Ford Super Duty (1999-2016) :: 2008 F350 - How To Locate Keyless Entry Code Sticker

I have looked at many of the other treads and I can not find the answer. How do I locate the keyless entry code sticker in my 2008 F350? I just bought the truck used, I do not have the card that is delivered with the truck and I don't want to pay the Stealership to hook it up to there computer. I am looking for the RAP or the computer module as it is called in the owner's guide.

It is not behind the glove box, there is no longer a fuse access panel under the dash like the earlier SD's, the drink holder under the upfitter switches does not "pop out." Before I start with any tools, I am looking for input.

View 14 Replies

Ford Super Duty (1999-2016) :: 4 Button Key Fob For Keyless Entry

I have got a new 4 button key fob for my 05 F350. How to program this unit for the keyless entry and the remote starter.

View 9 Replies

Ford Super Duty (1999-2016) :: 2006 - Replacing Keyless Entry Fob?

The key ring part of the fob for the keyless entry on the truck (2006 F250 V10) broke a while back. Finally got around to buyin a replacement only to realize that the keyless entry that came with the truck is not OEM. It's an Omega L2M 4410.

In trying to cycle locks to replace the fobs, the locks will not cycle. Tried everything that can be found on forums, youtube, etc. all to no avail. This leads me to believe that the aftermarket keyless was put on because there wasn't keyless from the factory.

I have experience with installing aftermarket systems, but this one stumps me - can't find where the system was installed in the first place. To me, this sounds like it should go to a shop for further investigation.

View 4 Replies

Ford Super Duty (1999-2016) :: F250 V10 - Keyless Remote Entry?

I recently purchased a 1999 F250 S/D v10 5 speed ext. cab and only received one ignition key (no keyless entry fobs).

The truck does not have a keypad on the doors, but if this truck has the remote keyless entry option, how can I tell?

View 14 Replies

Ford Super Duty (1999-2016) :: 2003 - Keyless Entry Keeps Popping Fuse?

I am trying to put in after market keyless entry on my 03 sd wired up my relays according to the 5 wire alternating door locks found on this page

[URL]....

but it keeps popping my fuse when I try to put it in, if this is even the correct set up I found another guy on here that used the same set up but never said if it worked or not

View 6 Replies

Ford Super Duty (1999-2016) :: 2003 F350 - Keypad Keyless Entry

Do the wiring for keypad keyless entry is in the harness and the programing in gem module on a 2003 F350 crew cab?? It would seems that is the same harness/parts as the excursion. I have not removed door panel yet, just trying to save some time.

This truck is one of my finest 4x4 rides yet, this would make much better!!! when i picked up my truck, included in the owners info was a factory keypad keyless entry code card, dealer told me that all trucks with keyless have that card regardless if it has keypad or keyless remote entry???

View 5 Replies

Ford Super Duty (1999-2016) :: 2003 F250 - Poor Keyless Entry Range

I have the factory keyless entry on my '03 F-250 SuperCab. I have always had to be within about 5'-8' of my cab to get the doors to lock/unlock. I thought it was normal for the longest time, but recently learned it's not. I am out of warranty now so I need to try and fix this myself. What is the location of the receiver module, and what it looks like? Also, is there an external antenna w/ the factory keyless entry, and where is it at? Transmitters are fine, as is battery power. Only think it could be is receiver/antenna.

View 14 Replies

Ford Super Duty (1999-2016) :: 2004 F250 - Keyless Entry Dies Suddenly

My 'new' 2004 F250 ExtCab SB w/5.4L sometimes 'drops' my keyless entry (key fob) for no apparent reason. Also, when I attempt to do the 'eight turns' of the ignition to get into program mode, it doesn't always work the first time (or second, or third, etc). Is this a common problem?

View 5 Replies

Ford Super Duty (1999-2016) :: Adding Factory Keyless Entry Without Replacing Complete Dash Harness?

Is it possible to add the factory keyless entry without replacing the complete dash harness? I have an aftermarket unit I can add but I'd rather have oe if possible. Truck is an 2003 f250 v10.

View 1 Replies

Ford - Explorer :: 2003 - Keyless Entry Lost Code

I have a 2003 Explorer with the Factory Keyless Entry on the driver's door. It recently quit working with either my code or the factory code. I have cleared my code, and the only response is that the keypad will light up, and I can lock all doors with the pad. It refuses to take a code to unlock. Other than the dealer route (and a possible new GEM)? The wireless remotes continue to work well.

View 14 Replies

Ford Super Duty (1999-2016) :: 2005 - Have Remote Key-less Entry?

Just bought a used 2005 F250 with a 6.0 PSD.

It has electric door locks but I was only given a standard key.

Q1. Are there trucks without Remote Keyless Entry?

Q2. How do I tell if the keyless receiver is installed in the truck?

Q3. Is there a way to unlock all the locks with the key in the door?

