Ford Ranger / B-Series :: Loose Shock On Passenger Side And Rattles When Going Over Bumps
Well, I had a friend put together my front brake rotor, now no more pulsating when coming to a stop, very smooth stop, new front brakes, had it aligned as well.. Also replaced the front shocks, however the passenger side came loose and rattles when going over bumps, speed bumps. I popped the hood, bounced my truck and could see it moving from left to right when bouncing front end of truck.
Question is, can i tighten it up myself, I dont have a jack, limited tools, I know, I know but i dont at the moment. My friend that worked on my truck lives a good drive and i hate to waste gas just for tightening something that should have been done but i have too, I will..
Ford Ranger / B-Series :: 2000 - Water Leak On Passenger Side Floor
2000 ford ranger, 2.5 2wd
Been having a little problem whenever it rains, the carpet on the passenger side gets soaked through and I'm not really sure where the leak is coming from. the only part of the floor that gets wet is the flat part where the passenger would put their feet, but the parts that slope up towards the dash and towards the middle of the cab stay dry. I've pulled up this part of the carpet, and the rubber grommets are intact and in good shape, and there is no rust or anything on the floorboard. from searching here it seems people have had similar problems, one thing being a leak into the seals around the third brake light above the rear window.
a couple things i should mention is that the air conditioning condenser has been broken for about two years, so could water get blocked up and leak in? since its winter here in PA i haven't used the air con since last summer though. I'm not really sure how long the leak has been happening since I've always kept a floor mat over that spot, and the carpet drys in a few days anyway.
Another thing i should mention is that the weather stripping at the bottom of the window on the drivers side door is not perfectly tight and tends to come out of place when the door is closed hard. this has been happening since i got the truck almost three years ago and a new piece was just put in a month ago (the leak had been occurring before the new piece was installed) when the truck was hit and went in for body work. possibly a drain routing to passenger floor? I should add that I'm sure it's not coolant, it has no odor and feels like water.
Might be a good idea to pull up the whole carpet on passenger's side and sit in the cab during the next storm...
Ford Ranger / B-Series :: How To Get Loose Evaporator Without Breaking
I've a 1993 2.3 and 1992 4.0 both with a/c systems down. On the 1993 Ranger I tried to loosen the evaporator tube nut to install the new accumulator now it looks like there's going to have to be a new evaporator. Without hardly any pressure that tube just twisted like it was nothing. Someone told me I have to spray it with wd-40 3 days prior to loosening it. I doubt that would even work. Hopefully removing the evaporator case cover under the hood won't be too time consuming because now I've got to. So I don't want to make the same mistake on my 1992 4.0. I need to change the accumulator, orifice tube, flush the evaporator, condenser, install the new hoses, and compressor before evacuating and recharging. Is there anything that makes it a breeze to loosening those evaporator and liquid line nuts without destroying the evaporator?
View 3 RepliesFord Ranger / B-Series :: 1998 4.0 - Timing Chain Getting Loose?
I really love this little truck. It's got 129,000 on it, but when I shut it down I can hear the chain clattering on the guides a little. Makes me wonder how much longer it will go before jumping a tooth. The truck has always been well maintained, but is there any ballpark figure when they usually let go? Is it worth it to pull the engine and put in a new chain? I'm fairly new to the Ranger.
View 5 RepliesFord Ranger / B-Series :: 1985 - Shifter Really Loose / Stuck In Reverse
1985 ranger 2.3L TK5 tranny. Shifter was really loose and the tranny finally got stuck in reverse. I have opened up the bottom cover, but am not sure where to move the shift forks to get it back to neutral. I bought a new shifter, but I need to get the tranny back to neutral before I can install it.
View 2 RepliesFord Ranger / B-Series :: Rear End Clunk Almost Sounds Like A Wheel Is Loose
I have a noise in my rear end, if I grab the bed of the truck, and rock the body back and forth, I hear a clunk, almost sounds like a wheel is loose, but checked them, all good, also checked the U-joints, and pulled the driveshaft to grease the spindle. Thinking it could be in the third member, maybe the Differential pinion shaft, or the lock bolt......
View 3 RepliesFord Ranger / B-Series :: Passenger Door Sounds Loose When Hit Any Bump
I have a 07 Ranger and the passenger door sounds loose when I hit any bump. Where should I start to make any adjustments on the door?
View 3 RepliesFord Ranger / B-Series :: 1999 - Started To Loose Power When Driving Up A Hill
I was driving up a hill an it started to loose power. i got up to the top of the highway an stopped an it just shut down. got towed home i thought it could of been the alternator but dose not seem to be. took the belt off to spin the motor an its not spinning. drained the oil an there is no metal in it to see if the motor was done. i try to start it an it just dose a click click an that's it. Is the motor done or is it a transmission problem?
View 3 RepliesFord Ranger / B-Series :: 1997 - Ran For About Ten Seconds / Stalled After Rattling And Now Won't Turn Over
I have a 1997 Ranger,4.0,4WD,auto,extended cab. It's always been a great truck. wouldn't start yesterday . I thought the battery was dead , put it on charger and it started right up today. It ran for about ten seconds, started rattling like crazy , stalled and now it won't turn over. Has 150,000 miles on it. Just had oil changed, No ticking or anything else. Drove it every day, just came back from 1000 mile trip.
