Ford Super Duty (1999-2016) :: Turning Over Fine Just No Start / No Fuel At Rail
I have a 99 f350 super duty with a v10. I drove it Friday night, but it wouldn't start Saturday morning. It is turning over fine, just no start. I have no pressure at the fuel rail. The pump does its little key on run. I can hot wire the pump at the tank, and it pumps. It builds up pressure after the fuel filter. I found that out when I changed the fuel filter. Will the pressure regulator shut off the fuel to the rail?
View 9 RepliesFord Super Duty (1999-2016) :: Rear Brake Line That Runs The Frame Rail Rusted
I have a 2000 dually and the brake line that runs the frame rail finally rusted through. It runs on the same side as the fuel tank. Is it easier to leave the old one in and run a new one along side it? I sure hate to think that I'll have to drop the tank for this.
View 7 RepliesFord Super Duty (1999-2016) :: Brake Line Rusted That Runs Along Driver Side Frame Rail
My 2000 SD has a brake line that rusted through. The one that runs along the drivers side frame rail. So I need to get new line to replace it. Since I am nowhere near my truck right now, what is the size of the steel line?
View 6 RepliesFord Super Duty (1999-2016) :: 2002 - Any Way To Have Fog Lights On With Parking Lights?
I was wondering if there was a DIY mod so I can have my foglights on with my parking lights and my high beams..
View 7 RepliesFord Super Duty (1999-2016) :: 4x4 Switch Knob Lights Up With Rest Of Dash Lights?
Should the indicator above reads "4x2, 4x4 hi, 4x4 low" light up when the driving lights (i.e. at night) switch is on?
If yes, how to change the light bulb?
Ford Super Duty (1999-2016) :: Trailer Has Running Lights But No Turn Signal Or Brake Lights
2013 F250 XL with factory towing package.
My camper and boat trailer do not have turning signal or brake lights when plugged into the round seven pin trailer connector. I have tried both the connector in the bed and under the bumper. I've also connected the trailers to other trucks and the lights work fine so I know the problem is in my truck.
Ford Super Duty (1999-2016) :: 2004 F250 - Rear Tail Lights And Front Running Lights Not Working
The rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
Ford Super Duty (1999-2016) :: HID Lights Adjustment?
I installed after market HID lights (Including light Assy) and there re no adjustments on the new housing, right now they are close but the passenger side is shinning high. Am I screwed and there is nothing I can do?
View 3 RepliesFord Super Duty (1999-2016) :: Running Lights Won't Go Off
99 f350 7.3... All lights working but running lights wont go off....
View 1 RepliesFord Super Duty (1999-2016) :: LED Clearance Lights Gone Out
A few of my clearance lights have gone out... and I'm looking to replace them. I was told the bulb type was "194" and was wondering if I could just drop in some 194 type LED bulbs like these, in amber color without changing anything else [URL] ..... I'm assuming it will plug right in but wanted to make sure
View 14 RepliesFord Super Duty (1999-2016) :: Lights To Fit In Bumper Under Headlights?
On the 99-07 front bumper i would like to add driving lights in the bumper under the headlights something like the 11 up bumpers have...
Looking for a light and housing that possibly could be installed with out having to re chrome, so it could have a bezel to cover cut edge of bumper...
Ford Super Duty (1999-2016) :: 2011 - Tail Lights Out?
I left town tonight and dad called to say I had no tail lights. I stopped and checked the book to see where the fuse is and couldn't find anything for the tail lights or parking lamps. I have brake lights, both rear turn signals and the tail lights blink when you lock it with the fob. The trailer socket shows I have trailer tail/marker working. Why don't my tail lights work?
View 14 RepliesFord Super Duty (1999-2016) :: 2008 - Cargo Lights Did Not Lit Up
Two days ago I noticed that I had one of my cargo lights that didn't light up---I took the light off and the bulb was blown, and other was OK. I picked up a couple of bulbs and I replaced both of them. Now, neither one will burn. I checked the bulbs with an ohm meter--they were good---checked the #10 fuse at the passenger kick panel and all OK, but I don't have voltage at the light sockets now. If the bulbs I used were a greater wattage than the originals, would that have sent an overload signal to the SJB (smart junction box) and stopped the supply of power to the lights? I'm tempted to put it right back where I started, with the one good, used bulb and see what happens then.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 - Running Lights On / Off By Themselves?
My 08 F3 50 seems to be turning the lights on and off by themselves throughout the course of the evening and the day currently I am disconnecting the negative cable trying to trace back a bad ground I'm not exactly sure what I'm doing
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Cab Over Lights Are Out
I have an 08 f350, and my cab over lights are out...I've checked net for issues and they all point in different directions... Running and towing lights are fine, just cab over lights are out...is there a fuse somewhere I cant find? could one burned bulb be out and it effects all?
View 3 RepliesFord Super Duty (1999-2016) :: 2012 - Mod To Keep Fog Lights On With Hi-Beams?
I have a 2012 F-250...per DOT specs, the fog lights go out with hi-beams on. However, in my opinion, the high beams on my truck are among the worst I've seen. Low beams are OK. Is there some easy mod to keep the fogs on with the brights?
View 14 RepliesFord Super Duty (1999-2016) :: Installing Puddle Lights?
I am going to be installing puddle lights to light up my step bars and I am looking to find out which wire to tie into? I was going to tie into the dome light circuit (blk/blue) so they would come on with keyless entry door unlock, but my dome light won't come on. So I either have to figure that out or go to plan B and find a difference source. Adding lights down there and found another way to power these? I don't know if extended cabs ever had the option for lighted running boards, maybe there is a dedicated wire somewhere? I don't want them on all the time, only when the truck is unlocked to light the step.
View 12 RepliesFord Super Duty (1999-2016) :: Reverse Lights Dim Or Don't Work At All
I have an 02 f350 XL. The other day it rained and all of my rear lights went haywire. All problems are out back.
- Step on brakes, high mount, and lic plate lights light up with brakes.
- Turn on marker lights and the high mount lights up and the tails and lic plate lights dim.
- Marker lights on, apply brakes, and the tails and lic plates lights go out on bed, high mount activates.
- Use turn signals with markers off and all of the rear lights including high mount flash..
- Reverse lights dim or dont work at all.
I have tried a new MF switch, checked all fuses. cleaned rear frame ground. took apart brake switch and cleaned it. non tilt column but checked wires. replaced flasher. unplugged brake light switch and headlight switch, problem is still there. removed trailer relays, no luck. checked all chassis plugs. disconnected TRS.
I should mention i have 12v cummins swap and a pcs with standalone harness. no problems over the last few months since swap until it rained last monday.
Ford Super Duty (1999-2016) :: 2006 - Yellow OEM Fog Lights?
On my o6 SD i want to make the OEM fog lights "selective yellow". I am going to tint the fog light lens with duplicator metal cast yellow. What I am wondering is if paint the outside of the lens or take apart and paint the inside.
I am leaning towards heating and splitting the lens from the housing and painting the backside of the fog light lens so the color will not be chipped off from lens wear and tear. What I am wondering is if the fluted rim on the inside of the lens will take the paint in a uniform manner, or would it be better just to paint the out side where it is smooth all the way to the housing.
I have a spare pair, I am working with and have split he lens from the housings before.