Ford - Explorer :: 2008 - Gasoline Smell Around The Driver Rear Quarter-panel
2008 Ford Explorer with 100,000 miles on it. My wife's car, and the last couple of times I've driven it I get a whiff of gasoline every now and then. I've looked at the engine and underneath the vehicle and have found no visible signs of a leak. Last night I walked by the car and smelled gasoline around the driver's rear quarter-panel. That is the opposite side of the fuel tank filler tube but it makes me think it could be fuel tank related. Where to start looking? Maybe a pin-hole in a line somewhere? Fuel filter? Fuel pump?
View 3 RepliesFord F-150 (2004-2008) :: 2005 5.4L - Oil Change - Filter?
I just bought a 2005 5.4L F-150 and need to do an oil change. The manual calls for an FL-820S Motorcraft filter. I bought one and it doesn't match up. The filter that is currently on the truck is smaller in diameter and a little longer. There's no numbers or manufacturer on it. What's up? What filter do I need?
View 14 RepliesFord F-150 (2004-2008) :: Loss Of MPG After Plug Change
I have an 04 F150 5.4 w/67k. Just changed the OE plugs. While I had it in the garage also cleaned the K&N air filter. Truck runs great but I lost about 3 MPG. I was getting 16 all around and am now getting about 13 under the same conditions. I bought a Purolator air filter and switched it with the K&N but there had been no difference. I used Champion plugs as the replacements. Truck ran great before and runs great now.
View 14 RepliesFord F-150 (2004-2008) :: No Brakes After Caliper / Brake Pad Change
After a routine brake pad replacement the brake pedal hits the floor when applied with normal force. The pedal feels like a badly leaking master cylinder, but prior to the pad replacement the brake pedal was firm as a rock with no drop at all. If I pump the brakes the pedal will come up to normal height, but if I then maintain light pressure the pedal will again sink to the floor.
1. Truck was braking fine, however pad 3/4 worn
2. Replaced front calipers, rotors and pads
3. Replaced front brake feed hoses
4. Replaced rear pads
5. Started engine
6. Started bleeding from furthest point from MC a) passenger rear, b) Driver Rear, c) passenger front, d)driver front. Did it two times...
Still, brake travels all the way to the fire wall and never develops tension. Moreover, sometimes, when person pumping brake puts pressure and i open bleed, no fluid comes out. Could it be a failed master cylinder??? I tend to think it's not because 24hrs ago, the pedal felt fine and the truck was braking ok.... So much for preventive maintenance.
Ford F-150 (2004-2008) :: Idle Really Rough When Put In Reverse After Oil Change
Okay I have a 2006 F-150 5.4 60,000 miles , Never once had any problems. I have always done the oil changes myself using 5w-20 mobile super and an S2 STP oil filter. Today, I did a normal oil change and once i filled it up I checked the oil it one last time and I topped it off just right according to the dipstick. And I also checked it after letting engine idle for 5 minutes. I changed the fuel filter also ( first time doing) but no leaks. I drove about two miles down the road, turned around and when I put it into reverse it idled really rough. It almost sounded like a thrown rod.
The rpm's dropped to about 500. I put it into drive and gave it a little gas and then all was fine. Engine ran perfect. I reversed it at least 5 more times and it did it every time but always recovering when given a little gas. I also noticed that there is some oil splashed on the undercarriage like it was leaking going down the road. I checked the filter gasket and it was fine and intact. It idles great in park, drives great. Just reverse it dives down and vibrates like crazy.? After getting home I noticed that the oil level on the dipstick is a little less than a 1/4 inch over the correct level.
Ford F-150 (2004-2008) :: 2006 FX4 - How To Change Spark Plug
I have a 2006 Fx4 with 60,000 miles. I wanted to change the spark plugs myself yet I can't seem to find were they are in the engine, I know how to take them out but I don't know how to get to them.
View 1 RepliesFord F-150 (2004-2008) :: 2006 - When To Change Spark Plugs Normally?
I am a newbie here, and also a new owner of a 2006 F150 XLT 4X4 with the 5.4 engine. It has 68K miles on it and looks to have been well cared for. I have a couple questions. First the truck is runnig great, no problems. I have read the threads regarding the spark plug issues and was looking for an opinion about changing them. Should I wait until I have problems, or due to the age of the truck, should I go ahead and attempt it soon? Also, I would like to find a used cap for the bed. I have the 6.5 bed, and wondered what range of years would work with my truck.
View 3 RepliesFord F-150 (2004-2008) :: 2005 - Transmission Oil And Filter Change
I have a 2005 f150 4x4 4.6 with 100000 miles. I am wanting to change my transmission fluid and filter, my dealer says all i need is to flush out the old and put in new, which is what they do, they say no need to change the filter.
View 5 RepliesFord F-150 (2004-2008) :: 2005 STX Misfiring After Spark Plug Change
I just changed the plugs in my 05 stx 4x4 4.6L. Truck was running fine, never a problem but it has 105k so I figured id change them. #4 was the only one that gave me a little problem (besides being so tight). The coil and spring pulled off the boot, and I had to get a pair of pliers and get the boot off the plug.
I simply slid the spring back through the boot and replaced it once I had changed the plug. Other than that they all came out easily. I replaced with motorcraft plugs, and #5 did have what looked like some oil down on the threads when I pulled it out, but not sure if that's a big deal or not
Any way, I am torn between ordering new boots and changing them out, or just biting the bullet and getting 8 new coils with new boots attached. Truck runs fine, but does the usual buck/jerk under a load in overdrive now (never once did it before)...
Ford F-150 (2004-2008) :: Trans Fluid Change - How To Get To Converter Plug
In the "Old days" I could pull the one-and-only coil wire and trigger the starter motor to rotate the converter so the plug was at the bottom. How do ya do this with COP engines so the engine does not start?
