Ford Ranger / B-Series :: 1990 - Broken Fuel Line At Fuel Pressure Regulator?
I have a 1990 Ranger with a 4.0L that I just changer the intake gasket on. I broke the fuel line at the Fuel Pressure Regulator. Cant seem to find one anywhere. It is a nylon inside/rubber outside with a cloth mesh and quick connect fitting line. Where to get one? Can I hose clamp it the FPR by cutting off the connector that broke?
View 1 RepliesFord Ranger / B-Series :: 2000 - Fuel Pressure Regulator Location?
I have a 2000 Ranger with the 3.0. Was wondering where the fuel pressure regulator is located on it. I like pictures.
View 1 RepliesFord Ranger / B-Series :: 1994 4X4 Would Not Start / No Spark And No Fuel Pressure
Sons 94 ranger 4.0 4x4 Auto 185k got him to work yesterday but would not start to bring him home. No spark, checked with timing light, and no fuel pressure. Searched and read alot of tips from Pawpaw so I tried a few things with no luck. Swapped the relays around, inspected coil pack and plugs. CEL was not on and goes out while cranking. I have a OBD scan tool but this truck must be too old or I need finding plug. Crank sensor maybe?
View 7 RepliesGolf IV R32 :: Fuel Pressure Regulator Leaking After Taking It Off?
I took my fuel pressure regulator off hoping it would get to my green top coolant temp sensor. It doesn't Now when I put it back on its leaking? I didn't depressurize the fuel line first. Can this be the cause? If so do I just open the gas cap, pull the fuse for the fuel pump, and then re-insert the fuel pressure regulator? or do I need to get new O-rings for the regulator?
View 10 RepliesFord Ranger / B-Series :: 1990 - Leak Where Regulator Connects To Fuel Line
I got a 1990 ford ranger 4.0l and is been leaking fuel from where the regulator conects to the fuel line the regulator is new. I cant find a new fuel line.
View 4 RepliesFord Ranger / B-Series :: 1994 V6 - Oil Pressure Gauge Does Not Work
My oil pressure gauge does not work. I was told that it's most likely the sensor. Where would I find this to change it out?
View 3 RepliesFord Ranger / B-Series :: 1994 - High Oil Pressure / Water Temperature?
I have a 94 ranger 5 speed xlt v6 4.0l 288k miles original engine. in the last month the oil pressure has gradually gone way up. a manual gauge shows 65psi at cold start ( in the 90* out side) after a minute of idle it dropped to 60psi, at 2k rpms the psi was 85+. also the water temp has gotten hotter to the point of almost being unsafe. it appears that in the hotter part of the day the psi goes higher. the oil and filter was changed 1200 miles ago. the cooling system has been update in the last year with a new radiator new thermostat. no cross contamination in the fluids, engine runs good other than gauges on dash showing water and oil getting close to unsafe range and manual gauge showing high pressure.
View 14 RepliesFord Ranger / B-Series :: 1994 - Coolant Loss / Head Gasket Leaking
I am working on my buddy's 1994 Ranger with a 2.3L I4 that has been going thru a large amount of engine coolant. The trucks has approximately 180,000 miles on it. When I had it parked on concrete I have not seen any signs of coolant on the concrete or any signs of coolant leaking. The next place I checked was inside the cab to see if there was any coolant from the heater core and there was not. The water pump has been replaced a couple of years back. I replaced the spark plugs today and did not see anything on the plugs that I would have thought were signs of coolant in the combustion chambers.
With that being said I have not worked on a vehicle with a leaking head gasket before. Would there be any visible signs on the sparks plugs? If so what would I be looking for? When standing in front of the vehicle with the engine running there is a slight smell of antifreeze being "vaporized". Are there any noted issues with this engine that would cause this? Are there any other things I should check? Could it be a leaking head gasket causing this? If so how can I check for that?
Ford Ranger / B-Series :: 1994 4x4 - Noisy Rear With Leaking Axle Seals
Really noisy rear with leaking axle seals. Looking to swap in a "yard" unit. Mine has 10" shoes. The door sticker says it's a code 86 rear. If I look for a ranger with a code 86, will everything be the same?
View 5 RepliesFord Ranger / B-Series :: 1994 XLT 2.3L - EVAP System Would Not Hold Pressure - Diagram?
I have a '94 Ranger XLT with the 4 cylinder 2.3L motor. I recently failed my smog test here in CA because the evap system would not hold pressure. All the emissions were perfect, but it wouldn't hold pressure. I changed the fuel filler neck -- it was cracked -- but there is still a problem somewhere. Is there a diagram that shows where all the hoses are for the evap system? I'm thinking that some other hoses might be cracked since they have been there over 20 years. Is this a good place to start looking or should I be checking something else?
View 4 RepliesFord Ranger / B-Series :: 1995 Mazda B4000 - 4wd Light Blinking 6X Then Go Off
So i just bought a b4000 pickup 5spd .. Anyway the truck has eletrical 4x4 with manual hubs. When i turn the switch nothing happens. The 4wd/4wd low lights both flash 6x then go off then flash again while running , driving, koeo, anytime like an obd1 check engine light code flashing. Anyway i checked the wiring for the 4wd switch no power, went to the fuse interior no pwr, went to the engine fuse box power. You don't hear the transfer case engage at all as well.
View 5 RepliesFord Ranger / B-Series :: 2000 B4000 - Broken Center Armrest
I have a 2000 b 4000 broken armrest trying everything to fix keeps breaking on plastic below. And how long before it breaks again!!! Ford ....
