Ford F-150 (2009-2014) :: 5.4 Spark Plugs Socket Different?
is there a diffrent spark plug socket too take out the plugs on the 5.4 3v motor cause i tried a socket i thought would work but i wouldn't go in the spark plug hole like what gives
View 4 RepliesFord F-150 (2004-2008) :: Spark Plugs Removal?
Sstripped threads using an impact to remove the plugs?
View 4 RepliesCorolla / Matrix 2009-13 :: Spark Plugs Won't Come Out
I can't get a single spark plug to come out of my 2009 Corolla S. I'm using a 3/8 ratchet with a 3 inch extension and a GearWrench 9/16" x 6" Magnetic Swivel Spark Plug Socket (3938D). Which is exactly what others have suggested. It feels like the socket is just spinning around on top of the spark plug. I'm kind of at a loss for what to do now?
View 10 RepliesCamry :: 2009 SE 4cyl - 165,000 Miles On Original Spark Plugs (Highway Driving)
I have an 09 camry se 4cyl with 165k. I believe the service interval on the plugs is 100k. However, 75% of my miles are from highway driving. Plainly put, the car still drives like brand spankin new and get gets 30mpg hwy. This tells me the plugs are doing their job just fine. What concerns would you have if any?
View 14 RepliesToyota - Corolla :: 2002 - Tighten Spark Plugs To Same Torque Specifications As Regular Plugs
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
Ford F-150 (2009-2014) :: 2011 - PCV Valve Removal?
How do you remove the pcv valve on 2011 5.0l. I don't want to break it .
View 1 RepliesFord F-150 (2009-2014) :: Not Starting After Warmed Up - No Spark
Got a 2013 F-150 with a start problem after warm. If I let it sit with battery disconnected it will start up. When it will not start it acts like a no spark issue.
View 1 RepliesFord F-150 (2009-2014) :: Removal Of Fabric Lining From Under The Engine?
Just wondering if this would hurt anything or if it's a splash guard of sorts. There's been previous posts about the alternators being mounted too low on these trucks and getting water damaged over short periods of time.
View 14 RepliesFord F-150 (2009-2014) :: Rear Spring Spacers Removal
How to remove the spacer from the rear-end, spring and axle housing. If so, would it be the best to remove one at time etc. Must they be re-located below the axle or totally removed. I don't have a hoist to work from only floor jacks.
View 14 RepliesFord F-150 (2009-2014) :: 2011 - Replacing Spark Plug?
This is Just an FYI. I replaced the plugs in my 2011 F-150 3.5 Ecoboostwith 50,000 miles. I had a miss under heavy acceleration. Turns out the plugs had a gap over .090" and the side electrode was burned. Replaced them and all is well.
View 8 RepliesFord F-150 (2009-2014) :: 2010 - Spark Plug Replacement
My 2010 5.4 F-150 Lariat 2WD truck has 130,000 Miles on it and the gas mileage took a dive from 16.5 to 15.2. I'm over due to change the spark plugs. Are there any secrets or tricks I should know about before I get started changing them.
View 3 RepliesFord F-150 (2009-2014) :: Front Passenger And Center Seat Removal
I am looking at using a 2009 F150 XLT to rig up a soil sampling truck. I was hoping to remove the front-passenger and front-centre seat to make room for a probe that will go through the floor into the soil. As I was looking through articles to see if this was possible I read that some newer models dont make this easy, as there are air bag sensors and seat belt sensors that screw up the process. Before going out to look at the truck and make an offer, I was wondering - if there are any tips for removing these seats.
View 3 RepliesFord F-150 (2009-2014) :: 2011 - Rear Seat Back Removal?
Trying to install some nice seat covers in my '11 supercab and can't seem to figure out how to remove the rear seat back. What is the combination?
View 2 RepliesFord F-150 (2009-2014) :: Ecoboost Misfires - Spark Plug Replacement?
Ok so besides intercooler condensation causing misfires this is the #1 reason for misfires on this engine. Any misfires on this engine has great potential to damage the catalyst and should not be taken lightly. As many know by now boosted engines are hard on the plugs be it iridium platinum whatever and you may find the need for new plugs by 50k miles. More so now as many are coming in with carbon tracking as this one had. In this video I walk you through the procedure to change out plugs on these engines with the revised plugs, gap specs and TSB that have all come out recently.
Ford F150 3.5L V6 Ecoboost Misfires: Spark Plug Replacement - YouTube...
Ford F-150 (2009-2014) :: Winch Mount Installation - Removal Of Plastic Molding?
Installed the Rough Country winch mount yesterday. One hour, by myself. Used a floor jack to lift it in place.
Only problem was removing the plastic molding which came in the spot the fairlead will be. Just a small rectangular plastic molding with a couple of bars down the middle for looks. It had two screws on top edge, and two pushpins on bottom , but also was molded with two catches on each side on the back I did not see. When I figured it out, and squeezed with just my fingers, little too hard and snapped one catch on each side. They slide into a slot and catch but wont be doing that ever again. Oh well.
As for mount, solid and easy to install. I used hand tools as the air gun would only hit one of the bolts for the front tow hooks. The other was blocked by plastic molding. No big deal.
Hidden Winch Mounting Plate for 09-14 Ford F-150 Pickup [1010] | Rough Country Suspension Systems.
Ford F-150 (2009-2014) :: 2011 - Heater Control Knobs Removal / Replacement
The heater control knob cracked on my 2011 Ford F150. Where I can get a replacement and how to take that off?
View 2 RepliesFord F-150 (2009-2014) :: Dirt Fell In Injector Hole After Fuel Rail Removal?
I thought id tackle installing my new boss intake this morning and didn't think to clean everything up enough and after i removed the fuel rail some dirt and small stones one was about a quarter of in inch round fell into the injector hole. I no that all will be in the engine now and I feel awful about it.
View 14 RepliesFord - Ranger :: Cylinder Misfire - Spark Plugs Keep Going Bad
I purchased a 2000 Ford Ranger last year. Within the first two months of ownership, the vehicle was having a cylinder 4 misfire. To fix it, I replaced the fuel filter, plugs, wires and cap - replacing the wires, plugs and cap fixed the issue. The issue went away for four months when cylinder 4 misfired again. I brought it to a repair shop and they again replaced the wires and plugs. The vehicle now has a cylinder 6 misfire.
There has to be something causing these plugs to continually go bad. Rather than just replacing the plugs again, I'd like to attempt to be proactive and fix the root of the issue. I've googled the issue and some of the forums seem to indicate a bad EGR valve.
Ford - F150 :: 1987 - Got Spark Through The Plugs But Won't Start
I just put an '86 5.0 engine from an F150 2wd pickup in my '87 truck of the same model. The motor was running when pulled but when I set in the '87, it won't run. I've replaced coil, distributor assembly, plugs, wires, throttle body, checked timing etc. I've got spark through the plugs and fuel in the cylinder but with no luck. Don't know where to turn next.
View 3 Replies