Ford Super Duty (1999-2016) :: 2003 - Tranny Real Rough When Put It In Reverse?
Went for a drive today in my Wifes 2003 F-250 5.4 automatic, Parked it and went for a hike, came back, started the truck ,put the it in reverse and it was running real rough.Put it in Drive and still running rough, figured i would put the truck in low and see what happens.It ran fine.Got home and did a visual inspection on the tranny, didn't see anything that jumped out at me.The fluid was fine. What this might be?
View 13 RepliesFord Super Duty (1999-2016) :: Tranny Would Not Shift Back Into Drive After Stopping At Stop Sign
I need to solve tranny problem, it started out a while back, would not shift back into drive after stopping at stop sign (after driving fine for about 20 miles) thought maybe dirty filter so did fluid and filter change seemed to work for a while then started again noticed it was mostly after using cruise control, but u joints were very bad, so replaced 2 of the 3 and worked fine for about a thousand highway miles, then got really bad. Now when I check the tranny fluid cold and /or hot it is way up on the dipstick. Took to ford dealer in ladoga, lied and said no speed sensor codes, but list on the paper he gave me had all kinds of abs and a p500 code.
View 9 RepliesFord Super Duty (1999-2016) :: 6 Speed Manual Will Not Shift Into Reverse Or Low
I have a 2000 F350, Turbo diesel with 223 000 miles. 6 speed manual transmission will not shift into reverse or low.
View 14 RepliesFord Super Duty (1999-2016) :: 4r100 - Lagging Reverse And Loss Of Shift Pressure
Had my trans rebuilt in August because of a lagging reverse and loss of shift pressure. Had it rebuilt and beefed up a little and I've had problems getting the trans to be like it was new and seven years ago. I had enough of my head gasket oil leak and loosing my job recently so I bought a trans pressure kit and hooked it up today, all I can say is I now have another problem to get corrected. I'll list my pressures and I took videos so I'll upload them to YouTube and link it that way.
Park - 85psi
oem - 50-65psi
R - 25psi start then slowly rises to 60psi
oem - 70-100psi
N - 85psi
oem - 50-65psi
D - 82psi
oem - 50-65psi
2 - 20psi then slow to 80psi
oem - 50-65psi
1 - 50psi then slow to 100psi
oem - 70-100psi
My WOT pressure at 1-2 and then 2-3 shift is 170psi, I cannot find OEM spec online yet but I believe I was told it should be over 200psi....
Ford Super Duty (1999-2016) :: 2002 F250 - Starter Engages When Shift Into Reverse
I have a 02 F250 Super Duty XLT with a triton V8 with a automatic transmission . and when I shift into reverse after driving for a while the starter engages . It does not happen all the time . If i start up the truck and shift through or into reverse it doesn't happen . the only time it happens is when i've been driving for awhile and want to back up or park it will only do it once or twice after each drive so trying to get it to happen while in the shop is almost impossible . could this be caused by the transmission range sensor . I just had the code P0705 (transmission range sensor , A circuit input ) come on but the problem has been happening for a few weeks before that code came up .
View 6 RepliesFord Super Duty (1999-2016) :: O/D Stem Light Started Flashing After Transmission Rebuild
Had a front seal leak on my 2000 F250 V10 with 122000 miles. Since I've towed for years and the tranny had to be pulled I opted to just rebuild the whole tranny. I had problems from the beginning where it wouldn't shift into third and when I took my foot off the gas it would just go out of gear completely and just rev. After I stopped and started over, it would shift fine for the rest of the day.
Finally the O/D stem light started flashing and the mechanic did something to fix it. Since then it has shifted fine but when it went into overdrive the rpm would bump up and kind of slide into overdrive. Left the truck with the mechanic again for two weeks and it's better, sometimes revs and slides into overdrive not every time though.
My problem, besides the overdrive shifting, is it now takes forever to shift in to 4th gear. I have to take my foot off the gas to make it shift into 4th and overdrive won't kick in until 45 MPH. My gas mileage, while bad enough before all this, has now dropped another 2 mpg to around 7.5 to 8. I was thinking about taking it to a Ford dealer for some kind of analysis.
Ford Super Duty (1999-2016) :: 2002 F250 - Cylinder 7 Dead - Rebuild Crate Motor?
160,000 miles and cylinder 7 is dead and 3 is dying, valves probably with rings right behind. Is it better to rebuild or buy a crate motor? Buying a crate motor, will a 5.0 fit? Should I spend the 5 or so grand beefing up this one, dropping in a 302 or putting it toward a newer model?
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F350 Rattles On Rough Roads / Front Outer Axle Rebuild
I am getting ready to put new axle shaft u-joints in my 2008 F350 (they are shot, they actually rattle on my rough roads). While I am at it I figure I will grease the front wheel brg cartridge, replace the needle brg that is inside the cartridge. I am also afraid I will the axle shaft vacuum seal. I don't want to go to ford an get raped, diesel O-rings doesn't have parts for the newer pickups and I don't want to get junk from the parts houses. Where I can get these parts for a reasonable price? What the best brands are? Are they the same parts as the earlier super duties? I know the lock out is different.
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Vibration / Grinding On Front Driver Side After Partial Rebuild
2001 f350 4x4 dually 7.3 powerstroke, I recently replaced the hub assembly, stub shaft and seal, u joint, ball joints on the front drivers side and now periodically the truck makes a grinding growling vibration coming from front drivers side and stops after hitting a bump...
