Ford Super Duty (1999-2016) :: 2003 F250 V10 Never Dies Just Loses Power And Drops Truck To Idle
We have replaced 4 fuel pumps on a row.
Voltage is good...even ran a fresh circuit.
Ran new supply lines
But, can't seem to understand the continued drop in pressure. It usually takes about a day of driving to crater after a new pump/filter is installed.
It never dies, just loses power and drops the truck to an idle. Funny thing...if I shut the truck off and turn it right back on...full power for a short period!
The truck is used on a ranch that has plenty of rough roads...thought inertia switch maybe but i believe that would stop fuel completely right?
I am totally stumped and so is the mechanic.
Ford Super Duty (1999-2016) :: F250 4x4 460 Dies While Driving / No Warning
My 1997 F250, 4x4, 460, auto has started dying with no warning while driving from 5 to 30 miles. Changed the fuel filter and the fuse under the hood. Where to start.
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F250 4R100 Trans Blowing 10a Fuse When Pull Selector Into First Gear
Whenever I manually pull my gear selector into first gear it blows one of the 10a fuses (not sure which number). I lose all gauges and accelerator pedal. It's about the fourth fuse from the right on the bottom row.
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F350 Will Start And Then Dies When Try To Put In Gear
My 2000 ford f350 will start and then dies on me when i try to put in gear. I changed air n fuel filter. Adding oil i noticed the stick was still reading dry. Noticed a big oil spot under the hood. What should i try to do? Do not want to put in shop cause every time she goes in I come out broke.
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Keyless Entry Dies Suddenly
My 'new' 2004 F250 ExtCab SB w/5.4L sometimes 'drops' my keyless entry (key fob) for no apparent reason. Also, when I attempt to do the 'eight turns' of the ignition to get into program mode, it doesn't always work the first time (or second, or third, etc). Is this a common problem?
View 5 RepliesFord Super Duty (1999-2016) :: Code P1747 - Shudders And Dies When Drop It In Gear?
It's a 1999 f250sd 5.4l auto. Has code p1747. Truck shudders and almost dies when you drop it in gear, put it back in park idles fine. I have read all the post on here about this and checked wires from trans up to pcm look and test well. Tested plug c1048 wires with the digital meter to body ground with battery unhooked and got 6.66k ohms on pin 11 circuit 925, 421 ohms pins 1 and 12. Plugged c1048 back to trans checked 925 w/y wire at plug c103 got 9.1 ohms back to trans. Is the EPC solenoid bad or is it pcm? I think its epc but want to verify before i take trans apart.
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F250 V10 - Sudden Power Loss And Dies Randomly
I have a 2001 f250 super duty extended cab with the v10. Over the past week it has been running fine and it will all of a sudden lose power and dies. I've been able to start it back up once right away and a few times it started up after a few hours of messing with it.
So, after the truck dies it will crank and crank but will not start. We have checked fuel pressure and nothing. Then we applied direct current to the fuel pump and it turns on. Then we applied direct current to the fuel pump slot in the fuse box and got a fuel pressure reading of 40 psi. But when we crank we have no pressure.
When we apply direct current to the fuel pump slot in the fuse box the truck will only crank and not start.
Ford Super Duty (1999-2016) :: Truck Shudders And Almost Dies When You Drop It In Gear - Code P1747
Its a 1999 f250sd 5.4l auto. Has code p1747. Truck shudders and almost dies when you drop it in gear, put it back in park idles fine. I have read all the post on here about this and checked wires from trans up to pcm look and test good. Tested plug c1048 wires with digital meter to body ground with battery unhooked and got 6.66k ohms on pin 11 circuit 925, 421 ohms pins 1 and 12. Plugged c1048 back to trans checked 925 w/y wire at plug c103 got 9.1 ohms back to trans. Is the epc solenoid bad or is it pcm. I think its epc but want to verify before i take trans apart.
View 3 RepliesFord Super Duty (1999-2016) :: 2002 F250 Randomly Dies While Driving When Hits Bumps And Won't Start Immediately
My 2002 F250 7.3 randomly dies while driving and seems to only be when I hit a bump no matter the size. I have checked the valve cover harness connector outside of the valve covers and they look fine. I checked the ECM connection took it off and reconnected it.
Changed the CPS censor twice, checked the ICP sensor, checked continuity of all the glow plugs through the valve cover harness. Checked the fuel pump, checked all related fuses, changed the fuel filter, checked glow plug relay, batteries hold good voltage and were recently upgraded to bigger batteries.
