Ford Wiring/Electrical :: 2000 F150 - Power Cuts Out When Attempting To Start
2000 XLT F150 4.6 - New starter & solenoid(s), battery cable & fuse links good.
When i turn the key, I hear one single click and the power cuts out entirely. I can't attempt a second start or turn on the lights or have any power going through the truck until I disconnect the battery for about 10 seconds then reconnect. Electrical becomes live again, then when the ignition is turned the electrical cuts out again. I do hear a single cluck at the starter (probably attempting to engage when it cuts out) and a clunk right at the inside fuse box (drivers side).
S-10 :: 96 Isuzu Hombre 2.2L Cuts Off While Driving Then Won't Start
I've been working with a friend who has a problem with his 96 Isuzu Hombre 2.2L (same as S10). Runs fine, then intermittently cuts off. He pulls to the side of the road, and tries to start it. It cranks but won't fire. He waits about 10 minutes or so, then he starts it up just fine. No computer codes.
View 14 RepliesFord - F150 :: 2006 - Engine Cuts Out Under Medium Acceleration
My truck has about 100,000mi and has had all the scheduled maintenance.
My 2006 5.4 engine cuts out under medium acceleration when accelerating from a stop. Happens when warm or cold. Works fine under light acceleration. Cut out happens before it shifts into second. Cuts out just for a second, then resumes. Stumbles twice under heavy acceleration. Very repeatable.
I noticed the gas was low - above E but below 1/4. So I filled up at the gas station. The problem went away. I had this issue with a 1980s fuel injected VW - it would get a vacuum lock on the gas tank. But with this truck I did not notice and inrush of air when I took the gas cap off.
I suppose it could be the gasoline sloshing towards the rear of the tank, away from the fuel inlet pickup.
Ford Fuel System :: 1988 F150 - Cuts Out Under Load?
My 88 F150 (300 six, 5 speed, dual tanks, 176,000 miles). The truck has the low pressure fuel pumps in the tanks and the high pressure pump on the frame rail setup. Truck starts fine, but cuts out severely under acceleration for the first 30 seconds of driving. After that I only notice the problem when applying a lot of throttle (does not cut out under gradual acceleration) or climbing steeper hills. If I kill it for a few minutes and then take off again the problem is back for the first 30 seconds or so. I have replaced all the tune-up type stuff (all filters, plugs & wires, dist. cap & rotor, ignition coil, o2 sensor, cleaned throttle body, replaced IAC valve, numerous sensors). Timing is dead on at 10 deg. BTDC with SPOUT unplugged. My FPR was bad so I also replaced that. Condition exists regardless of which fuel tank I am using (no problems with tank selector).
Getting no KOEO codes, but getting KOER code 41 and plugs do seem to show a lean condition possibly. I'm still averaging around 16 MPG since this became a real problem about 3 months ago.
I removed the bowl from the reservoir between the tanks and the high pressure pump on the frame. No filter in there, but it was clean with no gunk or sediment found. I removed the line from the inlet side of the high pressure pump and found that while cranking the engine I have fuel flowing freely (same amount of flow regardless of which tank I've switched to). The flow was steady, but not extremely strong. If I understand right the in-tank pumps are not designed to provide much pressure? Below is what I found at the schrader valve:
key on, engine off - high pressure pumps runs for about 1 second, brings gauge up to 48 psi
idle, FPR connected - 40 psi
idle FPR disconnected - 52 psi
revving throttle with FPR connected - 46 psi maximum
Connector, where fuel pump relay plugs in, seems to be clean and not corroded at all.
Ford - F150 :: 2004 - Stalls / Cuts Off And Idles Poorly In Reverse
I have a 2004 F-150 crewcab, 4.6L with 118,000. I don't drive the truck often but for the past few months its stalls and cuts off, and idles poorly in reverse. Truck cutting off at low RPM's, low speeds, and after going over some bumps. At one point the engine light came on but now it is off and I am still having the issues. . . . not sure what code it would display. I have been reading articles and blogs and most say the TPS, MAF, or IAC is the problem.
