Ford Super Duty (1999-2016) :: 2009 F250 - Removing Throttle Body?
Read about and want to clean my throttle body. Why have to remove it from the truck ? 2009 f-250 5.4 .....
View 5 RepliesFord Super Duty (1999-2016) :: 2015 F250 - Lousy Throttle Response
Took delivery of my 2015 F250 in June with 2WD and the 6.2 gas engine. What I thought to be a slow throttle response seems to be more of a quick shifting transmission according to two different dealerships. My 6 speed automatic has already shifted to 4th gear at only 25-30 MPH. My Dodge Hemi I sold never had shifts as quick as this and I think it's to quick. My question is....is there a way to change these shift points so I get more speed before it shifts into the higher gears?
View 10 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Evaporator Cleaning - Easiest Access?
Cleaning the evaporator on a 03 F250? A buddy of mine cleaned his F150 and said it made a noticeable difference. I was thinking of trying it on mine. If you have, whats the easiest access? Any recommended cleaner?
View 2 RepliesFord Super Duty (1999-2016) :: 2015 - No Response To The Throttle At All
I have a 2015 SD with only 4100 miles on it. This has happened to me twice. Both times, traveling slowly at idle or just above. Anyway, tried to give it a little gas, and -----nothing. Lightly pumped the throttle a couple of quick times and back on line. The motor didn't die, but there was no response to the throttle at all. The first time, I thought maybe it was something I did. Then it doesn't happen for a month and a half and then again, in heavy traffic in the rain. Haven't had my first service yet, and you can bet I'll tell them about it. Almost felt like a two-stroke that had loaded up?
View 2 RepliesFord F-150 - 1997-2003 :: 1999 - High Idle After Cleaning Throttle Body
High mileage 1999 4.6 4wd 5 spd: Needed to replace the rear ABS sensor and decided to clean the throttle body too while the battery was unplugged. Cleaned it around the butterfly and not much else. Truck idled at 750 BEFORE cleaning the TB. Now it fluctuates between 820 and 950 rpms. Also tends to stay at a higher rpm after pushing in the clutch and taking it out of gear.
Did a thorough check for vacuum leaks, nothing. After research, I cleaned the IAC and re installed (battery was disconnected then too). No improvement. Unplugged the IAC while running- ZERO change in idle. Installed new IAC, no change whatsoever. Unplugged NEW IAC, no change whatsoever. Is there an issue with the PCM needing time to fully re learn? Am I missing something.
Ford Super Duty (1999-2016) :: 2004 F250 6.0 - No Throttle?
2004 f250 6.0 4x4 no throttle at all, no cel, idles and runs just fine just no throttle, had a diesel mechanic look at it and he couldn't pull any codes, where to start, checked all wiring, checked connections, changed the EBP sensor and tube (read that was a fix multiple times) no change
View 4 RepliesFord Super Duty (1999-2016) :: 2015 F250 - No Compression On 3 Cylinders
I've got a 2015 F250 with a 6.2 Liter with no compression on 3 cylinders. The dealer just diagnosed it and has not opened it up yet but the mechanic says it is probably a broken valve spring...that it is not uncommon in this engine.
My concern is not repairing the spring my concern is what a "free spinning" piston in 3 cylinders does to the life expectancy of the main and connecting bearings in this engine. I have rebuilt engines in the past and I have bought re-built from auto parts stores and from Jasper and I have never had any last more than 60-70K miles. It seems to me that even with very little mileage on the engine with three of eight pistons jumping around under no pressure that there could be considerable scarring of the bearings or bearing surfaces. I am no expert by any stretch but this is an engine in atruck that has less than 22K miles on it and I ain't real happy about opening it up let alone trusting for the next 280K miles that the bearings have more wear on them than they should have. It was only driven about 20 miles total like this but that is a lot of pressure on a highly tuned and pretty darn precision machine.
This is the newest vehicle I have owned since 1988 and I meant for it to be the last pickup I drive (I drive 'em til the wheels fall off) but I am not overly confident that even if this is a one off problem that it hasn't caused even more damage that won't show up for another 100K miles or so???
Ford Super Duty (1999-2016) :: 2015 F250 - Vibration From Driveline
I have a 15 F250 CC SB 6.2 4x4 that is suffering from a driveline vibration. Had the shaft checked for balance and it was off. It's a little better now but still there. Checked all the angles and they're correct. Also came up with a curious observation that all CC SB 4x4's have a slip yoke driveshaft at the transfer case while all the other trucks have the fixed yoke. This appears to be my source of the vibration.
View 3 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Hesitation When Give It Throttle
I bought the 2005 F250 6.0 Turbo Diesel with 67,000 miles on it last March. It has given me gave me absolutely no problems until now. In the last 2 weeks I have had it plugged in when it was below 32 degrees outside. Otherwise, I just remote started it every morning and let it run for 20 minutes before I left. In the last 2 weeks, I have noticed the same problem whether it is morning, afternoon, or evening and it happens at different times. I will be at a standstill at a stop light, stop sign, or parked in my driveway when this occurs. Sometimes, and like I said, "sometimes", it will hesitate when I give it throttle. It will quickly respond after maybe a second, but the hesitation is still there. It only does this on occasion!
I work for a Lucas Oil distributor, so in the winter I ran the "extreme diesel conditioner" through it with a tank of diesel about every other week. I also used the fuel-injector cleaner at every fill up. On "ONE" occasion, and like I said, "ONE" occasion, when it hesitated at a stoplight, I looked in the rear view mirror, and noticed a short burst of white smoke, and then it took off. It has not done that since. I took the EGR off and cleaned it and it seemed okay until 2 days later, then the same hesitation came back, but like I said, at times!
