Ford Super Duty (1999-2016) :: 2001 - While Taking Away Sluggish - Skipping At Idle?
just bought a 01 f350 v10, 40,000 miles, plowing beast, anyways when taking off truck seems sluggish, give it more gas as its fine. At idle there appears to be a skip. There are no check engine lights on, could it be the coil pack or even maybe fuel problem? Have done plenty to this beast to get it close to perfect and this motor issue is it.
View 14 RepliesFord Super Duty (1999-2016) :: Chirping Noise While Taking Slight Right Turns 20 - 40 MPH
Just noticed today, while taking slight right turns 20-40MPH, I get a really loud and angry chirping sounds? Its only right turns...It sounds like a forest of angry crickets.
View 4 RepliesFord Super Duty (1999-2016) :: Trans Slipping When Taking Off From A Stop Light
99 F250 7.3 everyday worker, just recently my tranny slipped as I was taking off from a light, I thought hmm that's odd! Pulled away from the next light , it did not slip! Later in the day did it again, so I ran by the transmission shop to have a service done, to my surprise I was told service would not work, and a rebuild was going to be 3200-4k. truck has been used lightly for the last week or so, slips sometimes and not others. I still believe I need to have it serviced? can I do this myself ( I haven't a clue)....
View 7 RepliesFord Super Duty (1999-2016) :: TPS Fault Lit Up On Message Center When Taking Off From A Light
So on my way to work this morning taking off from a light on a smooth blacktop my message center lit up with "tire pressure sensor fault". is there any way to tell which sensor it is without a scan tool?
View 11 RepliesFord Super Duty (1999-2016) :: When Taking Off Truck Will Not Shift Into OD Unless Cycle The Button On Shifter
I am having a bit of an issue with my new to me 2002 F350 V10 Ford, I have noticed a few times in the when taking off (first time after being parked)the truck will not shift into over drive unless I cycle the button on the shifter, after that the OD seems to work fine for the rest of the trip. Second thing I noticed is the "OD" light on the end of the shifter will come on at times (indicating the OD is off) even when the truck is in over drive, wiggling the shifter makes the light go out and the truck will not change gears. Would a new gear shifter fix this as it is a bit sloppy?
View 3 RepliesFord Super Duty (1999-2016) :: Turn Signal Sometimes Taking A Few Seconds Before Actually Starts To Flash
Need better understanding of the wiring and turn signal selector than I do in my 07 6.0 HD. At first the issue started with the right front and right mirror blinking fast indicating a burnt out rear right turn signal. However after a few seconds the right rear will start working and the speed would be normal. I noticed it worse on very wet days making me think the rear tail light was letting in water and messing with the bulb. But it turns out it does it on nice days too.
These days it has evolved into the turn signal sometimes taking a few seconds before any of the right side actually starts to flash, also sometimes the indicator does not automatically deactivate after a right turn.
Giving the bottom of the steering column a calibrated tap usually always fixes the issue until the next turn.
Assuming its a bad turn signal selector switch Part number YL3T-13K359-ABJAEA but not knowing the wiring diagram I dont see how this bad switch would intermittently stop controlling the right rear turn signal. I would guess that it would tell the flasher left or right, not which lefts and which rights.
Ford Super Duty (1999-2016) :: 4x4 Does Not Engage
On my 99 lariat the 4x4 does not engage. It's got a electric switch on the dash. The 4x4 light comes on when I turn the key on for 3 seconds. But when I turn the switch I got nothing and can't hear anything trying to engage. Where to start or how to test the switch?
View 3 RepliesFord Super Duty (1999-2016) :: 4x4 Low Range Does Not Engage
What are some simple checks, my 4x4 low range does not engage, just stays in 4 hi. 2003 f350 screw v10.
View 5 RepliesFord Super Duty (1999-2016) :: 2001 F250 - 4x4 Won't Engage
My truck: 2001 F250 V8 Triton Automatic 4x4
Problem: 4x4 won't engage
Symptoms: No dash lights....nothing happens when I turn the 4x4 switch. When I start the truck I hear what sounds like a motor (transfer case motor maybe?) trying to switch (even though my dash switch is on 2WD)... It tries three times and stops.
What I've done: Checked fuses ...they appear ok to me
I don't have a maintenance manual yet ...
The 4x4 used to work up until about 2 weeks ago. Started having a hard time getting it to go into (and out of) 4x4 and then it just stopped all together.
Ford Super Duty (1999-2016) :: Tow / Haul Fails To Engage
2008 F-250XL, 5.4L V8, 5 speed auto, 3.73 rear.
Two/haul fails to engage and does not light up dash indicator light from time to time. After 4 or 5 tries it usually will engage normally. No codes.
