Ford Super Duty (1999-2016) :: Trans Cooler Lines In Radiator
I have Russell fittings and hose coming to hook up my new 6.0 cooler into my 5.4 powered truck. Have a question on the fittings on the bottom of the radiator for the cooler lines, first what is the 3/8" line called? Is it a double flare or what? And second question the female end that's into the plastic tank with the hex head does that unscrew or is it made into the tank? Trying to figure this out so I can overnight two adapters so I can get rid of the fugly hard line completely and use Russell braided line throughout my install
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Transmission Cooler Line Start To Leak
I have a 2008 Ford F250 V-10 Superduty and recently I had a transmission cooler line start to leak. I ordered replacement lines and the tool for the quick disconnect. The line that's leaking is from the radiator to the quick disconnect. I was able to replace the one line, however the second line (problem area) has been a nightmare. The line cracked right at the quick disconnect fitting.
The hard line is tight in the fitting and corroded. broke the tool trying to remove from disconnect. The line is flush with the quick disconnect. How to get that out of the fitting? or another method of fix? Its a hard 1/2 line going into connect crimped to rubber line going to transmission.
Ford Super Duty (1999-2016) :: 2008 - High Oil Temps / Cooler Is Fully Or Partially Clogged
2008 6.4L .... My ECT 191-197 and EOT 220-230 high side on interstate no load on truck air temp 70 degrees. Is this a sign thermostat failing. Is there a certain temp to determine if your cooler is fully clogged or just partially clogged? I plan on doing a flush with restore then restore plus. Is there any point in using restore with temps this high. Or do I have to break down and buy the half kit to bypass OEM oil cooler? I need this fixed ASAP hauling the RZR to arkansas in a week. I know ill mess something up if i try to pull a load with those temps.
View 2 RepliesFord Super Duty (1999-2016) :: Trans Slipping When Taking Off From A Stop Light
99 F250 7.3 everyday worker, just recently my tranny slipped as I was taking off from a light, I thought hmm that's odd! Pulled away from the next light , it did not slip! Later in the day did it again, so I ran by the transmission shop to have a service done, to my surprise I was told service would not work, and a rebuild was going to be 3200-4k. truck has been used lightly for the last week or so, slips sometimes and not others. I still believe I need to have it serviced? can I do this myself ( I haven't a clue)....
View 7 RepliesFord Super Duty (1999-2016) :: 2008 - Trans Filter Change?
2008 f250 auto
is the trans filter change possible?
i didnt see this in the tech folder and no videos for a 2008
Ford Super Duty (1999-2016) :: 2008 - Adding A Remote Trans Filter?
I used to own a fleet of school buses and I had remote trans filter on all of them. I'd change the filter about every 10K and felt like it really extended my trans life on Allisons. I wanted to put on my SD, so, I had a spare filter block with a 20psi bypass valve, and I used it. Worked out real well mounted to the radiator support, up front--easy access. uses a NAPA 1268 filter. In the picture it looks like the hoses are real close to the AC condenser, but in real life, the are three inches from it.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Trans Temp Sending Unit Replacement?
The trans temp guage on my '08 F-350. V-10 started acting erratically, and the wrench icon popped up on the display. i crawled under the truck to look for the sending unit and it's lead. i assume that i found the lead. it is encased in a corrugated sleeve, and appears to be a vaccuum type tube and boot connector? the boot still had a small round gray cap plugged into it. it appears that the cap was never glued (go figure) upon assembly. i have tried to reach up on top of the trans to find the sending unit to figure out the best angle of attack. i can barely touch it with the tip of my finger. going with mechanical guages is out of the question at the moment, so i'm wondering can it be driven any distance this way, AND any schmooze tricks developed to get at the sucker without dropping the cross member or exhaust????
View 3 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Trans Occasionally Slam When Shift From Drive To Reserve
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 RepliesFord Super Duty (1999-2016) :: Heat Went Out - Replaced Thermostat And Gasket?
So my issue, had heat last year, turned on first time this year and its cold. So I did some research on the site and have done a few things but still no heat
First thing I did was flushed coolant system and add new coolant as I have 235,000 miles on the truck and it looked rough
Ran the truck for a while and checked heater core hoses, they were both warm, not hot by any means so I pulled the thermostat and replaced the thermostat and gasket
Now the hoses to heater core are both hot and my temp gauge went up about 1/4" higher than it ever has, but still no heat.
Blows fine, just cold or sometimes luke warm. I pulled the glove box back to try and see I I could hear anything when I change from hot to cold and I hear or see nothing. Only movement I see is when changing cycles from defrost, heater, ac... So could this be a blend door issue an how do I get to the blend door, is it behind the big plastic plenum box?
Ford Super Duty (1999-2016) :: 2008 F250 - Wipers Came On With Switch In Off Position And Won't Stop
I have a 2008 f250 with 6.4. Was sitting my truck with key on and motor off listening to radio on lunch and my wipers came on by themselves. Switch was in off position and we're in slow speed. If I turn switch they wouldn't change speed til high position. Turned key off and back on and they came on still. Pulled 30 amp fuse in battery junction box to shut them off.
