Ford Super Duty (1999-2016) :: F250 - Transmission Fluid Is Low / Slipping
1999 F250 SD... Tranny fluid is low, tranny slipped one time on me. I checked the fluid and it's low. No drips on the garage floor, so I'll have to inspect closer. But my question is can I add new fluid without screwing it up even more? It's got 170,000 miles and I doubt the fluid has ever been changed. I just bought the truck last week, so I can't say for sure, but it hasn't had a regular flush or change. It doesn't smell burnt but it's just a little darker than new fluid. I was told by the guy I bought it from that the torque converter was changed in it not too long ago.
View 11 RepliesFord Super Duty (1999-2016) :: 2011 F250 - Transmission Slipping For A Second When Accelerate
2011 f250 gas 4x4... I bought last year with 65k miles, now has 105k. sometimes when accelerating it slips for a second like a manual would if you jabbed the clutch while pulling. I had the 100k trans flush done. I noticed it a couple times before but more frequent recently. How concerned should i be?
View 6 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Transmission Slipping Going Uphill
I bought my F-250 Super Duty 6.0 last October, and I am extremely happy with it comparing to my former '03 Dodge 2500 TD. The Ford drives so much better!
There is only one problem I have with it. Without pulling it shifts nice and has lots of power. A Month ago I bought a fifth wheel trailer and I hardly notice it behind the truck, also it doesn't use more diesel pulling. However going uphill the transmission seems to slip, and I can hear (sounds like) a fan running loud? I loose speed.
All the temperature gauges stay normal, no difference. It starts to pull worse. I replaced de tranny filters, inside and the outside one. Also I did put the correct transmission fluid in there, no difference. Almost no grindings in the oilpan/magnet.
I looked on many sites, but cannot find anything on this. Personally I think it's the torque converter? My final step would be to have the transmission rebuild, with the best parts available, (close to WA, ID, MO)...
Ford Super Duty (1999-2016) :: 2008 F250 - H&S Tranny Rev Up While Accelerating - Slipping?
I have a older minimax with the latest updates and have noticed that under full acceleration the tranny seems to rev up faster than the truck is accelerating. This occurs i think in 3rd gear like accelerating onto a on ramp etc. Kinda like its slipping if you know what I mean. I'm running the mild tunes in tow mode. Everything else seems ok.
View 7 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Transmission Cooler Line Start To Leak
I have a 2008 Ford F250 V-10 Superduty and recently I had a transmission cooler line start to leak. I ordered replacement lines and the tool for the quick disconnect. The line that's leaking is from the radiator to the quick disconnect. I was able to replace the one line, however the second line (problem area) has been a nightmare. The line cracked right at the quick disconnect fitting.
The hard line is tight in the fitting and corroded. broke the tool trying to remove from disconnect. The line is flush with the quick disconnect. How to get that out of the fitting? or another method of fix? Its a hard 1/2 line going into connect crimped to rubber line going to transmission.
Ford Super Duty (1999-2016) :: Transmission Slipping In 3rd Gear?
Truck is slipping in/out of gear in 3rd gear. Shut it off and the problem may not come back for several days, but in general it is getting more frequent. No codes are registering for the transmission. Curious the wisdom of performing a simple fluid/filter change vs taking it to the transmission shop. Fluid basically looks/smells good, and is full.
View 14 RepliesFord Super Duty (1999-2016) :: 2011 - Transmission Slipping When Cold?
Got the truck 2 months ago and it only happened 3 times; always on a cold engine.
2 times were on my street at low speed just out of my driveway. It's like the engine shuts down for a while and maybe downshifts too. Feels like someone is stepping on the brakes for a second and then all is back to normal.
Last time I was getting out of a restaurant and accelerating hard to get up to speed on a 70km/h road. The downshift happened while I was going almost 70 but still in low speed so the braking effect was severe enough to throw me forward. Once again everything was fine the next second.
I'm not sure if it's the transmission downshifting or the engine cutting; maybe even the ABS kicking in for some reason. It happens too fast and too rarely to be sure. My feeling from what I remember is that the truck is downshifting and I'm feeling the braking effects from compression. 6.2 engine.
Ford Super Duty (1999-2016) :: Transmission Slipping In / Out Gear - Code P0705
I recently had a thread going regarding my 1999 F350 2wd auto transmission slipping in/out gear. Tried to follow up on old thread but got confused so I'm trying to start a new one. Basic problem is that truck was slipping in/out of gear. Cleaned the solenoid pack electrical plug (as instructed on previous thread) and the truck didn't act up for 2 weeks. Today it started slipping in/out again and this time it registered a code of P0705.
