Ford Super Duty (1999-2016) :: 2003 F250 - Clutch Pedal Not Retracting All The Way
I just bought my first Ford. Its a 2003 F250 SD with 5.4L, 5 speed manual, extended cab, 2WD. The truck is experiencing intermittent problems with the clutch pedal.
If I depress the clutch pedal for a long time, then sometimes it does not retract all the way. It does this, for example, when I am at a traffic light waiting for the next opportunity to make a left hand turn.
The truck runs and operates as it should even when this does happen. The easy response is to place your toes under the clutch pedal and pull it aft to its completely released position.
The master and slave cylinder and the booster spring attached to the clutch pedal assembly have been replaced and this condition still continues.
Ford Super Duty (1999-2016) :: F250 - Clutch Pedal Slave Fingers
I have a 99 f250 sd truck that came as a auto and I am changing it to manual. I bought a slave cylinder unit setup and got it put in and as I was installing rod from pedal to slave I must of broke plastic fingers that hold rod. So is them fingers replaceable or must I buy another unit? with no foot on pedal it sticks up close to bottom of dash now. I tried pushing clutch all the way to floor and still rises too high. What can I do????
View 1 RepliesFord Super Duty (1999-2016) :: F250 - Clutch Pedal Went Straight To The Floor Boards
Pulled out of street this morning and as I was shifting into 3rd my clutch pedal went straight to the floor boards. I was able to keep it in 2nd gear and get it back to my driveway . The pedal will only go straight to floor or goes straight up too the bottom of dash board. It's spring loaded. Am I dealing with a linkage issue?. I had clutch as I pulled out of my driveway and stopped go at the stop sign. Plus I was able to drive it back too my house with the pedal on the floor boards. Where I should look first?
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Clutch Not Disengage - Stiff Pedal
I've got a 2000 F250, 5.4L 4x4 with the ZF5 5-speed transmission. Three years ago I replaced the complete clutch assembly, pressure plate, throw-out bearing, etc, and had the flywheel re-machined. Put it back in and all has been well. Only has about 15k miles on it. Earlier this week I went to drive it and all of the sudden it started getting harder to shift and by the end of the trip the clutch will not disengage at all when I push the pedal in.
Furthermore the pedal is much harder to push than it always has been. Checked the reservoir and it's fine. After some searching it seems to most likely be an issue with the master and/or slave cylinder either needing to be bled or replaced. Further reading revealed that bleeding and recommends just replacing the whole system, so I've priced that out. Was it a master/slave issue? Anything else I should check in case it isn't?
Ford Super Duty (1999-2016) :: 2009 F250 4x4 - Rattling When Push The Clutch Pedal To The Floor?
My stock 2009 ford f250xl 4x4 with a 5.4 and 6 speed has been giving me a weird sound lately started about a month ago and only happens on a cold start situation meaning if it sits over night it will do the sound. the sound goes away after 3-5 min of warm up in my driveway, the sound happens when i push the clutch pedal to the floor. it has no pronounced abnormal sounds through out the rest of the day when its hot which perplexes me, check out the vid on my u tube site for a sound of it.
MAH00111 - YouTube
MAH00115 - YouTube
Ford Super Duty (1999-2016) :: Hissing Sound From AC That Lasts For A Couple Of Seconds Then Goes Away
I used the a/c for the first time this year on my 2013 F250 and heard some noises I don't remember hearing before. When the a/c(or defrost) is on every 12 sec or so I hear a hissing sound that lasts for a couple of seconds then goes away. Is this the compressor cycling and if so is it normal to hear it inside the cab?
I know it has to do with the a/c because if I shut it off as the hissing sound is being made the sound will instantly stop. Other than the noise the a/c works fine and blows cold air. Also, if it matters I have the standard control panel, not climate control.
Ford Super Duty (1999-2016) :: Check Engine Light Turns On Randomly And Goes Off After A Couple Of Seconds
I own a 2000 Ford F-250 5.4 Automatic. It tows my 5th wheel trailer very good. On our last trip it suddenly experienced the "check engine light" effect.
The light turns on randomly and either goes of after a couple of seconds or it doesn't go on when I restart the engine.It is mainly annoying, but when in towing it really hurts, because the engine switches into an emergency mode and stalls.
I read that the engine uses only 4 cylinders. I read many articles on the web about that light, but I couldn't find a solution. The thing is I brought the car to several repair shops but none read a code from the computer.
I think it's not a real fault but a misreading or maybe a cable that's grounding? The problem is, I can't bring the car to a repair shop, because there is nothing wrong with the car. How can I find the source of the problem?