Engine runs just a little rough but not enough to be of concern. Air filter is clean and oil level is perfect. What could possible be causing my truck to randomly die when it hits a bump and not start back right away??? This truck is new to me and its the first diesel engine I have ever owned.
Ford Super Duty (1999-2016) :: F250 5.4L - No First Gear?
Friend's truck started shifting wierd the other day, starts in second gear (maybe higher). The transmission is a fresh rebuild, the shop wouldn't warranty the rebuild and blamed electrical problems outside the tranny. Fuses are all good, engine light is on but the cheapo code reader won't show a code. Did a search and no answers. Had the overdrive light flashing from before, that code was for a wheel speed sensor.
1999 F250 (7 bolt) 5.4L 4x4
Ford Super Duty (1999-2016) :: F250 Won't Go Into Park Gear
I have an issue with a truck I just bought. Sometimes, it doesn't go to Park when I shut it down. In order to start it I have to sometimes put it in neutral. Once in a while it will start when in the Park gear. What I should look into to fix it? It doesn't seem like a big deal.
View 6 RepliesFord Super Duty (1999-2016) :: 2001 F250 Not Going Into Gear
Having trouble with the truck going into gear. It started by having to put the truck in first and manually shift until in drive, once it finally engaged and would drive normal. But now im having trouble with going into gear at all. What could be the issue????
View 8 RepliesFord Super Duty (1999-2016) :: F250 V10 Will Not Move In Any Gear
I have a 1999 F-250 V10, I went to get into my truck to go to Lowes and only to learn I forgot my wallet. Here is where my problem lye. I came back home and decided to wait until the next morning to go back to Lowes, so I go to get in my truck cranked it up and went to put in reverse and it didn't move. It is like it is in neutral; so I went and put it in drive and still, it would not move. It is like it is in neutral. I can not figure out what is going on with my truck.
View 12 RepliesFord Super Duty (1999-2016) :: F250 Won't Go In Any Gear - 4x4 Light On?
Kevin here, and I'm a newbie. I recently purchased my first 4x4, a 99 F250 with ESOF. Last night I had put it in 4high for a rough road turn-around and then flipped the switch back to 2H, the 4x4 light didn't go off. Then when I got to the house (about 1/2 mile), it rolled when put in park and now it won't go into any gear.
View 7 RepliesFord Super Duty (1999-2016) :: F250 Won't Shift Into Any Gear
Friend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 RepliesFord Super Duty (1999-2016) :: 2001 F250 V10 Won't Shift Out Of Low Gear?
I may be going to look at a 2001 F250, 4x4 with a V10 engine tomorrow. I think it is a shop truck for a business. The owner said that the mechanics told him that the trans won't shift out of low gear. It is an automatic. Maybe something as simple as a modulator valve (do they still use them)?
View 4 RepliesFord Super Duty (1999-2016) :: 2007 F250 - ABS Light On After Gear Swap
I just went from 3.73 to 4.30 gears on my 2007 f250 6.0. It has the standard Sterling 10.5 rear and Dana 60 front. My mechanic friend who did the swap said the ABS light came on during his test drive but the truck drove fine. I was of the understanding that the truck would not need to be recalibrated for proper speedometer and transmission function, but what about the ABS?
View 7 RepliesFord Super Duty (1999-2016) :: 2001 F250 V10 - Stalling At Stop In Gear
I have a 2001 F250 V10. It idles around 1k and when stopped at stop lights or when put in reverse it stalls. I have replaced IAC, fuel filter, tranny filter, oil filter, plugs, coil boots, tranny fluid, oil, air filter, and PVC along with the PVC hose. I'm totally stumped. It doesn't stall if I do a rolling stop.
View 14 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Hard To Drive Under 40 MPH In 3rd Gear
I recently purchased a 00 F250 psd 4x4. Other than doing all of the fixes it needs to make it ride better I have been questioning the trucks "get up and go" and the EXTREMELY sensitive skinny pedal. Truck seems to pull very hard and puts out some black smoke under hard throttle but nothing like the really tuned trucks I have seen. But the skinny is so sensitive its hard to drive under 40mph in 3rd and once it gets up to 55 or so its real sharp getting on and off the throttle. Trans shifts great, TC locks and unlocks, truck runs awesome IMO but just a bit harsh. Is there a way to find out if it was tuned prior to me buying it other than inspecting for a chip, or is this the way they are and I just have to get used to it more...?
View 9 Replies