Ford Super Duty (1999-2016) :: 2013 F250 - Amber Flashing Light Install
I'm installing a new amber light on my 2013 F250 signal cab and was wondering where most people run the wires into the cab. It has a magnetic mount and I didn't want to put a hole in the roof. I have a cap on the truck and I also don't have a sliding rear window. This will not be a temp. install. Putting the wires in through a hole in the 3rd brake light?
View 3 RepliesFord Super Duty (1999-2016) :: Only Changing LED Fog Light Bulbs?
I have now found a chit load of LED fog bulbs in my search. I don't want to change out the entire light, just the bulbs. How do the bulbs effect the side vision. Almost hit a deer a couple of nights ago with my F350.....don't want that
View 8 RepliesFord Super Duty (1999-2016) :: 2008 - Leading Light Bulbs Removal?
My dad has a 2008 f350 and both reading light bulbs are burnt out. How do you get the light out to get to them ??
View 3 RepliesFord Super Duty (1999-2016) :: LED Bulbs - Brake Light And Signals Do Not Work On Trailer
I replaced all the exterior bulbs in my 2013 F250 6.7L with LED bulbs. My trailer lights work but brake and signals don't work on the trailer.
View 5 RepliesFord Super Duty (1999-2016) :: 2013 F250 - Amber Beacon Wire Routing
I have a 2013 F250 that I am installing a amber warning beacon on. I need to be able to get the end of the electrical cable into the cab of the truck but it has a 12 volt lighter plug on the end that cannot come off. Is there a rubber plug somewhere in the cab that I can route the cable through?
View 3 RepliesFord Super Duty (1999-2016) :: F250 - Day Time Running Lights - Adding LEDs
Looking for some info on wiring up some Day Lights Running Lights on a 2016 F250 with diesel engine? Thinking of adding LED lights to front of vehicle for day time use.
View 13 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Fog Light Replacement
I have a 08 F350 CC with the factory fog lights. One of them has burnt out. Do I replace just the bulb or the entire unit? Is there a part number?
View 1 RepliesFord Super Duty (1999-2016) :: 4x4 Light Goes On After Replacement Of Blown Fuse?
I noticed I was not shifting into 4x4 electronically and replaced the blown fuse in the engine compartment. Now the 4x4 light goes on, but I don't think it is engaging the system...
The back end breaks free very easily, but there seems to be a little pull in the front. Is it possible to have unequal power to the wheels?
Ford Super Duty (1999-2016) :: Trailer Light Replacement Harness
The pigtail from my bumper mounted 7-pin to the factory connector is all hacked up from the previous owner so I'm looking to replace that pigtail. Also wondering if there should be 2 connectors down there to add a connector for my gooseneck or do I need to splice another universal 7-pin into the bumper light pigtail? Also, is there another (preferably slightly cheaper) option besides e-trailer for such a connector?
View 3 RepliesFord Super Duty (1999-2016) :: Changing Bulbs In Side Mirror?
How to change the bulbs in my outside mirrors.
View 2 RepliesFord Super Duty (1999-2016) :: 2010 F250 - Map Light Bulb Replacement
How to change my map light bulbs over the front seat of my new (to me) 2010 F250 King Ranch with a sunroof. I have tried to remove the whole assembly with a plastic trim tool with no success. I have pulled as hard as I dare and figure there must be a procedure I am missing. It appears to me that the whole assembly has to be pulled down.
View 6 RepliesFord Super Duty (1999-2016) :: F250 - Bulb Replacement On Driver Side Mirror Light
How to remove the orange cover to replace the bulb in the driver side mirror - tried but worried I'm going to break it...
View 2 RepliesFord Super Duty (1999-2016) :: 2005 - While Tightening Up Turn Signal Bulbs - They Turn Towards Fender?
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 RepliesFord Super Duty (1999-2016) :: Lug Nut Replacement?
Any downside to using a nut that covers the entire stud on my '99 450?
View 2 RepliesFord Super Duty (1999-2016) :: Replacement Turbo For 7.3L?
After 225,000 miles, my turbo appears to have failed -- not spinning. This is a stock turbo that is unaltered. Yes, I change my oil and filter every 3000 miles.
My question is; what is a reliable after-market replacement part that will bolt up?
Ford Super Duty (1999-2016) :: Seat Belt Replacement?
My "new" truck has a sluggish seatbelt on the driver's side. It won't retract all the way.
How do I get to the mechanism to have a look at it or put in a replacement?
The belt on this one comes out of the top of the seat, not from against the door.
Ford Super Duty (1999-2016) :: 2007 - Tailgate Replacement?
07 Superduty, Oxford white. I have been looking all around NC pick a parts for a decent replacement tailgate. I know more recent years will fit, with hinge mods. Question is, what is the most recent year that will fit with hinge swaps only?? Looking for a source in SC/NC/VA for a replacement?
View 7 RepliesFord Super Duty (1999-2016) :: 2008 - LED Replacement Bulb?
Using LED replacement bulbs? I have a 2008 super duty. Want to upgrade lighting.
View 14 RepliesFord Super Duty (1999-2016) :: Dash Vents Replacement?
I seem to be having a run of bad luck with my dash vents. 3 of the 4 vents in the dash have broken and I would like to replace them.
Are these vents made aftermarket? If so who? The dealer wants fifty some odd dollars each.