Ford Super Duty (1999-2016) :: 2003 F550 - Hubs Won't Stay Locked
Just got done with a ball joint replacement on my 2003 F550, everything went together great, just as it should. Until I got to the drivers side hub lock.
I have Mile Marker 449s/s manual hubs. Turn from free to lock and theres this loud clicking sound about halfway to LOCK (passenger side doesn't do this). Hub will stay locked for about 2 rotations, then it unlocks and makes a clicking sound. You cannot turn the hub back to FREE, it gets halfway and stops. I tried forcing it and broke the spring fingers inside. Have a new set on order.
Is this a locking hub issue or an assembly error? I was going to take these steps.
- Take passenger side hub lock off and see if it operates normally or same on drivers side.
- If same, remove axle and re-seat/re-assemble everything again
Anything to specifically check? All the parts went back in, washers were in correct order, outer snap ring is in groove.
Ford Super Duty (1999-2016) :: Inside And Outside Cab Lights Stay On When Doors Are Closed
Why my interior and outside cab light just started to stay on when doors are closed and dial is turned off.
View 4 RepliesFord Super Duty (1999-2016) :: 2013 F550 - Key In / Door Chime Disconnect?
Really love my 2013 F550 but the door chime is driving me crazy. On my 2003 f150 you could just drop the column cover and unhook one wire running to the tumbler. So I had a look and found it to be totally different. How to unhook it on this truck?
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F550 Cranks But Won't Start
It has a 7.3 bone stock in it. When it is cranking you can hear a relay clicking. it's behind the dash just below the radio. There are 3 relays together 1 big one which is for trailer lights and 2 small ones which i don't know where they go. but i replaced all 3 and i still hear the clicking ONLY when the engine is cranking.
View 1 RepliesFord Super Duty (1999-2016) :: 2001 F550 - New Clutch Won't Disengage All The Way
I have a 2001 F550 flatbed tow truck with a 7.3 and the ZF 6 trans. i put a Luk clutch flywheel pressure plate new throw out bearing new clutch fork New clutch slave cylinder and master set up. When i push the clutch in it is VERY EASY compared to the way it was before. Ane when you push the clutch in and put it in gear you can hear the clutch disc rubbing on the flywheel and if you lift your foot the thickness of a hair the truck takes off. Also i can't engage my PTO because the clutch is not disengaging all the way. there is No adjustments on this set up. What Now.
View 2 RepliesFord Super Duty (1999-2016) :: Interior Lights Won't Turn Off With Closed Door?
I'm not just reposting it though. I went ahead and sprayed all of the door switches with WD-40 multiple times, and the interior cab lights still come on. So, I'm assuming one of the switches in the doors is bad. Only thing is, I don't know how to figure out which door has a bad switch. Any way I could check this? Or it may be something other than a bad switch. It's annoying not having any interior lights (I took them all out to keep the battery from running down).
View 6 RepliesFord Super Duty (1999-2016) :: 2001 F550 Just Stopped Running While Driving Now Won't Start
I have a 01 F550 Super Duty with a dynamic wheel lift system. One of my drivers was driving the truck when it just stopped running. I can't figure out what's happened. I think I have checked everything and yet it just turns over but won't start...
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F350 - Dome Light To Shut Off Without Delay When Door Closed?
Ok so long story short, my Viper 2 way alarm, instead of the brain being wired to each of the 4 doors individually, the installer ran 1 wire to the dome light. seems to work fine as far as arming/disarming/locking/unlocking, but since the dome light stays on for 10 seconds or whatever after the door is shut.
When I arm it, the 2 way remote says "door open" because the light is still on so it thinks a door is open. this eventually times out and all the sensors arm, but theres a long delay. it arms fine and no alerts pop up if i lock the doors first from the outside keypad on the door, making the lights go off, then hit arm on the viper, and everything is good to go.
can i change it so no matter what, as SOON as i shut the door, the light goes off? i want there to be NO delay, if possible. if not, i may need to just have the installer run a wire to each door and take the single run to the dome light off, as it is sorta annoying to me.
Ford Super Duty (1999-2016) :: 2001 - Headlights Blink Off / Low Beams Stay On With Highs On
I have a 2001 F53 chassis Coachmen Mirada. My low beams, and only the low beams, blink off and back on ea. 2 seconds, and the low beams stay on with highs on. I have confirmed with a friend who has the identical model that the lows should go off. The dip is momentary and happens regardless of anything else. The highs don't blink and do go off when they should.
The headlight switch seems to work normally. The multi function switch does turn the highs on and off as it should. Both sides behave the same. The Daylight running lights are separate and work fine. The high and lows are 2 different bulbs. Where do you think I should start checking? With previous cars I was led to believe that a headlight that goes off meant a breaker being tripped due to a short or bad breaker. I can't find a breaker to check.