View 3 RepliesFord Ranger / B-Series :: 1998 Mazda B4000 - Missing Enough To Shake The Truck At Around 80 Km/hr
So Im working on a 1998 mazda b4000, frost plug blew out going down the highway changed the engine because it got cooked pretty bad. The wrecker engine I got for what ever reason will only run good if the driver side of coil pack is done 5,6,4 any other order truck wont run at all. Misses enough to shake the truck at around 80 km/hr otherwise its pretty good. Also the engine I got came factory with no egr.... no provisions nothing. exhaust manifold capped off, seemed kinda odd.
View 5 RepliesFord Ranger / B-Series :: 2001 B4000 - Radio Interference / Steady Static Noise On AM Only
This interference correlates directly to tire rotation speed, engine rpm has no effect. Under about 5mph it won't make the noise, but over that you hear a pop more or less for every rotation of the tire and when you hit say 50mph it is just a steady static noise on AM only. Haven't pulled the head unit yet, checked several body grounds under the hood and all are good. Don't know if a damaged wheel sensor could cause an issue or not.
View 4 RepliesFord - E150 :: 1995 - Acting Like Running Out Of Fuel - Fuel Pressure Regulator?
Today, my 1995 E150 suddenly started acting like it was running out of fuel Lucky for me, this happened close to both a parts store and my usual mechanic's shop. Unluckily for me, it happened on Saturday, and my shop can't get to it until Thursday. So here I am, hoping to do a fix in the meantime.
At first, it seemed that it must have been the fuel pump, because I couldn't hear it come on when I turned on the ignition. Then, a guy who said he was a mechanic told me he could hear the pump cycling, and that my problem was the fuel pressure regulator. So he managed to start the vehicle after a few tries, then it crapped out again. He did this twice. Then he went away.
I called every parts store in town, and none of them had a fuel pressure regulator for my vehicle, and the earliest any of them could get one was Monday. But I knew I was due for a fuel filter, and I'd changed filters on this vehicle before, so I got one of those and put it in. To my delight, the van started right up and idled beautifully. In fact, it ran beautifully for about 15 minutes, until I came to a slight rise, then it crapped out again. It still started up and idled smoothly, and even revved up smoothly, until it reached a high idle speed, at which point it crapped out. I did manage to limp into the parking lot of my shop - which, again, can't get to it until Thursday.
So my question is: does this sound like a fuel pressure regulator to you? If so, is that a job which somebody with a reasonable mechanical aptitude (i.e., at least good enough to change the fuel filter) should be able to feel safe doing? If the answer to those two is "yes" (or even if it's "no")....
Ford Ranger / B-Series :: 1999 B4000 - Random Stalls / P0171 And P0174 Error Codes Come Up
I have a 1999 B4000 V6 4.0L with 78K miles on it. I recently had P0171 and P0174 error codes come up. I replaced the MAF sensor and have not had the codes return but now the truck will basically stalls out when sitting at a stop light. It does not do it all the time just randomly. It has never done it when engine is cool but only once up to temp. The idle is smooth at cold engine but begins to get rougher once warmed up (nothing too bad just noticeable). I cleaned the IAC with MAF cleaner but no joy. I reseated all plug cables at the coil but no change. RPM around 600-700 then fluctuates up a bit then truck will stall quickly( I usually cannot put other foot on gas in time to get it to increase RPM before it dies)....
View 5 RepliesFord Ranger / B-Series :: 1998 - Low Fuel Pressure If Rev Up A Bit
I've got 30 lbs of fuel pressure that drops to 28 if you rev it up a bit on a 1998 ranger 4.0 with a new fuel filter. Haynes manual say it should be 56-72 lbs. Bad news is fuel pressure regulator is in the tanks with the pump. Can the regulator be swapped out or is it one assembly with the fuel pump? Is there anything I should check first?
View 4 RepliesFord Ranger / B-Series :: 1998 2.5 - Fuel Pressure Down To 40 PSI?
Ok so my dad has been using my 98 while I was fixing his 92 4.0. I had the 92 perfect and then someone pulled in front of me and totaled it out. Well now I got my 98 back and it's all messed up. Check engine is on p0171. Fuel pressure test done and it's steady 40-42 psi. I remember last year I checked it was like 68-72 psi. It hasn't been a year or two since fuel pump and strainer were replaced. Filter probably 15,000 miles ago. It's currently running good sometimes it cuts off when you start it then next time it stays running. Is this another fuel pump failure? How much longer will it last on 40 psi? The fuel lines and tank have 336,000 miles, engine maybe 150,000 and injectors have about 20,000 miles on them.
View 4 RepliesFord Ranger / B-Series :: 1995 - Would Not Start / No Fuel Pressure
I have a 95 Ranger 2.3 with a manual tranny. In the past I have had problems with this truck not starting do to a bad inertia switch and numerous fuel pumps. A couple of weeks ago I pulled the truck off of the driveway into the street and let it set there for a few hours. When I went to put it back on the driveway it would not start. I got it pushed on the side of the garage. I did my normal routine of doing a pressure check. I had no fuel pressure so I assumed that it was the fuel pump (as usual) so I dropped the tank and changed the pump.
I got it back together and it still wouldn't start. I checked the fuel pressure and the manifold still had 0. So I started my diagnostic. I have power from the fuse to the fuel pump relay. I then checked the wiring at the inertia switch and found that there is no voltage with the key on at the supply side of the inertia wiring. I verified continuity between power distribution block and the inertia switch. I put in a new fuel pump relay and it still has no fuel rail pressure and there still is no electric signal at the inertia switch. Where to go from here?