View 2 RepliesBuick - Lesabre :: Cuts Off When Start Driving And Cranks Right Back Up
I was wondering my buick a 1995 lasbre it cranks up fine and the engine light comes on and off when i start driving it cuts off and cranks right back up people say its the crank sensor...
View 1 RepliesFord Wiring/Electrical :: 1996 F150 - AC Runs And Then Cuts Out / Compressor Not Turning
Have and intermittent condition with my 1996 F-150 4.9. AC runs and then cuts out (compressor not turning). I lose 12v to both side of high side switch. I tried to troubleshoot using a schematic in Haynes Foprd Pickups and Bronco for 92 and later F-Series/Bronco, but the color code for the wiring doesn't match up.
On my truck, there is 2 wires from the low side pressure switch which mates to a socket with only 1 wire. I have 12 volts at switch terminal on dash control, and it seems that I have an broken wire behind the dash, as I can get it to operate again when I move the harness around. Where can I get a schematic of this part of the circuit?
Ford Wiring/Electrical :: 2000 F150 - Hooking Power Door Lock To Command Start?
I am trying to hook up my power door locks to my command start. I am having trouble getting it to work. Ive tried a number of relay diagrams from the12volt.com. I've tried actuators/reverse polarity and it blows both my factory door lock fuse and the fuse I have supplied to the relays. Ive also tried 5 wire alternating 12 volt positive door locks, and 3 wire positive door lock combinations. Both of these combinations the relays click back and forth fine with the actuators unhooked, when I connect the actuators the doors unlock with the factory switch but when I unlock with my remote it blows the fuse. How to properly connect the actuators?
View 3 RepliesFord - F150 :: Loud Boom And Cloud Of Smoke Comes Out From Front After 15 Minutes Of Parking
Last night parked my 2004 Ford F150 after a 15 minute drive in 85 degree weather. About 15 minutes after parking I heard a loud boom and a cloud if smoke came out from the front of my truck. Lots of people on the street also saw it and said they thought it was a tire but alas, all tires are fine and oddly a look under the hood showed zero signs of anything unusual, no leaks under and I even drove it home with no perceived problems. What this could be or what to look out for?
View 8 RepliesFord Wiring/Electrical :: 2004 F150 - Parking Brake Light Stays On
Why the parking brake light in my dash stays on, 2004 F150. Fluid in master cylinder is full, has no signs of leaks anywhere.
View 2 RepliesFord 6.7L Power Stroke Diesel :: 2006 F150 - Rear Parking Sensors Quit Working
My work truck that I drive, a 2006 F-150 Lariat 4x4 extended cab, rear parking sensors quit working. The button on the dash is lit up all the time like when you shut it off. I posted this on the F-150 section too and was able to find a suggestion that you can listen to each sensor while in reverse and if you don't hear a clicking at the sensor it has failed. All (4) sensors are clicking away while in reverse so not sure what else to check, no one in the F150 section, so that is why I put it here.
View 3 RepliesStalling :: 2005 Ford Explorer Cuts Off While Driving
Has happened twice. No check engine light, no code. Lights and electronics stay on, beeps like the door is open, shuts off and I am able to turn it right back on. Definitely do not want this happening on the highway. Don't have any other issues with idle, etc..
View 11 RepliesFord Ranger / B-Series :: Bronco II A/C Cuts Off While Driving
The panel goes off and the fan quits blowing. Sometimes it works, cools great, then just cuts off...
1989 Bronco II 2.9 4x4 auto 164k miles... I have been on TRS, BroncoII Corral, and even FSB searching.
This is the first attempt at reaching out because i have found that here at FTE the folks that chime in know their stuff, or know where i can find out for myself.
Ford - Mountaineer :: 2003 - Engine Randomly Cuts Out While Driving
Was just out and about today with my girlfriend and while driving back home, the engine just randomly cutout. I pulled over to the side of the road and popped the hood just to see if something came undone. Everything is kosher. Started it back up and carried on, but while driving the rpms kept dropping low and when stopped it would drop to about 450-500rpm.