Ford Super Duty (1999-2016) :: F550 - ABS Light On
Ok, so I am trying to get are 99 F550 all fixed up and have a few things to ask.
So we have had the ABS light on now for some time. I had it scanned at O Riley's and the scanner said the abs sensor on the passenger side was faulty. So I replaced that and the light was still on. We had taken the truck to ford to get it checked out for a rear end problem we have been having as some of you may know from a previous post I made.
Well ford said it was the rear sensor on the axle that was causing the abs light to come on. So I replaced that. Still have the abs light on. I disconnected the batteries to try and see if that would reset it and it did not. I hooked up the Scan Gauge II and ran to see if it picked up anything. It said it did not pick up any thing. I still did a code clear but it didn't work. If there a tricky way that you have to get the code cleared off?
2nd I was checking the fluid. I noticed that the tranny fluid is over filled quite a bit. Will this hurt it? Should I drain the fluid to where its at the fill line?
Ford Super Duty (1999-2016) :: 2015 F550 Does Not Have Exhaust Brake
OK, so I have the brake pedal downshifting, but there is no real exhaust brake. Can I have one installed, like the latter model 2015 or even the 2016, with the button?
View 9 RepliesFord Super Duty (1999-2016) :: 2008 F550 - Water In Fuel
I have a 2008 f-550 diesel. Had water in fuel. Flushed the entire system. Replaced the fuel filters and injectors but still will not start.
View 2 RepliesFord Super Duty (1999-2016) :: 2000 F550 / No Power And No Start
I'm working on a 2000 7.3 that was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start ...
View 2 RepliesFord Super Duty (1999-2016) :: 2013 F550 - Towing Limits?
I have a new 2013 F-550 Lariat 200" WB on order. I can and will increase the combination weight on the truck, to make full use of the 19, 500 gvwr. My question is how much will a current F-550 pull on a 5th wheel/gooseneck style trailer before it becomes dangerous? I plan to set the truck up with an 11ft aluminum Eby flat body, with a Holland FW6000 5th wheel placed under the body. I am considering a 35 or 40 ft flat gooseneck.
The combination weight would be changed based upon the axles I choose to put under the trailer. Two 12k axles will give me 44,000 gcwr, two 15k axles will give me 50,000 gcwr, and two 16k axles would give me a 51,000 gcwr. The truck will be able to carry about 10,000-11,000, the trailer needs to take the rest. I am confident that 44,000 gcwr will not be a problem, but the idea of 50,000, or 51,000 really makes me question safety. So, how much have you hauled with a F-550, and a gooseneck trailer?
Ford Super Duty (1999-2016) :: 2012 F550 XL - Parking Lights Will Not Go Off
New to me 2012 F550 parking lights will not go off. Battery disconnected now. Touch battery cable parking lights come on.
View 14 RepliesFord Super Duty (1999-2016) :: F550 V10 High Idle Up To 1200 Or So
I have a 1999 Ford F550 with a 6.8L V10 and a 4R100 Auto.
I want to run an underhood hydraulic pump, like what a wrecker uses only I want to use it to run a generator under the truck.
How can I get a 6.8 to idle up to 1200 or so? I searched the Body builders guide and it looks as if the idle up is for the 7.3 only.
My truck also is not a 2005 and up like the other posters, who can take advantage of a drive by wire.
Also I doubt my transmission has a PTO cover so I think a generator option using that route is a dead end. What are my options to idle the truck up to 1200?
Ford Super Duty (1999-2016) :: F550 - Uneven Load On Rear Suspension
I have a new to me 1999 f550 w/ 7.3 and I have installed an aluminum service body with a crane on the passenger side bins. The crane itself weights about 650lbs plus the steel frame it is mounted on (superstructure in the aluminum service body). I'm concerned about the uneven load on the rear suspension. It does sag slightly to the passenger side - guessing 1" - I will measure tomorrow.
1) Should I be concerned?
2) What can I do to correct it? (without just adding weight to counter balance it).
Ford Super Duty (1999-2016) :: 2012 F550 - Horn Not Working / No Power
I am trying to figure out where the relay would be when i look online for the map of the relay box under the hood it says nothing of a horn relay. I don't have a key fob for the doors to unlock so I wouldn't think its tied to the computer. Should mention nothing happens when you hit the horn also fuse is fine. No power at the actual horn when i hit the steering wheel(horn)....
View 8 RepliesFord Super Duty (1999-2016) :: 2000 F550 - Headlights No Longer Work
Recently removed a plow and wiring harness from my 00 F550 and now my headlights no longer work. The headlight plugs have an adapter that the plow harness plugged in to and it now appears I need some type of end plug on each one to complete the circuit. The problem is the dealer doesn't understand what I need and doesn't think there is such a part out there. Perhaps my thinking is all wrong.
View 3 Replies