I replaced the air filter and since then I have done nothing. I am now being told to check the coolant level in the resevoir. When I un-screwed the cap the cap, there was pressure in there and the fluid was about 1/4 inch low from the line. I was also told to check the filter on top of the block, but I have not gotten that far. Ford says it is the EGR cooler system! I have "NO" check engine lights!
Ford Super Duty (1999-2016) :: 2005 F250 - Quick Throttle Response
2005 f250 4x4 , crew cab v10. Just put on my magnaflow muffler and gotta say, What a difference that makes! Can't wait to get the k&n intake kit and see what that will do. I see that my truck has the electronic throttle control instead of the previous v10s with the cable. I am wondering, is there any way to get quicker throttle response like with the old cable style throttle? Just seems real sluggish to rap up the rpm in park with no load on it.
View 1 RepliesFord Super Duty (1999-2016) :: 1997 F250 - Throttle Chocking Under Acceleration
My 1997 250hd has the 5.8 we have rep[laced the cap,rotor,iac,tps,plugs and wires about to do the fuel filter and drop one of the tanks and change out the pump,also has a new fuel regulator. What could be making it choke out under acceleration...
View 3 RepliesFord F-150 - 1997-2003 :: Throttle Body Cleaning
I need to clean my throttle body on my '97 F-150 and it has a label saying not to clean directly. Is it still safe to use TB cleaner and to go ahead and clean it? It needs done but how would I go about it.
View 6 RepliesFord F-150 (2004-2008) :: When Should Do Throttle Body Cleaning
read a few posts over the years relating to dirty throttle body, but never understood them. At 60000 miles, should this be attempted by the average guy or just leave it alone if it aint broke?
Any pics addressing where is it, what makes it dirty, how to open it, what to clean it with and how often as preventive maintenance?
Ford Super Duty (1999-2016) :: 2015 F250 XL - Back Up Camera Installation
First tech post for my new truck. I just bought a hold-over but new 2015 F250 XL Supercab 2wd and love the simplicity of no unwanted options. That said, there are two features I am adding. The first is perfectly straightforward, cruise control (swap button cluster and have the function turned on by the dealer). The second is a tiny bit more involved, back-up camera, in mirror display with bluetooth hands-free (I like the simple AM/FM radio because I can work it all with gloves on).
So I basically need three things from the truck and my research has been inconclusive on a couple of things because most of the threads are for 2014 or earlier. I think I can pull switched 12V and ground (pin 1 and 4) plus reverse lights (center, or pin 7) all from the the trailer wiring harness. It appears these are not affected by the canbus load restrictions of other places to tap reverse signal (remember, XL so likely nothing in the overhead console for the auto-dimming rear view mirror). Are there any challenges with this when I do hook up my enclosed trailer or when it is not hooked up regarding the trailer brake controller/anti-sway?
I already found a good youtube video for how to route the wires so I think this is my primary challenge at this point.
Ford Super Duty (1999-2016) :: 2015 F250 - Starter Fuse Keeps Blowing
Just bought a used 15 F-250 with 57,000 miles, yesterday tried to start it and nothing happened. Checked the starter fuse and it was blown, replaced it and it immediately blew when i tried to start the truck. Pulled the starter and had it tested and it was good, replaced the relay and still blowing fuses. I have got it to start a couple of times but as soon as you kill the engine and try to restart it blows the fuse. What was the fix? Truck had no problems trying to start before this problem started.....
View 7 RepliesFord Super Duty (1999-2016) :: 2015 F250 - Groaning Noise At Start Up
Dealer says groaning noise at start up, when I let my foot off brake at a stand still is normal,worse if i turn steering wheel with brake on.
View 8 RepliesFord Super Duty (1999-2016) :: 2015 F250 6.2 - Buzzing Noise On Shutdown
2 weeks ago, I purchased a 2015 F250 6.2 with 16K miles. Upon bringing her home, I noticed that there is a buzzing noise coming from the engine compartment after I shut down the motor which lasts approximately one minute (give or take). Since the truck is still under factory warranty, I figure I'll take it to the local dealership, but I'm wondering with the 6.2 has had the same issue and what the issue could possibly be.
View 6 RepliesFord Super Duty (1999-2016) :: 2015 F250 - Accessory Power Under Dash
2015 F250 diesel. I am hooking up an air pressure gauge inside the cab to report the pressure on my rear aftermarket air bags. The pressure reading will come from a tap on the actual pressure line, but I need 12vdc to operate the backlight on the gauge. I have found a bundle of loose wires under the steering column, 4 of which are firewall pass-through wires for the upfitter switches. Do one of the remaining wires in the bundle is an accessory power wire? I need a plain key-on accessory wire connection, not a dash-light connection.
I am using one of the upfitter switches to switch my on-board air compressor and a second switch to inflate/deflate the air bags. Want to save the other 2 switches for future use.
Ford Super Duty (1999-2016) :: 2015 F250 - Installation Of Upfitter Switches
I just got a 15 f250 with the console and nav system but it didn't come with the upfitter switches.
I picked these up and got a copy of the .pdf for the installation, but I'm finding it hard to follow for where the relay and box should install. I ran the wire up to the upfitter switch location and can even find a nice spot to connect the grounding wire.
I can't for the life of me figure out where the box installs and where the wiring harness taps into the main harness. Need a photo of where your box is installed and where it taps into the main harness?