Ford Super Duty (1999-2016) :: 2001 - Dipstick Tube Rusted And Snapped?
OK, so I have a 01 f350sd and i went to check my oil and the dipstick tube itself is so rusted it snapped in half so I took it to the dealer which I knew was going to be over priced labor but still checked the tube itself is 20 dollars but labor is upwards of 300-500... My engine is the 5.4 triton.
View 2 RepliesFord Super Duty (1999-2016) :: Broken Dipstick Tube At Block On 5.4 Plow Truck
I just finished putting a 7.3 back in one of our f450 plow trucks today, so then i moved onto our 2001 F250 5.4 plow truck. The dipstick tube was rusted in half so i pulled on the remaining half to get it out and put in the new dipstick. However, it broke off at the block. So now i cannot see how to get the rest out with out doing a lot more work. I haven't removed the splash guard yet but will i have to remove the manifold , the oil filter base, or both?
View 14 RepliesFord Super Duty (1999-2016) :: What Size Tube To Fit For Brake Bleeder
2010 F250, what size tube do I need to fit on the brake bleeder screw? The tubes I have are all too big and the size marks are no longer legible.
View 4 RepliesFord Super Duty (1999-2016) :: How To Read Transmission Dipstick
Just did a drop an refill of my trans fluid. Put in a little under 8 qts.
My question is where should the fluid read ? Is half way between full and E good or should it be right up to the line ?
Obviously I'm reading it while trans is warm and in nuetral, engine running
Ford Super Duty (1999-2016) :: New Shifter Tube Now Key Won't Come Out And Steering Wheel Not Locking
Today I put a new shifter tube in a 02 f450. Everything works well, but the key won't come out and the steering wheel won't lock. Was told there is a button to push by the turn signal side but don't see any. Looked around top and bottom of column and didn't see anything out of place. Also found a black wire with a pink strip not connected to anything. Touched the wire to the column and key dinger sounded. Where should this wire be connected?
View 10 RepliesFord Super Duty (1999-2016) :: Excursion Won't Start After Changing Shift Tube
I changed the shift tube in my Excursion today. I'm trying to put the key switch back in. It will go in and rotate fairly hard. I can not get the key to release. When I hook the battery back up, everything functions as it should but it won't start, the key won't release and it still turns hard. The dash lights come on and such when the key is turned to run. I tried a different key with the same results. Everything looks good.
View 1 RepliesFord Super Duty (1999-2016) :: Salt On The Dipstick / Manifold Is Leaking?
04 f250, 5.4 ,90,000mi. Checked my oil today and saw this white flaky crap on the dipstick its salt, probably from a broken dipstick tube, probably broken at the manifold right where there was a huge deposit salt right on top. The manifold is leaking anyway I was hoping to wait till spring when everything dries out and warms up a little bit, but with salt getting into the engine I think I have to do it now. Is there any way to deflect moisture off the road away from the exhaust manifolds?
View 4 RepliesFord Super Duty (1999-2016) :: F250 - Dipstick Covered With Dirt?
My 2016 Ford F-250 has 14,000 miles on it. I took it in for its second oil change today and came away with big problems. When the mechanic pulled the dipstick out he found it covered with a guncky dirt like material. He said he had never seen anything like it. He changed the oil and checked it again with more gunk coming out. I drove it to the nearest Ford house where a mechanic pulled the dipstick out and found the same thing. He said that he had never seen anything like it. Every time he pulled the dipstick out, it had more coated on it.
View 6 RepliesFord Super Duty (1999-2016) :: 2002 - New Shifter Tube - Key Won't Come Out - Steering Wheel Won't Lock?
Today I put a new shifter tube in a 02 f450. Everything works well, but the key won't come out and the steering wheel won't lock. Was told there is a button to push by the turn signal side but don't see any. Looked around top and bottom of column and didn't see anything out of place. Also found a black wire with a pink strip not connected to anything. Touched the wire to the column and key dinger sounded. Where should this wire be connected?
View 14 RepliesFord Super Duty (1999-2016) :: 2000 - A/C Vents Smell Moldy - Location Of Drain Tube?