View 3 RepliesFord Super Duty (1999-2016) :: No Power From Tranny
Yesterday wife left driveway and about a block away she phone truck "died". It actually starts and the engine is fine - shifting from park to reverse or any gear seems to have no effect. After tow home - i check and there are no codes (using ODBII scanner), the tranny fluid seems full and red. Looking carefully there is a slight rpm drop when idle into reverse or a gear other than neutral or park... but revving engine in any gear doesn't move the truck.
Is there anything else i should check before taking to a tranny shop? Its a 230k mile workhorse for the house but not critical if its down for a week or two. I have had it for 10 years and put the last 40k miles on it. Is there any diagnostic suggested given the symptoms?
Ford Super Duty (1999-2016) :: 2003 F350 - Tranny Won't Go Into O/D?
I've got a 2003 F350 CCSB SRW V10 Auto 4X4 3.73 LS diff. The tranny doesn't always go into overdrive when I get about 40 or 50, even 60. I went down the freeway the other day at 65 in 3rd turning about 2500 rpms. Am I hurting anything here? One thing I have noticed is the overdrive light on the shifter does not work. Light doesn't come on. Leads me to believe that there is a frayed wire in the steering column. Could that cause the tranny to act funny? The cruise control works, so I'm thinking the speed sensor on the diff is ok, but I could be wrong.
View 3 RepliesFord Super Duty (1999-2016) :: Tranny Codes P0750 And P0733 Came On?
i have p0750 shift solenoid A error and p0733 gear 3 ratio error and i was woundering how i fix them problems
View 9 RepliesFord Super Duty (1999-2016) :: 2002 - Mixed Tranny Fluid?
2002 F250 5.4 Crew with limited-slip diff.
I put in about a quart of MERCON-compatible this weekend when the level was low. Found out that last tranny flush used MERCON V.
Now I have at least a quart of the MERCON-compatible in with the MERCON V fluid.
Should I not worry and just use MERCON V from now on, or will the two fluids have problems in my tranny?
Ford Super Duty (1999-2016) :: Leakage From Front Of Tranny Causing Smoke
On a few occasions I had leakage from the front of my tranny causing smoke. It happened again yesterday and when I checked I was down a quart of fluid. This morning everything was fine, no leaks all day and the tranny works fine, I tow a heavy work trailer. My search here shows that this is a common problem from the front pump seal and that it gets worse in time. Went to a tranny shop and the guys says the torque converter isn't locking up and overheating the tranny and causing the leak. He also said that if it leaked all the time then it would be the front pump seal. Anyhow he says it need to be rebuilt, new converter and all that stuff.
2000 f-250 V-10 121000 miles
Ford Super Duty (1999-2016) :: 2008 F250 - H&S Tranny Rev Up While Accelerating - Slipping?
I have a older minimax with the latest updates and have noticed that under full acceleration the tranny seems to rev up faster than the truck is accelerating. This occurs i think in 3rd gear like accelerating onto a on ramp etc. Kinda like its slipping if you know what I mean. I'm running the mild tunes in tow mode. Everything else seems ok.
View 7 RepliesFord Super Duty (1999-2016) :: 2002 - How To Check Cooling Pump On Tranny
I have the 6 speed (ZF) i know there is a cooling pump on this tranny. Is there a way that you can check the pump to see if it is working???? If not will it set a code??
02 7.3 CC
Ford Super Duty (1999-2016) :: 2006 - Tranny Slipping While Towing Uphill
'06 Power Stroke/136k miles.
This last weekend I was towing my rzr up hill and the tranny slipped, lost power, and the "Wrench" check eng came on. I pulled over, checked my fluids, checked for leaks, checked for smells, couldn't see anything visibly wrong.
Turned it back on and no other issues on the way to the camp site. On the way home, days later, same thing happened twice. Is the tranny going bye bye? Would it be worth it to get a flush for the possibility it just may be the fluid and maybe some sediments or something of the sort?
AND the bigger question is, if it is the tranny, should I trade this POS in, or replace the tranny? It has had a few problems lately with the turbo. Needs a new AC compressor. I didn't do much homework or know about the 6.0's before I bought this truck. After I bought this truck last year I heard about all the problems the 6.0's have and wished I would have went another route.
I can turn a wrench pretty decent (Aircraft Mechanic) but I have very little knowledge on vehicles, let alone this POS. I am apprehensive about doing a transmission or any big components without assistance. This is why I am trying to decide what the best option would be for the long run.
Ford Super Duty (1999-2016) :: 2001 F250 - Tranny Started Overheated
So out of nowhere, my tranny started over heating. Got up to 210. It usually runs in the 140-150 range. I have the 6.0 cooler, and 7500 miles on the synthetic fluid. My cooler lines to the radiator were ice cold. I crimped my bypass and this seemed to fix it a little (I know this is a no no), I did the flow test before driving it and it passed. It seems to heat up the most at stop lights in gear. It drives fine, no slipping, no chattering. I also dropped the pan, had some stuff on the magnet, replaced the filter too. It doesn't seem to heat up as bad now, goes to about 190. I will install the new bypass tomorrow when it comes in from the ford dealer. Whats causing the heat? BTW truck has a 4" lift with 35's no other mods.
View 4 RepliesFord Super Duty (1999-2016) :: Start Truck No Gears / Restart And Tranny Works?
2002 sd 7.3 4x4. When I start up engine and put truck in any gear I get nothing but the ugly clicking sound when I shift back into park. Turn off engine and restart, everything works as normal. Doesn't do it every time 4-8 normal start ups then a bad one. Brought it to a tranny guy, head scratcher for him. Any other solution before I start changing parts?
View 6 Replies