Ford Super Duty (1999-2016) :: Unpredictable Steering When Turn Sharp Right Or Left Suddenly
My steering pulls hard left or hard right, and also seems to have a mind of its own when it turns sharp right or left suddenly, as though someone else is driving. It's very disconcerting when you think you're making a left and the truck veers right.
Today I was making a left onto a bridge and truck kept going straight. I almost hit the bridge. I have an 06 Ford F250 Turbo Diesel. What this could be?
Ford Super Duty (1999-2016) :: 2011 F250 - Knocking Sound From Rear Passenger Side Cab Corner
Just became the proud owner of a used 2011 F-250 Supercab, 6.2L. Overall the truck is great but it does have a-few things that need fixing, the most annoying of which is a knocking sound from the rear passenger side cab corner. Sounds like the exhaust vibrating and smacking up against the floorboard but that's not it. Everything seems tight, even the front suspension.
The only thing I can see that may be the cause is the rear passenger cab mount seems worn. I can rotate the bottom rubber portion without too much effort and when I feel for the top rubber portion all I feel is the metal cup on the top, like the rubber has collapsed and the metal cup is sitting directly on the frame mount.
So... how many cab mounts there are for the Supercab? I think there are two on each side and two in the front. All of the information & videos I've seen describe the locations for the crew cab. Also, is it possible to replace the cab mounts and not have to mess with the ones in the front? I hear those are the real buggers.
Ford Super Duty (1999-2016) :: F250 Truck Just Quit When Turned A Corner
Ok here goes I dive a 1999 f250 super duty with 5.4 it's automatic 4x4. I dropped my kids off at school and was headed home turned a corner when the oil/temperature light flashed and the truck just quit. I tried restarting it and it just clicked like the battery dead. Had my better half come and jump it. Did not work it would only roll about a half Revolution and stop. So we towed it home where I put the battery on the charger. Now I can't even get it to roll over. And yes there is oil and it did not over heat.
View 14 RepliesFord Super Duty (1999-2016) :: 2015 F250 - Groaning Noise At Start Up
Dealer says groaning noise at start up, when I let my foot off brake at a stand still is normal,worse if i turn steering wheel with brake on.
View 8 RepliesFord Super Duty (1999-2016) :: Groaning / Growling Noise Barely Audible
I have a 04 F250 4x4. This growling noise has been driving me nuts. Its barely audible, but its there. Brought it to the dealer for service a few weeks ago, they said I had a bad front hub bearing. So I got the truck back, ordered a hub bearing, and last weekend jacked the truck up to see whats going on. Spun both front wheels, no noise whatsoever. Checked for up/down play and side/side play, nothing. So I held off on installing the hub bearing.
The noise is really more noticeable when going down the road and when you hit dips in the road. Kinda where the bounce puts more force/weight on the front end, the growling gets louder. The truck has 74k miles on it. Its there whether the hubs are locked or unlocked. Could I still have a bad hub bearing even though the wheel spins free and quiet, and no play???
Ford Super Duty (1999-2016) :: F250 - Door Corner Rattle At Highway Speeds
My factory-ordered 2016 F250 CC SB 6.2L 4X4 3.73 is about 6 weeks old. Driver and passenger side door rattle noise (in upper back corner) at highway speeds (65-75 mph) has gotten progressively worse over those 6 weeks. See attached video.
Trying to determine if this is caused by:
Door seals: the temperature here in Iowa has dropped from a few weeks in the 90's to the now in the mid-60's.
Could the temperature change have caused the seals to change shape/structure and result in the rattle/noise?
The exterior seal between the front and back doors (attached to front of the back door): mine seems a little loose on top, but nothing that would cause this kind of noise.
Ford Super Duty (1999-2016) :: Rear Turn Signal Won't Working?
I replaced the bulb and it's still not blinking and doing the quick blink on the front and mirror bulbs.
The bulb turns on when on parking lights; it just won't blink.
Ford Super Duty (1999-2016) :: 2012 F250 - Rear Heated Seats Won't Turn Off
2012 f250 diesel Lariat 4dr 4x4. He called me today cause he knows I do all the work on my own F250 diesel. He has heated seats in the back and he said that they turn on by them selves and they won't turn off. He had to actually disconnect the wire harness to get the heating elements to turn off so his wife's friends wouldn't burn their bottoms in the middle of august is Texas.. Any ways, he said both sides are staying on and wouldn't turn off using the switch.