So I put it in neutral and kept my foot on the gas to keep the engine up to about 1000-1500 RPM just so it wouldn't cutout. Drove part of the way home with overdrive off, even though speed limits in some areas won't let me even get into over drive. No check engine light, no messages on the message center, nothing. Looked into it and it seems to be one of several things.
Mass Air Flow sensor
Fuel Filter
Fuel Pump
Throttle Position Sensor
Yesterday I did fill up with gas, so maybe I got a there after they filled up the tanks. 2003 Merc. Mountaineer 4.6L.
Ford F-150 (2004-2008) :: 2006 - Truck Cuts Off In Seconds After Driving
I drive a 2006 Lincoln Mark LT and recently had a new heater core installed, but now when I try to drive it, it cuts off on me once I get out of the driveway. It starts back up fine, but then cuts again seconds after I try to drive. When I start the car it idles fine. I could have it idling for 10 minutes plus and have no issues, but once I shift it into gear and begin to back out of the drive way it shuts down again.
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Cruise Control Cuts Off While Driving
This has happened 3 or 4 times now while driving down the road. Just cruising down the road the CC will just cut out. I'll hit the "set accel" button on the wheel and all is good again until it randomly decides to do it again.
The only thing I've changed recently is the rear end speed sensor to cure the ABS light. I wouldn't/didn't think this would have any effect on the cruise control, but IDK, maybe I'll put the original one back in and test it.
Ford Ranger / B-Series :: Engine Cuts Out While Driving - Continuous Memory Code 22
1988 Bronco II - 2 days ago while driving my check-engine light came on for about 5 seconds, though there were no apparent drivability issues, then went away and did not come back for the remaining 20 or so miles home. Then yesterday while driving to a destination the engine cut out a few times. Gauges and such stayed illuminated but the engine lost power as if it wasn't getting fuel or spark. It occurred randomly over a 3 minute period: 1 second bogging, then 10 seconds powering, 3 bogging, 20 powering, 2 bogging... I depressed the clutch to check if the engine could idle and it stalled. Then I restarted the truck and drove 5 miles home with no issues or check engine light and even driving for a minute at WOT would not make the issue remanifest. I did not drive it today for fear of breaking down and I hope to get this solved before taking it on the road again.
I read the following codes:
KOEO: 11 (passes)
Continuous Memory: 22: Manifold Absolute Pressure (MAP) or BARO sensor out of range.
KOER: 11 (passes)
Ford Ranger / B-Series :: 1998 - Cuts Out While Driving - Throttle Position Sensor
The Problem: When I start my Ranger it dies right away, I do this about 10 times or so (worse when it is wet or has rained) then I can finally keep it running, by hitting the gas. Once I get it running it will cut out while driving as well. The idle is normal and if fires properly, I just took it in to the shop (non-dealer) and they said it fires normal and has normal fuel pressure, and the their computer returned no error codes. Their sugestion was replace the throttle position sensor. Do you all think this part could be the cause and where is the this sensor and is it hard to replace?
View 12 RepliesExplorer :: 2000 Ford O/D Light Start Flashing After Driving 3-8 Miles From Starting Out
My 2000 Ford Explorer O/D off light starts flashing after driving it after 3-8 miles from starting out. After shutting it off, it resets itself. It seems to stick between 2nd and 3rd (automatic trans) because I get a surge on my RPMs. I took it to two places, spent $200.00 and the problem remains. The tranny shop actually changed a "range sensor" and thought it was fixed. Nope - O/D off started flashing before I even got back home. I've been looking on the internet and it seems that alot of explorer owners have been having the same types of problems. The shops I have talked to have no idea other than rebuild my transmission. It only has 46,000 miles on it! It seems to me that the overdrive is not kicking in when needed and the light comes on.
View 14 Replies