My a/c vents smells musty/moldy when A/C is turned on, searched the FTE site and everyone says to check the A/C drain tube to make sure it is not clogged, I have searched all over top and bottom with a flashlight for the drain tube and swear there isn't one. I think it should be on the bottom of the condenser box but just do not see it. Where it is located? The vent smell is Awful!
2000 F350 Super Cab 7.3 Diesel
Ford Super Duty (1999-2016) :: Burnt Antifreeze Smell / Leak In Tube At The Rear Of Engine
I have a 2011 F350 diesel 6.7l. I have had this smell outside the front of the vehicle for months and so I took it finally to a dealer to solve the leak problem. They spent hours on it and eventually found a leak in a tube at the rear of the engine under the intake manifold and supposedly solved my problem. That was 2 weeks ago and I have driven about 300km.(180 miles) but the smell is still noticeable. How long should I wait before it goes away or should I return it to the dealer for further work?
View 6 RepliesFord Super Duty (1999-2016) :: 2014 F250 - Slight Bit Of Blow By Coming From Dipstick
I had a 2014 F-250 I bought new. Absolutely loved the truck. Things got tight so I decided to sell it yesterday. I'm now looking at a 2005 F-250 with 113k miles. It's got a lift, 37" tires, DPF delete, pretty sure the EGR delete but not sure exactly what to look for under the hood. A ton of LED light bars, SCT tuner, I was told its bulletproofed by a dealer, and it's a king ranch. It runs great. I plan on having a diesel mechanic look it over but here are my concerns. It does have a slight bit of blow by coming from dipstick. Very little. Also a slight oil leak that looks like it's coming from the bell housing so maybe rear seal?
View 14 RepliesFord Super Duty (1999-2016) :: V10 - Coolant Leak Where Heater Core Tube Goes Into Intake At Rear Of Engine
I have a leak where my heater core tube goes into the intake at the rear pass side of engine. I have read that this part is pressed in. I dont want to remove the intake since i just paid $400 to have a new gasket kit put on. My question is can I bypass this tube with a hose from the water pump like in this video?
FORD 4.6 , 5.4 , 6.8, HEATER HOSE UNDER INTAKE REPLACEMENT THE EASY WAY !!! - YouTube....
If I can do a rubber hose like in the video I was to make sure that the tube just goes through the intake and that it does not supple coolant into the intake??
Ford 7.3L Power Stroke (1999-2003) :: Dipstick Tube Flange Leaking
The dipstick tube flange is now leaking ....
View 3 RepliesFord Super Duty (1999-2016) :: Lug Nut Replacement?
Any downside to using a nut that covers the entire stud on my '99 450?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Dipstick Tube Adapter Flange Leak
I had a leak at the flange several months ago. I fixed it with the diesel o rings kit. I made a trip from TX to AL with no leaking and drive it daily without leaks. But, 2 weeks ago noticed a small dribble of a leak from the same spot again - not enough to leave a mark on the pavement but any leaking drives me nuts. I applied some RTV. It worked for the 2 weeks.
Today, noticing another dribble of a leak coming through the RTV down the pan. I'm thinking the flange is bent and not keeping that o-ring sealed against the pan. I'm going to try to apply some additional RTV at the leak spot. If this doesn't work? Is that Strictly Diesel adapter really worth that kind of dough? Is pushing the OEM adapter into the pan really acceptable? Any other options?
Ford 7.3L Power Stroke (1999-2003) :: 2001 - Engine Oil Dipstick Coming Out Of Tube?
I have a 2001 7.3 and have found the engine oil dipstick coming out of the dipstick tube by 6 - 8 inches on three different occasions. Did not think much of it until my other 2000 7.3 did the same thing.
What causes this as afraid it will come all the way out and get into the serpentine belt.
Ford Super Duty (1999-2016) :: Replacement Turbo For 7.3L?
After 225,000 miles, my turbo appears to have failed -- not spinning. This is a stock turbo that is unaltered. Yes, I change my oil and filter every 3000 miles.
My question is; what is a reliable after-market replacement part that will bolt up?
Ford Super Duty (1999-2016) :: Seat Belt Replacement?
My "new" truck has a sluggish seatbelt on the driver's side. It won't retract all the way.
How do I get to the mechanism to have a look at it or put in a replacement?
The belt on this one comes out of the top of the seat, not from against the door.