Ford Super Duty (1999-2016) :: 2003 F250 - Rear Brakes Sticking
2003 F250 V10 4x4. I have a rear brake sticking so I assume I have to replace the calipers. Which brand should I go with?
View 2 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Brake Started Sticking?
I have a 2002 Ford F250 Superduty with a 7.3 diesel. Brakes started sticking on it. I replaced all the calipers cause the boots were starting to crack but not leaking. All four brakes are still sticking. I can drive a little ways and then the brake peddle feels funny and they start dragging all four. I can loosen the bleeder and brake fluid will spray out and release the brakes for awhile.
View 4 RepliesFord Super Duty (1999-2016) :: 2010 F250 V10 - Starter Seems To Be Sticking When Try To Start The Truck
I have a 2010 F250 V10 4x4. about every 3-4 times when you start the truck....it seems as though the starter "sticks". If I catch it and shut it off and then turn the key right back it fires up and does not stick. Its as if the gear is staying kicked out into the flywheel. Are we thinking the starter itself? I'm thinking starter...but looking for input before I crawl under it.
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 4x4 - Left Rear Caliper Sticking After Replacing
Two weeks ago did a road trip to NH from RI and i heard a slight dragging only at low speed (10-15mph) in my left rear tire. figured the caliber was dragging a little, it was. Before arriving in NH the brake light came on. Long story short i get back to RI and the left side noise gets worse and starts to lock up. I finally replace the rotor which was warped, pads, and caliper which was bad.
Was driving it same day and still here the same dragging and screeching noise and the brake light is still on. On my way home the left side locked up at low speed without hitting breaks and slid the truck, mid you all parts are new on that side. I am not sure what it could be at this point something in side the axle?
Ford Super Duty (1999-2016) :: 2006 F250 - Tow / Haul Light Only Blinks For First Couple Of Minutes Of Driving Then Stops
I've got a 2006 f250 with 160,000 miles, trans was rebuilt by previous owner about 10,000 miles ago. The tow/haul light started blinking yesterday, only blinks for first couple of minutes of driving and then stops. Service engine light popped on today as well. Won't have access to a code reader until tomorrow, but looking for some preliminary info...
View 3 RepliesFord Super Duty (1999-2016) :: Clutch Pedal Close To Floor?
I have a 06 f360 PSD 6 speed. On a road trip and the clutch pedal is getting very close to the floor. No Slippage but the longer I leave the pedal pressed the worse it gets. Are there any good descriptions how the clutch in this truck works?? Slave cyl??
View 14 RepliesFord Super Duty (1999-2016) :: No Start - Tow Haul Light On When Clutch Pedal Pressed?
Had a No start issue.Turn the key and nothing. Could hear the relays click so knew it wasn't the ignition. Could jump the starter via the wire on the passenger fender so starter good. Replaced the clutch position switch last night. Still have no start but now when I press clutch I have a tow haul light come on dash.If I press it again it turns off. Truck doesn't have tow haul option installed. I hear a relay clicking under the dash too. This is a 2004 Superduty (F550). Replaced the ignition switch today and still same.
View 3 RepliesFord Super Duty (1999-2016) :: F250 - Clutch Needs To Go All The Way To Floor
I Have a 1999 f250 7.3 diesel with the zf5 manual transmission and to shift gears I need to push the clutch all the way to the floor. Could this possibly be the slave and master cylinder or is it the clutch?
View 14 RepliesFord Super Duty (1999-2016) :: F250 Started To Shake For At Least 3 Or 4 Seconds While Driving
I was driving my 99 f250 superduty and out of no where it sounded like i had blown a tire started to shake for at least 3 or 4 seconds pulled to the side of the road got out and check tires were good, got back on the road with no more problem.
View 1 RepliesFord Super Duty (1999-2016) :: F250 Stalls A Little When Press On The Gas Pedal
I have a 1999 f250 that runs and drives great but the only issue I have is when I baby the gas pedal it stalls a little and when I give it more gas it's fine or if. I'm going 50mph then let off gas and then baby the pedal it's stalls a little.
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 - No Clutch Safety Switch
2002, F250, 5.4L, ZF-6 trans.
Ok...today by accident turned the key with the truck in gear and clutch not depressed...much to my surprise the truck tried to start and lurched forward.
Is this a sign of a failing clutch safety switch or Could it be an ignition switch problem? Anything else that I am not thinking of?
Ford Super Duty (1999-2016) :: 2006 F250 - Fan Clutch Roaring On Acceleration
I have a 06 6.0 with 340000 miles on it believe it or not still pulls great. The problem is my clutch fan keeps roaring when I press the gas it's extremely loud all my gauges are fine so the truck isn't overheating? Also not a bad fan clutch I wasted 300 bucks on that and it's still doing the same thing.
View 6 Replies