View 12 RepliesFord Ranger / B-Series :: 1999 4x4 - Clunking / Rattling Occasionally While Driving
I am considering purchasing a 1999 4x4 ford ranger. The original owner has receipts for everything done on it recently. Rebuilt transmission, New ac, New shocks, new tires. I have never owned a ford but I always loved my friend's ranger. The only problem I had with it was an occasional clunking/rattling noise when test driving. I have read and was told this can be a common problem.
View 1 RepliesFord Ranger / B-Series :: Rattling Noise Sometimes Kind Of Metallic Ping From Rear End
1988 Ranger, 2.9, 5 speed, 2wd, 7.5, 3.42:1, 190K or 290K on the odo.
I've been hearing this rattling, sometimes kind of a metallic ping, from the rear the last week. I thought it was probably the universal joints, didn't do it often, only under load between 1500-1900RPM roughly in second, third and fourth. I planned on working on it this weekend.
Today it started really making noise, sounds like valves rattling as though the timing was too high but it was coming from the rear end. It was making it all the way through the gears into fifth, even when cruising. Once it cooled down a bit it nearly went away.
I'm going to get started on it as soon as I can, but I can't get it in the shop to pull the differential cover and take a look right now. Dad's shop is full of crap, I live on top of a hill, not many safe places to get one up in the air properly. What is causing that sound?
Ford Ranger / B-Series :: 1990 - Trans Started Making Rattling / Grinding Noises
1990 Ranger 5 speed... The tranny has recently started making noises, first I thought it was the throw out bearing but I am afraid it is more than that. As I go thru the gears the trans makes rattling/grinding sounds: in 1st, 2nd, 3rd and 5th it is loud but 4th it is quiet. What might be going on inside the tranny....
View 14 RepliesPassat (B6) :: Driver Side Rear Door Loose And Keeps Rattling Every Time Base Hits
Something inside my driver's side rear door is loose and keeps rattling every time the base hits. I tried to take the panel out but I broke one of the Clips. Any diagram or a DIY on how to access inside and figure out what the problem is?
View 3 RepliesFord Ranger / B-Series :: Runs Rough - Driver Side Exhaust Manifold Cold / Passenger Side Hot?
1990 Bronco II, 2.9l, auto, 4x4. Was running just fine. Sitting in Park just idling away. All of a sudden, just starts running real rough, ticking, etc.
Towed it home. This morning, started up OK but still running really rough.
While running, pulled spark plug wires one at a time from the drivers side. Had no effect but could tell the wires were sparking as I held them up to metal.
Turned truck off. Drivers side exhaust manifold COLD, passenger side HOT.
This sounds real bad to me. Am I missing something simple that could cause the drivers side of the engine to not work?
Ford Ranger / B-Series :: 2000 - Won't Start?
I have a 2000 Ranger 4.0L manual transmission. I just replaced the starter/solenoid on it a few days ago. I went to start it, and I got 1 click and the whole system goes dead (ie: lights, instrument panel, everything!) I checked all the fuses and the starter relay in the fuse box. All good. I tested the battery, it's charged and good. I even tried jumping it. Same problem.
I can remove power from the system, re-apply power and same issue. I'm not even sure where to start here. I checked the ground terminal on the battery. It's connected to the frame and clean. Cables are tight to the battery and clean.
What am I missing?
Ford Ranger / B-Series :: 2000 - 4WD Hard To Shift
2000 ranger 3.0 auto 4wd hard to shift. Are the cables known to stretch?
View 6 RepliesFord Ranger / B-Series :: 2000 - Fuel Economy 5 - 8 Mpg?
I am experiencing Dismal fuel Economy, I filled the tank about 16 gallons (tank read full) and went 118 miles, I burned to about 1/4th of a tank remaining, so a rough estimate is I burned 12 gallons of fuel to go 118 miles, leaving me 5-8MPG Cruising 50-60 miles an hour.... What should I be looking for..... I have 110,7XX on the truck. it's slow as heck, it hesitates and just has no get up and go unless you really step on it. It's had a recent tune up.
Plugs were changed at 105,000 miles roughly.... I'm at a loss to know why this little truck is burning so much fuel. It's the 6 Cyl Flex fuel engine. with just normal fuel run in it...I've looked at night for arcing wires and there's no flashes... there is no real miss, I checked the intake for pirate air and fixed one minor leak and have recently rechecked it as well...I've not pulled the plugs out again yet....
Ford Ranger / B-Series :: 2000 - Misfire On Cylinder 4
This has been an issue for about 8 months now. I'm getting a misfire on cylinder 4. So far compression test, new gas filter, fuel injectors cleaned, spark plugs and wires replaced. coil pack replaced. Heater valve was leaking but was replaced.
View 10 RepliesFord Ranger / B-Series :: 2000 - Burping The Radiator?
I replaced a cracked radiator with a new one on my 2000 model B2500 a coupla' days ago, guessing at the refill, as I just got the truck and don't have a manual. Guestimate was pretty close, but I got some weirdness from the temp gauge for a bit. Temp gauge read cold (even though it was maybe sixty degrees outside) after idling for quite a bit, but would rise to operating temp if I ran the RPM's up a bit, then fall back to cold when I let it drop back down to idle.....never rose to above normal operating temperature, though.
I took a short drive down the road, stayed at normal temp, but dropped back down to cold when I parked it. Taking a peek under the hood, had air blowing out into the resevoir, bubbling like bathtub farts. All appears to be normal today, but I've gotta' take this truck for a roadtrip in a coupla' days and would like to make sure I ain't missed a step that'll send me hikin'.
What is the process of burping the radiator so's I can be sure it's all good?