I'm not very familiar with the heated seat wiring, especially for the back seats. I told him their may have been a relay that went bad, but now I"m thinking that they much have a controller or something that is acting up. He said that the front seats are acting normal. Also, he has the touch screen and navigation upgrade as well as auto climate control, not sure if this stuff matters for the back seats though...
Ford Super Duty (1999-2016) :: 2013 F250 - Right Rear Turn Signal Does Not Work Sometimes
2013 f-250 crew cab short box, 6.2 gas with 48k miles. Right rear turn signal does not work...SOMETIMES. I took the brake light assembly off...bulb is good, turned on signal and the bulb will flash so I put it back together then drove a couple miles and then signal quits working again. I can't find any loose/corroded/bad wires at the bulb socket and I can't get the bulb to quit working when I have taillight assembly apart, (trying to replicate failure). There are never any blown fuses either.
View 5 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Brake Lights And Rear Turn Signals Don't Work
My sons 2006 F350 brake lights and rear turn signals quit working. When the headlights are on, all the lights operate but the rear turn signals and brake lights do not nor do the emergency flashers. The front signals work but flash very rapidly. Although I'm not an auto electrician, I'm fairly mechanically inclined but the fact that the front signals work, the rear don't and all lights work as lights, just not as turn signals or brake lights.
View 4 RepliesFord Super Duty (1999-2016) :: 2007 F250 Auto 4x4 Not Engaging - Rear Wheels Spinning / Front Did Not Turn
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
Ford Super Duty (1999-2016) :: 1995 F250 - No Turn Signals - Brake / Rear Running Lights - Fuse Ok?
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 RepliesFord Super Duty (1999-2016) :: Clicking Sound In Front Left When Make Sharp Turns To The Left And Hit Small Bumps
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
Ford Super Duty (1999-2016) :: 2005 - While Tightening Up Turn Signal Bulbs - They Turn Towards Fender?
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Turn Signals Do Not Work - Green Arrow Indicator Won't Even Turn On
I just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?
Ford Super Duty (1999-2016) :: EBrake Light Show Up On Dash / Turn Signals Stopped Working / Heated Seats No Longer Turn On
Coming back from a trip I got a e-brake light show up on the dash then noticed the signals stopped working and the heated seats no longer turn on. I scanned it with my AE and got a brake fluid sensor error come up but nothing about the signals .... is this a common problem or is there a connection between all this? 2003 F350 6.0L .....
View 2 RepliesFord Super Duty (1999-2016) :: Driver Side Rear Brakes Making Popping Noise - Bad Rotors / Rear Wheel Bearings?
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
Ford Super Duty (1999-2016) :: No Startup / Won't Even Turn Over
My F-350 has developed a new problem. It wont start. It wont even turn over. All Electricity is on, glow plugs glow, gauges work, lights work, but when you turn the key to the start position noting happens. Some of the indicators go dark.
I even tried a jump thinking my batteries no longer handle the load. Same results. I suppose I can remove the batteries and take them in for testing. In fact, I'll probably do that now.
2002 F-350 Superduty, 7.3 Ltr, Turbocharged. 260000+ miles.
Ford Super Duty (1999-2016) :: No 4WD Light When Turn The Key On
I am having some problems with my 4WD, it's not working. When I turn the key on, I do not see the 4WD light. I have locked the hubs with no change. I noticed that my switch was not illuminated either, so I started there. I took the switch out, cleaned it up a bit and reinstalled it. Now it's illuminated but still no 4WD. I have swapped the two relays and still nothing. I have checked all the fuses under the dash and they were all good.
I don't believe the switch is the problem(they seem to be pretty simple and it doesn't look like there's much to go wrong. Is there a better way to test the switch other than just seeing the illumination light on? I plan on testing the transfer case shift motor tomorrow but I don't believe that is the problem since I'm not even getting the dash 4x4 light.
My other thought is replace the GEM but I was trying to rule out a few of the cheaper alternatives first.
I almost forgot to mention, approximately 7 months ago, my buddy and I were going coyote hunting. Being the genius he is, he didn't unload his rifle while we were in the truck and at some point, something happened and he touched off a round.
The shot was a well placed point blank shot and went right through a large group of wires on the passenger side trim panel under the glove box.
Initially, he bagged himself a trophy size Superduty but after some emergency surgery and a bit of soldering, everything has been fine.
I haven't used the 4WD after this incident but I can't say for certain this caused it because I haven't checked until now. Do you think this caused it? Is there a hidden/residual problem that I missed?