View 3 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Truck Will Not Stop Shaking When Driving
I have a 2008 F250 crew cab lariat 4x4 with 20 inch factory wheels that the steering wheel shakes during normal driving left to right. I bought this truck with 1500 miles on it. This shaking started at 50k miles and I was thinking it was a balance issue so I got new tires a month later since mine were about worn out anyways. They were factory replacement nitto terragrapplers. Shake was still there, swapped out for another set of nittos and shake still there, swapped to BFG AT KO's and shake better, but still there. I have gone through 10 or so balances, 5 roadforce balances, 2 alignments at 4 different shops including the ford dealer through the 3 sets. My wheels are scratched to hell and back from the careless people at the tire stores from so many balances.
My truck sat at the Ford dealer for a week just the other day and they changed the steering stabilizer. I thought it was gone, but a a few days later shaking started again. It almost feels as if every little bump, rut, crack in the road the steering wheel feels and shimmies (doesn't matter the speed, gets worse and more noticeable at higher speeds). The Ford Dealer says can't duplicate, but then when I go down there and test drive with them it's "oh yeah I see that, it shouldn't be doing that". The Ford Dealer says they can't find anything loose in the front end when I tell them to check tie rods, bearings, etc.
My truck has 62k miles on it now and it's driving me to the point of thinking about trading it on a Chevy. I love my truck, but it kills me everytime I make a payment and it rides like crap. I am still under extended warranty so I need to get this fixed before it goes out. I've also noticed that if I turn my steering wheel back and forth real quick while driving like warming up for a Nascar race I can feel a bumble in the steering wheel. This is NOT the death wobble as I use to get that around the 20k mile range and it disappeared and has never been back.
Ford Super Duty (1999-2016) :: 2008 F250 - Vibration When Accelerating From A Stop And Under Load
My F250 6.4, 3.73 Crew Cab Short bed vibrates when accelerating from a stop with my 5th wheel on. The 5th wheel weighs 12K. It is a medium to high frequency vibration that is felt throughout the entire truck. It continues through the shift into 2nd (TorqueShift Tranny). The harder you accelerate the more you feel it.
It does not occur if truck is unloaded and you accelerate at full throttle. Is this normal or should I get it looked at?
Ford Super Duty (1999-2016) :: 2006 - 6.0L EGR And Oil Cooler Upgradation?
My 2006 F350 is starting to heat up on me while at lights and parked while idling. I am going to do a reverse flush with Restore and Restore Plus as per Nylyons guide.
I also plan to switch out the oil cooler and upgrade the EGR.
Engine Oil Cooler Upgraded EGR Cooler Kit Ford 6 0L OHV V8 Diesel Turbo ....
Ford Super Duty (1999-2016) :: Black Soot On 6.4L Inter Cooler?
I've got a thick layer of black soot-like buildup on the lower passenger side of my intercooler. Just bought the truck (2008 F250, 6.4L, CC, SWB, 4x4, 150K miles).
What would cause a buildup like this on the intercooler?
Ford Super Duty (1999-2016) :: 2006 - EGR Cooler Started To Leak?
My EGR cooler started to leak last week . Right now I have it , the oil cooler and HPOP out for the updated STC fitting. [9-05 Trk. build date with 2 piece fitting]
Yesterday I pulled the turbo apart to check the vanes .Was throwing a 0299 code for some time . It took half the day to separate the Unison ring from the housing,. Cleaned and freed it up. Unison ring shows no wear .but the mating surface of the turbo housing is corroded and not smooth. Shaft end play is fine.Would not put it back on if I were not selling this truck. Truck has 77,000 miles and in great shape.
How critical is having a smooth surface for the unison ring to mate to?
Ford Super Duty (1999-2016) :: Stalling Intermittently After Oil Cooler Replacement
Recently had an oil cooler EGR cooler replaced. On my first big tow broke down on a major highway. Got it towed to the dealership and diagnosed as a blown out IPR screen. Replace the entire IPR and had no problems the entire trip. A few week later I am sensing the same problems again that i had before the major blowout. Randomly while driving down the highway the truck will stall for a half second or so and then kick back in and continue fine. Seems like the truck loses fuel for a second and then regains itself.
And it's not always at speed either...sometimes just coming to a stop I can feel it. Now this has only happened three times in the past 10 days or so but seems like it needs to get addressed. These symptoms are similar to what I experienced before my major IPR blowout. After it was replaced I didn't have any of the stalling problems but its now happening again. Could I possibly have some gunk in the IPR again that's causing this intermittent problem? Or something else altogether?
Ford Super Duty (1999-2016) :: 2008 F250 - Permanently Stop TPMS Light From Coming Up On Dash?
Am I the only one who thinks the tire pressure monitoring system is a silly feature? Is there any way to delete this and stop the light from coming up on the dash? I want to do new wheels and tires on my 2008 f250 and I don't want to deal with the tpms. Can it be tuned out from the computer?
View 14 RepliesFord Super Duty (1999-2016) :: Oil Cooler Pump Throwing Wrench Light?
Having problem with oil cooler pump throwing the wrench light? Dealer says it cools the oil and mine could be clogged a bit.. cost of total job around 8-10 k. And take cab off.
It seems when engine gets hot wrench light comes on cause not cooling oil down properly... it overheated. Gauges were very high.. Once when I was in full boost towing a ranger up a hill. First time it ever happened.. pulled over for 5 mins than started temp went back normal and finished tow no problem after that cause I kept boost lower!
Ford Super Duty (1999-2016) :: 2010 F350 - P012F Code For Oil Cooler
2010 F350 in my shop today. so, before dismantling the entire top of the motor for this inbred oil cooler job, is there anything else responsible for the P012 engine oil temp issue? it throws the wrench icon and cuts power and i pulled the P012F code.
View 9 Replies