View 14 Replies

Ford Super Duty (1999-2016) :: 2005 F250 5.4 Seems To Have Lost Power

I have an 05 F-250 with the 5.4 liter motor, 4" lift, 35" tires 4x4. I have not had any problems with the truck and have 110,000 miles on it. the only thing I even did to it was replace an alternator. Recently it seems to have lost power.

I use the truck mainly for hauling my smaller horse trailer which is roughly 7500 fully loaded but most times i haul it at about 5500lbs.

I also have a 2003 7.3 which we pull at 20,000lbs no problem

View 11 Replies

Ford Super Duty (1999-2016) :: 2010 F250 V10 - Lost All Power - Code P0300 Came Up

I have a 2010 F250 with the V10 and 42000 miles. Lost*power*while pulling a trailer. Couldn't get over 30 mph. Tried turning back home and lost all*power*and would barely idle. Fuel filter good air filter good. Code P0300 came up. Towed it back to the house and then couldn't even get it to idle. Wouldn't throttle up past about 2800 rpm. Cleaned MAF sensor and nothing. Somewhere during all that P0174 code came up and misfire cylinder 10. Cleared codes and they haven't come back. Now when trying to crank, it barely turns over, yet battery is good. Opened air filter cover after getting it to start one time and there was some light smoke coming out. Also while barely keeping it running for a little bit, the catalytic converter on the driver side was fire hot and the other side I could grab with my hand.

View 6 Replies

Ford Super Duty (1999-2016) :: 2004 F350 - Shacking And Lost Power / Code PO284

I have a 04 f350 6.0L truck ran great all day today then out of the blue it started shacking and lost power then i plugged my tunner in and code popped up po284.

View 6 Replies

Ford Super Duty (1999-2016) :: 2005 F350 - How To Get Spare Tire Out Without Damaging The Unit - Key Lost

I just got a 2005 F-350. I would like to get the spare tire out without damaging the unit, but don't have the key. Is there a trick to getting it out? Would there be a way to get one from a dealer?

View 3 Replies

Prius (2004-09) :: Lost Red Button From Keyless Entry Remote

I noticed today that the red (panic) button cover is lost from my keyless entry (silver Toyota logo) Gen II 2008 remote.

What I basically need is a broken remote, essentially just that red rubber cover.

View 7 Replies

Ford Super Duty (1999-2016) :: 2005 F250 - CEL Code 2285?

Ok says injector pressure sensor low first guess was the upgrade to the blue spring. Did that code clear for a day then comes back on looking at the hfcm but kinda unsure? Came on after we got the real cold snap and i had to buy a block heater I don't see one on here i also added diesel 911 to the tank this is a 05 f250 w 6.0l....

View 2 Replies

Ford Super Duty (1999-2016) :: 2005 F350 - Misfire Code P0307

I had a 05 f350 5.4 3v come into my shop with a CEL. Did the usual it had a p0307. So I did the usual again changed plug and coil plug cam out no prob they were done 15k ago. Test drove a few times and it was fine. Few days later customer brought back with same code p0307. thought maybe I got a bad plug or coil so I moved them to #6, misfire stays on #7. When I drive it local its fine when I go to pull on to highway and really put my foot in it CEL flashes (misfire) and it pings like crazy and loses all power. Scan it back at shop and still only p0307!!

View 10 Replies

Ford Super Duty (1999-2016) :: 2005 F250 - Code For Cylinder 3 Misfire

My 5.4 F250 with 200,000 miles having many problems... It all started a few months ago, when the cam needed to be replaced, and a cam phaser was also replaced at the same time. It ran fine after, then threw a code for cylinder 3 misfire. The guy I took it to said it was due to the huge crack in the exhaust manifold and that was messing with the o2 sensor coming up as a cylinder 3 misfire. So, got the new manifold and it was good for a few weeks.

Now, starting the other night, Friday the 13th, it threw a CEL when I was coming into the driveway. It had been throwing a code every once in a while, and I brought it to school to scan it Friday the 13th but there was no code. So, I assume that it is an intermittent problem, no big deal. When I go to get in my truck to go to work a few hours later, the 5.4 cranks... and cranks... and cranks.

I get it to fire up, and it dies again. Run codes, and it says that the cam positioning sensor is broken. Replace both of them, still acts up ie. doesn't start when it does start it runs very rough and stalls. Get it up to my uncles shop, and replace fuel filter.. Still runs like trash. Run codes now, and it says rich/lean in bank 1.. My uncle tells me to move my truck out of the shop, so I start it up, and it runs great. No hiccups, it idles perfect as I move his truck out of the shop first.

I park my truck outside and let it idle for about 10 mins, and when I come back out it is still idling, perfectly fine. I get in, put it in reverse, and get about 20 feet when it dies and will no longer start back up. What could be going wrong?! Sick of throwing money into this thing! At one time while started up in my uncles shop, it was blowing black smoke, as if it was a diesel!

View 10 Replies