View 4 RepliesFord F-150 (2004-2008) :: Running Rough And Skipping After Plug Change?
I just completed a successful second spark plug change, using Motorcraft SP515 plugs just like last time. After reconnecting battery and starting engine, it ran poorly throughout a short road test. Felt like it was skipping. Checked under the hood and found that the #2 fuel injector was disconnected, so I reconnected the injector.
I took another short road trip and it still ran poorly as if skipping. So, this time I disconnected the battery for several minutes while removing the #2 plug thinking I may possibly have fouled the plug by the injector not being connected. I also checked all of the other injector and coil connections. Reconnected battery and took another short trip. It still runs poorly. No codes yet.
Ford F-150 (2004-2008) :: Tapping Noise Coming From The Engine After Oil Change
I just bought an '04 F150 from a friend. It has 250K miles on it. When I got the truck there were no tapping noises coming from the engine. Now that I changed the oil, at start up till about 5 miles down the road, I hear the tapping noise. I put Castrol high mileage 5W-20 in it. Could it just be the oil I'm using or something more expensive?
View 9 RepliesFord F-150 (2004-2008) :: 2007 5.5L - Upper Engine Rebuild After Oil Change
We operate a garage, did an oil change on a 2007 F150 with a 5.4L, with 70,000 km. A few days later, began to make noise. Owner took it to the dealer, the dealer told him it needed an upper engine rebuild. A technician at the dealership said the oil filter came apart and caused the engine damage. Scored cam guides and cam shaft damage. Installed OEM recommended, Pennzoil 5w20, and Pennzoil PZ42, Purolator manufactured. No loss of oil, proper quantity of oil installed. Sent the filter to Purolator for testing, came back 100% within specifications, no missing parts, gaskets present intact. What would cause this damage?
View 11 RepliesFord F-150 (2004-2008) :: 2005 - Alignment Required With Strut Change?
I have a 2005 F-150 4x2 with 4.2L mojo. If I change the struts, is an alignment required due to slight changes in the top mount location? I plan on having it aligned but timing wise I may not be able to get it all done at the same time.
View 1 RepliesFord F-150 (2004-2008) :: Engine Seafoamed - Motor Noise Upon Initial Startup After Oil Change
Today I decided to do some maintenance on the truck as it needed an oil change and some other unrelated misc stuff.
1. I seafoamed the engine thoroughly. I bought two cans of this stuff, half of a can went into the fuel, another half can in through the brake booster vacuum hose, and I dumped a full can of into the oil. Took it for a 30 minute drive, let the ol' gal smoke as it usually does on a seafoam, and then changed the oil. No noises, I noticed immediately improvement in acceleration.
2. Upon intial startup after the oil change, I thought the motor was coming apart. It was only for about two seconds, (i was counting to make sure) if it didn't have oil pressure and no noise by 3, I was shutting it off. It hasn't done it since.
Is it possible I just knocked some crap loose in the heads causing the oil drain a lot faster into the pan than I expected? I'll try it again in a few hours after everything has cooled off and oil has drained back into the pan, but I wanna make sure I didn't damage anything. Still drives good, no problems, no noises since.
The last oil change I did, I didn't do a Seafoam, but I figured with winter coming it's a good idea to get her running in top form. I used Pennzoil Platinum 5w20, with a Motorcraft oil filter for those wondering.
Truck has 133K on the clock, and it's had the slight cam phaser tick since I've purchased it, no other problems. I bought it almost a year ago.
Toyota - Corolla :: 2008 - Rust Spots On Back Quarter Panel In Front Of Wheel Well
I just noticed 2 rust spots on the back quarter panel in front of the wheel well on my Corolla. Then I looked on the other side, and found rust in the exact same spot. It looks like the rust is near some bolts that are holding on (what looks like) a small plastic mud flap (I'm not really sure if that is the correct technical name). Anyway, is that normal to have rust in the same spot on both sides, or is it defective? This is the only car I've ever purchased new so I was planning on keeping it, like, FOREVER. I think I've taken pretty good care of it so I plan to have it fixed. Just wondering if I should bring it to Toyota.
View 15 RepliesPrius (2004-09) Fuel :: 2008 Touring - MPG Drops After Oil Change
I changed the oil on my 2008 Prius Touring in the weekend. I consulted the manual after the oil was changed. One mistake I made was to use 10W-30 instead 5W-30 recommended. The manual mentioned that it affects MPG with 10W-30. For the 270 miles trip I took right after, my average MPG dropped from ~46 to 45 highway. My short commute driving dropped from ~37 to 34. Comparison are made on the same roads with similar temperature and driving speed. Is that normal? Will it go back up after a while?
View 12 RepliesPrius (2004-09) :: 2005 - Leak From Driver Side Rear Quarter Window
I just bought a 2005 Prius a couple days ago and have spent the weekend discovering "hidden" little issues. One was that after a heavy night a rain there was a small pool of water in the very back of the car underneath the cargo area near the wire that runs from the traction battery. In fact the little prongs holding a slim white (electronic) box connecting to the battery were rusted out.
View 3 RepliesFord F-150 (2004-2008) :: Sporadic Front Brake Drag / Hard Pedal Post Front Brake Line Change
Had a lift done (Rough Country, after reading through these forums) on my 04 F150 Newer Body Style 4x4. Now, sometimes the pedal gets harder to push on until it won't go down at all and the brakes (only the front) start dragging. It goes away after awhile (my rotors are shot and I'm going to have to replace them after I figure out what is going on) but always comes back. The brake lines have been bled and I'm having a shop bleed them again tomorrow (that's what they said the issue was) just in case.
View 11 Replies