View 7 RepliesFord Super Duty (1999-2016) :: 2011 F250 Loses Power And Tranny Is Slipping
Heard a 2011 F250 gaser while driving in the morning just falls flat on its face, almost like its starving for fuel as well as it feels like the tranny is slipping too. What this could be? I am not sure if its electrical or what.
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Trans Slipping Accompanied By A Sound Like Hitting A Rev Limiter
I have a 2001 F250 SD 4x4 5.4L . I purchased the truck used with about 120,000 miles on it. It runs great despite averaging about 10.8 mpg. Shortly after I got the truck, I noticed what I thought was an intermittent transmission issue when the trans would shift. I would get a "flare" that lasted briefly as if the trans was slipping, but it was accompanied by a sound that I'm not sure how to describe, but it was somewhat like hitting a rev limiter. It only happened when the transmission shifted. The fluid was clean and did not smell burnt. I assumed it was a misfire issue, even though it did not happen often, and seemed to only happen at shift points. I changed all of the plugs and all of the coil packs. It still does the exact same thing. Sometimes it only does it once every couple of days, and other times it may do it 3 or 4 times a day.
View 5 RepliesFord Super Duty (1999-2016) :: 2008 F250 Wants To Go Into 4wd All By Itself
Seems recently my 2008 f250 diesel wants to go into 4wd all by itself. It's the electric switch on dash with the auto/lock front hubs. I'm thinking either the dash switch or the accuator motor. Where to start though... Also I can turn the switch to 4 wheel high and it doesn't go in.
View 1 RepliesFord Super Duty (1999-2016) :: F250 4X4 - Auto To Manual Transmission?
I am changing my 99 f250 4x4 from auto to manual tranny. I am just looking for pics of where the hydro line runs. I don't want line rubbing something and ruining line. Like does line run under the cab wiring harness? Like between wiring and firewall? Where on firewall does reservior get mounted usually? Are the holes all ready there for it that I am not seeing?
View 1 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Transmission Will Not Go Into Lock Up
I am again trying to fix my truck. 2005 F-250 6.0 4wd, automatic. Truck now has 89K on it. Truck does not seam to go into lockup mode while driving down the road. it started just after I spun my wheels in a snow storm. No symptom's previous to this. No codes in dash no lights and also no codes when I checked it with an obd code reader.
View 4 RepliesFord Super Duty (1999-2016) :: 2008 F250 XL - No Aux Audio
So my dad just bought a 2008 f250 xl with a single cd head unit and mp3 hookup. When you press the aux button on the head unit, it displays ' no aux audio". We have tried unplugging the radio and plugging it back in for a few minutes, but that has not worked .. Any way to get the aux input to work?
View 6 RepliesFord Super Duty (1999-2016) :: 2008 F250 - 4x4 Not Engaging / Won't Go Into 4wd Hi Or Lo
Pump works fine. Replaced pvh. Won't go into 4wd hi or lo no matter what I try. Even with them in lock. How do I know if hubs need replaced or just hub locks?
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Leakage From Oil Pan
I just got a 2008 Ford F250 PSD 6.4L and there is an oil leak that seems to be coming from somewhere in-between the front oil pan and the oil pan closer to the back. Where this is leaking from and how to fix it.
View 3 RepliesFord Super Duty (1999-2016) :: 2008 - 17 X 9 Will Fit On F250 Truck?
I have a 2008 f-250 4x4 extended cab, I picked up a set of black rock steel wheels 17x9. I now have 265 70 17s on my truck. will these wheels work and with what size tires.
View 4 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Transmission Line Replacement?
I'm having trouble disconnecting the transmission lines to replace them. I can't get them off. I have the tool. Can I replace the fittings in the radiator?.
View 3 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Transmission Shifting Hard
I have a 2002 ford f250 with the 7.3l diesel. I recently installed a ts performance chip. On my pcm. And after i first tried all the different stages I didn't like how my transmission was shifting hard. So I contacted the manufacturer and he told me they could reprogram the chip for smoother shifting. So I removed the pcm and removed the chip. But when I went to reinstall the pcm I bent one of the pins on the pcm some how.
So I took it back out and straightened the pin with pliers . i reinstalled it back in the truck. Only to find when I reattached the battery cable I have no power to anything ignition ,horn, lights,Cigarette lighter etc. So my question is if the pcm is bad, or not contacting properly due to the pin being messed up. would that have anything to do with the lights and horn and all that? I suspect its the gem bsm or Vsm. Whichever one my truck has. But really not sure because everything worked fine just 20 min b4.