Ford Super Duty (1999-2016) :: 2005 F250 - 4x4 Would Not Engage
2005 F-250 King Ranch Diesel ... My truck when I got it the 4x4 wouldn't engage. I replace the front inner seals, and the lock outs. Still wouldn't work. Took the shift motor off and freed it up and it worked fin till today. Changed the shift motor and still nothing. This truck has been nothing but problems since I have had it and now this ... Truck is going on the market soon and would sell better if the 4x4 worked ...
View 13 RepliesFord Super Duty (1999-2016) :: Vacuum Leak - 4x4 Won't Engage
How to diagnose a vacuum leak without a vacuum leak diagnostic tool.
My ESOF won't engage, AC/heat blowers default to defrost - classic symptoms. And while we can leave without AC/heat, we really need the ability to engage 4x4 low, especially as we get higher into the Andes and the roads unsmooth.
Ford Super Duty (1999-2016) :: 2005 F250 XLT - 4X4 Won't Engage
F-250 2005 XLT 5.4L 4X4. Had ford for a few years now (Escape as a personal vehicle and econoline as business vehicle). Now I'm having a little problem with 4x4. It wont engage. Worked fine last week and now nothing! I did check all the fuses and when i switch to either 4Lo or 4Hi I can hear a clicking sound behind the switch but feel like it's getting blocked or something. Tries a few time then stop...
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - 4x4 Will Not Engage
I have a 04 ford f250 superduty... I tried to use my 4x4 today and the front wheels would not engage using the ESOF. The light comes on in the dash saying its in 4x4. i do not believe i have a vacuum leak because it doesn't switch over to the automatic setting for defrost. what else could it possibly be I'm stumped at this point.
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 V10 - 4x4 Will Not Engage
4x4 will not engage. 4x4 light on dash does not come on. Can not hear motor switching into 4x4. Check fuses under dash all looked good.
Truck is a 2004 F250SD V10 ....
Ford Super Duty (1999-2016) :: 4x4 Doesn't Engage From Inside On F250
I have a problem on my F250 4x4. The 4x4 doesn't engage from inside. I tested for vacuum on the pipe that leads out of the solenoid. There seems to be no vacuum building on the outlet line. This is the line that go to the wheels. Is my solenoid stuffed. the pump works well and vents do not default to defrost.
View 14 RepliesFord Super Duty (1999-2016) :: Cannot Get 4x4 To Engage - Front Locking Hubs
I am considering buying a 2001 Ford F250 Super Duty XLT 4x4 V10 engine tomorrow. I am hesitant because I cant get the 4x4 to engage. It goes into 4x4 low and high and the front driveshaft spins but it wont engage the wheels. One side locking hub locks but the other side the locking hub is cracked off and so I there is no way to turn to lock that side. I will of course replace the Locking Hub ASAP if I buy the rig but my question here is, if one side is locked should one side of the front axle spin, meaning if only one side Locking Hub is locked should that wheel turn and the other not? Both are not turning but as I said the driveshaft is spinning.
I don't know if both sides need to be locked in order for the front wheels to engage while in 4x4 high or low. Or if one side should engage if only one side is locked; the wheel that's locked of course..
2001 Ford F250 XLT Super Duty 4x4
V10 engine...
Ford Super Duty (1999-2016) :: 2008 F250 Won't Engage Into 4x4 / Just Clicking
Basically I have a 2008 f250 (6.4l if that makes any difference) That wont engage into 4x4. When you go to turn the switch to engage the 4x4 all you get is a click click click click click. Is that a problem with the 4x4 shifting solenoid on the transfer case? Anything else to look for? The truck has 95k miles on it....
View 2 RepliesFord Super Duty (1999-2016) :: HVAC Goes To Full Defrost And 4WD Does Not Engage
I have a 2005 F350 6.0 with 4 wheel drive.
Late last winter, the 4WD stopped working. I diagnosed it to be a vacuum problem. Like a moron, I purchased a vacuum pump and threw it in there, I just figured that it was bad. It turns out the new pump I bought was bad, but the old pump was fine... Go figure. At any rate, when I switch to 4WD, my HVAC goes to full defrost and the 4WD does not engage.
I think I've narrowed the problem down to the 4WD actuator, since if I hook the vacuum pump output directly to the hubs, the 4WD works fine. If I switch it into 4WD, I can hear the vacuum releasing in the actuator, but it doesn't seem like any vacuum actually gets routed to the hubs. It just opens to atmosphere.
I've noticed that after switching to 4WD, the actuator only "Releases" the vacuum for a few seconds, and then seems to close itself. Is this normal? If I cycle the 4WD selector from 2WD to 4WD repeatedly, it will continue to cycle.
1. Is there any way to service this valve, or should I replace it?
2. Is the valve acting normally?
3. Am I on track with this repair?