
I have a 1997 f-350 crew cab 4x4 w/ off road package and 7.5 fuel muncher power package. My engine stalls going down the road w/ no warning. Sometimes it will start back up immediately, and other times not until i cycle the ignition 6 times or so.it seems to be getting worse as time goes by. Since it started i replaced tps, cap, rotor, plugs and wires. I also replaced fuel tank and pump and filter about 1.5 years ago. Some other issues to clear up, but concerned w/ current problem.
View 2 RepliesFord Super Duty (1999-2016) :: F350 Engine Temp Started To Increase - Code P1212 For ICP
1999 F350 SD ... Yesterday when goosin it to get on the highway my rig threw up a code quickly and engine temp started to increase. Once temp got in the red, oil pressure got a little figgity. The code was for the ICP(p1212), so I cleaned the plug and made sure coolant and oil were topped. This morning she ran barely over normal temp (stock gauge). This afternoon same thing as yesterday but without the code. When I let off of the accelerator temp goes down. I just got married so I have little funds to throw at a shop.
View 4 RepliesFord Super Duty (1999-2016) :: 2007 F250 - Very Rough Idle When First Started / Engine Missing
I have a 2007 F250 4X4 6.0 diesel. When first started it idles extremely rough to a point it sounds like a old gas engine missing. But after it warms up for about 15 minutes it runs and idles like a new truck. I'm thinking it's the injectors if so is this something I can change/clean ....
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F250 Started Chugging And Check Engine Light Came On
I have a 05 f250 with a 5.4 I'm having issues with I was driving along the truck started chugging along and the check engine light came on so I checked it with my bully dog the codes that came up were p0192 which is fuel pressure sensor circuit low the next one is p0452 is evaporative emission pressure sensor switch low also came up with p0191 tonight haven't dug into that yet.
I change out the pressure sensor switch from a buddies truck didn't make a difference put my sensor in his truck his worked fine I clean the throttle position sensor and The maf also put a new air filter on not throwing a misfire code but seems like it may be. A little background on the truck it's a 5.4 3valve with a bully dog tuner, mufflers been removed added straight pipe mechanically that's all that's done